scholarly journals THE EFFECT OF MIXING ON THE PRODUCTION OF BIODIESEL FROM NEEM SEED OIL USING METHANOL AND HOMOGENEOUS CATALYST

2018 ◽  
Vol 6 (9) ◽  
pp. 451-457
Author(s):  
F. Sini ◽  
I. M Atadashi

Biodiesel was prepared through alkali-catalysed transesterification of neem seed oil using sodium hydroxide as catalyst and ethanol. This process of was carried out firstly throuch eserification and then via transesterification. The process was carried out by varying stirring speed (350, 450, 550, 650, 750 and 850 rpm.) and keeping other variables constant (temperature of 60oC, catalyst concentration of 1w/w%  and 6:1 oil to ethanol molar ratio). In this research work, a yield of 93w/w% was achieved at the stirring speed of 850 rpm. It was observed that the viscosity (3.73mm2/s at 400C) of neem oil methylester generated was within the limit (2-6mm2/s) specified by the American Society for Testing and Materials Standards. The density of neem biodiesel at ambient temperature (250C) was found to be 0.85g/ml, which is exactly close to the density of diesel (0.83g/ml). The Flash Point of the neem oil biodiesel produced was 153.60C which above the ASTM D6751 minimum standards for biodiesel fuel of 130oC. Furthermore, Neem oil biodiesel has a pour point of -40C and a cloud point of 20C. These values clearly indicate that the use of neem oil methyl esters in colder regions is limited. However, this value is also indicative of the high potential of this fuel as biodiesel particularly in Northern Nigeria where temperature is always above 20oC, a temperature at which the oil is fluid.

2019 ◽  
Author(s):  
Chem Int

Biodiesel produced by transesterification process from vegetable oils or animal fats is viewed as a promising renewable energy source. Now a day’s diminishing of petroleum reserves in the ground and increasing environmental pollution prevention and regulations have made searching for renewable oxygenated energy sources from biomasses. Biodiesel is non-toxic, renewable, biodegradable, environmentally benign, energy efficient and diesel substituent fuel used in diesel engine which contributes minimal amount of global warming gases such as CO, CO2, SO2, NOX, unburned hydrocarbons, and particulate matters. The chemical composition of the biodiesel was examined by help of GC-MS and five fatty acid methyl esters such as methyl palmitate, methyl stearate, methyl oleate, methyl linoleate and methyl linoleneate were identified. The variables that affect the amount of biodiesel such as methanol/oil molar ratio, mass weight of catalyst and temperature were studied. In addition to this the physicochemical properties of the biodiesel such as (density, kinematic viscosity, iodine value high heating value, flash point, acidic value, saponification value, carbon residue, peroxide value and ester content) were determined and its corresponding values were 87 Kg/m3, 5.63 Mm2/s, 39.56 g I/100g oil, 42.22 MJ/Kg, 132oC, 0.12 mgKOH/g, 209.72 mgKOH/g, 0.04%wt, 12.63 meq/kg, and 92.67 wt% respectively. The results of the present study showed that all physicochemical properties lie within the ASTM and EN biodiesel standards. Therefore, mango seed oil methyl ester could be used as an alternative to diesel engine.


Author(s):  
Lkama J. Drambi ◽  
Yusuf Mohammed

The study investigated the effects cutting fluids on tool wearing on high speed steel (HSS) using mild steel workpiece for teaching machining operation. Two specific objectives guided the study, two corresponding research questions were poised and two null hypotheses were formulated. The theoretical frame work for the study was hinged on experiential learning theory as propounded by Rogers (1969). The growing demand for biodegradable materials has opened an avenue for using vegetable oils such as neem seed oil, castor oil and water melon seed oil as an alternative to conventional cutting fluids. In this study, some aspects of the turning process on mild steel using HSS cutting tool at variety of spindle speed, feed rate and constant depth of cut were observed using neem seed oil, soluble oil and straight oil in comparison. The data collected from the study was analyzed using mean and analysis of variance (ANOVA). The decision rule was that, the smaller the mean value obtained the more effective the cutting fluid and the higher the mean value, the less effective the cutting fluid. The hypotheses were tested at α=0.05 significance level using analysis of variance (ANOVA). The findings of the study revealed that soluble oil is more effective in reducing tool wearing than neem oil and straight oil at variety of feed rates and spindle speeds during machining operation. Also there is no significant difference in the mean readings of tool wearing when using neem oil, soluble oil, and straight oil as cutting fluid. It was therefore recommended that machinists should be encouraged to use soluble oil which has greater advantage over neem and straight oils in machining operations


