scholarly journals PERUBAHAN KUAT GESER TANAH LEMPUNG TANON PADA METODE ELEKTROOSMOSIS DENGAN VARIASI BEDA POTENSIAL

2020 ◽  
Vol 3 (2) ◽  
pp. 68
Author(s):  
Tri Nugraheni Handayani ◽  
Niken Silmi Surjandari ◽  
Noegroho Djarwanti

<p><em>Soft clay soil located in</em> Kalikobok<em> village, </em>Tanon, Sragen<em> is one of soil type that does not qualify to build a structural building on it, because the characters of soft clay soil that has height of water content which is causing the soil carrying capacity becomes low. In other way, if the water content is low, then it will increase the carrying capacity of the soil. Dewatering process is needed, one of the examples is by electroosmosis methods. Electroosmosis is a drainage method by force that drain the water from anode to cathode so it will fix the technical properties  of soil. In this study the variables used are the length of time of the electric current and the voltage. The variation of duration is three days and five days, the variation of potential difference that used is 0 volts, 4.5 volts, 9 volts, and 12 volts. The parameters that tested as a comparison are soil shear strength of soil at each voltage and position (anode, middle, cathode). The results showed that the greater application of potential differences can increase the values of c and </em><em>φ, but the value of c at the cathode position decrease due to water accumulation at the cathode. </em></p>

2018 ◽  
Vol 7 (1) ◽  
pp. 29-34
Author(s):  
Redaksi Tim Jurnal

Characteristics soft soil can cause instability and long-term degradation problems. This is because the soil has a low shear strength value and high compressibility. One type of soil belonging to the soft soil type is soft clay soil. Red soil belongs to the soft clay soil type. Therefore, the purpose of this research to determines the parameters of the shear strength of red soil in the area of Pakjo City Palembang, South Sumatra Province. The equipment had been used to obtain parameters of mechanical properties of red soil was using Triaxial apparatus. The results of the red soil properties index include: water content value (□ 27.70%, specific gravity value (Gs) 2.67, liquid limit value (LL) 66.00%, value of plastic limit of 25.13% and index value (IP) of 40.87% Classification of soil CH (USCS) and A-7-6 (AASHTO). The result of the Triaxial tests was the value of cohesion (c): 16.25-18, 15 kPa, and internal friction (□): 13.50-14.75⁰. The result of shear strength (□) : 17.68-24.02 kPa. The shear strength value of red soil indicates soil which includes soft soil (12.5-25 kPa).


2014 ◽  
Vol 803 ◽  
pp. 255-264
Author(s):  
Khairul Nizar Mohd Yusof ◽  
Fauziah Ahmad ◽  
Mohd Mustafa Al Bakri Abdullah ◽  
Muhammad Faheem Mohd Tahir

Clay soil is one of the problematic soils due to its natural states which have low bearing capacity and high compressibility. The effect and problem of the clay soil characteristic creates a problem for construction especially excessive settlement and this can lead to unstable and potential cracks of engineering structures. At presents, there are few of soil improvement types can be carried out to overcome these problems, and electro osmotic consolidation is one of the options. This method has been applied many years ago especially in european countries. The study encompasses the determination of water content, atterberg’s limits and undrained shear strength after electro osmotic consolidation treatment of clay soils taken from 0.5 m and 1.5 m at southwest part of johor. All the samples were tested according to BS1377:1990. An experimental study was implemented in a pvc cylinder tube having dimensions of 300 mm height and 100 mm diameter. In the results of electro osmotic consolidation tests by installing copper spring electrodes, the measured undrained shear strength was increased considerably at the anodes especially compared to the initial undrained shear strength due to electro osmosis process and consolidation. As laboratory studies of its measurement have shown, the application of electro osmotic consolidation after the application of a direct current applied voltage of 10 volts, at the anodes especially: (i) a decrease by approximately 35% in water content; (ii) an increase around 29% in undrained shear strength; and (iii) a decrease about 21% in index plasticity. The results obtained in this study shows that the electro osmotic enhanced 15 kpa vertical loading consolidation is a feasible approach in strengthening of south west soft clay in johor. It can be clearly suggested that the higher the voltage applied in the system, the higher readings of undrained shear strength and the lower of water content especially at the anodes.


