The Effect of Hydrogen on the Kinetics of Solid Phase Epitaxy in Amorphous Silicon

1990 ◽  
Vol 205 ◽  
Author(s):  
J. A. Roth ◽  
G. L. Olson ◽  
D. C. Jacobson ◽  
J. M. Poate ◽  
C. Kirschbaum
Keyword(s):  
Growth Rate ◽  
Solid Phase ◽  
Intrinsic Value ◽  
Amorphous Layer ◽  
Inert Gas ◽  
Solid Phase Epitaxy ◽  
Depth Profiles ◽  
Kinetics Of ◽  
Crystal Interface ◽  
Good Agreement

AbstractThis paper discusses the intrusion of H into a-Si layers during solid phase epitaxy and the effect of this H on the growth kinetics. We show that during annealing in the presence of water vapor, H is continuously generated at the oxidizing a-Si surface and diffuses into the amorphous layer, where it causes a reduction in the epitaxial growth rate. The measured variation of growth rate with the depth of the amorphous/crystal interface is correlated with the concentration of H at the interface. The diffusion coefficient for H in a-Si is determined by comparing measured depth profiles with calculated values. Hydrogen intrusion is observed even in layers annealed in vacuum and in inert gas ambients. Thin (<;5000 Åthick) a-Si layers are especially susceptible to this effect, but we show that in spite of the presence of H the activation energy for SPE derived earlier from thin-layer data is in good agreement with the intrinsic value obtained from thick, hydrogen-free layers.

Process and Mechanism of CoSi2/Si Solid Phase Epitaxy by Multilayer Reaction

1999 ◽  
Vol 580 ◽  
Author(s):  
Bing-Zong Li ◽  
Xin-Ping Qu ◽  
Guo-Ping Ru ◽  
Ning Wang ◽  
Paul Chu
Keyword(s):  
Epitaxial Growth ◽  
Solid Phase ◽  
Amorphous Layer ◽  
Solid Phase Epitaxy ◽  
Initial Stage ◽  
Vital Effect ◽  
Amorphous Si ◽  
Kinetics Of ◽  
State Amorphization

AbstractA multilayer structure of Co/a-Si/Ti/Si(100) together with Co/Ti/Si(100) is applied to investigate the process and mechanism of CoSi2 epitaxial growth on a Si(100) substrate. The experimental results show that by adding an amorphous Si layer with a certain thickness, the epitaxial quality of CoSi2 is significantly improved. A multi-element amorphous layer is formed by a solid state amorphization reaction at the initial stage of the multilayer reaction. This layer acts as a diffusion barrier, which controls the atomic interdiffusion of Co and Si and limits the supply of Co atoms. It has a vital effect on the multilayer reaction kinetics, and the epitaxial growth of CoSi2 on Si. The kinetics of the CoSi2 growth process from multilayer reactions is investigated.

Diffusion model for deposition of epitaxial GaAs layers prepared by the MOCVD method

1991 ◽  
Vol 56 (10) ◽  
pp. 2020-2029
Author(s):  
Jindřich Leitner ◽  
Petr Voňka ◽  
Josef Stejskal ◽  
Přemysl Klíma ◽  
Rudolf Hladina
Keyword(s):  
Experimental Data ◽  
Growth Rate ◽  
Kinetic Model ◽  
Gas Phase ◽  
Substrate Surface ◽  
Deposition Process ◽  
Hydrogen Atmosphere ◽  
Epitaxial Gaas ◽  
Kinetics Of ◽  
Good Agreement

The authors proposed and treated quantitatively a kinetic model for deposition of epitaxial GaAs layers prepared by reaction of trimethylgallium with arsine in hydrogen atmosphere. The transport of gallium to the surface of the substrate is considered as the controlling process. The influence of the rate of chemical reactions in the gas phase and on the substrate surface on the kinetics of the deposition process is neglected. The calculated dependence of the growth rate of the layers on the conditions of the deposition is in a good agreement with experimental data in the temperature range from 600 to 800°C.

Kinetics of arsenic-enhanced solid phase epitaxy in silicon

2004 ◽  
Vol 95 (8) ◽  
pp. 4427-4431 ◽  
Author(s):  
B. C. Johnson ◽  
J. C. McCallum
Keyword(s):  
Solid Phase ◽  
Solid Phase Epitaxy ◽  
Kinetics Of

Kinetics of solid phase epitaxy in thick amorphous Si layers formed by MeV ion implantation

1990 ◽  
Vol 57 (13) ◽  
pp. 1340-1342 ◽  
Author(s):  
J. A. Roth ◽  
G. L. Olson ◽  
D. C. Jacobson ◽  
J. M. Poate
Keyword(s):  
Ion Implantation ◽  
Solid Phase ◽  
Solid Phase Epitaxy ◽  
Amorphous Si ◽  
Kinetics Of

Solid phase epitaxy of implantation-induced amorphous layer in (11̄00)- and (112̄0)-oriented 6H-SiC

