Deformation of Erythrocyte in Couette Type of Pulsatile Shear Field

Author(s):  
Shigehiro Hashimoto

Abstract The experimental methodology has been designed for evaluation of the cyclic deformation of an erythrocyte in the pulsatile shear field in vitro. To observe the deformation of the suspended erythrocytes in the Couette type of the shear flow, a rheoscope system has been manufactured. The system consists of a pair of counter-rotating parallel disks and an inverted phase-contrast microscope. The human erythrocytes were suspended in the dextran aqueous solution of high viscosity. The rotating speed varies sinusoidally to make the pulsatile shear field. The deformation of each erythrocyte was measured at the video image of the rheoscope. The experimental results show that the system is available to measure the following behavior of an erythrocyte. The ellipsoidal shape of each erythrocyte varies cyclically to follow the pulsatile cyclic shear field. The delay of deformation phase of each erythrocyte in the cycle is related to the frequency of the cyclic variation of the shear field. The delay is also related to deformability of the erythrocyte.

Author(s):  
R Doeker ◽  
M Gutberlet ◽  
GP Meyer ◽  
R Noeske ◽  
R Felix ◽  
...  
Keyword(s):  

Lab on a Chip ◽  
2021 ◽  
Author(s):  
YUHAO QIANG ◽  
Jia Liu ◽  
Ming Dao ◽  
E Du

Red blood cells (RBCs) are subjected to recurrent changes in shear stress and oxygen tension during blood circulation. The cyclic shear stress has been identified as an important factor that...


2021 ◽  
Vol 18 (1) ◽  
Author(s):  
Gwendolyn Williams ◽  
Suraj Thyagaraj ◽  
Audrey Fu ◽  
John Oshinski ◽  
Daniel Giese ◽  
...  

Abstract Background Phase contrast magnetic resonance imaging, PC MRI, is a valuable tool allowing for non-invasive quantification of CSF dynamics, but has lacked adoption in clinical practice for Chiari malformation diagnostics. To improve these diagnostic practices, a better understanding of PC MRI based measurement agreement, repeatability, and reproducibility of CSF dynamics is needed. Methods An anatomically realistic in vitro subject specific model of a Chiari malformation patient was scanned three times at five different scanning centers using 2D PC MRI and 4D Flow techniques to quantify intra-scanner repeatability, inter-scanner reproducibility, and agreement between imaging modalities. Peak systolic CSF velocities were measured at nine axial planes using 2D PC MRI, which were then compared to 4D Flow peak systolic velocity measurements extracted at those exact axial positions along the model. Results Comparison of measurement results showed good overall agreement of CSF velocity detection between 2D PC MRI and 4D Flow (p = 0.86), fair intra-scanner repeatability (confidence intervals ± 1.5 cm/s), and poor inter-scanner reproducibility. On average, 4D Flow measurements had a larger variability than 2D PC MRI measurements (standard deviations 1.83 and 1.04 cm/s, respectively). Conclusion Agreement, repeatability, and reproducibility of 2D PC MRI and 4D Flow detection of peak CSF velocities was quantified using a patient-specific in vitro model of Chiari malformation. In combination, the greatest factor leading to measurement inconsistency was determined to be a lack of reproducibility between different MRI centers. Overall, these findings may help lead to better understanding for application of 2D PC MRI and 4D Flow techniques as diagnostic tools for CSF dynamics quantification in Chiari malformation and related diseases.


2017 ◽  
Vol 8 ◽  
pp. 1649-1657 ◽  
Author(s):  
Antonín Brož ◽  
Lucie Bačáková ◽  
Pavla Štenclová ◽  
Alexander Kromka ◽  
Štěpán Potocký

