scholarly journals Lightsaber: A Simulator of the Angular Sensing and Control System in LIGO

Galaxies ◽  
2021 ◽  
Vol 9 (3) ◽  
pp. 61
Author(s):  
Tomislav Andric ◽  
Jan Harms

The suspended test masses of gravitational-wave (GW) detectors require precise alignment to be able to operate the detector stably and with high sensitivity. This includes the continuous counter-acting of seismic disturbances, which, below a few Hertz, are not sufficiently reduced by the seismic isolation system. The residual angular motion of suspended test masses is further suppressed by the Angular Sensing and Control (ASC) system. However, in doing so, the angular motion can be enhanced by the ASC at higher frequencies where the seismic isolation system is very effective. This has led to sensitivity limitations between about 10 Hz and 25 Hz of the LIGO detectors in past observation runs. The observed ASC noise was larger than simple models predict, which means that more accurate detector models and new simulation tools are required. In this article, we present Lightsaber, a new time-domain simulator of the ASC in LIGO. Lightsaber is a nonlinear simulation of the optomechanical system consisting of the high-power cavity laser beam and the last two stages of suspension in LIGO including the ASC. The main noise inputs are power fluctuations of the laser beam at the input of the arm cavities, read-out noise of sensors used for the ASC, displacement noise from the suspension platforms, and noise introduced by the suspension damping loops. While the plant simulation uses local degrees of freedom of individual suspension systems, the control is applied on a global angular basis, which requires a conversion between the local and global bases for sensing and actuation. Some of the studies that can be done with this simulation concern mis-centering of the beam-spot (BS) position on the test masses, the role of laser power fluctuations for angular dynamics, and the role of the various nonlinear dynamics. The next important step following this work will be a detailed comparison between Lightsaber results and data from the control channels of the LIGO detectors.

Author(s):  
Tomislav Andric ◽  
Jan Harms

The suspended test masses of gravitational-wave (GW) detectors require precise alignment to be able to operate the detector stably and with high sensitivity. This includes the continuous counter-acting of seismic disturbances, which, below a few Hertz, are not sufficiently reduced by the seismic isolation system. The residual angular motion of suspended test masses is further suppressed by the Angular Sensing and Control (ASC) system. However, in doing so, the angular motion can be enhanced by the ASC at higher frequencies where the seismic isolation system is very effective. This has led to sensitivity limitations between about 10 Hz and 25 Hz of the LIGO detectors in past observation runs. The observed ASC noise was larger than simple models predict, which means that more accurate detector models and new simulation tools are required. We present Lightsaber, a new time-domain simulator of the ASC in LIGO. The simulation is a nonlinear simulation of the optomechanical system consisting of the high-power cavity laser beam and the last two stages of suspension in LIGO including the ASC. The main noise inputs are power fluctuations of the laser beam at the input of the arm cavities, read-out noise of sensors used for the ASC, displacement noise from the suspension platforms, and noise introduced by the suspension damping loops. While the plant simulation uses local degrees of freedom of individual suspension systems, the control is applied on a global angular basis, which requires a conversion between the local and global bases for sensing and actuation. Some of the studies that can be done with this simulation concern mis-centering of the beam-spot (BS) position on the test masses, the role of laser power fluctuations for angular dynamics, and the role of the various nonlinear dynamics.


RSC Advances ◽  
2017 ◽  
Vol 7 (74) ◽  
pp. 46615-46620 ◽  
Author(s):  
J. Kustra ◽  
E. Martin ◽  
D. Chateau ◽  
F. Lerouge ◽  
C. Monnereau ◽  
...  

Two-photon excitation of photobases is used to induce pH changes and control the condensation step of the sol–gel process at the focal point of a laser beam in a confocal configuration.


