Mo doped SnO2 quantum dots dispersed over rGO sheets as an efficient anode material

Author(s):  
Yong-Cun Huang ◽  
Sanjaya Brahma ◽  
C-C Chang ◽  
Jow-Lay Huang

Abstract We explore the effect of Mo doping over the large enhancement of electrochemical property of Mo doped SnO2 quantum dots (3-5 nm) grown over rGO (reduced graphene oxide) sheets by a soft chemical process in ambient conditions. The composites were prepared over a range of Mo doping concentrations (0-10%) and 5 % Mo doping had achieved the best energy storage characteristics. The capacity of the active material could reach ~851 mAh g-1 (@ 78mAg−1) in the beginning and that retained ~89 % (~758 mAh g-1) with superior cyclic stability (100 cycles) and rate capability (506 mAh g-1 @ ~1.5 A g-1). Addition of the reductant of 0.06 mol during the synthesis procedure led to further improvement of the capacity to ~875 mAh g−1 (~92 % retention) and the rate capability (~587 mAh g−1). These impressive results are ascribed to the distribution of Mo doped SnO2 QDs, doping of Mo6+ at Sn4+ lattice sites providing more electrons for easy electrical transport, reduction of GO (graphene oxide) to rGO. Mo doping led to the decline in the charge transfer resistance (Rct) from 14.99 Ω for un-doped SnO2/rGO to 14.09 Ω (2.5 %), 11.61 Ω (5 %) and 11.4 Ω (10 %) and promote the electrochemical property of the composite. A simple room temperature synthesis process was used to produce Mo doped SnO2/rGO nanocomposite and that can be employed for the production of many other oxides and their composites for interesting applications.

Author(s):  
Tingjiao Xiao ◽  
Fengjin Yi ◽  
Mingzhi Yang ◽  
Weiliang Liu ◽  
Mei Li ◽  
...  

The “shuttle effect” and sluggish reaction kinetics of lithium polysulfides lead to inferior cycling performance and rate capability of Li-S batteries, which hurdles their practical application. Herein, a composite of...


NANO ◽  
2019 ◽  
Vol 14 (03) ◽  
pp. 1950037 ◽  
Author(s):  
Bingning Wang ◽  
Xuehua Liu ◽  
Binghui Xu ◽  
Yanhui Li ◽  
Dan Xiu ◽  
...  

Three-dimensional reduced graphene oxide (RGO) matrix decorated with nanoflowers of layered MoS2 (denoted as 3D MoS2/RGO) have been synthesized via a facile one-pot stepwise hydrothermal method. Graphene oxide (GO) is used as precursor of RGO and a 3D GO network is formed in the first-step of hydrothermal treatment. At the second stage of hydrothermal treatment, nanoflowers of layered MoS2 form and anchor on the surface of previously formed 3D RGO network. In this preparation, thiourea not only induces the formation of the 3D architecture at a relatively low temperature, but also works as sulfur precursor of MoS2. The synthesized composites have been investigated with XRD, SEM, TEM, Raman spectra, TGA, N2 sorption technique and electrochemical measurements. In comparison with normal MoS2/RGO composites, the 3D MoS2/RGO composite shows improved electrochemical performance as anode material for lithium-ion batteries. A high reversible capacity of 930[Formula: see text]mAh[Formula: see text][Formula: see text][Formula: see text]g[Formula: see text] after 130 cycles under a current density of 200[Formula: see text]mA[Formula: see text][Formula: see text][Formula: see text]g[Formula: see text] as well as good rate capability and superior cyclic stability have been observed. The superior electrochemical performance of the 3D MoS2/RGO composite as anode active material for lithium-ion battery is ascribed to its robust 3D structures, enhanced surface area and the synergistic effect between graphene matrix and the MoS2 nanoflowers subunit.


2014 ◽  
Vol 936 ◽  
pp. 480-485
Author(s):  
Yan Dan Huang ◽  
Ying Bin Lin ◽  
Zhi Gao Huang

LiFePO4/C-Ge electrodes were prepared with vacuum thermal evaporation deposition by depositing Ge films on as-prepared LiFePO4/C electrodes. The effect of Ge film on the electrochemical performances of LiFePO4/C cells was investigated systematically by charge/discharge testing, cyclic voltammograms and AC impedance spectroscopy, respectively. It was found that Ge-film-surface modified LiFePO4/C showed excellent electrochemical performances compared to that of the pristine one in terms of cyclability and rate capability. At 60°C, LiFePO4/C-Ge film exhibited outstanding cyclability with less than 5% capacity fade after 50 cycles while the pristine one suffers 15%. Analysis from the electrochemical measurements showed that the presence of Ge film on the LiFePO4/C electrode would protect active material from HF generated by the decomposition of LiPF6 in the electrolyte and stabilize the surface structure of active material during the charge and discharge cycle. Electrochemical impedance spectroscopy (EIS) results indicated that Ge film mainly reduced the charge transfer resistance Rct of LiFePO4/C electrode, resulting from the suppression of the solid electrolyte interfacial (SEI) film.


