scholarly journals Effect of Iron Chloride on the Strength Behaviour of the Expansive Clay

From the fast few decades, several techniques were introduced inorder to modify the behaviour of expansive clays. The use of strong electrolytes like calcium chloride (CaCl2 ), aluminum trichloride (AlCl3 ) and iron chloride (FeCl3 ) were extensively used in various civil engineering applications. Expansive soils possesses alternate shrinkage and swelling with the removal and addition of water from it. Iron chloride was effectively used to alter the swelling and shrinkage and also improve the engineering behaviour of expansive clays. Therefore, in the current work an effort is made for study the influence of iron chloride (FeCl3 ) on the strength behaviour of the expansive soil. The outcomes from the laboratory investigation proved that the usage of iron chloride (FeCl3 ) produce reduction in swelling and improvement in the strength. It was found that 1% FeCl3 be the optimum for both the UCS and CBR. Hence, from the investigation it was showed that iron chloride is a valuable stabilizer to enhance the properties of black cotton soil and to create it apt for various applications of Civil Engineering.

2017 ◽  
Vol 3 (8) ◽  
pp. 610 ◽  
Author(s):  
Sadam Hussain

Swelling of expansive clays is one of the great hazards, a foundation engineer encounters. Each year expansive soils cause severe damage to residences, buildings, highways, pipelines, and other civil engineering structures. Strength and deformation parameters of soils are normally related to soil type and moisture. However, surprisingly limited focus has been directed to the compaction energy applied to the soil. Study presented herein is proposed to examine the effect of varying compaction energy of the engineering properties i.e. compaction characteristics, unconfined compressive strength, California bearing ratio and swell percentage of soil. When compaction energy increased from 237 KJ/m3 to 1197 KJ/m3, MDD increased from 1.61 g/cm3 to 1.75 g/cm3, OMC reduced from 31.55 percent to 21.63 percent, UCS increased from 110.8 to 230.6 KPa, and CBR increased from mere 1 percent to 10.2 percent. Results indicate substantial improvement in these properties. So, compacting soil at higher compaction energy levels can provide an effective approach for stabilization of expansive soils up to a particular limit. But if the soil is compacted more than this limit, an increase in swell potential of soil is noticed due to the reduction in permeability of soil.


2013 ◽  
Vol 649 ◽  
pp. 217-222
Author(s):  
Mircea Aniculaesi ◽  
Anghel Stanciu ◽  
Irina Lungu

The main factor that governs the shrink-swell behavior of expansive soils is the change in water content and the amount and type of clay size in the soil. In this paper, the research made are focused in reducing the swell potential of the studied clay by improvement in two ways: first by stabilization with a combination of eco-cement and Portland cement (1:1 ratio), and second by synthetic fiber reinforcement. A series of laboratory tests were performed on synthetic fiber reinforced expansive soil to determine the potential for using synthetic fiber reinforcement to reduce swell potential of soils. Specimens tested were prepared at two different synthetic fiber dosages 0.2% and 0.4%. The treatment of expansive clay with 5% eco-cement and 5% Portland cement revealed a better improvement of the swelling potential. The synthetic fiber reinforcement of the expansive soil doesn’t lead to a significant improvement of the soil.


2020 ◽  
Vol 8 (5) ◽  
pp. 1781-1785

Stabilization of black cotton soil is a challenging task for geotechnical engineers since such soil is highly vulnerable to expansive characteristics when the moisture content is increased. Due to its expansive nature, it is also called as swelling or expansive soils. Among the clay minerals, Montmorillonite is mainly responsible for such expansive characteristics. Bore log profile has a cluster of soil specimens including black cotton soil also which is unavoidable. Soil engineers have a serious concern about such expansive soil since it is treacherous for foundation of buildings. To overcome such deficiencies it becomes essential to stabilize the soil conditions. The commonly employed methods to decrease the expansive behaviour are: Chemical stabilization, Mechanical stabilization and installation of moisture barriers. In this paper, chemical stabilization method is adopted. Soil stabilizers, namely, sodium silicate, epoxy resin and polyvinyl alcohol are chosen and are mixed with black cotton soil in varying proportions of 5%, 10% and 15% to study the changes in geotechnical properties. From the results it is evident that polymer treated soils reduce plasticity characteristics and shows better results in geotechnical properties.


