Agronomic factors affecting the yield and quality of forage maize in Ireland: effect of plastic film system and seeding rate

2003 ◽  
Vol 58 (4) ◽  
pp. 362-371 ◽  
Author(s):  
G. P. Keane ◽  
J. Kelly ◽  
S. Lordan ◽  
K. Kelly
1977 ◽  
Vol 17 (88) ◽  
pp. 765 ◽  
Author(s):  
AP Meissner ◽  
AL Clarke

Trials lasting three years were conducted at 27 sites in the south-east of South Australia to examine the responses of mown subterranean clover-ryegrass pastures to repeated annual applications of potassium chloride. At 20 sites, yield of dry matter (DM) was increased by potassium in one or more harvests. Responses were measured in 9 out of 55 winter harvests and 42 out of 86 spring harvests; mean responses to 100 kg ha-1 KCl (-Y100) at responsive sites were 380 and 560 kg DM ha-1 in winter and spring respectively. When potassium dressing increased yield, the proportion of clover in the sward was either maintained or increased. The herbage concentration of potassium was usually increased, and its magnesium concentration sometimes depressed, by potassium application. Although the K:Mg ratio was thereby increased, especially during winter, it rarely reached 15, the value considered necessary to induce grass tetany in cattle. Multivariate regression analysis showed that the exchangeable potassium concentration (Kex) of the top 10 cm of soil, the depth of soil overlying clay or limestone, and the sand content of the topsoil were factors affecting yield response. The best regression equations, however, explained less than half of the response variations. In practice, Kex alone would have usefully diagnosed potassium responsive sites. Responses occurred often when Kexwas less than 0.2 me 100 g-1 and rarely when it was greater. The use of potassium fertilizer is likely to be worthwhile to establish new pasture, to maintain the clover content of old pasture, and to increase the yield and quality of hay, where soils have less than 0.20 me 100 g-1 Kex. Such soils are most commonly sands more than 30 cm deep.


Foods ◽  
2019 ◽  
Vol 8 (9) ◽  
pp. 424 ◽  
Author(s):  
Ahmad ◽  
Cawood ◽  
Iqbal ◽  
Ariño ◽  
Batool ◽  
...  

Carrots are a multi-nutritional food source. They are an important root vegetable, rich in natural bioactive compounds, which are recognised for their nutraceutical effects and health benefits. This review summarises the occurrence, biosynthesis, factors affecting concentration, and health benefits of phytochemicals found in Daucus carota. Two hundred and fifty-five articles including original research papers, books, and book chapters were analysed, of which one hundred and thirty articles (most relevant to the topic) were selected for writing the review article. The four types of phytochemicals found in carrots, namely phenolics, carotenoids, polyacetylenes, and ascorbic acid, were summarised. These chemicals aid in the risk reduction of cancer and cardiovascular diseases due to their antioxidant, anti-inflammatory, plasma lipid modification, and anti-tumour properties. Numerous factors influence the amount and type of phytochemicals present in carrots. Genotype (colour differences) plays an important role; high contents of α and β-carotene are present in orange carrots, lutein in yellow carrots, lycopene in red carrots, anthocyanins in the root of purple carrots, and phenolic compounds abound in black carrots. Carotenoids range between 3.2 mg/kg and 170 mg/kg, while vitamin C varies from 21 mg/kg to 775 mg/kg between cultivars. Growth temperatures of carrots influence the level of the sugars, carotenoids, and volatile compounds, so that growing in cool conditions results in a higher yield and quality of carrots, while higher temperatures would increase terpene synthesis, resulting in carrots with a bitter taste. It is worthwhile to investigate the cultivation of different genotypes under various environmental conditions to increase levels of phytochemicals and enhance the nutritional value of carrot, along with the valorisation of carrot by-products.


1993 ◽  
Vol 85 (2) ◽  
pp. 341-347 ◽  
Author(s):  
W. J. Cox ◽  
S. Kalonge ◽  
D. J. R. Cherney ◽  
W. S. Reid

2020 ◽  
Vol 5 (86) ◽  
pp. 3-10
Author(s):  
V.G. Chernikov ◽  
◽  
R.A. Rostovtsev ◽  
N.A. Kudryavtsev ◽  
I.V. Uschapovsky ◽  
...  

