scholarly journals AQUIFER CHARACTERIZATION AND PHYSIOCHEMICAL ANALYSIS OF DISTRICT DERA GHAZI KHAN PUNJAB, PAKISTAN

2021 ◽  
Vol 36 (3) ◽  
pp. 47-57
Author(s):  
Waqas Shafiq ◽  
Hadayat Ullah ◽  
Muhammad Zaheer ◽  
Mubashir Mehmood ◽  
Umer Farooq ◽  
...  

The study area is located in the arid section of Punjab province, Pakistan. The accessibility of freshwater is the main problem in this area. The area is mainly flat and alluvial deposits are present down to 800 m. The groundwater is not fit for drinking because of its salinity. Hence, it is essential to mark the transition between fresh water and saltwater. Resistivity models were used to locate freshwater areas. The saltwater areas are between 10 and 30 m deep. Salt flats and clayrich deposits are visible on resistivity maps and were identified by low resistance values. After linking resistivity data and maps, it is determined that the south portion of the area has a freshwater aquifer, especially at a depth of 200 m. At this depth, the quality of water is very good, regardless of its mild salinity in some areas. The margin between salty and freshwater is set to no degree. This is dependent upon the recharge and usage of an aquifer. Groundwater pollution poses a severe threat to the city’s residents. Results from the physio-chemical analysis of the water samples confirm the presence of arsenic in excessive amounts in water samples and are outside the limits set by the WHO and NDWQS. Just two out of 10 samples are within the limits for safe drinking water. The results of this research are valued for groundwater management and the installation of tubular wells in freshwater areas for households and irrigation purposes.

2017 ◽  
Vol 2 (6) ◽  
pp. 42
Author(s):  
Abdulkadir A. Gidado ◽  
Ibrahim Halliru ◽  
Christiana Anawuese Kendeson ◽  
Yusuf Abdullahi

In a bid to ascertain the quality of water for human consumption in Kashere Metropolis, essential physico-chemical parameters were evaluated on samples of drinking water obtained from boreholes, pond and wells located at densely populated areas, labelled as: Kashere cattle market Pond, KP; Kashere cottage Hospital Borehole, HB; Kashere Market Borehole, MB; Federal University, Kashere (FUK) campus Borehole, CB; Kashere cottage Hospital Well, HW; Kashere Market Well, MW and FUK campus Well, CW. Standard procedure for the determination of chemical and physical characteristics of the water samples were used. The results of the investigated parameters in the samples were as follows: ρH 6.61‒7.96, Turbidity 0.0‒2568 FTU, Electrical Conductivity 60.5‒1151 Mhocm-1, Total Dissolved Solids (TDS) 25.9‒518.0 mgL-1, Ca 0.0033‒0.5446 ppm, Mg 0.0793‒1.2215 ppm, Cd 0.0010‒0.0030 ppm, Zn 0.0024‒0.l054 ppm, Pb 0.0002‒0.0026 ppm and Fe 0.0044‒0.5649 ppm. Except for the concentration of Fe (in CB; 0.5649 ppm), all the analyzed minor and major cations in the water samples were in very low concentration and below the permissible limits of WHO standard guidelines values for drinking water.  It is recommended that, water from the pond should be properly treated before consumption due to its high turbidity.  Also periodic assessment of the quality of drinking water from these water sources should be conducted, to ascertain that they are not contaminated by either or both organic and inorganic pollutants.


Author(s):  

The paper presents the results of the determination of heavy metals in drinking water samples from centralized water supply systems and wells of individual water supply of the Sverdlovsk region. It was found that the content of copper ions in the samples does not exceed its maximum permissible concentration, and the content of lead and cadmium ions in most samples is higher than the permissible norms. It is established that water samples from Nizhny Tagil and Serov are more contaminated with cadmium. The causes of drinking water pollution are discussed. It was found that the pollution of water from the centralized water supply systems with heavy metals is mainly due to the non-compliance of the operated water pipes with sanitary and hygienic requirements. Groundwater pollution is caused by the infiltration of industrial effluents containing heavy metals from storage and sedimentation tanks through soil. It is shown that numerous industrial enterprises in the Sverdlovsk region aggravate the process of pollution of surface and groundwater with heavy metals. The unsatisfactory quality of water in terms of the content of heavy metals in Sverdlovsk region is revealed. The authors dwell on the need to continue research to determine the content of other heavy metals in water and expand the geography of sampling in the region in order to assess more accurately the quality of water.