Diamond nanoparticles, known as nanodiamonds (NDs), possess several medically significant properties. Having a tailorable and easily accessible surface gives them great potential for use in sensing and imaging applications and as a component of cell growth scaffolds. In this work we investigate in vitro interactions of human osteoblast-like SAOS-2 cells with four different groups of NDs, namely high-pressure high-temperature (HPHT) NDs (diameter 18–210 nm, oxygen-terminated), photoluminescent HPHT NDs (diameter 40 nm, oxygen-terminated), detonation NDs (diameter 5 nm, H-terminated), and the same detonation NDs further oxidized by annealing at 450 °C. The influence of the NDs on cell viability and cell count was measured by the mitochondrial metabolic activity test and by counting cells with stained nuclei. The interaction of NDs with cells was monitored by phase contrast live-cell imaging in real time. For both types of oxygen-terminated HPHT NDs, the cell viability and the cell number remained almost the same for concentrations up to 100 µg/mL within the whole range of ND diameters tested. The uptake of hydrogen-terminated detonation NDs caused the viability and the cell number to decrease by 80–85%. The oxidation of the NDs hindered the decrease, but on day 7, a further decrease was observed. While the O-terminated NDs showed mechanical obstruction of cells by agglomerates preventing cell adhesion, migration and division, the H-terminated detonation NDs exhibited rapid penetration into the cells from the beginning of the cultivation period, and also rapid cell congestion and a rapid reduction in viability. These findings are discussed with reference to relevant properties of NDs such as surface chemical bonds, zeta potential and nanoparticle types.


1990 ◽  
Vol 76 (6) ◽  
pp. 923 ◽  
Author(s):  
Pascal Millet ◽  
William E. Collins ◽  
Claude E. Monken ◽  
Bobby G. Brown

2004 ◽  
Vol 16 (2) ◽  
pp. 226 ◽  
Author(s):  
F. Martinez-Pastor ◽  
F. Olivier ◽  
T. Spies ◽  
L. Anel ◽  
P. Bartels

Biological Resource Banks represent a potentially valuable tool for species conservation. It is, however, necessary to understand the species-specific cryopreservation process and its consequences for spermatozoa to aid in the development of assisted reproduction as a future conservation tool. The aim of this study was to assess the in vitro functionality of white rhinoceros Cerathoterium simum epididymal spermatozoa both before and after cryopreservation. Testes from a harvested white rhino bull were removed and transported at 5°C to the laboratory within 4h. The cauda epididymis was dissected out and flushed with 2mL of Tris-citrate egg yolk extender (fraction A, Biladyl, Minitüb, Germany). A 0.1mL aliquot was removed for analysis and the balance (9mL; 2mL fraction A+7mL sperm sample) mixed with an additional 27.2mL of Tris-citrate egg yolk with glycerol (fraction B, Bidadyl). The extended sample was allowed to cool to 4°C over a 6-h period before an additional 29.2mL of cooled fraction B were added (final sperm concentration=150×106mL−1). Sperm samples were loaded into 0.25-mL straws and frozen over LN2 vapor (4cm for 20min) for later assessment. Sperm straws were thawed by placing the straws in water at 37°C for 30s. Pre-freeze and post-thaw evaluations were carried out in the same manner. Media used included: HEPES for washing (20mM HEPES, 355mM sucrose, 10mM glucose, 2.5mM KOH) and HEPES saline (197mM NaCl, instead of sucrose). An aliquot was diluted with HEPES (washing) and centrifuged for 5min at 600×g; the pellet was resuspended in HEPES saline. Sperm motility (total motility %, TM;; and progressive motility %, PM) was assessed using phase contrast microscopy (×200; 37°C). Sperm plasma membrane status was assessed using the fluorescent dye, propidium iodide (50ngmL−1 in HEPES saline;; 10min, RT). Percentage of cells with plasma membranes intact (unstained;; PMI) was recorded. Mitochondrial status was assessed with the fluorescent dye, JC-1 (7.5μM in HEPES saline;; 30min, 37°C). The % of cells with an orange-stained midpiece was recorded (active mitochondria;; MIT). Resilience to hypoosmotic shock (HOS test) was assessed by diluting a sample in 100mOsm/kg HEPES saline (1:20; 15min, RT). An aliquot was stained with PI to assess plasma membrane status (HOSPMI), and the rest was fixed with formaldehyde, and % coiled tails (positive endosmosis;; HOST) was estimated using phase contrast microscopy (×400). Evaluations of PMI, MIT and HOSPMI were performed using fluorescence microscopy (×400, 450–490nm excitation filter). The results indicated that quality was good pre-freezing (TM: 60%; PMI: 86%; MIT: 100%), except for a PM value of 15%. After thawing, although there was a drop in TM (30%), there was no decrease in PM (20%). Our in vitro functional assessment indicated a loss of quality between the pre-freeze and post-thaw evaluations, but PMI and MIT maintained their pre-thaw levels (60% and 72%, respectively). The HOS test, which indicates plasma membrane integrity, decreased from the pre-freeze level (91%) to a post-thaw value of 70%. HOSTPMI was 72% pre-freeze, and decreased to 54% post-thaw. In conclusion, epididymal spermatozoa from the white rhino may retain its functionality after cryopreservation in a commerically available cryo-extender (Bidadyl). The use of assisted reproduction techniques could someday play a role in the management and conservation of the white rhinoceros and related species.


