Optimization of EDMed fly ash and Rice husk ash reinforced hybrid Al-based composite using improved COPRAS and Entropy method

2023 ◽  
Vol 18 (2) ◽  
pp. 1
Author(s):  
Mohan Kumar Pradhan N.A.
Keyword(s):  
Fly Ash ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Entropy Method

Life cycle assessment and cost analysis of fly ash–rice husk ash blended alkali-activated concrete

2021 ◽  
Vol 295 ◽  
pp. 113140
Author(s):  
Sarah Fernando ◽  
Chamila Gunasekara ◽  
David W. Law ◽  
M.C.M. Nasvi ◽  
Sujeeva Setunge ◽  
...  
Keyword(s):  
Life Cycle Assessment ◽  
Life Cycle ◽  
Fly Ash ◽  
Cost Analysis ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Alkali Activated Concrete ◽  
Alkali Activated

Sulfate resistance of blended cements containing fly ash and rice husk ash

2007 ◽  
Vol 21 (6) ◽  
pp. 1356-1361 ◽  
Author(s):  
P. Chindaprasirt ◽  
P. Kanchanda ◽  
A. Sathonsaowaphak ◽  
H.T. Cao
Keyword(s):  
Fly Ash ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Blended Cements ◽  
Sulfate Resistance

Physical Properties of Cement Mortar Containing Waste Ash

2015 ◽  
Vol 804 ◽  
pp. 129-132
Author(s):  
Sumrerng Rukzon ◽  
Prinya Chindaprasirt
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Cement Mortar ◽  
Ash Content ◽  
Water Requirement ◽  
Test Results ◽  
Pozzolanic Material ◽  
Materials Used

This research studies the potential for using waste ash from industrial and agricultural by-products as a pozzolanic material. Classified fly ash (FA) and ground rice husk ash (RA) were the materials used. Water requirement, compressive strength and porosity of cement mortar were investigated. Test results indicated that FA and RA (waste ash) have a high potential to be used as a good pozzolanic material. The water requirement of mortar mix decreases with the increases in fly ash content. For ground rice husk ash (RA), the water requirement of mortar mix increases with the increases in rice husk ash content. In addition, the reduction in porosity was associated with the increase in compressive strength.

Experimental Study on Various Mineral Admixtures in Fibre Reinforced Concrete

2019 ◽  
pp. 309-317
Author(s):  
Kavitha E ◽  
Karthik S ◽  
Eithya B ◽  
Seenirajan M
Keyword(s):  
Fly Ash ◽  
Rice Husk ◽  
Power Plants ◽  
Rice Husk Ash ◽  
Thermal Power ◽  
Experimental Studies ◽  
Mineral Admixtures ◽  
Hardened Concrete ◽  
Polypropylene Fibres ◽  
Concrete Production

The quantity of fly ash produced from thermal power plants in India is approximately 80 million tons each year, and its percentage utilization is less than 10%. An attempt has been made to utilize these cheaper materials in concrete production. This thesis aims at investigating the characteristics of fresh concrete and various strengths of hardened concrete made with various mineral admixtures such as fly ash. GGBFS, silica fume. Rice husk ash along with polypropylene fibres in various proportions.  M20 grade concrete is considered for experimental studies with 53grade Ordinary Portland Cement blended with varying percentages of mineral admixtures. The maximum size of coarse aggregate used is 20mm.  Various mineral admixtures such as fly ash. GGBFS.Silica fume. Rice Husk Ash were added concrete in various percentages by partially replacing cement and the optimum percentage of the mineral admixtures will be found.  Based on the obtained values, the admixture with maximum mechanical strength is determined and to this polypropylene fibre is added by varying 0 to 0.5 % by weight of cement to the mix.  The test results obtained were compared and discussed with conventional concrete.

scholarly journals Industrial Wastes in Soil Improvement

2011 ◽  
Vol 2011 ◽  
pp. 1-5 ◽  
Author(s):  
G. V. Rama Subbarao ◽  
D. Siddartha ◽  
T. Muralikrishna ◽  
K. S. Sailaja ◽  
T. Sowmya
Keyword(s):  
Fly Ash ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Cost Effective ◽  
Dry Weight ◽  
Soil Improvement ◽  
Geotechnical Properties ◽  
Point Of View ◽  
Industrial Wastes ◽  
Engineering Structures