2020 ◽  
Vol 4 (2) ◽  
pp. 99
Author(s):  
Yaseen Ahmed Hamaamin ◽  
Jwan Bahadeen Abdullah

Water is vital for all forms of life on earth. Assessing the quality of water especially drinking water is one of the important processes worldwide which affect public health. In this study, the quality of drinking water in Sulaimani City is monitored for a study period of 1 year. A total number of 78 water samples were collected and analyzed for 17 physical and chemical properties of water supply system to the city. Samples of water are collected from the three main sources of drinking water for Sulaimani City (Sarchnar, Dukan line-1, and Dukan line-2) from February to August 2019. The results of physical and chemical parameters of collected water samples were compared with the World Health Organization and Iraqi standards for drinking water quality. The results of this study showed that mostly all parameters were within the standards except the turbidity parameter which was exceeded the allowable standards in some cases. This research concluded that, in general, the quality of drinking water at the three main sources of Sulaimani City is suitable and acceptable for drinking.


Author(s):  
Danjuma, Florence Yachim ◽  
Onaji, Ajegba Innocent ◽  
Ocheme Julius Okojokwu ◽  
Danladi Yakubu Papi

Lack of access to safe drinking water is a threat to public health and wellbeing of the people as it exposes them to risk of waterborne diseases. This study assessed the bacteriological quality of well water samples obtained from Zaria communities and compared the level of contamination between wells with internal wall casting (cast wells) and wells without internal wall casting (non-cast wells). Water samples from 142 wells were collected for a period of six months encompassing both rainy and dry seasons (July to September for rainy season and November to January for dry season). The water samples were collected and analysed for faecal contamination using membrane filtration technique. The water samples contained high density of bacterial counts ranging from 1.73x103±2.73x102 – 2.02x102±1.85x102cfu/100ml during the raining season and 4.17x102±3.07x101 – 1.39x103±3.27x102cfu/100ml during the dry season. Coliforms and E. coli were present in all the samples with  total coliform counts ranging from 1.06 x 103 – 2.12 x 104 cfu/100 ml and E. coli counts ranging from 5.10 X 102 – 5.0 X 104 cfu/100 ml Counts were higher during the raining season in all the locations compared to the dry season. Faecal coliform counts were higher in wells without casting (91.9%) compare to wells with casting (91.2%) while E. coli counts were higher in wells with casting (77.9%) compared to wells without casting (66.2%). There was no significant difference in the bacterial counts between cast and non-cast wells (p-values were all greater than 0.05).A total of 168 organisms were isolated from this study and they include; E. coli(48.3%), Klebsiella pnuemonaie(11.8%), Klebsiella ozanae(13.2%), Enterobacter agglomerans(11.8%), Enterobacter gergoviae(14.7%), Enterobacter aerogenes (8.8%), Citrobacter freundii(8.8%), Proteus mirabilis (5.9%), Serratia liquefaciens(10.3%) and Acinetobacter lwoffii (2.9%). E. coliwas isolated more frequently (48.3%) compared to other species and was more frequent in non-cast wells (50.0%) compared to cast wells (47.1%). Other species were more frequent in cast wells. The bacteria isolated from this study are mostly of enteric origin; these organisms acquire public health significance under certain conditions, therefore, their removal in drinking water should be given moderate priority. The wells in this study fail to meet the minimum standard for safe drinking water and are therefore not safe for domestic purposes especially for drinking purpose without adequate treatment.


2020 ◽  
Vol 150 ◽  
pp. 01006
Author(s):  
Najib El Khodrani ◽  
Serine Omrania ◽  
Abdrrahim Nouayti ◽  
Abdelmajid Zouahri ◽  
Ahmed Douaik ◽  
...  

The quality of water resources in Morocco is degraded by pollution from agriculture, industry and urbanization. In this work we have realized a comparative study of two groundwater pollution zones: M’nasra (Kenitra) and Sfafaa (Sidi Slimane). In general, the results of this study showed that most water wells are strongly mineralized as the conductivity far exceeds the standard of drinking water. Sodium chloride (NaCl) concentration is between 33.9 and 1184.6 mg / l and shows some of the wells are loaded with salts. The pH is generally basic in all wells. Pollution by nitrates two regions showed that the ground water is strongly affected M’nasra zone terms of the permeability of the soil of the city. The concentration of nitrate can reach high values compared to the results obtained on the ground water at Sfafaa zone whose nitrate concentrations around 20 mg/l. Further pollution of groundwater in the two regions of the shows values of organic matters that go far beyond the standards of drinking.


