Monolitmc integrated optical detection for microfluidic systems using thin film photodiodes based on amorphous silicon

Author(s):  
H. Schaefer ◽  
K. Seibel ◽  
M. Walder ◽  
L. Schoeler ◽  
T. Pletzer ◽  
...  
2021 ◽  
pp. 131330
Author(s):  
Katerina Nikolaidou ◽  
Pedro G.M. Condelipes ◽  
Catarina R.F. Caneira ◽  
Maximilian Krack ◽  
Pedro M. Fontes ◽  
...  

1997 ◽  
Vol 36 (Part 1, No. 10) ◽  
pp. 6226-6229 ◽  
Author(s):  
Huang-Chung Cheng ◽  
Jun-Wei Tsai ◽  
Chun-Yao Huang ◽  
Fang-Chen Luo ◽  
Hsing-Chien Tuan

2000 ◽  
Author(s):  
Pi-Fu Chen ◽  
Jr-Hong Chen ◽  
Dou-I Chen ◽  
HsixgJu Sung ◽  
June-Wei Hwang ◽  
...  

1996 ◽  
Vol 424 ◽  
Author(s):  
R. E. I. Schropp ◽  
K. F. Feenstra ◽  
C. H. M. Van Der Werf ◽  
J. Holleman ◽  
H. Meiling

AbstractWe present the first thin film transistors (TFTs) incorporating a low hydrogen content (5 - 9 at.-%) amorphous silicon (a-Si:H) layer deposited by the Hot-Wire Chemical Vapor Deposition (HWCVD) technique. This demonstrates the possibility of utilizing this material in devices. The deposition rate by Hot-Wire CVD is an order of magnitude higher than by Plasma Enhanced CVD. The switching ratio for TFTs based on HWCVD a-Si:H is better than 5 orders of magnitude. The field-effect mobility as determined from the saturation regime of the transfer characteristics is still quite poor. The interface with the gate dielectric needs further optimization. Current crowding effects, however, could be completely eliminated by a H2 plasma treatment of the HW-deposited intrinsic layer. In contrast to the PECVD reference device, the HWCVD device appears to be almost unsensitive to bias voltage stressing. This shows that HW-deposited material might be an approach to much more stable devices.


Solar Energy ◽  
2013 ◽  
Vol 97 ◽  
pp. 591-595 ◽  
Author(s):  
C. Banerjee ◽  
T. Srikanth ◽  
U. Basavaraju ◽  
R.M. Tomy ◽  
M.G. Sreenivasan ◽  
...  

2008 ◽  
Vol 1066 ◽  
Author(s):  
Kyung-Wook Shin ◽  
Mohammad R. Esmaeili-Rad ◽  
Andrei Sazonov ◽  
Arokia Nathan

ABSTRACTHydrogenated nanocrystalline silicon (nc-Si:H) has strong potential to replace the hydrogenated amorphous silicon (a-Si:H) in thin film transistors (TFTs) due to its compatibility with the current industrial a-Si:H processes, and its better threshold voltage stability [1]. In this paper, we present an experimental TFT array backplane for direct conversion X-ray detector, using inverted staggered bottom gate nc-Si:H TFT as switching element. The TFTs employed a nc-Si:H/a-Si:H bilayer as the channel layer and hydrogenated amorphous silicon nitride (a-SiNx) as the gate dielectric; both layers deposited by plasma enhanced chemical vapor deposition (PECVD) at 280°C. Each pixel consists of a switching TFT, a charge storage capacitor (Cpx), and a mushroom electrode which serves as the bottom contact for X-ray detector such as amorphous selenium photoconductor. The chemical composition of the a-SiNx was studied by Fourier transform infrared spectroscopy. Current-voltage measurements of the a-SiNx film demonstrate that a breakdown field of 4.3 MV/cm.. TFTs in the array exhibits a field effect mobility (μEF) of 0.15 cm2/V·s, a threshold voltage (VTh) of 5.71 V, and a subthreshold leakage current (Isub) of 10−10 A. The fabrication sequence and TFT characteristics will be discussed in details.


2009 ◽  
Vol 105 (12) ◽  
pp. 124504 ◽  
Author(s):  
S. L. Rumyantsev ◽  
Sung Hun Jin ◽  
M. S. Shur ◽  
Mun-Soo Park

2006 ◽  
Vol 326-328 ◽  
pp. 689-692
Author(s):  
Seung Jae Moon

The thermal conductivity of amorphous silicon (a-Si) thin films is determined by using the non-intrusive, in-situ optical transmission measurement. The thermal conductivity of a-Si is a key parameter in understanding the mechanism of the recrystallization of polysilicon (p-Si) during the laser annealing process to fabricate the thin film transistors with uniform characteristics which are used as switches in the active matrix liquid crystal displays. Since it is well known that the physical properties are dependent on the process parameters of the thin film deposition process, the thermal conductivity should be measured. The temperature dependence of the film complex refractive index is determined by spectroscopic ellipsometry. A nanosecond KrF excimer laser at the wavelength of 248 nm is used to raise the temperature of the thin films without melting of the thin film. In-situ transmission signal is obtained during the heating process. The acquired transmission signal is fitted with predictions obtained by coupling conductive heat transfer with multi-layer thin film optics in the optical transmission measurement.


Sign in / Sign up

Export Citation Format

Share Document