Soil existing at a particular site may not be appropriate for construction of engineering structures. The present study made an attempt to enhance the geotechnical properties of a soil replaced with industrial wastes having pozzolanic value like rice husk ash (RHA) and fly ash (FA). Soil is replaced with RHA in 2%, 4%, and 6% to dry weight of soil. It is observed that soil replaced with 4% RHA is the optimum for the soil used in this study from geotechnical point of view. To know the influence of fly ash, soil is further replaced with 4% FA along with 4% RHA. It is found that results of soil replacement by both RHA and FA proved to be soil modification and not the improvement. Hence, a cost-effective accelerator like lime is used for further replacing the above soil-4%, RHA-4% FA mix. The optimum lime content is found to be 4%.

scholarly journals Development of a Zero-Cement Binder Using Slag, Fly Ash, and Rice Husk Ash with Chemical Activator

2015 ◽  
Vol 2015 ◽  
pp. 1-14 ◽  
Author(s):  
M. R. Karim ◽  
M. F. M. Zain ◽  
M. Jamil ◽  
F. C. Lai
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Setting Time ◽  
Time Flow ◽  
Alumina Gel ◽  
Cement Binder ◽  
Increasing Demand ◽  
Chemical Activator

The increasing demand and consumption of cement have necessitated the use of slag, fly ash, rice husk ash (RHA), and so forth as a supplement of cement in concrete construction. The aim of the study is to develop a zero-cement binder (Z-Cem) using slag, fly ash, and RHA combined with chemical activator. NaOH, Ca(OH)2, and KOH were used in varying weights and molar concentrations. Z-Cem was tested for its consistency, setting time, flow, compressive strength, XRD, SEM, and FTIR. The consistency and setting time of the Z-Cem paste increase with increasing RHA content. The Z-Cem mortar requires more superplasticizer to maintain a constant flow of110±5% compared with OPC. The compressive strength of the Z-Cem mortar is significantly influenced by the amounts, types, and molar concentration of the activators. The Z-Cem mortar achieves a compressive strength of 42–44 MPa at 28 days with 5% NaOH or at 2.5 molar concentrations. The FTIR results reveal that molecules in the Z-Cem mortar have a silica-hydrate (Si-H) bond with sodium or other inorganic metals (i.e., sodium/calcium-silica-hydrate-alumina gel). Therefore, Z-Cem could be developed using the aforementioned materials with the chemical activator.

Use of Water Glass from Rice Husk and Bagasse Ashes in the Preparation of Fly Ash Based Geopolymer

2019 ◽  
Vol 798 ◽  
pp. 364-369 ◽  
Author(s):  
Khemmakorn Gomonsirisuk ◽  
Parjaree Thavorniti
Keyword(s):  
Mechanical Properties ◽  
Compressive Strength ◽  
Fly Ash ◽  
Rice Husk ◽  
Ball Mill ◽  
Water Glass ◽  
Rice Husk Ash ◽  
Raw Materials ◽  
Agricultural Waste ◽  
Preparation Process

The aim of this work is to study the feasibility of preparation of fly ash based geopolymer using sodium water glass from agricultural waste as alternative activators. Rice husk ash and bagasse ash were used as raw materials for producing sodium water glass solution. The sodium water glass were produced by mixing rice husk ash and bagasse ash with NaOH in ball mill and boiling. The prepared sodium water glass were analyzed and used in geopolymer preparation process. The geopolymer paste were prepared by adding the obtained water glass and NaOH with fly ash. After cured at ambient temperature for 7 days, mechanical properties were investigated. Bonding and phases of the geopolymer were also characterized. The geopolymer from rice husk ash presented highest compressive strength about 23 MPa while the greatest for bagasse ash was about 16 MPa.

Sign in / Sign up

Export Citation Format

Share Document