2019 ◽  
Vol 8 (3) ◽  
pp. 1-21
Author(s):  
Prasidha Raj Neupane ◽  
Iswor Bajracharya ◽  
Meera Prajapati ◽  
Hishila Sujakhu ◽  
Pramod Awal

Bottled water is generally considered safe for drinking. However, several studies have reported the substandard quality of bottled water. Physico-chemical assessment of ten different brands of bottled water distributed in Bhaktapur Municipality was carried out from January 2018 to March 2018. In total, one hundred bottled water samples consisting of ten different brands were collected randomly from various retail outlets. Eight selected physico-chemical and microbiological parameters were analysed following standard methods, and the results were compared with the Nepal Drinking Water Quality Standard (NDWQS) (2005). Out of one hundred samples, sixty-nine samples did not comply with the standard pH limit. Other physico-chemical parameters were found to comply with the standard though variations were observed in the concentrations among different brands. Microbial contamination was not found in any brands of the bottled water samples considered in this study. However, it is necessary to examine other contaminants such as heavy metals, minerals, and chemicals to know the overall quality of water. Moreover, the regulatory bodies are required to strictly monitor water processing companies for the maintenance of the quality of bottled water.


1992 ◽  
Vol 25 (2) ◽  
pp. 41-48 ◽  
Author(s):  
S. Rigal

From about 1960, numerous organic materials for the transport and storage of water appeared on the market. The reasons for this were their interesting mechanical properties, and their ease of use. Nevertheless, some organic materials may cause alteration of the quality of water in contact with them, due to an inadequate inertness. In France a protocol to allow a selection of these materials was drawn up, giving primary importance to the organoleptic test. This test is the first step of control which the product must satisfy. The Centre de Recherche et de Contrôle des Eaux de Paris, who drew up these requirements tests, has at its disposal a great deal of results concerning organoleptic behaviour of all types of materials. This inertness test is followed up by global chemical analysis, a study of cytotoxicity, and the research for mineral and organic micropollutants leached into the water by the material. The controlled material must meet the requirements for the whole test.


2017 ◽  
Vol 18 (5) ◽  
pp. 1606-1616 ◽  
Author(s):  
Md. Atikul Islam ◽  
Md. Ali Akber ◽  
Prosun Kumar Ghosh

Abstract Southwest coastal Bangladesh has an acute scarcity of safe drinking water. Both the government and non-government organizations are now promoting reverse osmosis based small scale desalination plants (SSDPs) to ensure safe drinking water. The aim of this study was to assess the physico-chemical and bacteriological quality of the desalination plants (DPs) installed in southwest coastal Bangladesh. Water samples were collected from the inlet and outlet of 10 DPs. The product water mostly complied with water quality standards. High levels of total dissolved solids (TDS) and electrical conductivity (EC) in feed water were reduced significantly after the treatment, although 10% and 20% of the product water samples respectively did not comply with the WHO drinking water standards for those parameters. Compliance of product water with the WHO and Bangladesh drinking water standards for chloride, bicarbonate and sodium were found in respectively 80%, 90% and 70% of the samples, although their concentrations in all the feed water samples were higher than both of the standards. About one-third of the DPs did not meet the drinking water standard for sodium, which may be an important health concern for the people consuming this water. Apart from one of the DPs, all of them complied with the standard for faecal coliform and Escherichia coli. Results suggest that proper maintenance of the SSDPs is necessary to ensure safe drinking water for the coastal population of southwest Bangladesh.


Author(s):  
Francesca Serio ◽  
Lucia Martella ◽  
Giovanni Imbriani ◽  
Adele Idolo ◽  
Francesco Bagordo ◽  
...  

Background: The quality of water for human consumption is an objective of fundamental importance for the defense of public health. Since the management of networks involves many problems of control and efficiency of distribution, the Water Safety Plan (WSP) was introduced to address these growing problems. Methods: WSP was applied to three companies in which the water resource assumes central importance: five water kiosks, a third-range vegetable processing company, and a residence and care institution. In drafting the plan, the terms and procedures designed and tested for the management of urban distribution systems were applied to safeguard the resource over time. Results: The case studies demonstrated the reliability of the application of the model even to small drinking-water systems, even though it involved a greater effort in analyzing the incoming water, the local intended use, and the possibilities for managing the containment of the dangers to which it is exposed. This approach demonstrates concrete effectiveness in identifying and mitigating the dangers of altering the quality of water. Conclusions: Thanks to the WSP applied to small drinking-water systems, we can move from management that is focused mainly on verifying the conformity of the finished product to the creation of a global risk assessment and management system that covers the entire water supply chain.


Sign in / Sign up

Export Citation Format

Share Document