scholarly journals Identification of strain effects in the activities of 234U / 238U in groundwater on the profile Irkutsk Baikal

Author(s):  
Sergey Rasskazov ◽  
◽  
E.P. Chebykin ◽  
A.M. Ilyasova ◽  
I.S. Chuvashova ◽  
...  
Keyword(s):  
2019 ◽  
Vol 2 (2) ◽  
pp. 1210-1220 ◽  
Author(s):  
Sun Jae Kim ◽  
Taner Akbay ◽  
Junko Matsuda ◽  
Atsushi Takagaki ◽  
Tatsumi Ishihara

2017 ◽  
Vol 1 (2) ◽  
Author(s):  
R. S. Alencar ◽  
K. D. A. Saboia ◽  
D. Machon ◽  
G. Montagnac ◽  
V. Meunier ◽  
...  

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Toshifumi Imajo ◽  
Takashi Suemasu ◽  
Kaoru Toko

AbstractPolycrystalline Ge thin films have attracted increasing attention because their hole mobilities exceed those of single-crystal Si wafers, while the process temperature is low. In this study, we investigate the strain effects on the crystal and electrical properties of polycrystalline Ge layers formed by solid-phase crystallization at 375 °C by modulating the substrate material. The strain of the Ge layers is in the range of approximately 0.5% (tensile) to -0.5% (compressive), which reflects both thermal expansion difference between Ge and substrate and phase transition of Ge from amorphous to crystalline. For both tensile and compressive strains, a large strain provides large crystal grains with sizes of approximately 10 μm owing to growth promotion. The potential barrier height of the grain boundary strongly depends on the strain and its direction. It is increased by tensile strain and decreased by compressive strain. These findings will be useful for the design of Ge-based thin-film devices on various materials for Internet-of-things technologies.


2021 ◽  
pp. 2007862
Author(s):  
Chia‐Tse Tai ◽  
Po‐Yuan Chiu ◽  
Chia‐You Liu ◽  
Hsiang‐Shun Kao ◽  
C. Thomas Harris ◽  
...  

Author(s):  
Maria C. Garcia Toro ◽  
Miguel L. Crespillo ◽  
Jose Olivares ◽  
Joseph T. Graham

2020 ◽  
Vol 31 (19) ◽  
pp. 195711 ◽  
Author(s):  
Barbara Farkaš ◽  
Nora H de Leeuw

2016 ◽  
Vol 685 ◽  
pp. 487-491 ◽  
Author(s):  
Mikhail Chukin ◽  
Marina Polyakova ◽  
Alexandr Gulin ◽  
Olga Nikitenko

It is shown that combination of strain effects leads to possessing the ultra-fine grain structure in carbon wire. The continuous method of wire deformation nanostructuring was developed on the basis of simultaneous applying of tension deformation by drawing, bending deformation when going through the system of rolls and torsional deformation on a continuously moving wire. One of the main advantages of the developed method is that various hardware devices and tools already applied for steel wire production can be used to implement this method thus simplifying its introduction to the current industrial equipment. The efficiency estimation of the developed continuous method of deformation nanostructuring was carried out using carbon wire with different carbon content. It is shown that the mechanical properties of the wire after combination of different kinds of strain can vary over a wide range. This method makes it possible to choose such modes of strain effect, which can provide the necessary combination of strength and ductile properties of carbon wire depending on its further processing modes and application.


Sign in / Sign up

Export Citation Format

Share Document