2019 ◽  
Vol 2019 ◽  
pp. 1-10
Author(s):  
Yuxin Ma ◽  
Ping Cui ◽  
Dan Zhan ◽  
Bing Gan ◽  
Youliang Ma ◽  
...  

The graphene oxide-coated SnO2-Li1/3Co1/3Mn1/3O2 (GO-SnO2-NCM) cathode material was successfully synthesized via a facile wet chemical method. The pristine NCM and GO-SnO2-NCM were characterized by X-ray diffraction, scanning electron microscopy, energy-dispersive spectroscopy, transmission electron microscopy, and X-ray photoelectron spectroscopy. The results showed that the double-coating layer did not destroy the NCM crystal structure, with multiple nano-SnO2 particles and GO uniformly covering the NCM surface. Electrochemical tests indicated that GO-SnO2-NCM exhibited excellent cycling performance, with 90.7% capacity retention at 1 C after 100 cycles, which was higher than 74.3% for the pristine NCM at the same cycle. The rate capability showed that the double-coating layer enhanced surface electronic–ionic transport. Electrochemical impedance spectroscopy results confirmed that the GO-SnO2-coating layer effectively suppressed the increased electrode polarization and charge transfer resistance during cycling.


Nanomaterials ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 3448
Author(s):  
Alexandra Meyer ◽  
Fabian Ball ◽  
Wilhelm Pfleging

To increase the specific capacity of anodes for lithium-ion cells, advanced active materials, such as silicon, can be utilized. Silicon has an order of magnitude higher specific capacity compared to the state-of-the-art anode material graphite; therefore, it is a promising candidate to achieve this target. In this study, different types of silicon nanopowders were introduced as active material for the manufacturing of composite silicon/graphite electrodes. The materials were selected from different suppliers providing different grades of purity and different grain sizes. The slurry preparation, including binder, additives, and active material, was established using a ball milling device and coating was performed via tape casting on a thin copper current collector foil. Composite electrodes with an areal capacity of approximately 1.70 mAh/cm² were deposited. Reference electrodes without silicon were prepared in the same manner, and they showed slightly lower areal capacities. High repetition rate, ultrafast laser ablation was applied to these high-power electrodes in order to introduce line structures with a periodicity of 200 µm. The electrochemical performance of the anodes was evaluated as rate capability and operational lifetime measurements including pouch cells with NMC 622 as counter electrodes. For the silicon/graphite composite electrodes with the best performance, up to 200 full cycles at a C-rate of 1C were achieved until end of life was reached at 80% relative capacity. Additionally, electrochemical impedance spectroscopies were conducted as a function of state of health to correlate the used silicon grade with solid electrolyte interface (SEI) formation and charge transfer resistance values.


Nanomaterials ◽  
2019 ◽  
Vol 9 (3) ◽  
pp. 469 ◽  
Author(s):  
Yi Huang ◽  
Yu Jiang ◽  
Zhaofei Ma ◽  
Yan Zhang ◽  
Xianfeng Zheng ◽  
...  

WS2 is considered as a potential anode material for lithium ion batteries (LIBs) with superior theoretical capacity and stable structure with two-dimensional which facilitates to the transportation and storage of lithium ion. Nevertheless, the commercial recognition of WS2 has been impeded by the intrinsic properties of WS2, including poor electrical conductivity and large volume expansion. Herein, a seaweed-liked WS2/reduced graphene oxide (rGO) composites has been fabricated through a procedure involving the self-assembling of WO42−, hexadecyl trimethyl ammonium ion with graphene oxide (GO) and the subsequent thermal treatment. The WS2/rGO nanocomposite exhibited the outstanding electrochemical property with a stable and remarkable capacity (507.7 mAh·g−1) at 1.0 A·g−1 even after 1000 cycles. This advanced electrochemical property is due to its seaweed-liked feature which can bring in plentiful active sites, ameliorate the stresses arisen from volume variations and increase charge transfer rate.


2021 ◽  
Author(s):  
Xu Dan ◽  
Ruiyi Li ◽  
Qinsheng Wang ◽  
Yongqiang Yang ◽  
Haiyan Zhu ◽  
...  

The paper reports the synthesis of nickel-silver-graphene quantum dot-graphene hybrid. Histidine-functionalized graphene quantum dots (His-GQDs) were bonded to graphene oxide (GO) and then combined with Ni2+ and Ag+ to form...


2021 ◽  
Vol 73 ◽  
pp. 105519
Author(s):  
Yuxin Yan ◽  
Sivakumar Manickam ◽  
Edward Lester ◽  
Tao Wu ◽  
Cheng Heng Pang

Sign in / Sign up

Export Citation Format

Share Document