The Effect of Substituting Rdf on the Physical and Environmental Properties of Coal Fly Ash

1988 ◽  
Vol 136 ◽  
Author(s):  
Ashaari B. Mohamad ◽  
David L. Gress
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Physical Properties ◽  
Activity Index ◽  
Coal Fly Ash ◽  
Pozzolanic Activity ◽  
Portland Cement Concrete ◽  
Fly Ash Concrete ◽  
Refuse Derived Fuel ◽  
Cadmium And Lead

ABSTRACTRefuse-derived-fuel (RDF) consisting mainly of waste paper and plastics is a viable fuel source for the production of power. An experimental test burn partially substituting coal with RDF was undertaken by the Public Service of New Hampshire at the Merrimack Power Station.Five percent and ten percent RDF were substituted, on a BTU basis, for coal in the test bums. The chemical and physical properties of the resulting fly ash were determined. Twelve test burn days were run with 4 days of 5% RDF and 8 days of 10% RDF. Emphasis was placed on investigating the effect of the RDF fly ash on Portland cement concrete.Most of the chemical and physical properties of the coal-RDF fly ash were found to be comparable with ordinary coal fly ash except for the amount of cadmium and lead, the pozzolanic activity index and the compressive strength of fly ash concrete. Cadmium and lead were at average levels of 5.1 ppm and 102.6 ppm for the 5% RDF, and 7.8 ppm and 198.3 ppm for the 10% RDF, respectively. Although the pozzolanic activity index of coal-RDF fly ash increases over normal coal fly ash, preliminary results show that the 28-day compressive strength of concrete with direct replacement of cement and sand decreases by up to 30%. Leaching tests on crushed concrete were conducted to evaluate the environmental effect of acid rain.

Effect of Specimen Size and Curing Condition on the Compressive Strength of Alkali-Activated Concrete

2017 ◽  
Vol 2629 (1) ◽  
pp. 9-14 ◽  
Author(s):  
Robert James Thomas ◽  
Sulapha Peethamparan
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Specimen Size ◽  
Portland Cement Concrete ◽  
Cement Concrete ◽  
Slag Cement ◽  
Fly Ash Concrete ◽  
Activated Slag ◽  
Alkali Activated Concrete ◽  
Alkali Activated

Alkali-activated concrete is a rapidly emerging sustainable alternative to portland cement concrete. The compressive strength behavior of alkali-activated concrete has been reported by various studies to a limited extent, but these discussions have been based on minimal evidence. Furthermore, although it is known that specimen size has a distinct effect on the apparent compressive strength of concrete, this effect has yet to be modeled for alkali-activated concrete. This paper presents the results of a comprehensive study of the effects of curing condition (i.e., moist-cured at ambient temperature for 28 days or heat-cured at 50çC for 48 h) and specimen size on the compressive strength of sodium silicate–activated fly ash and slag cement concrete. The heat-cured strength of alkali-activated slag cement concrete was linearly related to the moist-cured strength; the former was about 5% greater than the latter. Heat curing also improved the strength of alkali-activated fly ash concrete, although the effect was greatly magnified for lower-strength mixtures and was much less significant at higher strengths. Existing size effect laws employed for portland cement concrete proved reasonably accurate in describing the effect of specimen size on the apparent strength of alkali-activated slag cement concrete. However, these existing models greatly underestimated the size effect in alkali-activated fly ash concrete; the authors suggest that this finding was the result of significant microcracking in the alkali-activated fly ash concrete.

scholarly journals Wood ashes from electrostatic filter as a replacement for the fly ashes in concrete

2021 ◽  
Vol 2 (2) ◽  
Author(s):  
Piotr-Robert Lazik ◽  
◽  
Harald Garrecht ◽  
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Coal Fly Ash ◽  
Wood Ash ◽  
Fly Ashes ◽  
Normal Concrete ◽  
Cement Production ◽  
Fly Ash Concrete ◽  
Electrostatic Filter ◽  
Laboratory Investigations

