Combined Process Simulation and Emulation of an SRAM Cell of the 5nm Technology Node

Author(s):  
Xaver Klemenschits ◽  
Siegfried Selberherr ◽  
Lado Filipovic
2021 ◽  
Author(s):  
Saurabh Kumar ◽  
R. K. Chauhan ◽  
Manish Kumar ◽  
Mangal Deep Gupta

Author(s):  
Sunil Kumar Ojha ◽  
O.P. Singh ◽  
G.R. Mishra ◽  
P.R. Vaya

Noise margin analysis of SRAM cell is became more crucial for on chip applications. Currently the technology is migrating towards less than 10nm node and hence it is necessary to measure the noise margin of SRAM cell very effectively, since memory is one of the major part of system on chips (SOCs) and Network on chips (NOCs) devices. If the margin is not calculated efficiently then it may leads to bad chip product and the whole device which contains this chip may not work as per the expectation. This further leads to low yield which increases the number of defective chips compared to good one. In this paper the noise margin analysis of SRAM cell is performed using 7nm process technology node using HSPICE simulator.


2015 ◽  
Vol 2015 ◽  
pp. 1-10 ◽  
Author(s):  
Priya Gupta ◽  
Anu Gupta ◽  
Abhijit Asati

The paper presents a novel 8T SRAM cell with access pass gates replaced with modified PMOS pass transistor logic. In comparison to 6T SRAM cell, the proposed cell achieves 3.5x higher read SNM and 2.4x higher write SNM with 16.6% improved SINM (static current noise margin) distribution at the expense of 7x lower WTI (write trip current) at 0.4 V power supply voltage, while maintaining similar stability in hold mode. The proposed 8T SRAM cell shows improvements in terms of 7.735x narrower spread in average standby power, 2.61x less in averageTWA(write access time), and 1.07x less in averageTRA(read access time) at supply voltage varying from 0.3 V to 0.5 V as compared to 6T SRAM equivalent at 45 nm technology node. Thus, comparative analysis shows that the proposed design has a significant improvement, thereby achieving high cell stability at 45 nm technology node.


2021 ◽  
Vol 13 ◽  
Author(s):  
Vijay Kumar Sharma ◽  
Masood Ahmad Malik

Background: As the Technology node scales down to deep sub-micron regime, the design of static random-access memory (SRAM) cell becomes a critical issue because of increased leakage current components. These leakage current components prevent to design a low power processor as large of the processor power is consumed by the memory part. Objective: In this paper, a SRAM cell is designed based on ON/OFF logic (ONOFIC) approach. Static noise margin (SNM) of the cell for the different states are calculated and evaluated by using butterfly as well as noise (N) curves with the help of Cadence tools at 45 nm technology node. Methods: ONOFIC approach helps to reduce the leakage current components which makes a low power memory cell. A performance comparison is made between the conventional six-transistor (6T) SRAM cell and memory cell using ONOFIC approach. Results: Low value of power delay product (PDP) is the outcome of ONOFIC approach as compared to conventional cell. ONOFIC approach decreases PDP by 99.99% in case of hold state. Conclusions: ONOFIC approach improves the different performance metrics for the different states of the SRAM cell.


2020 ◽  
Vol 15 (2) ◽  
pp. 1-7
Author(s):  
Chusen Duari ◽  
Shilpi Birla ◽  
Amit Kumar Singh

Static Random-Access Memory cells with ultralow leakage and superior stability are the primary choice of embedded memories in contemporary smart devices. This paper presents a novel 8T SRAM cell with reduced leakage and improved stability. The proposed SRAM cell uses a stacking effect to reduce leakage and transmission gate as an access transistor to enhance stability. The performance of the proposed 8T SRAM cell with a stacked transistor has been analyzed based on the power consumption and static noise margin (RSNM, HSNM, and WSNM). The power consumption in the case of FinFET based 8T cell is found to be 572 pW at 22 nm technology node, which is reduced by a factor nearly  as compared to that of CMOS based 8T cell. Further, in the case of FinFET based novel 8T SRAM cell at 22 nm technology node, the power consumption is found to be reduced by a factor of  as compared to that of FinFET based conventional 6T SRAM cell. WSNM, HSNM, and RSNM of the 8T SRAM cell designed with FinFET logic are observed as 240 mV, 370 mV, and 120 mV respectively at 0.9 V supply voltage. When comparing with conventional 6T FinFET Cell, the proposed Cell shows 20%, 5.11%, and 7% improvement in WSNM, HSNM, and RSNM, respectively. The sensitivity of SNM with temperature variation is also analyzed and reported.  Further, the results obtained confirm the robustness of the proposed SRAM cells as compared to several recent works.


Sign in / Sign up

Export Citation Format

Share Document