scholarly journals Implementation of non-isolated three-port converter through augmented time response

2021 ◽  
Vol 12 (2) ◽  
pp. 913
Author(s):  
Ramya Devasahayam ◽  
Godwin Immanuel D
Keyword(s):  
Steady State ◽  
Time Domain ◽  
Closed Loop ◽  
High Gain ◽  
Pi Controller ◽  
Time Response ◽  
Voltage Gain ◽  
Closed Loop System ◽  
Time Domain Response ◽  
Fast Responses

<p><span lang="EN-US">The work is concerning a multi-port dc-dc converter with improved time response and steady state output. Here the converter carries bare amount of switches for managing the power with mono inductance. The inductance and along with that the switched capacitance are pre owned to bring large voltage gain. This paper put forwarded an appropriate controller for the closed loop monitored high-gain converter with three ports. Higher is that the conversion rate. This converter is also a good interface between DC-source and load that aims to progressing time response with FLC and PI controller in the closed loop system. The converter with the PI controller and FLC is look over and the fast responses are compared with time domain specifications. The simulation outcome indicates that the FLC based converter brings most excellent time domain response.</span></p>

scholarly journals Current mode proportional resonant controlled multi input–SEPIC-re-boost-system

2019 ◽  
Vol 10 (2) ◽  
pp. 682
Author(s):  
B. Jagadish Kumar ◽  
Basavaraja Banakara
Keyword(s):  
Time Domain ◽  
Closed Loop ◽  
Current Mode ◽  
High Gain ◽  
Peak Time ◽  
Motor Speed ◽  
Loop Control ◽  
Multiple Input ◽  
Simulation Results ◽  
Time Domain Response

<p>The intention of this paper is to identify a suitable controller for closed loop multi converter system for multiple input sources and to improve time response of high-gain-step up-converter. Closed-loop Multi Converter System (MCS) is utilized to regulate load-voltage.  This effort recommends suitable-controller for closed-two loop-controlled-SEPIC-REBOOST Converter fed DC motor. The estimation of the yield in open-two loop and closed- two-loop-circuit has been done using MATLAB or Simulink. Closed-two loop-control of Multi Converter System with Propotional+Integral (PI)- Propotional+Integral (PI) and Proportional+Resonant (PR) - Proportional+Resonant (PR) Controllers are investigated and their responses are evaluated in conditions of rise time, peak time, settling time and steady state error. It is seen that current-mode PR-PR controlled MCS gives better time domain response in terms of motor speed. A Prototype of MCS has been fabricated in the laboratory and the experimental-results are authenticated with the simulation-results.</p>

A High Step-up DC-DC Converter Based on the Voltage Lift Technique for Renewable Energy Applications

2021 ◽  
Vol 13 (19) ◽  
pp. 11059
Author(s):  
Shahrukh Khan ◽  
Arshad Mahmood ◽  
Mohammad Zaid ◽  
Mohd Tariq ◽  
Chang-Hua Lin ◽  
...  
Keyword(s):  
Renewable Energy ◽  
Common Ground ◽  
Closed Loop ◽  
Low Voltage ◽  
Renewable Energy Sources ◽  
Input Voltage ◽  
High Gain ◽  
Boost Converter ◽  
Open Loop ◽  
Voltage Gain

High gain DC-DC converters are getting popular due to the increased use of renewable energy sources (RESs). Common ground between the input and output, low voltage stress across power switches and high voltage gain at lower duty ratios are desirable features required in any high gain DC-DC converter. DC-DC converters are widely used in DC microgrids to supply power to meet local demands. In this work, a high step-up DC-DC converter is proposed based on the voltage lift (VL) technique using a single power switch. The proposed converter has a voltage gain greater than a traditional boost converter (TBC) and Traditional quadratic boost converter (TQBC). The effect of inductor parasitic resistances on the voltage gain of the converter is discussed. The losses occurring in various components are calculated using PLECS software. To confirm the performance of the converter, a hardware prototype of 200 W is developed in the laboratory. The simulation and hardware results are presented to determine the performance of the converter in both open-loop and closed-loop conditions. In closed-loop operation, a PI controller is used to maintain a constant output voltage when the load or input voltage is changed.

scholarly journals PI- Controlled PV Fed Fly Back Converter with Enhanced Dynamic Response

2019 ◽  
Vol 8 (2S11) ◽  
pp. 4031-4034
Keyword(s):  
Steady State ◽  
Dynamic Response ◽  
Rise Time ◽  
Closed Loop ◽  
Input Voltage ◽  
Pi Controller ◽  
Open Loop ◽  
Load Variations ◽  
Simulink Model ◽  
Step Down

Fly back converter is the most popular converter because of its simplicity, low part counts and isolation. It occupies less volume and it saves cost. Fly back converter steps up and step down the voltage with the same polarity. Open loop operation remains insensitive to the input voltage and load variations. Matlab Simulink model for Fly back converter is established using PI controller. Open loop Fly back converter system and closed loop fly back converter systems are simulated and their outcomes are compared. Comparison is done in terms of Rise time ,Settling time and steady state error

Optimizing the Feedback Gains of the Robust Linear Regulator

1999 ◽  
Vol 121 (3) ◽  
pp. 346-350
Author(s):  
Jie Huang
Keyword(s):  
Computer Simulation ◽  
Steady State ◽  
Transient Response ◽  
Closed Loop ◽  
Feedback Gain ◽  
Frobenius Norm ◽  
Closed Loop System ◽  
Optimal Feedback ◽  
Linear Regulator ◽  
Fixed Set