2016 ◽  
Vol 76 (4) ◽  
pp. 951-954 ◽  
Author(s):  
M. A. Formentini ◽  
L. F. A. Alves ◽  
M. E. Schapovaloff

Abstract Gyropsylla spegazziniana (Paraguay tea ampul) is one of the most important pests of Paraguay tea plants, and prohibition of synthetic insecticide use for control of this pest has led to the search for alternative methods. This laboratory study aimed to compare different control strategies for G. spegazziniana, utilizing a commercial neem seed oil product. Paraguay tea seedlings were treated with neem oil solution both pre- and post-infestation with 5th instar nymphs. The systemic action of neem oil was also evaluated by treating plant soil with the neem oil solution, followed by transfer of the insects to plants 24 h post-treatment. Spray treatments were effective against the pest, especially post-infestation (80% mortality), demonstrating the potential of neem oil for control of the Paraguay tea ampul. No significant effects were observed with respect to systemic activity.


2018 ◽  
Vol 6 (9) ◽  
pp. 442-450
Author(s):  
Mujidatu Ahmed Lira ◽  
Musa Idris Atadash

Biodiesel was produced from neem seed oil via a two-step process of esterification and transesterififcation reactions. The transesterification was carried out using CH3ONa as catalyst with ethanol as the alcohol. The reaction temperature was varied between 30, 40, 50, 60, and 700C, while all other process parameters were kept constant. From the results obtained, a significant change in biodiesel yield (73-79%) from 30-50oC temperatures was observed. At a temperature of 60oC, a good yield of 94% was obtained which was observed at a temperature below the boiling point of the alcohol used. At 70oC biodiesel yield of 67% was obtained; this indicates a drop in biodiesel yield. Further flash point of 149.60C indicated that the biodiesel produced is within the specification of ASTM D6751. Also, the high value of flash point indicated that the fuel is safe for handling as it exceeds the minimun ASTM requirement (130min). It is worthy to mention that other properties such as viscosity, pour point and cloud point etc investigated also presented good values which were within ASTM D6751. The formation of biodiesel was confirmed by FT-IR analysis. The conversion of the ester functional group into methyl esters in biodiesel verified the success of the reaction.


Author(s):  
Anusha P

Abstract: The consumption of edible oil is very high in the country and still the indigenous production does not meet the demand and considerable amount of edible oil is imported. Also, it is not advisable to divert these sources for biodiesel production. On the other hand, the non-edible oil resources could be a solution for biodiesel production. Non-edible oil from the plant seeds is the most promising alternative fuel for internal combustion engine because it is renewable, environment friendly, non-toxic, biodegradable has no sulphur and aromatics, has favourable combustion value and higher cetane number. Extensive work has been done on the transesterification of non-edible oils; however, no significant work has been done on the optimization of transesterification process, oil characterization and fuel analysis of most of the non-edible seed oils. Low cost and abundantly found non-edible oils such as Neem oil could be a better option for biodiesel processing. In the present work, optimization of transesterification process and analysis of biodiesel from non-edible oil was done; based on optimized protocol for biodiesel production from Neem seed oil converted into fatty acid methyl esters (FAME) through base catalyzed trans esterification using an optimum ratio of 1:6 (Oil : Methanol) at 600C. Biodiesel from these sources was analyzed for qualitative and quantitative characterization by using, GC-MS and FT-IR techniques. Based on qualitative and quantitative analysis of biodiesel, it is concluded that the biodiesel from these species can be feasible, cost effective and environment friendly. Keywords: Neem oil, Biodiesel, Tran’s esterification, GC-MS, and FT-IR.


HortScience ◽  
1993 ◽  
Vol 28 (7) ◽  
pp. 719-720 ◽  
Author(s):  
Harold E. Moline ◽  
James C. Locke

The antifungal properties of a hydrophobic neem (Azadirachta indica A. Juss.) seed extract (clarified neem oil) were tested against three postharvest apple (Malus domestica Borkh.) pathogens—Botrytis cinerea (pers.) ex Fr. (gray mold), Penicillium expansum Thom. (blue mold rot), and Glomerella cingulata (Ston.) Spauld. & Schrenk. (bitter rot). The antifungal activity of neem seed oil also was compared to that of CaCl2. A 2% aqueous emulsion of the clarified neem seed oil was moderately fungicidal to B. cinerea and G. cingulata in inoculated fruit, but bad little activity against P. expansum. Ethylene production was reduced 80% in fruit dipped in 2% neem seed oil compared to wounded, inoculated controls. Neem seed oil was as effective an antifungal agent as CaCl2, but the effects of the two combined were not additive.