The formation of fiber flax yield and quality parameters depends on many soil-climatic, breedinggenetic, as well as anthropogenic factors. The quality of flax fiber is a combination of a number of features and properties that depend on the varietal characteristics of plants, the conditions of their cultivation, technologies for harvesting and straw retting, as well as on the processing modes of raw materials. During plant vegetation (90-130 days) many factors such as soil conditions (pH 4.8-5.5, humus 1.8-2.5%, P2O5 and K2O – 150-200 and 100-200 mg/kg, respectively) and the area of plant nutrition (15-30 million seeds/ha), temperature regime (the sum of active temperatures 1000-1800ºC), water supplying (400-430 units of water mass to create 1 unit of dry matter) and insolation (the arrival of FAR during the growing season 20-25 kcal / cm²), contamination of weeds (more than 60 annual and perennial species) and pests (more than 200 types of fungal, bacterial and viral diseases), features of phytosanitary measures (more than 50 chemicals) and agrotechnologic manners (Federal Register of technologies for the production of crop products) have a great influence on the quality of flax raw materials and can be a limit factor. Environmentally hazardous pollution of air, water and soil - the main components for the production of fiber flax – strongly affects the yield and quality of flax products. The development of waste-free environmentally friendly technologies for the cultivation, harvesting and processing of flax is an urgent task of scientific support of the industry. The main environmental factors affecting the yield and quality of fiber flax are discussed in the article.


Author(s):  
V. Stroyanovskyi ◽  

Goal. To substantiate the technology of growing fennel in Lisste. Crop accounting was performed by continuous submerged threshing. Methods. The yield was brought to 100% purity and standard humidity according to the method described by V.O. Moiseychenko and V.O. Yeshchenko. Mathematical data processing was performed according to the method of B.A. Dopehova. Results. The article highlights the results of studies of technological factors influence (sowing time, seeding rates, row spacing, growth regulators and terms of their application) on the yield and quality of fennel seeds when grown in the Western Forest-Steppe. Indicators of yield and content of essential oil in seeds depending on the studied factors are given. According to the research results, on average over the years of research the yield of fennel seeds at 1.56 t / ha was obtained by sowing at the level of thermal regime of the soil 6–80C in a wide row at 45 cm by seeding rate of one million sprouting seeds per hectare. Among the studied agents Vermiyodis was the best when used for seed treatment, and the agent Humifield – for the treatment of vegetative plants, the yield on these variants exceeded the control by: 0.28 and 0.30 t / ha, respectively. The maximum content of essential oil in the same variants of experiments was determined. In addition, calculations have been made which show that the maximum conditional oil yield of 60 kg / ha was observed in the variant of sowing in the first term with a row spacing of 45 cm and the sowing rate of one million sprouting seeds per hectare. The use of growth regulators helped to increase the conditional yield of essential oil by 4.5–11.6 kg / ha. Conclusions. Тo ensure the yield of fennel seeds at the level of 1.56-1.8 t / ha, the content of essential oil in the seeds - in the range of 6.26-6.36% in the Western Forest-Steppe, we offer sowing at the level of soil thermal regime 6-80C in a wide row at 45 cm sowing rate of one million such seeds per hectare, in the phase of plant stems - spraying crops growth regulator Humifield at the rate of 100 g / ha, dissolved in 250 liters of water.


1984 ◽  
Vol 64 (3) ◽  
pp. 667-675 ◽  
Author(s):  
L. BELZILE

The effects of cultivars, date and rate of seeding on the yield and quality of alfalfa (Medicago sativa L.) seeded at the end of summer and harvested the year after was studied from 1971 to 1975 on a Kamouraska clay. Seeding in early August gave the best results; seeding should not be carried out after mid-August. Differences between cultivars were more important on the third than on the first cut. Aftergrowth was an important factor on yield during the first year of harvest. Seeding rate did not always affect the yield, but the 6,7 kg/ha rate yielded less than the 13,4 kg/ha rate at the first cut and when the cuts were summed. The combined effects of the three factors studied indicates the importance of the seeding date on the height, cover and yield of alfalfa. Digestibility and crude protein content of the dry matter were affected more by seeding dates than by cultivars. The effect of cultivars on quality was variable and seeding rates had no effect. The variation in forage quality may be attributed to a difference in maturity of the plant at harvest, rather than only to the factors studied.Key words: Medicago sativa L., cultivar, date, rate, yield, quality


Sign in / Sign up

Export Citation Format

Share Document