Dust Dispersion Modeling of the Urban Environment Air nearby the Potash Production

2018 ◽  
Vol 878 ◽  
pp. 263-268
Author(s):  
G.V. Seimova ◽  
I.V. Stefanenko ◽  
M.S. Kalashnikova

Air pollution is one of the most significant problem and threats to human health worldwide. The most common pollutant is particulate matter (PM). For characteristics of the PM and their health effects, commonly used indicator is the mass concentration of particles with diameters less than 10 microns (PM10) and small dispersed suspended particles with diameter less than 2.5 microns (PM2.5), as such small particles are able to penetrate deep into the respiratory tract of the human body. The concentration of particles PM10 and PM2.5 in the air is subjected of rationing. This problem has been explored in many countries with the aim of possible reducing concentrations of PM10 and PM2.5 in the air.

2021 ◽  
Vol 35 (1) ◽  
pp. 28-40
Author(s):  
Jaehark Goo

Many fire-related casualties are caused by smoke inhalation. The particulate matter in smoke is deposited on the walls of the respiratory system, and adversely affects the human body through the respiratory and circulatory systems. In order to estimate the adverse effects of smoke particles on the human body, it is reasonable to consider the quantity of harmful substances from smoke particles that are absorbed by each region of the respiratory tract rather than the mass concentration of smoke particles in the air. This is because the absorption amount is a consequent factor that depends on a wide variety of other factors and is not solely determined by the causative factor, that is, the mass concentration in the air. In this study, the lung deposition loads of smoke particles from plastics, such as LDPE, PA66, PMMA, and PVC were quantified using the lung deposition load index (LDLIn), and the results were compared with the findings of conventional particulate matter (PM) mass concentration indices, such as PM2.5 mass and PM10 mass. The LDLIn value was calculated from the number of smoke particles generated during a fire that were deposited in each region of the respiratory tract for the given combustion materials and fire conditions. Herein, the LDLIn quantified the lung deposition load by reflecting the surface area concentration by particle size as well as the deposition characteristics in the respiratory tract according to particle size and breathing conditions. Even at the same PM mass concentration index value, each material and fire condition resulted in different LDLIn values according to the change in concentration distribution by particle size. The LDLIn values also varied depending on the breathing conditions.


2021 ◽  
Vol 10 (10) ◽  
pp. 2150
Author(s):  
Aleksandra Ratajczak ◽  
Artur Badyda ◽  
Piotr Oskar Czechowski ◽  
Adam Czarnecki ◽  
Michał Dubrawski ◽  
...  

A substantial proportion of airway disease’s global burden is attributable to exposure to air pollution. This study aimed to investigate the association between air pollution, assessed as concentrations of particulate matter PM2.5 and PM10 on the upper respiratory tract symptoms (URTS) in children. A nation-wide, questionnaire-based study was conducted in Poland in winter 2018/2019 in a population of 1475 children, comparing URTS throughout the study period with publicly available data on airborne particulate matter. A general regression model was used to evaluate the lag effects between daily changes in PM10 and PM2.5 and the number of children reporting URTS and their severity. PM10 and PM2.5 in the single-pollutant models had significant effects on the number of children reporting URTS. The prevalence of URTS: “runny nose”, “sneezing” and “cough” was positively associated with 12-week mean PM2.5 and PM10 concentrations. In the locations with the highest average concentration of PM, the symptoms of runny nose, cough and sneezing were increased by 10%, 9% and 11%, respectively, compared to the cities with the lowest PM concentrations. This study showed that moderate-term exposure (12 week observation period) to air pollution was associated with an increased risk of URTS among children aged 3–12 years in Poland. These findings may influence public debate and future policy at the national and international levels to improve air quality in cities and improve children’s health.


2017 ◽  
Vol 2017 (67) ◽  
pp. 31-37
Author(s):  
O. Turos ◽  
◽  
T. Maremukha ◽  
I. Kobzarenko ◽  
A. Petrosian ◽  
...  

2017 ◽  
Vol 17 (5) ◽  
pp. 1142-1155 ◽  
Author(s):  
Sabrina Rovelli ◽  
Andrea Cattaneo ◽  
Francesca Borghi ◽  
Andrea Spinazzè ◽  
Davide Campagnolo ◽  
...  