Author(s):  
Reffanda Kurniawan Rustam ◽  
Ayu Resti ◽  
Herri Purwanto ◽  
Firdaus Muhammad
Keyword(s):  

2011 ◽  
Vol 3 (2) ◽  
pp. 71-75
Author(s):  
Saulius Malūnavičius

The article deals with the active surface materials (ASM) on the clay soil shear strength parameters, which are used in calculating the building base strength and stability of soil pressure in to supporting surface and slope stability. From the known mineral composition of clay soil was partially removed calcium compounds and were polluted of different concentration of pollutants and the values were compared. The analysis of active surface material substance influence on clay soil shows that higher concetration of pollutants in solution results in decreased soil cohesion, where the angle of internal friction remains various values.


2019 ◽  
Vol 24 (2) ◽  
pp. 113
Author(s):  
Paravita Sri Wulandari ◽  
Daniel Tjandra

Reservoir is needed as a source of water supply to the surrounding populations. The design of a reservoir needs to consider several aspects of soil embankment such as variations in water content and changes in shear soil shear strength and also the influence of water level in reservoir. The purpose of this research is to analyze these three aspects in the design of a reservoir. This research was begun by taking soil samples for embankment and conducting soil tests to obtain soil characteristics at the initial condition. The further laboratory tests were conducted to determine the effect of changes in water content on the shear strength of the soil. The variation of soil embankment characteristic was then modeled by Plaxis 2D program to obtain the effect of changes in soil embankment characteristic and fluctuation of the water level in the reservoir. The results showed that the increase in water content significantly decrease the shear strength of the soil. The changes of soil shear strength affect the pattern of slope failure and safety factor. In addition, the pattern and direction of the slope failure were also influenced by the water level of the reservoir.


2021 ◽  
Vol 14 (3) ◽  
pp. 131-140
Author(s):  
Shams Othman ◽  
Jasim M. Abbas

Chemical stabilization is one of the most alternative methods using on soil stabilization with various materials. In recent decades geopolymer has been attention from engineers and experts geotechnical to use it for improvement of soil, because of considered eco-friendly and cost-effective. This paper aims to investigate the influence of used MK-based Geopolymer in geotechnical engineering and to enhance the properties of soil. Where the MK is considered eco-friendly material and cost-effective compared to other materials. Different percentages of Metakaolin-based Geopolymer were used, which are 8, 10, 12, and 14%. It can be concluded that the peak value of strength illustrated when used MK of 10% with curing time 14 days. In addition, Scanning Electron Microscope (SEM) results show the clay particles covered by cementations compounds due to the reaction of the Geopolymer with clay which led to the production of binder particles.


2021 ◽  
Author(s):  
Alessandro Fraccica ◽  
Enrique Romero ◽  
Thierry Fourcaud