This paper aims to improve the transient response of a linear regulator system by optimizing the feedback gains associated with a fixed set of desirable eigenvalues of the closed-loop system. The optimal feedback gain is such that the Frobenius norm of the steady state of the compensator is minimized. Computer simulation shows that this scheme is effective in improving the transient response of the regulator system.

scholarly journals Design and operation of closed-loop triple-deck buck-boost converter with high gain soft switching

2020 ◽  
Vol 11 (1) ◽  
pp. 523
Author(s):  
S. Narasimha ◽  
Surender Reddy Salkuti
Keyword(s):  
Closed Loop ◽  
High Gain ◽  
Pi Controller ◽  
Boost Converter ◽  
Vital Role ◽  
Soft Switching ◽  
Parallel Operation ◽  
Zero Voltage Switching ◽  
Switching Losses ◽  
Zero Voltage

<span>This paper presents the design and operation of three-stage buck-boost converter with high gain soft switching using closed loop proportional integral (PI) controller. The proposed converter is designed by arranging three identical buck-boost converters working in parallel. The converter units are connected to each other by an inductor as a bridge. This inductor plays a vital role in soft switching operation of converter by maintaining the voltage applied to switches at zero voltage at switching intervals, i.e., the zero-voltage switching (ZVS). The closed-loop system is designed by PI controller, and it maintains the output constant irrespective of changes in input, and the system becomes stable. The proposed converter is efficient in reducing switching losses, leading to improved converter efficiency. Due to parallel operation of three identical converters, the output voltage and input current contain fewer ripples than those of a single converter with same specifications. Proposed converter is more economical and reliable with simpler structure as it utilizes only two inductors as extra elements. The design and analysis of proposed circuit has been carried out in MATLAB Simulink by operating the circuit in various modes.</span>

Investigation of an Electrohydraulic Servovalve With Tuneable Return Pressure and Drain Orifice

1987 ◽  
Vol 109 (3) ◽  
pp. 276-285 ◽  
Author(s):  
S. LeQuoc ◽  
R. M. H. Cheng ◽  
A. Limaye
Keyword(s):  
Closed Loop ◽  
Design Procedure ◽  
High Gain ◽  
Velocity Versus ◽  
System Control ◽  
Closed Loop System ◽  
Test Rig ◽  
Step Method ◽  
Steady State Condition ◽  
Tuning Parameters

This paper describes a new concept of electrohydraulic servovalve where the novelty lies mainly in the fact that the return pressure and return orifice of the servovalve are tuneable and can be adjusted to satisfy the system control requirements. The actuator velocity characteristics of a hydraulic servomechanism operating under steady state condition is analysed through the use of dimensionless quantities. It is established that the proposed configuration exhibits a nonlinear actuator velocity versus servovalve opening relationship and at small servovalve opening, the system offers a higher actuator velocity. The closed loop system transient responses are also investigated by means of digital computer simulation. The results are experimentally verified on a test rig specifically designed for this purpose. It is observed that with the return pressure and return orifice properly tuned, one can achieve a high gain yet high damping servosystem. A design procedure is described which provides the designer with a step by step method for determining the tuning parameters in order to obtain a desired system performance.

Output feedback boundary control of a flexible marine riser system

2017 ◽  
Vol 24 (16) ◽  
pp. 3617-3630 ◽  
Author(s):  
Yu Liu ◽  
Fang Guo
Keyword(s):  
Boundary Control ◽  
Closed Loop ◽  
Vibration Suppression ◽  
High Gain ◽  
Loop System ◽  
System State ◽  
Marine Riser ◽  
Closed Loop System ◽  
Observer Error ◽  
System States

This paper is concerned with the design of boundary control for globally stabilizing a flexible marine riser system. The dynamics of the riser system are represented in the form of hybrid partial–ordinary differential equations. Firstly, when the system state available for feedback is unmeasurable, an observer backstepping method is employed to reconstruct the system state and then design the boundary control for vibration suppression of the riser system. Subsequently, for the case that the system states in the designed control law cannot be accurately obtained, the high-gain observers are utilized to estimate those unmeasurable system states. With the proposed control, the uniformly ultimately bounded stability of the closed-loop system is demonstrated by the use of Lyapunov’s synthetic method and the state observer error is converged exponentially to zero as time approaches to infinity. In addition, the disturbance observer is introduced to track external environmental disturbance. Finally, the control performance of the closed-loop system is validated by carrying out numerical simulation.

scholarly journals Fractional PID controlled cascaded flyback switched mode power supply with enhanced time domain response

2019 ◽  
Vol 10 (2) ◽  
pp. 909 ◽  
Author(s):  
K. Sasikala ◽  
R. Krishna Kumar
Keyword(s):  
Time Domain ◽  
Power Supply ◽  
Closed Loop ◽  
Supply Voltage ◽  
Dc Voltage ◽  
Flyback Converter ◽  
Proportional Integral ◽  
Modeling Simulation ◽  
Switched Mode Power Supply ◽  
Time Domain Response

<p>This work compacts with the modeling, simulation, and application of a Fractional Order Proportional Integral Differential (FOP-I-D) controlled Cascaded Flyback Switched Mode Power Supply (CFSMPS) system. It recommends Parallel cascaded flyback converter for the production of essential DC voltage from the input supply voltage. The output from CFSMPS is regulated by using closed loop configuration. The simulation of Closed-loop Proportional-Integral (PI) and FOP-I-D controlled CFSMPS system has been done and the results of the systems are related. The outcomes signify that the FOP-I-D based system has presented an enhanced response to represent as similar to the PI controlled CFSMPS system. The FOP-I-D controlled CFSMPS system has benefits like decreased steady-state error and enhanced time-domain response.</p>

Sign in / Sign up

Export Citation Format

Share Document