Author(s):  
Mohammad Hashem Askariyeh ◽  
Madhusudhan Venugopal ◽  
Haneen Khreis ◽  
Andrew Birt ◽  
Josias Zietsman

Recent studies suggest that the transportation sector is a major contributor to fine particulate matter (PM2.5) in urban areas. A growing body of literature indicates PM2.5 exposure can lead to adverse health effects, and that PM2.5 concentrations are often elevated close to roadways. The transportation sector produces PM2.5 emissions from combustion, brake wear, tire wear, and resuspended dust. Traffic-related resuspended dust is particulate matter, previously deposited on the surface of roadways that becomes resuspended into the air by the movement of traffic. The objective of this study was to use regulatory guidelines to model the contribution of resuspended dust to near-road traffic-related PM2.5 concentrations. The U.S. Environmental Protection Agency (EPA) guidelines for quantitative hotspot analysis were used to predict traffic-related PM2.5 concentrations for a small network in Dallas, Texas. Results show that the inclusion of resuspended dust in the emission and dispersion modeling chain increases prediction of near-road PM2.5 concentrations by up to 74%. The results also suggest elevated PM2.5 concentrations near arterial roads. Our results are discussed in the context of human exposure to traffic-related air pollution.


2018 ◽  
Author(s):  
Francis D. Pope ◽  
Michael Gatari ◽  
David Ng’ang’a ◽  
Alexander Poynter ◽  
Rhiannon Blake

Abstract. East African countries face an increasing threat from poor air quality, stemming from rapid urbanisation, population growth and a steep rise in fuel use and motorization rates. With few air quality monitoring systems available, this study provides the much needed high temporal resolution data to investigate the concentrations of particulate matter (PM) air pollution in Kenya. Calibrated low cost optical particle counters (OPCs) were deployed in Kenya in three locations: two in the capital of Nairobi and one in a rural location in the outskirts of Nanyuki, which is upwind of Nairobi. The two Nairobi sites consist of an urban background site and a roadside site. The instruments were composed of an Alphasense OPC-N2 optical particle counter (OPC) ran with a raspberry pi low cost microcomputer, packaged in a weather proof box. Measurements were conducted over a two-month period (February–March 2017) with an intensive study period when all measurements were active at all sites lasting two weeks. When collocated, the three OPC-N2 instruments demonstrated good inter-instrument precision with a coefficient of variance of 8.8 ± 2.0 % in the PM2.5 fraction. The low cost sensors had an absolute PM mass concentration calibration using a collocated gravimetric measurement at the urban background site in Nairobi. The mean daily PM1 mass concentration measured at the urban roadside, urban background and rural background sites were 23.9, 16.1, 8.8 µg m−3. The mean daily PM2.5 mass concentration measured at the urban roadside, urban background and rural background sites were 36.6, 24.8, 13.0 µg m−3. The mean daily PM10 mass concentration measured at the urban roadside, urban background and rural background sites were 93.7, 53.0, 19.5 µg m−3. The urban measurements in Nairobi showed that particulate matter concentrations regularly exceed WHO guidelines in both the PM10 and PM2.5 size ranges. Following a Lenschow type approach we can estimate the urban and roadside increments that are applicable to Nairobi. Median urban and roadside increments are 33.1 and 43.3 µg m−3 for PM10, respectively, the median urban and roadside increments are 7.1 and 18.3 µg m−3 for PM2.5, respectively, and the median urban and roadside increments are 4.7 and 12.6 µg m−3 for PM1, respectively. These increments highlight the importance of both the urban and roadside increments to urban air pollution in Nairobi. A clear diurnal behaviour in PM mass concentration was observed at both urban sites, which peaks during the morning and evening Nairobi rush hours; this was consistent with the high measured roadside increment indicating vehicular traffic being a dominant source of particulate matter in the city, accounting for approximately 48.1, 47.5, and 57.2 % of the total particulate matter loading in the PM10, PM2.5 and PM1 size ranges, respectively. Collocated meteorological measurements at the urban sites were collected, allowing for an understanding of the location of major sources of particulate matter at the two sites. The potential problems of using low cost sensors for PM measurement without gravimetric calibration available at all sites are discussed. This study shows that calibrated low cost sensors can be used successfully to measure air pollution in cities like Nairobi. It demonstrates that low cost sensors could be used to create an affordable and reliable network to monitor air quality in cities.


