LOW TEMPERATURE THERMOELECTRIC PROPERTIES AND AGING PHENOMENA OF NANOSTRUCTURED p-TYPE Bi2-XSbXTe3 (x = 1.46, 1.48, 1.52 AND 1.55)

2013 ◽  
Vol 06 (05) ◽  
pp. 1340008 ◽  
Author(s):  
DALE HITCHCOCK ◽  
YEN-LIANG LIU ◽  
YUFEI LIU ◽  
TERRY M. TRITT ◽  
JIAN HE ◽  
...  

Over the past decade the widely used p-type ( Bi 2-x Sb x) Te 3 bulk thermoelectric materials have been subject to various nanostructuring processes for higher thermoelectric performance. However, these nanostructuring processing were conducted on compositions optimized for bulk materials (x ~ 1.52–1.55). This leads to the question of whether the optimal composition for bulk materials is the same for their nanoscale counterparts. In this work we hydrothermally grew Bi 2-x Sb x Te 3 nanopowders (nominally, x = 1.46, 1.48, 1.52 and 1.55) and measured their thermoelectric properties on cold-pressed vacuum-sintered pellets (74–78% of the theoretical density) below 300 K. The measurements were conducted 18 months apart to probe the aging phenomena, with the samples stored in ambient conditions. We have found that (i) the peak of thermopower shifts to lower temperatures upon nanostructuring but it shifts back to higher temperatures upon aging; (ii) the electrical conductivity degrades by a factor of 1.5–2.3 upon aging while the temperature dependence is largely retained; and (iii) the ZT of freshly made samples is sensitive to the x value, a maximum ZT ~ 1.25(~ 0.62) at ~ 270 K (~ 255 K) was attained in the freshly made sample x = 1.55(x = 1.46), respectively; while the ZT of aged samples is significantly lowered by a factor of 2–4 but lesser x-dependent. These observations have been discussed in the context of charge buildup and compensation at grain boundaries.

Materials ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 3448
Author(s):  
Francisco Arturo López Cota ◽  
José Alonso Díaz-Guillén ◽  
Oscar Juan Dura ◽  
Marco Antonio López de la Torre ◽  
Joelis Rodríguez-Hernández ◽  
...  

This contribution deals with the mechanochemical synthesis, characterization, and thermoelectric properties of tetrahedrite-based materials, Cu12-xMxSb4S13 (M = Fe2+, Zn2+, Cd2+; x = 0, 1.5, 2). High-energy mechanical milling allows obtaining pristine and substituted tetrahedrites, after short milling under ambient conditions, of stoichiometric mixtures of the corresponding commercially available binary sulfides, i.e., Cu2S, CuS, Sb2S3, and MS (M = Fe2+, Zn2+, Cd2+). All the target materials but those containing Cd were obtained as single-phase products; some admixture of a hydrated cadmium sulfate was also identified by XRD as a by-product when synthesizing Cu10Cd2Sb4S13. The as-obtained products were thermally stable when firing in argon up to a temperature of 350–400 °C. Overall, the substitution of Cu(II) by Fe(II), Zn(II), or Cd(II) reduces tetrahedrites’ thermal and electrical conductivities but increases the Seebeck coefficient. Unfortunately, the values of the thermoelectric figure of merit obtained in this study are in general lower than those found in the literature for similar samples obtained by other powder processing methods; slight compositional changes, undetected secondary phases, and/or deficient sintering might account for some of these discrepancies.


2003 ◽  
Vol 18 (7) ◽  
pp. 1646-1651 ◽  
Author(s):  
Ryoji Funahashi ◽  
Saori Urata ◽  
Toyohide Sano ◽  
Masaaki Kitawaki

Having recently succeeded in synthesizing large single crystals of (Ca2CoO3)CoO2 (Co-349) with superior thermoelectric properties using a modified flux method, we have prepared a composite material of Co-349 powder and single crystals and examined its thermoelectric properties. The electrical conductivity σ of this composite, which contained 20 wt.% single crystals, was higher than that of a sample without the single crystals. While the achievable effect has yet to be fully realized, improved grain alignment and the effect of current bypassing grain boundaries through the large single crystals in the composite are thought to cause the increasing σ, which consequently results in an enhanced thermoelectric figure of merit of about 0.56 at 973 K in air.


2005 ◽  
Vol 486-487 ◽  
pp. 602-605 ◽  
Author(s):  
J.B. Park ◽  
S.-W. You ◽  
K.W. Cho ◽  
J.I. Lee ◽  
Soon Chul Ur ◽  
...  

Induction melting was attempted to prepare the undoped and Nb-doped CoSb3 compounds, and their thermoelectric properties were investigated. Single phase d-CoSb3 was successfully obtained by induction melting and subsequent annealing at 400°C for 2 hours in vacuum. The positive signs of Seebeck coefficients for all the specimens revealed that Nb atoms acted as p-type dopants by substituting Co atoms. Electrical conductivity decreased and then increased withincreasing temperature, indicating mixed behaviors of metallic and semiconducting conductions. Electrical conductivity increased by Nb doping, and it was saturated at high temperature. Maximum value of the thermoelectric power factor was shifted to higher temperature with the increasing amount of Nb doping, mainly originated from the Seebeck coefficient variation.