Many concrete technologists are looking for a solution to replace Fly Ashes that would be unavailable in a few years as an element that occurs as a major component of many types of concrete. The importance of such component is clear - it saves cement and reduces the amount of CO2 in the atmosphere that occurs during cement production. Wood Ashes from electrostatic filter can be used as a valuable substitute in concrete. The laboratory investigations showed that the wood ash concrete had a compressive strength comparable to coal fly ash concrete. These results indicate that wood ash can be used to manufacture normal concrete.

scholarly journals An Appraisal of Compressive Strength of Concrete Incorporated with Chemically Different Fly Ashes

2020 ◽  
Vol 14 (1) ◽  
pp. 188-199
Author(s):  
Atsushi Suzuki ◽  
Dinil Pushpalal ◽  
Hiroo Kashima
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Physical Properties ◽  
Calcium Content ◽  
Fly Ashes ◽  
Fly Ash Concrete ◽  
Low Calcium ◽  
High Calcium ◽  
Applicable Range ◽  
Compressive Strength Of Concrete

Introduction: Generally, the compressive strength of fly ash concrete differs depending on the properties of fly ash. This strength difference causes difficulties for concrete engineers to guarantee the strength of supplied concrete. Methods: This research firstly carried out the compressive strength tests on the concrete incorporated with fly ash possessing various chemical composition, which are high and low calcium fly ashes. The linear and nonlinear regression analyses were adopted to build the strength prediction model. Results: The chemical and physical properties of procured fly ash with high and low calcium contents have been quantified. Specifically, the compressive strength of concrete with high calcium fly ash demonstrates a strong correlation with calcium content, rather than physical properties such as the surface area and loss of ignition. Therefore, the compressive strength on 28th day can be assessed by a simple formula, taking CaO content of fly ash as an independent variable. In further, the strength on an arbitrary day can be predicted based on the 28th day strength and the replacement rate of fly ash. Conclusion: The two-step framework proposed in this research enables concrete engineers to evaluate the compressive strength of fly ash concrete with an error rate of less than 30%, within the applicable range addressed in this research.

Effects of Elevated Temperatures on the Compressive Strength of HFCC

2011 ◽  
Vol 261-263 ◽  
pp. 416-420 ◽  
Author(s):  
Fu Ping Jia ◽  
Heng Lin Lv ◽  
Yi Bing Sun ◽  
Bu Yu Cao ◽  
Shi Ning Ding
Keyword(s):  
Compressive Strength ◽  
Elevated Temperature ◽  
Fly Ash ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Relative Strength ◽  
Ordinary Concrete ◽  
Residual Compressive Strength ◽  
Fly Ash Concrete ◽  
The Relationship

This paper presents the results of elevated temperatures on the compressive of high fly ash content concrete (HFCC). The specimens were prepared with three different replacements of cement by fly ash 30%, 40% and 50% by mass and the residual compressive strength was tested after exposure to elevated temperature 250, 450, 550 and 650°C and room temperature respectively. The results showed that the compressive strength apparently decreased with the elevated temperature increased. The presence of fly ash was effective for improvement of the relative strength, which was the ratio of residual compressive strength after exposure to elevated temperature and ordinary concrete. The relative compressive strength of fly ash concrete was higher than those of ordinary concrete. Based on the experiments results, the alternating simulation formula to determine the relationship among relative strength, elevated temperature and fly ash replacement is developed by using regression of results, which provides the theoretical basis for the evaluation and repair of HFCC after elevated temperature.

scholarly journals Production of ceramics from coal fly ash

2012 ◽  
Vol 18 (2) ◽  
pp. 245-254 ◽  
Author(s):  
Biljana Angjusheva ◽  
Emilija Fidancevska ◽  
Vojo Jovanov
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Solid State ◽  
Liquid Phase ◽  
Bending Strength ◽  
Coal Fly Ash ◽  
Liquid Phase Sintering ◽  
Heating Rates ◽  
Republic Of Macedonia ◽  
The Subject

