Aqueous Electrodeposition and Mechanism of Iron Group-Vanadium Ternary Alloys

2019 ◽  
Vol 33 (34) ◽  
pp. 19-31 ◽  
Author(s):  
M. Schwartz ◽  
B. Y. Yoo ◽  
Ken Nobe
Keyword(s):  
Ternary Alloys ◽  
Iron Group ◽  
Aqueous Electrodeposition

Phase equilibria in ternary alloys based on iron-group metals and containing refractory metals (Mo, W, Nb, Ta)

1988 ◽  
Vol 144 (1) ◽  
pp. 41-52 ◽  
Author(s):  
N. Asrar ◽  
L.L. Meshkov ◽  
E.M. Sokolovskaya
Keyword(s):  
Phase Equilibria ◽  
Refractory Metals ◽  
Ternary Alloys ◽  
Iron Group

Aqueous electrodeposition of iron group–vanadium binary alloys

2005 ◽  
Vol 50 (22) ◽  
pp. 4335-4343
Author(s):  
B.Y. Yoo ◽  
M. Schwartz ◽  
K. Nobe
Keyword(s):  
Binary Alloys ◽  
Iron Group ◽  
Aqueous Electrodeposition

Diffraction from arrays of antiphase boundaries in ordered III-V alloys

1987 ◽  
Vol 45 ◽  
pp. 312-313
Author(s):  
T. S. Kuan
Keyword(s):  
High Surface ◽  
Growth Conditions ◽  
Ternary Alloys ◽  
Local Growth ◽  
Antiphase Boundaries ◽  
Surface Mobility ◽  
Ordered Phases ◽  
Diffraction Patterns ◽  
Atomically Flat ◽  
Degree Of Order

Recent electron diffraction studies have found ordered phases in AlxGa1-xAs, GaAsxSb1-x, and InxGa1-xAs alloy systems, and these ordered phases are likely to be found in many other III-V ternary alloys as well. The presence of ordered phases in these alloys was detected in the diffraction patterns through the appearance of superstructure reflections between the Bragg peaks (Fig. 1). The ordered phase observed in the AlxGa1-xAs and InxGa1-xAs systems is of the CuAu-I type, whereas in GaAsxSb1-x this phase and a chalcopyrite type ordered phase can be present simultaneously. The degree of order in these alloys is strongly dependent on the growth conditions, and during the growth of these alloys, high surface mobility of the depositing species is essential for the onset of ordering. Thus, the growth on atomically flat (110) surfaces usually produces much stronger ordering than the growth on (100) surfaces. The degree of order is also affected by the presence of antiphase boundaries (APBs) in the ordered phase. As shown in Fig. 2(a), a perfectly ordered In0.5Ga0.5As structure grown along the <110> direction consists of alternating InAs and GaAs monolayers, but due to local growth fluctuations, two types of APBs can occur: one involves two consecutive InAs monolayers and the other involves two consecutive GaAs monolayers.

In situ TEM observations of melting in nanosized eutectic Pb-Cd inclusions embedded in Al

1996 ◽  
Vol 54 ◽  
pp. 986-987
Author(s):  
S. Hagège ◽  
U. Dahmen ◽  
E. Johnson ◽  
A. Johansen ◽  
V.S. Tuboltsev
Keyword(s):  
Electron Microscope ◽  
Melt Spinning ◽  
Ternary Alloys ◽  
Solid Matrix ◽  
Eutectic System ◽  
In Situ Tem ◽  
In Situ Observation ◽  
Orientation Relationships ◽  
Transmission Electron

Small particles of a low-melting phase embedded in a solid matrix with a higher melting point offer the possibility of studying the mechanisms of melting and solidification directly by in-situ observation in a transmission electron microscope. Previous studies of Pb, Cd and other low-melting inclusions embedded in an Al matrix have shown well-defined orientation relationships, strongly faceted shapes, and an unusual size-dependent superheating before melting.[e.g. 1,2].In the present study we have examined the shapes and thermal behavior of eutectic Pb-Cd inclusions in Al. Pb and Cd form a simple eutectic system with each other, but both elements are insoluble in solid Al. Ternary alloys of Al (Pb,Cd) were prepared from high purity elements by melt spinning or by sequential ion implantation of the two alloying additions to achieve a total alloying addition of up to lat%. TEM observations were made using a heating stage in a 200kV electron microscope equipped with a video system for recording dynamic behavior.

Electron microscope studies of the plastic deformation of ternary alloys based on GaAs

1990 ◽  
Vol 48 (4) ◽  
pp. 1120-1120
Author(s):  
R. Haswell ◽  
U. Bangert ◽  
P. Charsley
Keyword(s):  
Plastic Deformation ◽  
Electron Microscope ◽  
Room Temperature ◽  
Stacking Faults ◽  
The Other ◽  
Ternary Alloys ◽  
Dislocation Mobility ◽  
Semiconducting Materials ◽  
Micro Indentation

A knowledge of the behaviour of dislocations in semiconducting materials is essential to the understanding of devices which use them . This work is concerned with dislocations in alloys related to the semiconductor GaAs . Previous work on GaAs has shown that microtwinning occurs on one of the <110> rosette arms after indentation in preference to the other . We have shown that the effect of replacing some of the Ga atoms by Al results in microtwinning in both of the rosette arms.In the work to be reported dislocations in specimens of different compositions of Gax Al(1-x) As and Gax In(1-x) As have been studied by using micro indentation on a (001) face at room temperature . A range of electron microscope techniques have been used to investigate the type of dislocations and stacking faults/microtwins in the rosette arms , which are parallel to the [110] and [10] , as a function of composition for both alloys . Under certain conditions microtwinning occurs in both directions . This will be discussed in terms of the dislocation mobility.