Author(s):  
А.И. Таранова ◽  
А.П. Новицкий ◽  
А.И. Воронин ◽  
С.В. Таскаев ◽  
В.В. Ховайло

In this work the results of an experimental study of Fe2Ti1-xVxSn alloys (x = 0; 0.06; 0.15; 0.2) are presented. According to the temperature dependencies of the electrical conductivity, Seebeck coefficient and thermal conductivity, it is established, that the studied compositions exhibit transport properties typical for semiconductors. The substitution of V at the Ti site leads to a change of the p-type electrical conductivity behavior to n-type; the pristine sample of Fe2TiSn has the best thermoelectric properties.


2013 ◽  
Vol 68 (8) ◽  
pp. 643-646 ◽  
Author(s):  
Jian Yu ◽  
Wenyu Zhao ◽  
Hongyu Zhou ◽  
Ping Wei ◽  
Qingjie Zhang

2003 ◽  
Vol 793 ◽  
Author(s):  
Masatoshi Takeda ◽  
Yosuke Kurita ◽  
Keisuke Yokoyama ◽  
Takahiro Miura ◽  
Tsuneo Suzuki ◽  
...  

ABSTRACTPolycrystalline alkaline-earth hexaborides (MB6: M =Ca, Sr, Ba) were synthesized and their thermoelectric and transport properties were examined to discuss their possibility as high temperature thermoelectric materials. Hall measurements showed that carrier concentration of the BaB6 was the highest among the three hexaborides and that of CaB6 was the lowest. Substitution of part of the alkaline earth metals with one of the others changed the carrier concentration of the hexaboride. As the carrier concentration increased, Seebeck coefficient increased and electrical conductivity decreased. These results suggest that the thermoelectric properties of the divalent hexaborides depend largely on the carrier concentration, and optimum carrier concentration which gives maximum power factor was estimated to be approximately 2x1026 m−3. Consequently, such a substitution enables us to control Seebeck coefficient and electrical conductivity of the hexaborides, and will also be effective to reduce the lattice heat conduction due to the alloying effect. A thermoelectric device was fabricated using SrB6 and boron carbide thin films as n-type and p-type elements, respectively. To the best of our knowledge, this is the first demonstration of a thermoelectric device composed of only boron-rich solids.


2013 ◽  
Vol 06 (05) ◽  
pp. 1340006 ◽  
Author(s):  
JINGSHU XU ◽  
CHENGUANG FU ◽  
JIAN XIE ◽  
XINBING ZHAO ◽  
TIEJUN ZHU

The p-type skutterudite compounds of ( Pr 0.25 Nd 0.75)x Fe 3 CoSb 12 (x = 0.67–0.78) have been successfully synthesized by levitation melting followed by annealing and spark plasma sintering. The thermoelectric properties have been characterized by the measurements of Seebeck coefficient, electrical conductivity and thermal conductivity in the temperature range from 300 K to 850 K. The improvement in the thermoelectric properties was realized due to the reduction in the lattice thermal conductivity when the voids were partially filled by Pr 0.25 Nd 0.75. The maximum ZT value of ~ 0.83 for ( Pr 0.25 Nd 0.75)0.76 Fe 3 CoSb 12 was obtained at 700 K.


2005 ◽  
Vol 486-487 ◽  
pp. 554-557
Author(s):  
J.B. Park ◽  
S.-W. You ◽  
K.W. Cho ◽  
J.I. Lee ◽  
Soon Chul Ur ◽  
...  

Induction melting was attempted to prepare the undoped and Nb-doped CoSb3 compounds, and their thermoelectric properties were investigated. Single phase d-CoSb3 was successfully obtained by induction melting and subsequent annealing at 400°C for 2 hours in vacuum. The positive signs of Seebeck coefficients for all the specimens revealed that Nb atoms acted as p-type dopants by substituting Co atoms. Electrical conductivity decreased and then increased with increasing temperature, indicating mixed behaviors of metallic and semiconducting conductions. Electrical conductivity increased by Nb doping, and it was saturated at high temperature. Maximum value of the thermoelectric power factor was shifted to higher temperature with the increasing amount of Nb doping, mainly originated from the Seebeck coefficient variation.


2021 ◽  
Author(s):  
Srikanth Mandava ◽  
Neeta Bisht ◽  
Anjali Saini ◽  
Mukesh Kumar Bairwa ◽  
Khasimsaheb Bayikadi ◽  
...  

Abstract A novel SnSe nanoake system is explored for its thermoelectric properties from both experiments and ab initio study. The nanoakes of the low temperature phase of SnSe (Pnma) are synthesized employing a fast and efficient refluxing method followed by spark plasma sintering at two different temperatures. We report an enhanced power factor (12 W/mK2 - 67 W/mK2 in the temperature range 300 K-600 K) in our p-type samples. We find that the prime reason for a high PF in our samples is a significantly improved electrical conductivity (1050 S/m - 2180 S/m in the temperature range 300 K-600 K). From our ab initio band structure calculations accompanied with the models of temperature and surface dependent carrier scattering mechanisms, we reveal that an enhanced electrical conductivity is due to the reduced carrier-phonon scattering in our samples. The trans- port calculations are performed using the Boltzmann transport equation within relaxation time approximation. With our combined experimental and theoretical study, we demonstrate that the thermoelectric properties of p-type Pnma-SnSe could be improved by tuning the carrier scattering mechanisms with a control over the spark plasma sintering temperature.


2017 ◽  
Vol 699 ◽  
pp. 718-721 ◽  
Author(s):  
Mengliang Yao ◽  
Weishu Liu ◽  
Xiang Chen ◽  
Zhensong Ren ◽  
Stephen Wilson ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document