Nukleonika ◽  
2016 ◽  
Vol 61 (1) ◽  
pp. 75-83 ◽  
Author(s):  
Lucyna Samek ◽  
Zdzislaw Stegowski ◽  
Leszek Furman

Abstract Samples of PM10 and PM2.5 fractions were collected between the years 2010 and 2013 at the urban area of Krakow, Poland. Numerous types of air pollution sources are present at the site; these include steel and cement industries, traffic, municipal emission sources and biomass burning. Energy dispersive X-ray fluorescence was used to determine the concentrations of the following elements: Cl, K, Ca, Ti, Mn, Fe, Ni, Cu, Zn, Br, Rb, Sr, As and Pb within the collected samples. Defining the elements as indicators, airborne particulate matter (APM) source profiles were prepared by applying principal component analysis (PCA), factor analysis (FA) and multiple linear regression (MLR). Four different factors identifying possible air pollution sources for both PM10 and PM2.5 fractions were attributed to municipal emissions, biomass burning, steel industry, traffic, cement and metal industry, Zn and Pb industry and secondary aerosols. The uncertainty associated with each loading was determined by a statistical simulation method that took into account the individual elemental concentrations and their corresponding uncertainties. It will be possible to identify two or more sources of air particulate matter pollution for a single factor in case it is extremely difficult to separate the sources.


Author(s):  
Lili Wang ◽  
Qiulin Xiong ◽  
Gaofeng Wu ◽  
Atul Gautam ◽  
Jianfang Jiang ◽  
...  

Air pollution, including particulate matter (PM2.5) pollution, is extremely harmful to the environment as well as human health. The Beijing–Tianjin–Hebei (BTH) Region has experienced heavy PM2.5 pollution within China. In this study, a six-year time series (January 2013–December 2018) of PM2.5 mass concentration data from 102 air quality monitoring stations were studied to understand the spatio-temporal variation characteristics of the BTH region. The average annual PM2.5 mass concentration in the BTH region decreased from 98.9 μg/m3 in 2013 to 64.9 μg/m3 in 2017. Therefore, China has achieved its Air Pollution Prevention and Control Plan goal of reducing the concentration of fine particulate matter in the BTH region by 25% by 2017. The PM2.5 pollution in BTH plain areas showed a more significant change than mountains areas, with the highest PM2.5 mass concentration in winter and the lowest in summer. The results of spatial autocorrelation and cluster analyses showed that the PM2.5 mass concentration in the BTH region from 2013–2018 showed a significant spatial agglomeration, and that spatial distribution characteristics were high in the south and low in the north. Changes in PM2.5 mass concentration in the BTH region were affected by both socio-economic factors and meteorological factors. Our results can provide a point of reference for making PM2.5 pollution control decisions.


Author(s):  
Yongil Lee ◽  
Young-Chul Lee ◽  
Taesung Kim ◽  
Jin Choi ◽  
Duckshin Park

Hazards related to particulate matter (PM) in subway systems necessitate improvement of the air quality. As a first step toward establishing a management strategy, we assessed the physicochemical characteristics of PM in a subway system in Seoul, South Korea. The mean mass of PM10 and PM2.5 concentrations (n = 13) were 213.7 ± 50.4 and 78.4 ± 8.8 µg/m3, with 86.0% and 85.9% of mass concentration. Chemical analysis using a thermal–optical elemental/organic carbon (EC–OC) analyzer, ion chromatography (IC), and inductively coupled plasma (ICP) spectroscopy indicated that the chemical components in the subway tunnel comprised 86.0% and 85.9% mass concentration of PM10 and PM2.5. Fe was the most abundant element in subway tunnels, accounting for higher proportions of PM, and was detected in PM with diameters >94 nm. Fe was present mostly as iron oxides, which were emitted from the wheel–rail–brake and pantograph–catenary wire interfaces. Copper particles were 96–150 nm in diameter and were likely emitted via catenary wire arc discharges. Furthermore, X-ray diffraction analysis (XRD) showed that the PM in subway tunnels was composed of calcium carbonate (CaCO3), quartz (SiO2), and iron oxides (hematite (α-Fe2O3) and maghemite-C (γ-Fe2O3)). Transmission electron microscopy images revealed that the PM in subway tunnels existed as agglomerates of iron oxide particle clusters a few nanometers in diameter, which were presumably generated at the aforementioned interfaces and subsequently attached onto other PM, enabling the growth of aggregates. Our results can help inform the management of PM sources from subway operation.


Sign in / Sign up

Export Citation Format

Share Document