Electrodeposition of Strained-Layer Superlattices

1996 ◽  
Vol 451 ◽  
Author(s):  
T. P. Moffat
Keyword(s):  
Charge Transfer ◽  
Mass Transport ◽  
Structural Evolution ◽  
Iron Group ◽  
Morphological Instability ◽  
Group Metal ◽  
Iron Group Metal ◽  
Transport Control ◽  
Strained Layer Superlattices ◽  
Interfacial Charge

ABSTRACTA variety of Cu/(Ni, Co) multilayers have been grown on Cu single crystals by pulse plating from an alloy electroplating bath. Copper is deposited under mass transport control while the iron group metal is deposited under interfacial charge transfer control. The structural evolution of these films is influenced by the morphological instability of the mass transport limited copper deposition reaction and the development of growth twins during iron-group metal deposition. Specular films have been obtained for growth on Cu(100) while rough, defective films were typically obtained for growth on Cu(111) and Cu(110).

scholarly journals Preemptive intravenous iron therapy versus autologous whole blood therapy for early postoperative hemoglobin level in patients undergoing bimaxillary orthognathic surgery: a prospective randomized noninferiority trial

2021 ◽  
Vol 21 (1) ◽  
Author(s):  
Min Suk Chae ◽  
Mihyun Lee ◽  
Min Ho Choi ◽  
Je Uk Park ◽  
Misun Park ◽  
...  
Keyword(s):  
Blood Transfusion ◽  
Blood Group ◽  
Whole Blood ◽  
Orthognathic Surgery ◽  
Hemoglobin Level ◽  
Iron Therapy ◽  
Iron Group ◽  
Autologous Whole Blood ◽  
Bimaxillary Orthognathic Surgery ◽  
Iv Iron

Abstract Background Previous studies have reported the efficacy and safety of intravenous (IV) iron therapy during the perioperative period as an alternative and adjunct to allogeneic blood transfusion. Preemptive IV iron therapy provides noninferior hemoglobin levels on postoperative day (POD) 1 compared to autologous whole blood therapy (AWBT) in healthy patients who had undergone bimaxillary orthognathic surgery. Methods This was a prospective, patient-randomized, noninferiority trial. After excluding 2 patients, 64 patients were divided into two groups: the IV iron therapy group (patients received IV iron infusion 4 weeks before surgery; n = 32) and the AWBT group (2 units of autologous whole blood were collected 4 and 2 weeks before surgery; n = 32). The primary outcome was hemoglobin level on POD 1 and the prespecified noninferiority limit was − 1 g/dL. Results Baseline data were comparable, including hemoglobin and iron levels, between the two groups. Immediately before surgery, the levels of hemoglobin, iron, and ferritin were higher in the IV iron group than in the AWBT group. The mean treatment difference (iron group—whole blood group) in hemoglobin level on POD 1 between the two groups was 0.09 (95% CI = − 0.83 to 1.0). As the lower limit of the 95% CI (− 0.83) was higher than the prespecified noninferiority margin (δ = − 1), noninferiority was established. On POD 2, the hemoglobin level became lower in the iron group, which eventually led to greater requirement of allogeneic blood transfusion compared to the whole blood group. However, the iron group did not require allogeneic blood transfusion during or early after surgery, and the whole blood group showed continuously higher incidence of overt iron deficiency compared to the iron group. Conclusion As collection of autologous whole blood caused overt iron loss and anemia before surgery and intraoperative transfusion of whole blood was not able to prevent the occurrence of persistent iron deficiency after surgery, IV iron therapy was found to have potential benefits for iron homeostasis and subsequent erythropoiesis in healthy patients early after bimaxillary orthognathic surgery. Trial registration: Clinical Research Information Service, Republic of Korea, approval number: KCT0003680 on March 27, 2019. https://cris.nih.go.kr/cris/search/search_result_st01_kren.jsp?seq=15769&sLeft=2&ltype=my&rtype=my.

scholarly journals Short and Medium-Range Order in Liquid Ternary Al80Co10Ni10, Al72.5Co14.5Ni13, and Al65Co17.5Ni17.5 Alloys

2010 ◽  
Vol 65 (1-2) ◽  
pp. 123-131 ◽  
Author(s):  
Oleksandr S. Roik ◽  
Oleksiy Samsonnikov ◽  
Volodymyr Kazimirov ◽  
Volodymyr Sokolskii
Keyword(s):  
Three Dimensional ◽  
Range Order ◽  
Ternary Alloys ◽  
X Ray Diffraction ◽  
Medium Range Order ◽  
Intermediate Range Order ◽  
Transition Metal Atoms ◽  
Medium Range ◽  
Three Dimensional Models ◽  
Co Alloys

AbstractA local short-to-intermediate range order of liquid Al80Co10Ni10, Al72.5Co14.5Ni13, and Al65Co17.5Ni17.5 alloys was examined by X-ray diffraction and the reverse Monte Carlo modelling. The comprehensive analysis of three-dimensional models of the liquid ternary alloys was performed by means of the Voronoi-Delaunay method. The existence of a prepeak on the S(Q) function of the liquid alloys is caused by medium range ordering of 3d-transition metal atoms in dense-packed polytetrahedral clusters at temperatures close to the liquidus. The non-crystalline clusters, represented by aggregates of pentagons that consist of good tetrahedra, and chemical short-range order lead to the formation of the medium range order in the liquid binary Al-Ni, Al-Co and ternary Al-Ni-Co alloys.

Sign in / Sign up

Export Citation Format

Share Document