Author(s):  
Kamadi Subhadra and Dr. Ch Bhavannarayana

Expansive clay is a major source of undulations induced in any type of structures. Swelling of expansive soils causes serious problems and produces harm to many structures. Many research organizations are doing extensive work on waste materials concerning the viability and environmental suitability. Spent bleaching earth and misspend cement are waste derivatives from oil industry and cement warehouse. To avoid dumping problem and storage problems, it is the best method technique applied in expansive soils. Attempts are made to investigate the stabilization process identified in unconfined compressive strength and tri-axial compressive strength.Stability of any structure depends on strength properties of underground soil on which it is constructed. Structures basically transfer all the loads come on itself directly to the ground. If the underlying soil is not stable enough to support transferred loads then various types of failure occur such as settlement of the structure, cracks and so on. To solve this issue, soil improvement is necessary because it not only lowers the construction cost but also cuts the risk of any damage of structure later on. Numerous improvement methods can be adopted to make ordinary soil stable enough to support the structural loads. In this research work a number of tests may conduct using both ordinary soil and stabilised soil. This thesis explains the strength behavior of SBE treated black cotton soil reinforced with MC. The various percentage of SBE as 5%, 10%, 15%, 20% and 25% was used to find out the optimum value of RBI Grade. MC has been randomly included into the SBE treated soil at four different percentages of MC content, i.e. 2%, 4%, 6%, 8% and 10%.


2017 ◽  
Vol 23 (2) ◽  
pp. 124
Author(s):  
Wilis Diana ◽  
Edi Hartono ◽  
Anita Widianti

Expansive soils experience volumetric changes due to water content changes. These volumetric changes cause swell and shrink movement in soils, which in turn will inflict severe damage to structures built above them. A Proper understanding of how the expansive soil behaves during the wetting/drying process is essential for assessing the mitigation action of expansive soil hazard and design suitable foundation. The structures that build above expansive soil bed are susceptible to heave and to withstand swell pressure, thus the swell pressure must be considered in the design. This study focuses on swelling properties of two expansive clay from Ngawi, East Java and Wates, Yogyakarta. Laboratory test on disturbed samples is used to identified and to measured swelling properties. A series of swelling test was performed under constant soil dry density. The influence of initial water content and surcharge pressure on swelling properties (i.e swell percent and swell pressure) of compacted samples were investigated. The swelling properties test used ASTM standard 4546-03 method B. It was found that the lower initial water content the higher the swell percent, but the swell pressure seems not to be affected by initial water content. At the same initial water content, swell percent decrease with the increase of surcharge pressure, but swell pressure remains unchanged.


2018 ◽  
Vol 147 ◽  
pp. 07003
Author(s):  
David Simangunsong ◽  
Satrio Wibowo ◽  
Zufialdi Zakaria

Expansive soil is a kind of soil that has ability to shrinkage and swelling. According to Ronny (2014) Jatinangor area has expansive soil that is so very influential in the planning of infrastructure construction. This research aimed to measure the bearing capacity of the very expansive soils in Jatinangor area and to determine the correlation between activity number of soil and its bearing capacity. The method used is to collect the soil physics and mechanics data. Based on the soil mechanics data, the research location is divided into three zones of allowable bearing capacity, those are zone with allowable bearing capacity < 4 T/m2, zone with allowable bearing capacity 4-7 T/m2, and zone with allowable bearing capacity > 7 T/m2. The correlation between activity number and bearing capacity of soil follows the equation qa = -1.9505(A) + 6.957 with correlation coefficient is -0.7911.


2019 ◽  
Vol 8 (4) ◽  
pp. 9198-9202 ◽  

In this study the investigational results obtained in the laboratory on expansive soils treated with low-cost materials i.e, lime and press mud are used. It is conducted to check the signs of progress in the properties of expansive soil with Press Mud and lime in varying percentages. The test results such as the Unconfined compression test, liquid limit, plastic limit, shrinkage limit, hydrometer analysis and pH obtained on expansive clays mixed with different proportions of lime and press mud are presented and discussed in this work. From the demonstrated result the addition of Press mud with lime in soil stabilization improves the Unconfined Compressive strength of the soil when compared to lime stabilization alone. The index properties of the soil have also been marginally improved due to the addition of Press mud as an admixture.