&lt;p&gt;Soil tensile strength plays an important role in the hydro-mechanical behaviour of earth structures and slopes interacting with the atmosphere. Shrinkage-induced cracking may be generated by drying/wetting cycles, with consequent faster water infiltration from the top of slopes and reduction of the safety factor. Vegetation roots were proven to increase soil shear strength, but less is known about their effects on soil tensile strength. For this purpose, new equipment has been designed and used to induce plant growth in compacted soil samples and to perform uniaxial tensile tests on the reinforced material. The equipment is composed of two cylindrical moulds linked by a soil bridge in which the tensile crack is induced due to geometrical restraints.&lt;/p&gt;&lt;p&gt;For this study, silty sand was chosen and compacted at a low dry density (&amp;#961;&lt;sub&gt;d&lt;/sub&gt; = 1.60 Mg/m&lt;sup&gt;3&lt;/sup&gt;) and at a water content w = 15%. After compaction, samples were gently poured with water up to a high degree of saturation (S&lt;sub&gt;r&lt;/sub&gt; &amp;#8776; 0.95) and low suction (s &amp;#8776; 1 kPa). Then, six of them were seeded with Cynodon dactilon, adopting fixed seeding density and spacing. Plants were irrigated and let to grow for three months: during this period, suction was monitored by a tensiometer. Seven fallow specimens were prepared following the same procedure, for comparison purposes.&lt;/p&gt;&lt;p&gt;When ready, samples were dried in a temperature/relative humidity-controlled room and left in the darkness for three hours, to attain and equalise the desired value of initial suction. Finally, the tensile stress was induced on the soil by a displacement rate of 0.080 mm/min. For each test, suction was continuously monitored by a tensiometer while the water content was checked at the beginning and at the end. Moreover, the void ratio and the root volume and area ratio were assessed close to the crack generated, at the end of each test.&lt;/p&gt;&lt;p&gt;The hydraulic state affected the soil mechanical response upon uniaxial extension: an increase of strength and a more brittle behaviour were observed as suction was increasing. At the same suction, a higher strength was systematically observed in the vegetated soil. In fact, even at very low suction (i.e. s = 1 kPa), vegetation roots induced a considerable increase in soil tensile strength (i.e. 10 kPa). The soil hydraulic state also affected the root failure mechanism. In wet soil, the roots subjected to tension were stretched and pulled-out whereas in dry soil they experienced a more immediate breakage (i.e. in concomitance with the cracking of the surrounding soil). Some preliminary PIV (Particle Image Velocimetry) analyses showed differences among dry/wet and fallow/vegetated soils. Indeed, a more diffuse strain field was observed in vegetated samples, thanks to the redistribution of stresses induced by the roots.&lt;/p&gt;&lt;p&gt;Results were successfully interpreted by a well-established shear strength criterion for partially saturated soils, considering the degree of saturation, suction and soil microstructure. An increase of the soil shear strength was observed and correlated to the presence of roots and to their geometrical and mechanical features. Moreover, good consistency was detected with results coming from other equipment.&lt;/p&gt;&lt;p&gt;&amp;#160;&lt;/p&gt;


2012 ◽  
Vol 204-208 ◽  
pp. 334-337
Author(s):  
Wei Jiang ◽  
Bing Xin Gu

Freeze-thaw made the microstructure of the soil produce a certain degree of damage, which was relevant with the soil water content. 6 kinds of remolded soil of the water content was prepared, at low temperature of freezed, in room temperature of melt, after not consolidated non-drained triaxial compression test, the soil shear strength parameters was determined. The results show: after thawed, soil shear strength had reduced significantly, and water content exerted such a pronounced effect on strength of reducing amplitude. Accordingly, the relationship of shear strength reducing after thawing of remolded soil and the water content was set up preliminarily.


2011 ◽  
Vol 2011 ◽  
pp. 1-14 ◽  
Author(s):  
Eltayeb Mohamedelhassan

This experimental study was carried out in two test series to investigate the feasibility of decreasing the water content and increasing the shear strength and axial load capacity of laboratory-prepared soft clay by electrokinetic treatment. The focus of the investigations is the influence of pore fluid chemistry (fresh or highly saline water) on the gained improvement and on the energy consumption. The results showed that electrokinetics was effective in improving the properties of the soft clay with fresh and saline water. The degree of improvement, however, was superior in tests with freshwaters along with a lower energy consumption. The minimum water content and the maximum shear strength after the treatment were reported near the anode (28% ± 3.6 and 99.3 kPa ± 15.4 compared to 49.7% ± 3.1 and 12.1 kPa ± 1.7 in the control). The maximum axial load capacity of the foundation model after the treatment was 416 N compared to 28 N in the control. The energy consumption varied between 69.1 and 1994.6 Whr.


Sign in / Sign up

Export Citation Format

Share Document