Effect of monoterpenes on ex vivo transungual delivery of itraconazole for the management of onychomycosis

Aim: Due to the various drawbacks associated with current treatment therapy of onychomycosis, the main aim was to develop thermosensitive hydrogels and thermosensitive polypseudorotaxanes hydrogels-based nail lacquer for transungual delivery of Efinaconazole for management of onychomycosis. The objective is to enhance the permeation and retention of the drug in the nails and improve patient compliance. Method: Poloxamer 407 and Hydroxy Propyl -β- cyclodextrin was used to prepare the nail lacquers. 2-mercaptoethanol was added as a penetration enhancer to improve the penetration of the drug across the nail plate. The formulations were optimized by varying the concentration of poloxamer and water:ethanol ratio and evaluated based on basis of drying time, sol-gel transition temperature, ex vivo drug release and viscosity. The optimized formulation was further evaluated for pH, water resistance, non-volatile content, drug content, blush test, spreadability, and stability studies. Results: The increase in ethanol concentration, reduction in poloxamer proportion lead to reduction in lacquer stickiness thus, improving the lacquer drying time and penetration. The polypseudorotaxanes improved the permeation profile of the drug in comparison to the marketed nail lacquer. The presence of 2-mercaptoethanol also contributed in transungual delivery of Efinaconazole. Conclusion:: The polypseudorotaxanes based nail lacquer with the incorporation of penetration enhancer was able to achieve a high rate of drug penetration and retention, thus supporting the potential use of aqueous based-nail lacquer in transungual drug delivery for the onychomycosis treatment.

Download Full-text

Constant Voltage Iontophoresis Technique to Deliver Terbinafine via Transungual Delivery System: Formulation Optimization Using Box–Behnken Design and In Vitro Evaluation

Pharmaceutics ◽

10.3390/pharmaceutics13101692 ◽

2021 ◽

Vol 13 (10) ◽

pp. 1692

Author(s):

Anroop B. Nair ◽

Bandar E. Al-Dhubiab ◽

Jigar Shah ◽

Bapi Gorain ◽

Shery Jacob ◽

...

Keyword(s):

Low Voltage ◽

Ex Vivo ◽

Topical Therapy ◽

Nail Plate ◽

Drug Accumulation ◽

Constant Voltage ◽

Box Behnken Design ◽

Ex Vivo Permeation ◽

Transungual Delivery

Topical therapy of antifungals is primarily restricted due to the low innate transport of drugs through the thick multi-layered keratinized nail plate. The objective of this investigation was to develop a gel formulation, and to optimize and evaluate the transungual delivery of terbinafine using the constant voltage iontophoresis technique. Statistical analysis was performed using Box–Behnken design to optimize the transungual delivery of terbinafine by examining crucial variables namely concentration of polyethylene glycol, voltage, and duration of application (2–6 h). Optimization data in batches (F1–F17) demonstrated that chemical enhancer, applied voltage, and application time have influenced terbinafine nail delivery. Higher ex vivo permeation and drug accumulation into the nail tissue were noticed in the optimized batch (F8) when compared with other batches (F1–F17). A greater amount of terbinafine was released across the nails when the drug was accumulated by iontophoresis than the passive counterpart. A remarkably higher zone of inhibition was observed in nails with greater drug accumulation due to iontophoresis, as compared to the passive process. The results here demonstrate that the optimized formulation with low voltage iontophoresis could be a viable and alternative tool in the transungual delivery of terbinafine, which in turn could improve the success rate of topical nail therapy in onychomycosis.

Download Full-text

Correlation of γ-radioactivity and Scanning Electron Microscopy in measurement of retention of 111Indium-labeled canine endothelial cells on synthetic vascular grafts

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100156419 ◽

1989 ◽

Vol 47 ◽

pp. 886-887

Author(s):

E.J. Prendiville ◽

S. Laliberté Verdon ◽

K. E. Gould ◽

K. Ramberg ◽

R. J. Connolly ◽

...

Keyword(s):

Blood Flow ◽

Ex Vivo ◽

Vascular Grafts ◽

Retention Data ◽

Vascular Prostheses ◽

Group 4 ◽

Human Fibronectin ◽

Insufficient Time ◽

Group 3 ◽

Group 2

Endothelial cell (EC) seeding is postulated as a mechanism of improving patency in small caliber vascular grafts. However the majority of seeded EC are lost within 24 hours of restoration of blood flow in previous canine studies . We postulate that the cells have insufficient time to fully develop their attachment to the graft surface prior to exposure to hemodynamic stress. We allowed EC to incubate on fibronectin-coated ePTFE grafts for four different time periods after seeding and measured EC retention after perfusion in a canine ex vivo shunt circuit.Autologous canine EC, were enzymatically harvested, grown to confluence, and labeled with 30 μCi 111 Indium-oxine/80 cm 2 flask. Four groups of 5 cm x 4 mm ID ePTFE vascular prostheses were coated with 1.5 μg/cm.2 human fibronectin, and seeded with 1.5 x 105 EC/ cm.2. After seeding grafts in Group 1 were incubated in complete growth medium for 90 minutes, Group 2 were incubated for 24 hours, Group 3 for 72 hours and Group 4 for 6 days. Grafts were then placed in the canine ex vivo circuit, constructed between femoral artery and vein, and subjected to blood flow of 75 ml per minute for 6 hours. Continuous counting of γ-activity was made possible by placing the seeded graft inside the γ-counter detection crystal for the duration of perfusion. EC retention data after 30 minutes, 2 hours and 6 hours of flow are shown in the table.

