scholarly journals Production of Biodiesel from High Acid Value Waste Cooking Oil Using an Optimized Lipase Enzyme/Acid-Catalyzed Hybrid Process

2009 ◽  
Vol 6 (s1) ◽  
pp. S485-S495 ◽  
Author(s):  
N. Saifuddin ◽  
A. Z. Raziah ◽  
H. Nor Farah
Keyword(s):  
Acid Value ◽  
Reaction Rates ◽  
Waste Cooking Oil ◽  
Biodiesel Production ◽  
Hybrid Process ◽  
Initial Reaction ◽  
Cooking Oil ◽  
High Acid ◽  
Lipase Enzyme ◽  
Acid Catalyzed

The present study is aimed at developing an enzymatic/acid-catalyzed hybrid process for biodiesel production using waste cooking oil with high acid value (poor quality) as feedstock. Tuned enzyme was prepared using a rapid drying technique of microwave dehydration (time required around 15 minutes). Further enhancement was achieved by three phase partitioning (TPP) method. The results on the lipase enzyme which was subjected to pH tuning and TPP, indicated remarkable increase in the initial rate of transesterification by 3.8 times. Microwave irradiation was found to increase the initial reaction rates by further 1.6 times, hence giving a combined increase in activity of about 5.4 times. The optimized enzyme was used for hydrolysis and 88% of the oil taken initially was hydrolyzed by the lipase. The hydrolysate was further used in acid-catalyzed esterification for biodiesel production. By using a feedstock to methanol molar ratio of 1:15 and a sulphuric acid concentration of 2.5%, a biodiesel conversion of 88% was obtained at 50 °C for an hour reaction time. This hybrid process may open a way for biodiesel production using unrefined and used oil with high acid value as feedstock.

scholarly journals Enhancement of Biodiesel Production from High-Acid-Value Waste Cooking Oil via a Microwave Reactor Using a Homogeneous Alkaline Catalyst

Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 437
Author(s):  
Ming-Chien Hsiao ◽  
Peir-Horng Liao ◽  
Nguyen Vu Lan ◽  
Shuhn-Shyurng Hou
Keyword(s):  
Reaction Time ◽  
Reaction Temperature ◽  
Microwave Power ◽  
Acid Value ◽  
Waste Cooking Oil ◽  
Transesterification Reaction ◽  
Biodiesel Production ◽  
Alkaline Catalyst ◽  
Cooking Oil ◽  
High Acid

In this study, low quality oils (waste cooking oils) with high acid value (4.81 mg KOH/g) were utilized as the feedstocks for a transesterification reaction enhanced by additional microwave power and the use of an NaOH catalyst. The kinetics of the transesterification reaction under different reaction times and temperatures was studied. It was found that in the microwave-assisted transesterification reaction, the optimum conditions under a microwave power of 600 W were as follows: an NaOH catalyst of 0.8 wt %, a 12:1 molar ratio of methanol to oil, a reaction time of 2 min, and a reaction temperature of 65 °C. The conversion of waste cooking oil into biodiesel reached 98.2% after this short reaction time. This result conformed to 96.5% of the standard value of Taiwan CNS 15072. In addition, with increases in the reaction temperature from 55 to 65 °C, the reaction rate constant increased from 0.635 to 2.396 min−1, and the activation energy required for the transesterification reaction was 123.14 kJ/mole.

Biodiesel production from waste cooking oil using a novel biocatalyst of lipase enzyme immobilized magnetic nanocomposite

Fuel ◽  
2022 ◽  
Vol 313 ◽  
pp. 123057
Author(s):  
Ehsan Parandi ◽  
Maryam Safaripour ◽  
Magda H. Abdellattif ◽  
Majid Saidi ◽  
Alireza Bozorgian ◽  
...  
Keyword(s):  
Waste Cooking Oil ◽  
Magnetic Nanocomposite ◽  
Biodiesel Production ◽  
Cooking Oil ◽  
Lipase Enzyme

scholarly journals Reusability test of Silica - Titania Catalyst on Biodiesel Production from Waste Cooking Oil in Various Temperatures

2019 ◽  
pp. 116-123
Author(s):  
Fiona Rachma Annisa ◽  
Indang Dewata ◽  
Hary Sanjaya ◽  
Latisma Dj ◽  
Ananda Putra ◽  
...  
Keyword(s):  
Flow Rate ◽  
Acid Value ◽  
Waste Cooking Oil ◽  
Biodiesel Production ◽  
Tetrahedral Coordination ◽  
Cooking Oil ◽  
Used Cooking Oil ◽  
Ftir Characterization ◽  
Density Flow

This work has investigated the reusability of silica-titania in various temperatures (50 – 70°C) of biodiesel production from waste cooking oil. The reused silica-titania catalyst collected from silica-titania catalyst waste produced from the process of separating the catalyst from biodiesel products from palm oil and used cooking oil at various temperatures. The 1st and 2nd reused SiO2-TiO2 were characterized by DR UV-Vis and the spectra were deconvoluted for calculate the fraction of titanium in tetrahedral coordination. In addition the biodiesel products were characterized using FTIR, and several properties of biodiesel such as density, flow rate and acid value were analyzed in order to get the information about catalytic activity reused SiO2-TiO2. The results show the titanium tetrahedral fraction in reused catalyst (1st) and (2nd) are found to be 24,98% and 24.65%, respectively. The FTIR characterization of biodiesel products and waste cooking oil are almost similar. The analysis of waste cooking oil converted to biodiesel shows an optimum temperature of 50oC that at this temperature the lowest density or highest flow rate gave highest conversion of 47.82% using BCR1 and 39.13% using BCR2.