2021 ◽  
Vol 913 (1) ◽  
pp. 012075
Author(s):  
A H Prianto ◽  
Budiawan ◽  
Y Yulizar ◽  
P Simanjuntak

Abstract Biopesticides are environmentally friendly solutions used for pest control management. This is a feature of Neem (Azadirachta indica) seed oil and tar, which provides a synergistic effect on the bioactivity of pyroligneous acid, and both are known to have bioactive compounds. Therefore, the purpose of this study was to evaluate the effect of neem seed oil and tar on pyroligneous acid from rice husks in conventional emulsion form, and their efficacy on the polyphagous insect Spodoptera litura. Neem seed oil was added at concentrations of 10, 20, 30, and 40%, while the concentration of tar was 0.5, 1.0, and 2.0%. The conventional emulsion formed was then characterized using a digital microscope. The addition of neem seed oil and tar were able to increase the antifeedant activity of pyroligneous acid by 63.6 % while both neem oil and tar by 72.6 %. The 2.0% tar formulation (N4PT2) showed the highest antifeedant activity against S.litura (97.9 %) and had the smallest droplets size ranges (2.90 - 24.16 µm). The addition of tar tends to reduce the droplet size of neem oil and increase antifeedant activity.


Energies ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 2562 ◽  
Author(s):  
Chia-Hung Su ◽  
Hoang Nguyen ◽  
Uyen Pham ◽  
My Nguyen ◽  
Horng-Yi Juan

This study investigated the optimal reaction conditions for biodiesel production from soursop (Annona muricata) seeds. A high oil yield of 29.6% (w/w) could be obtained from soursop seeds. Oil extracted from soursop seeds was then converted into biodiesel through two-step transesterification process. A highest biodiesel yield of 97.02% was achieved under optimal acid-catalyzed esterification conditions (temperature: 65 °C, 1% H2SO4, reaction time: 90 min, and a methanol:oil molar ratio: 10:1) and optimal alkali-catalyzed transesterification conditions (temperature: 65 °C, reaction time: 30 min, 0.6% NaOH, and a methanol:oil molar ratio: 8:1). The properties of soursop biodiesel were determined and most were found to meet the European standard EN 14214 and American Society for Testing and Materials standard D6751. This study suggests that soursop seed oil is a promising biodiesel feedstock and that soursop biodiesel is a viable alternative to petrodiesel.


2012 ◽  
Vol 11 (2) ◽  
pp. 129 ◽  
Author(s):  
Amir Awaluddin ◽  
Saryono ' ◽  
Sri Nelvia ◽  
Wahyuni '

The demand for petroleum has increased recently due to the increase of world population, industries andtransportation. Biodiesel (fatty acids methyl esters) has become attractive because of high price of petroleum,limited recourses of crude oil, and environmental concerns. Most biodiesel is produced by transesterification oftriglycerides of refined/edible type oils using methanol and homogeneous catalyst such NaOH and KOH. The useof heterogeneous calcined CaCO3 catalyst, has advantages such as the ease of phase separation betweencatalyst and biodiesel. This paper presents factors affecting the synthesis of biodiesel from crude palm using thecalcined CaCO3 catalyst . The synthesis is carried out by two steps, the acid-catalyzed pre-esterification of free-fatty acid and followed by base-catalyzed transesterification of triglycerides. A study of optimizing the reactioncondition of the esterification followed by transesterification of crude palm oil (CPO) is performed to obtainmaximum production of biodiesel. Under conditions of catalyst calcination temperature of 9000C, reactor time of1.5 hours, catalyst dosage of 1,5%, reaction temperature of 700C and methanol/oil molar ratio of 9 : 1, the oilconversion is 74,6%. The as-synthesized biodiesel meets the requirements of Indonesian National Standard (SNI)for biodiesel.


Sign in / Sign up

Export Citation Format

Share Document