Author(s):  
R. F. Zeigel ◽  
W. Munyon

In continuing studies on the role of viruses in biochemical transformation, Dr. Munyon has succeeded in isolating a highly infectious human herpes virus. Fluids of buccal pustular lesions from Sasha Munyon (10 mo. old) uiere introduced into monolayer sheets of human embryonic lung (HEL) cell cultures propagated in Eagles’ medium containing 5% calf serum. After 18 hours the cells exhibited a dramatic C.P.E. (intranuclear vacuoles, peripheral patching of chromatin, intracytoplasmic inclusions). Control HEL cells failed to reflect similar changes. Infected and control HEL cells were scraped from plastic flasks at 18 hrs. of incubation and centrifuged at 1200 × g for 15 min. Resultant cell packs uiere fixed in Dalton's chrome osmium, and post-fixed in aqueous uranyl acetate. Figure 1 illustrates typical hexagonal herpes-type nucleocapsids within the intranuclear virogenic regions. The nucleocapsids are approximately 100 nm in diameter. Nuclear membrane “translocation” (budding) uias observed.


TAPPI Journal ◽  
2012 ◽  
Vol 11 (7) ◽  
pp. 37-46 ◽  
Author(s):  
PEDRO E.G. LOUREIRO ◽  
SANDRINE DUARTE ◽  
DMITRY V. EVTUGUIN ◽  
M. GRAÇA V.S. CARVALHO

This study puts particular emphasis on the role of copper ions in the performance of hydrogen peroxide bleaching (P-stage). Owing to their variable levels across the bleaching line due to washing filtrates, bleaching reagents, and equipment corrosion, these ions can play a major role in hydrogen peroxide decomposition and be detrimental to polysaccharide integrity. In this study, a Cu-contaminated D0(EOP)D1 prebleached pulp was subjected to an acidic washing (A-stage) or chelation (Q-stage) before the alkaline P-stage. The objective was to understand the isolated and combined role of copper ions in peroxide bleaching performance. By applying an experimental design, it was possible to identify the main effects of the pretreatment variables on the extent of metals removal and performance of the P-stage. The acid treatment was unsuccessful in terms of complete copper removal, magnesium preservation, and control of hydrogen peroxide consumption in the following P-stage. Increasing reaction temperature and time of the acidic A-stage improved the brightness stability of the D0(EOP)D1AP bleached pulp. The optimum conditions for chelation pretreatment to maximize the brightness gains obtained in the subsequent P-stage with the lowest peroxide consumption were 0.4% diethylenetriaminepentaacetic acid (DTPA), 80ºC, and 4.5 pH.


2014 ◽  
Vol 4 (2) ◽  
Author(s):  
Tamara Feldman

This paper is a contribution to the growing literature on the role of projective identification in understanding couples' dynamics. Projective identification as a defence is well suited to couples, as intimate partners provide an ideal location to deposit unwanted parts of the self. This paper illustrates how projective identification functions differently depending on the psychological health of the couple. It elucidates how healthier couples use projective identification more as a form of communication, whereas disturbed couples are inclined to employ it to invade and control the other, as captured by Meltzer's concept of "intrusive identification". These different uses of projective identification affect couples' capacities to provide what Bion called "containment". In disturbed couples, partners serve as what Meltzer termed "claustrums" whereby projections are not contained, but imprisoned or entombed in the other. Applying the concept of claustrum helps illuminate common feelings these couples express, such as feeling suffocated, stifled, trapped, held hostage, or feeling as if the relationship is killing them. Finally, this paper presents treatment challenges in working with more disturbed couples.


2020 ◽  
Vol 3 (11) ◽  
pp. 1100-1104
Author(s):  
Hussein Naeem Aldhaheri ◽  
Ihsan Edan AlSaimary ◽  
Murtadha Mohammed ALMusafer

      The Aim of this study was to determine Immunogenetic expression of  Toll-like receptor gene clusters related to prostatitis, to give acknowledge about Role of TLR in prostatitis immunity in men from Basrah and Maysan provinces. A case–control study included 135 confirmed prostatitis patients And 50 persons as a control group. Data about age, marital status, working, infertility, family history and personal information like (Infection, Allergy, Steroid therapy, Residency, Smoking, Alcohol Drinking, Blood group, Body max index (BMI) and the clinical finding for all patients of Prostatitis were collected. This study shows the effect of PSA level in patients with prostatitis and control group, with P-value <0.0001 therefore the study shows a positive significant between elevated PSA levels and Prostatitis.


Sign in / Sign up

Export Citation Format

Share Document