scholarly journals Multi-Feedstocks Biodiesel Production from Esterification of Calophyllum inophyllum Oil, Castor Oil, Palm Oil and Waste Cooking Oil

2020 ◽  
Vol 9 (1) ◽  
pp. 119-123
Author(s):  
H Hadiyanto ◽  
Apsari Puspita Aini ◽  
Widayat Widayat ◽  
Kusmiyati Kusmiyati ◽  
Arief Budiman ◽  
...  
Keyword(s):  
Vegetable Oils ◽  
Palm Oil ◽  
Ricinus Communis ◽  
Acid Value ◽  
Waste Cooking Oil ◽  
Raw Material ◽  
Biodiesel Production ◽  
Molar Ratio ◽  
Calophyllum Inophyllum ◽  
Cooking Oil

Biodiesel can be produced from various vegetable oils and animal fat. Abundant sources of vegetable oil in Indonesia, such as Calophyllum inophyllum, Ricinus communis, palm oil, and waste cooking oil, were used as raw materials. Multi-feedstock biodiesel was used to increase the flexibility operation of biodiesel production. This study was conducted to determine the effect of a combination of vegetable oils on biodiesel characteristics. Degumming and two steps of esterification were applied for high free fatty acid feedstock before trans-esterification in combination with other vegetable oils. Potassium hydroxide was used as a homogenous catalyst and methanol as another raw material. The acid value of C. inophyllum decreased from 54 mg KOH/gr oil to 2.15 mg KOH/gr oil after two steps of esterification. Biodiesel yield from multi-feedstock was 87.926% with a methanol-to-oil molar ratio of 6:1, temperature of 60 ℃, and catalyst of 1%wt. ©2020. CBIORE-IJRED. All rights reserved

scholarly journals Production of Bio-Hydrogenated Diesel by Hydrotreatment of High-Acid-Value Waste Cooking Oil over Ruthenium Catalyst Supported on Al-Polyoxocation-Pillared Montmorillonite

Catalysts ◽  
2012 ◽  
Vol 2 (1) ◽  
pp. 171-190 ◽  
Author(s):  
Yanyong Liu ◽  
Rogelio Sotelo-Boyás ◽  
Kazuhisa Murata ◽  
Tomoaki Minowa ◽  
Kinya Sakanishi
Keyword(s):  
Acid Value ◽  
Waste Cooking Oil ◽  
Ruthenium Catalyst ◽  
Pillared Montmorillonite ◽  
Cooking Oil ◽  
High Acid

Solid acid catalyzed biodiesel production from waste cooking oil

2008 ◽  
Vol 85 (1-2) ◽  
pp. 86-91 ◽  
Author(s):  
K JACOBSON ◽  
R GOPINATH ◽  
L MEHER ◽  
A DALAI
Keyword(s):  
Solid Acid ◽  
Waste Cooking Oil ◽  
Biodiesel Production ◽  
Cooking Oil ◽  
Acid Catalyzed

Pilot Plant of Biodiesel Production from Waste Cooking Oil

2012 ◽  
Vol 550-553 ◽  
pp. 687-692
Author(s):  
Guang Rui Liu ◽  
Guan Yi Chen
Keyword(s):  
Diesel Fuel ◽  
Public Transportation ◽  
Pilot Plant ◽  
Chemical Properties ◽  
Acid Value ◽  
Waste Cooking Oil ◽  
Raw Material ◽  
Biodiesel Production ◽  
Animal Fats ◽  
Cooking Oil

Biodiesel, as an alternative auto fuel for conventional fossil fuel, has drawn wide attention in recent years. In this research, a two-step process for biodiesel production using waste cooking oil as feedstock was studied in a pilot plant with a treatment capacity of 3 ton/d. The results show that: the process exihibited a good conversion ratio and the biodiesel displayed suitable physical-chemical properties in comparison with diesel fuel, such as flash point of 137°C, viscosity of 4.49 mm2/s, acid value of 0.44 mg KOH/g etc. The quality of biodiesel meets the agreement with the European specification defined by EN 14214. Afterwards, the mixture of biodiesel and diesel were test in the engine with a ratio of 50/50（v/v）, 20/80（v/v）, and 0/100（v/v）. It indicates the mixed fuel has a reasonable fuel consumption rates without diesel engine modification, when the biodiesel blended with 0# diesel as fuel. The present results demonstrated that the industrial scale plant would achieve promising objective with waste cooking oils and animal fats as raw material. Also, this biodiesel-based diesel fuel could be applied in Tianjin local public transportation system that improves its sustainable development.

Sign in / Sign up

Export Citation Format

Share Document