2001 ◽  
Vol 89 (3) ◽  
pp. 1986 ◽  
Author(s):  
Masataka Satoh ◽  
Yuuki Nakaike ◽  
Tomonori Nakamura
Keyword(s):  
Solid Phase ◽  
Amorphous Layer ◽  
Solid Phase Epitaxy

The Loss Kinetics of Substitutional Carbon in Si1-xCxRegrown by Solid Phase Epitaxy

2001 ◽  
Vol 40 (Part 1, No. 2A) ◽  
pp. 773-776 ◽  
Author(s):  
Yong Jeong Kim ◽  
Tae-Joon Kim ◽  
Tae-Kyung Kim ◽  
Byungwoo Park ◽  
Jong Han Song
Keyword(s):  
Solid Phase ◽  
Solid Phase Epitaxy ◽  
Kinetics Of

scholarly journals Effect of Non-Hydrostatic Stress on Kinetics and Interfacial Roughness During Solid Phase Epitaxial Growth in Si

1996 ◽  
Vol 441 ◽  
Author(s):  
William Barvosa-Carter ◽  
Michael J. Aziz
Keyword(s):  
Growth Rate ◽  
Epitaxial Growth ◽  
Uniaxial Compression ◽  
Solid Phase ◽  
Hydrostatic Stress ◽  
Uniaxial Stress ◽  
Cross Sectional ◽  
Time Resolved ◽  
Crystal Interface

AbstractWe report preliminary in-situ time-resolved measurements of the effect of uniaxial stress on solid phase epitaxial growth in pure Si (001) for the case of stress applied parallel to the amorphous-crystal interface. The growth rate is reduced by the application of uniaxial compression, in agreement with previous results. Additionally, the velocity continues to decrease with time. This is consistent with interfacial roughening during growth under stress, and is supported by both reflectivity measurements and cross-sectional TEM observations. We present a new kinetically-driven interfacial roughening mechanism which is consistent with our observations.

Epitaxy and Nucleation in Cu and Ag Doped Amorphous Si

1990 ◽  
Vol 205 ◽  
Author(s):  
J. S. Custer ◽  
Michael O. Thompson ◽  
D. J. Eaglesham ◽  
D. C. Jacobson ◽  
J. M. Poate ◽  
...  
Keyword(s):  
Solid Phase ◽  
Amorphous Material ◽  
Intrinsic Rate ◽  
Amorphous Layer ◽  
Solid Phase Epitaxy ◽  
Small Deviations ◽  
Random Nucleation ◽  
Low Concentrations ◽  
Critical Metal ◽  
Amorphous Si

AbstractThe competition between solid phase epitaxy and random nucleation during thermal annealing of amorphous Si implanted with the fast diffusers Cu and Ag has been studied. For low concentrations of these impurities, solid phase epitaxy proceeds with small deviations from the intrinsic rate and with the impurity remaining in the shrinking amorphous layer. At a critical metal concentration in the amorphous layer of ∼ 0.12 at.% rapid random nucleation occurs, halting epitaxy and transforming the remaining amorphous material to polycrystalline Si via grain growth. The nucleation rate is at least 8 orders of magnitude greater than the intrinsic homogeneous rate. At higher Cu concentrations nucleation is observed below the temperature needed for epitaxy (400°C). This nucleation, clearly caused by the presence of Cu or Ag in the layer, may be induced by the impurities exceeding the absolute stability concentration and starting to phase separate, leading to enhanced crystal Si nucleation in the metal rich regions.

Kinetics of NiSi Formation by Solid State Diffusion in Pt/NiCr/Si Via Growth of an Amorphous Cr-Rich Barrier Layer

1990 ◽  
Vol 205 ◽  
Author(s):  
B.K. Patnaik ◽  
Ju Hyeon Lee ◽  
D. Adams ◽  
G.A. Rozgonyi ◽  
N.R. Parikh ◽  
...  
Keyword(s):  
Growth Rate ◽  
Growth Stage ◽  
Amorphous Layer ◽  
Solid State Diffusion ◽  
Low Temperature Annealing ◽  
Prolonged Annealing ◽  
Transmission Electron ◽  
State Diffusion ◽  
Silicide Growth ◽  
Kinetics Of

AbstractWe have used Rutherford backscattering spectroscopy (RBS) to study the kinetics of NiSi growth during low temperature annealing of a Ni(Cr) layer on Si. During the silicide growth, a Cr-rich amorphous layer was formed between the silicide and the Ni(Cr) layers. This amorphous layer produces a slow and uniform silicide growth rate; the NiSi thickness was 60 nm after a 2h anneal at 475°C. After prolonged annealing, the amorphous layer recrystallized, causing very rapid silicide growth. When a thin (0.5 nm) layer of Pt was deposited between the Si and Ni(Cr) layers, the amorphous layer was thinner, the silicide growth rate was correspondingly greater and the rapid growth stage occurred earlier. The RBS data agreed qualitatively with transmission electron microscopy results for the growth of both the amorphous layer and the silicide.

Sign in / Sign up

Export Citation Format

Share Document