2020 ◽  
Vol 195 ◽  
pp. 03006
Author(s):  
Arthur Gomes Dantas de Araujo ◽  
Nayara Torres Belfort ◽  
Felipe Araujo Silva Barbosa ◽  
Thalita Cristiana Rodrigues Silva ◽  
Silvio Romero de Melo Ferreira ◽  
...  

Expansive soils may present cracks arising from the drying process and their evolution can cause irreparable damages to engineering projects. Investigating this phenomenon is vital to understanding its geomechanics. The objective of this article is to present numerical modelling of the formation and propagation of cracks in expansive soil. A desiccation experiment was therefore carried out using an expansive silty clay from Paulista, in northeastern Brazil. The drying process was monitored by measuring the temperature and relative humidity of the air, as well as by capturing images with a camera. The digital images were correlated using the Ncorr numerical tool in MATLAB. As a result, this study made it possible to conclude that the soil cracking dynamics presented a non-orthogonal pattern during the dryness test, while the image treatment made it possible to observe the tendency of cracks to appear and propagate on the soil surface, allowing for the detection of crack growth and propagation trends.


2021 ◽  
Vol 6 (1) ◽  
pp. 15
Author(s):  
Bhanu Prakash Darsi ◽  
Kumar Molugaram ◽  
Saisantosh Vamshi Harsha Madiraju

The rapid growth of population and fast urbanization has resulted in the reduction of the good quality of available land. Black cotton (BC) soil is one of such problematic soils, though they are very fertile soils, they are not suitable for the foundation of roads and buildings. They are expansive clays with a high potential for shrinking or swelling as a result of changing moisture content. Due to the intensive shrink-swell process, surface cracks appear during dry seasons. A small amount of rainfall, such as 6mm can make these soils impassable for all traffic. About 23% of the area in India is covered by BC soil. To utilize expansive soils effectively, proper ground improvement techniques are to be adopted. One of the most widely used techniques is to stabilize the expansive soil with conventional admixtures like lime, GGBS, cement, and fly ash. In the present study, an attempt is made to modify the engineering properties of black cotton soil. This research work presents the improvement of engineering characteristics of expansive soils using Lime and GGBS as an additive. For experimental work, Lime of 2%, 4%, and 6% used and corresponding 5%, and 10% of GGBS is used. Tests like the California Bearing Ratio (CBR) test, Unconfined Compression Strength (UCS) test, proctor test, Atterberg’s limits performed. After stabilization, it was found that UCS and CBR of soil increased significantly.


Author(s):  
Ehab Hamad Sfoog ◽  
◽  
Alvin John Lim Meng Siang ◽  
Nahla Naji ◽  
Sim Sy Yi ◽  
...  

Expansive soils are found in typical areas in the world especially in arid and semi-arid regions. The problems associated with this type of soil drive geotechnical engineers to invent new technologies as remediation’s such as physical and chemical treatments. Innovative foundation techniques were also suggested for remedying the swell-shrink problems of the expansive soil. The granular pile anchor (GPA) is relatively a more favorable technique indebted to its cost-effective, easy and fast to assemble and most importantly was found to be more efficient in remedying the expansive soil. Despite the extensive studies on the expansive soil remedies, yet the granular pile anchor system requires more comprehensive and in-depth investigations. This study is aimed at developing a model with granular piles of various length and diameter extended to the stable zone to investigate the heave and uplift pressure in the expansive soil. For this purpose, experimental and numerical analysis were conducted in a small and in a full scale model respectively. A significant improvement was attained in heave reduction and an increment of uplift capacity. The findings also show that heave decreased significantly when the length and diameter of the GPA increases while the uplift capacity increased. However, it was noted that the extension of length to the stable zone resulted in insignificant changes. Therefore, it can be concluded that the maximum length of 6 m is the ideal length for GPA with different diameters according to foundations design requirement for this particular type of soil.


Sign in / Sign up

Export Citation Format

Share Document