2021 ◽  
Author(s):  
Shigehiro Hashimoto ◽  
Hiroki Yonezawa

Abstract A cell deforms and migrates on the scaffold under mechanical stimuli in vivo. In this study, a cell with division during shear stress stimulation has been observed in vitro. Before and after division, both migration and deformation of each cell were analyzed. To make a Couette-type shear flow, the medium was sandwiched between parallel disks (the lower stationary culture-disc and the upper rotating disk) with a constant gap. The wall shear stress (1.5 Pa < τ < 2 Pa) on the surface of the lower culture plate was controlled by the rotational speed of the upper disc. Myoblasts (C2C12: mouse myoblast cell line) were used in the test. After cultivation without flow for 24 hours for adhesion of the cells to the lower disk, constant τ was applied to the cells in the incubator for 7 days. The behavior of each cell during shear was tracked by time-lapse images observed by an inverted phase contrast microscope placed in the incubator. Experimental results show that each cell tends to divide after higher activities: deformation and migration. The tendency is remarkable at the shear stress of 1.5 Pa.


1970 ◽  
Vol 8 (1) ◽  
pp. 31-38 ◽  
Author(s):  
Mohammad Nezab Uddin ◽  
Ishtiaq Ahmed ◽  
Monzurul Amin Roni ◽  
Muhammad Rashedul Islam ◽  
Mohammad Habibur Rahman ◽  
...  

The objective of this study was to design oral sustained release matrix tablets of Ranolazine usinghydroxypropyl methylcellulose (HPMC) as the retardant polymer and to study the effect of formulation factors suchas polymer proportion and polymer viscosity on the release of drug. In vitro release studies were performed usingUSP type II apparatus (paddle method) in 900 mL of 0.1N HCl at 100 rpm for 12 hours. The release kinetics wasanalyzed using the zero-order, first order, Higuchi and Korsmeyer-Peppas equations to explore and explain themechanism of drug release from the matrix tablets. In vitro release studies revealed that the release rate decreasedwith increase in polymer proportion and viscosity grade. Mathematical analysis of the release kinetics indicated thatthe nature of drug release from the matrix tablets was dependent on drug diffusion and polymer relaxation andtherefore followed non-Fickian or anomalous release. The developed controlled release matrix tablets of Ranolazineprepared with high viscosity HPMC extended release up to 12 hours.Key words: Ranolazine; Sustained release; Methocel E50 Premium LV; Methocel K100LV CR; Methocel K4M CR;Methocel K15M CR.DOI: 10.3329/dujps.v8i1.5333Dhaka Univ. J. Pharm. Sci. 8(1): 31-38, 2009 (June)


2018 ◽  
Vol 10 (5) ◽  
pp. 76
Author(s):  
Methaq Hamad Sabar ◽  
Iman Sabah Jaafar ◽  
Masar Basim Mohsin Mohamed

Objective: The aim of this study was to formulate ketoconazole (keto) as oral floating in situ gel to slow the release of keto in the stomach.Methods: Sodium alginate (Na alginate) was used as a primary polymer in the preparation of the in situ gel and was supported by the following polymers: guar gum (GG), hydroxypropyl methylcellulose (HPMC) K4M, K15M and carbapol 940 as viscosity enhancing agents. As a consequence, and to complete the gelation process of above formulations was by adding the calcium carbonate (CaCO3). The in situ gels were investigated by the following tests: floating lag time, floating duration, viscosity, drug content, in vitro gelling studies and in vitro release study.Results: The study showed that the faster release was obtained with F1 which contained Na alginate alone. Additionally, reduction in Na alginate concentration resulted in significant increase in drug release. It was also noted that the increase in GG (viscosity enhancing polymer) concentration resulted in non-significant decrease in percent drug release and the reduction in CaCO3 concentration led to significant increase in drug release. Moreover, the release of drug was also affected by grade of viscosity enhancing polymer, the faster release was observed with the formula which contained a polymer of low viscosity (HPMC K4M) and an opposite result was with the high viscosity polymer (HPMCK15M).Conclusion: This study showed the formulation of Na alginate with GG and CaCO3, led to gain floating in situ gel and a sustained release of keto. 


Sign in / Sign up

Export Citation Format

Share Document