Download Full-text

Elevated level of circulatory sTLT1 induces inflammation through SYK/MEK/ERK signalling in coronary artery disease

Clinical Science ◽

10.1042/cs20190999 ◽

2019 ◽

Vol 133 (22) ◽

pp. 2283-2299

Author(s):

Apabrita Ayan Das ◽

Devasmita Chakravarty ◽

Debmalya Bhunia ◽

Surajit Ghosh ◽

Prakash C. Mandal ◽

...

Keyword(s):

Risk Factors ◽

Coronary Artery Disease ◽

Coronary Artery ◽

Chronic Inflammation ◽

Ex Vivo ◽

Human Subjects ◽

Critical Role ◽

Atherosclerotic Cardiovascular Disease ◽

Tnf Α ◽

Artery Disease

Abstract The role of inflammation in all phases of atherosclerotic process is well established and soluble TREM-like transcript 1 (sTLT1) is reported to be associated with chronic inflammation. Yet, no information is available about the involvement of sTLT1 in atherosclerotic cardiovascular disease. Present study was undertaken to determine the pathophysiological significance of sTLT1 in atherosclerosis by employing an observational study on human subjects (n=117) followed by experiments in human macrophages and atherosclerotic apolipoprotein E (apoE)−/− mice. Plasma level of sTLT1 was found to be significantly (P<0.05) higher in clinical (2342 ± 184 pg/ml) and subclinical cases (1773 ± 118 pg/ml) than healthy controls (461 ± 57 pg/ml). Moreover, statistical analyses further indicated that sTLT1 was not only associated with common risk factors for Coronary Artery Disease (CAD) in both clinical and subclinical groups but also strongly correlated with disease severity. Ex vivo studies on macrophages showed that sTLT1 interacts with Fcɣ receptor I (FcɣRI) to activate spleen tyrosine kinase (SYK)-mediated downstream MAP kinase signalling cascade to activate nuclear factor-κ B (NF-kB). Activation of NF-kB induces secretion of tumour necrosis factor-α (TNF-α) from macrophage cells that plays pivotal role in governing the persistence of chronic inflammation. Atherosclerotic apoE−/− mice also showed high levels of sTLT1 and TNF-α in nearly occluded aortic stage indicating the contribution of sTLT1 in inflammation. Our results clearly demonstrate that sTLT1 is clinically related to the risk factors of CAD. We also showed that binding of sTLT1 with macrophage membrane receptor, FcɣR1 initiates inflammatory signals in macrophages suggesting its critical role in thrombus development and atherosclerosis.

Download Full-text

The Shikani HME: A New Tracheostomy Heat and Moisture Exchanger

Journal of Speech Language and Hearing Research ◽

10.1044/2020_jslhr-19-00107 ◽

2020 ◽

Vol 63 (9) ◽

pp. 2921-2929

Author(s):

Alan H. Shikani ◽

Elamin M. Elamin ◽

Andrew C. Miller

Keyword(s):

Ex Vivo ◽

Moisture Loss ◽

Speaking Valve ◽

Time Zero ◽

In Series ◽

Turbulent Airflow ◽

The Difference ◽

Loss Efficiency ◽

Heat And Moisture ◽

Lung Simulation

Purpose Tracheostomy patients face many adversities including loss of phonation and essential airway functions including air filtering, warming, and humidification. Heat and moisture exchangers (HMEs) facilitate humidification and filtering of inspired air. The Shikani HME (S-HME) is a novel turbulent airflow HME that may be used in-line with the Shikani Speaking Valve (SSV), allowing for uniquely preserved phonation during humidification. The aims of this study were to (a) compare the airflow resistance ( R airflow ) and humidification efficiency of the S-HME and the Mallinckrodt Tracheolife II tracheostomy HME (M-HME) when dry (time zero) and wet (after 24 hr) and (b) determine if in-line application of the S-HME with a tracheostomy speaking valve significantly increases R airflow over a tracheostomy speaking valve alone (whether SSV or Passy Muir Valve [PMV]). Method A prospective observational ex vivo study was conducted using a pneumotachometer lung simulation unit to measure airflow ( Q ) amplitude and R airflow , as indicated by a pressure drop ( P Drop ) across the device (S-HME, M-HME, SSV + S-HME, and PMV). Additionally, P Drop was studied for the S-HME and M-HME when dry at time zero (T 0 ) and after 24 hr of moisture testing (T 24 ) at Q of 0.5, 1, and 1.5 L/s. Results R airflow was significantly less for the S-HME than M-HME (T 0 and T 24 ). R airflow of the SSV + S-HME in series did not significant increase R airflow over the SSV or PMV alone. Moisture loss efficiency trended toward greater efficiency for the S-HME; however, the difference was not statistically significant. Conclusions The turbulent flow S-HME provides heat and moisture exchange with similar or greater efficacy than the widely used laminar airflow M-HME, but with significantly lower resistance. The S-HME also allows the innovative advantage of in-line use with the SSV, hence allowing concurrent humidification and phonation during application, without having to manipulate either device.

Download Full-text