Dense ceramics are produced from fly ash from REK Bitola, Republic of Macedonia. Four types of fly ash from electro filters and one from the collected zone with particles < 0.063 mm were the subject of this research. Consolidation was achieved by pressing (P= 133 MPa) and sintering (950, 1000, 1050 and 11000C and heating rates of 3 and 100/min). Densification was realized by liquid phase sintering and solid state reaction where diopside [Ca(Mg,Al)(Si,Al)2O6] was formed. Ceramics with optimal properties (porosity 2.96?0.5%, bending strength - 47.01?2 MPa, compressive strength - 170 ?5 MPa) was produced at 1100?C using the heating rate of 10?C/min.

An Investigation of Usability of Brown Coal Fly Ash for Building Materials

2013 ◽  
Vol 438-439 ◽  
pp. 30-35 ◽  
Author(s):  
Nirdosha Gamage ◽  
Sujeeva Setunge ◽  
Kasuni Liyanage
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Brown Coal ◽  
Water Contamination ◽  
Building Materials ◽  
Coal Fly Ash ◽  
Sustainable Building ◽  
Laboratory Investigations ◽  
Cold Pressed ◽  
Initial Results

The Victoria State of Australia has the second largest reserves of brown coal on earth, representing approximately 20% of the worlds reserves, and at current use, could supply Victoria with its energy for over 500 years. Its combustion, annually, yields up to 1.3 million tonnes of fly ash, which is largely use for land-fills. Disposal of fly ash in open dumps cause massive environmental problems such as ground water contamination that may create various health problems. This study focuses on the usability of brown coal fly ash to develop a sustainable building material. A series of laboratory investigations was conducted using brown coal fly ash combined with cement and aggregate to prepare cold pressed samples aiming to test their properties. Initial results indicate that compressive strength satisfies minimum standard compressive strength required for bricks or mortar.

scholarly journals Utilization of Electroplating Sludge as Subgrade Backfill Materials: Mechanical and Environmental Risk Evaluation

2018 ◽  
Vol 2018 ◽  
pp. 1-9 ◽  
Author(s):  
Yu Zhang ◽  
Peixin Shi ◽  
Lijuan Chen ◽  
Qiang Tang
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Water Content ◽  
Environmental Risk ◽  
Coal Fly Ash ◽  
Surrounding Environment ◽  
Electroplating Sludge ◽  
Backfill Materials ◽  
Standard Limit ◽  
The Impact

The electroplating sludge may pose serious threat to human health and surrounding environment without safe treatment. This paper investigated the feasibility of using electroplating sludge as subgrade backfill materials, by evaluating the mechanical properties and environmental risk of the cement-coal fly ash solidified sludge. In this study, Portland cement and coal fly ash are used to solidify/stabilize the sludge. After curing for 7, 14, and 28 days, the stabilization/solidification sludge specimens were subject to a series of mechanical, leaching, and microcosmic tests. It was found that the compressive strength increased with the increase of cement content, curing time, and the cement replacement by coal fly ash besides water content. Among these factors, the impact of water content on the compressive strength is most noticeable. It was observed that the compressive strength declined by 87.1% when the water content increased from 0% to 10%. Besides, leaching tests showed that the amount of leaching heavy metals were under the standard limit. These results demonstrated utilization of electroplating sludge in subgrade backfill material may provide an alternative for the treatment of electroplating sludge.

Compressive strength and microstructure evolution of low calcium brown coal fly ash-based geopolymer

2019 ◽  
Vol 9 (1) ◽  
pp. 17-34 ◽  
Author(s):  
Muhamed Khodr ◽  
David W. Law ◽  
Chamila Gunasekara ◽  
Sujeeva Setunge ◽  
Robert Brkljaca
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Brown Coal ◽  
Microstructure Evolution ◽  
Coal Fly Ash ◽  
Low Calcium
Sign in / Sign up

Export Citation Format

Share Document