The Evolution Behavior of Defects in the Nanofilms of W/Cu and W Probed by Doppler Broadening Positron Annihilation Spectroscopy

2017 ◽  
Vol 373 ◽  
pp. 104-107
Author(s):  
Ling Wang ◽  
Ai Hong Deng ◽  
Kang Wang ◽  
Yong Wang ◽  
Xiao Bo Lu ◽  
...  

W/Cu multilayer nanofilms and pure W nanofilms were prepared in pure Ar and He/Ar mixing atmosphere by radio frequency magnetron sputtering method. The defect evolution of the samples was characterized by Doppler broadening positron annihilation spectroscopy (DB-PAS).The results show that plenty of defects can be produced by introducing helium (He) into W/Cu multilayer nanofilms. With the natural storage time increasing, the helium located in the near surface of W/Cu multilayer nanofilm would be released gradually and induce the coalescence of the helium related defects due to the diffusion of the helium and defects. In addition, the pure W nanofilms were irradiated by 30 keV helium ions and 40 keV hydrogen (H) ions in sequence at room temperature. From the DB-PAS analysis, it can be shown that a large number of vacancy-type defects are produced due to the He and/or H irradiation. H ions would be trapped by He related defects and produced He-H-V complexes.

2012 ◽  
Vol 331 ◽  
pp. 41-52 ◽  
Author(s):  
Andreas Wagner ◽  
Wolfgang Anwand ◽  
Maik Butterling ◽  
Thomas E. Cowan ◽  
Fine Fiedler ◽  
...  

A new type of a positron annihilation lifetime spectroscopy (PALS) system has been set up at the superconducting electron accelerator ELBE [ at Helmholtz-Zentrum Dresden-Rossendorf. In contrast to existing source-based PALS systems, the approach described here makes use of an intense photon beam from electron bremsstrahlung which converts through pair production into positrons inside the sample under study. The article focusses on the production of intense bremsstrahlung using a superconducting electron linear accelerator, the production of positrons inside the sample under study, the efficient detector setup which allows for annihilation lifetime and Doppler-broadening spectroscopy simultaneously. Selected examples of positron annihilation spectroscopy are presented.


2015 ◽  
Vol 1792 ◽  
Author(s):  
Jiantuo Gan ◽  
Augustinas Galeckas ◽  
Vishnukanthan Venkatachalapathy ◽  
Heine N. Riise ◽  
Bengt G. Svensson ◽  
...  

ABSTRACTCuxO thin films have been deposited on a quartz substrate by reactive radio frequency (rf) magnetron sputtering at different target powers Pt (140-190 W) while keeping other growth process parameters fixed. Room-temperature photoluminescence (PL) measurements indicate considerable improvement of crystallinity for the films deposited at Pt>170 W, with most pronounced excitonic features being observed in the film grown using Pt=190 W. These results corroborate well with the surface morphology of the films, which was found more flat, smooth and homogeneous for Pt >170 W films in comparison with those deposited at lower powers.


2007 ◽  
Vol 561-565 ◽  
pp. 1161-1164
Author(s):  
Xiao Na Li ◽  
Bing Hu ◽  
Chuang Dong ◽  
Xin Jiang

Fe/Si multi-layer films were fabricated on Si (100) substrates utilizing radio frequency magnetron sputtering system. Si/β-FeSi2 structure was found in the films after the deposition. Structural characterization of Fe-silicide sample was performed by transmission electron microscopy, to explore the dependence of the microstructure of β-FeSi2 film on the preparation parameters. It was found that β-FeSi2 particles were formed after the deposition without annealing, whose size is less than 20nm ,with a direct band-gap of 0.94eV in room temperature. After annealing at 850°C, particles grow lager, however the stability of thin films was still good.


2006 ◽  
Vol 957 ◽  
Author(s):  
Luis Manuel Angelats ◽  
Maharaj S Tomar ◽  
Rahul Singhal ◽  
Oscar P Perez ◽  
Hector J Jimenez ◽  
...  

ABSTRACTZn0.90Co0.10O and Zn0.85[Co0.50Fe0.50]0.15O targets were used to grow thin films by rf magnetron sputtering. XRD patterns of the films showed a strong preferred orientation along c-axis. Zn0.90Co0.10O film showed a transmittance above 75% in the visible range, while the transmittance of the Zn0.85[Co0.50Fe0.50]0.15O film was about 45%; with three absorption peaks attributed to d-d transitions of tetrahedrally coordinated Co2+. The band gap values for Zn0.90Co0.10O and Zn0.85[Co0.50Fe0.50]0.15O films were 2.95 and 2.70 eV respectively, which are slightly less than ZnO bulk. The Zn0.90Co0.10O film showed a relatively large positive magnetoresistance (MR) at the high magnetic field in the temperature range from 7 to 50 K, which reached 11.9% a 7K for the magnetoresistance. The lowest MR was found at 100 K. From M-H curve measured at room temperature shown a probable antiferromagnetic behavior, although was possible to observe little coercive field of 30 Oe and 40 Oe for Zn0.90Co0.10O and Zn0.85[Co0.50Fe0.50]0.15O films, respectively.


2004 ◽  
Vol 19 (23) ◽  
pp. 3951-3959 ◽  
Author(s):  
CORINE BAS ◽  
N. DOMINIQUE ALBÉROLA ◽  
MARIE-FRANCE BARTHE ◽  
JÉRÉMIE De BAERDEMAEKER ◽  
CHARLES DAUWE

A series of dense copolyimide membranes was characterized using positron annihilation spectroscopy. The positron annihilation lifetime spectroscopy performed on film with a classical positron source gives informations on the positronium fraction formed and also on the hole size within the film. The Doppler broadening spectra (DBS) of the gamma annihilation rays coupled with a variable energy positron beam allow the microstructural analyses as a function of the film depth. Experimental data were also linked to the chemical structure of the polyimides. It was found that the presence of the fluorine atoms strongly affects the positron annihilitation process and especially the DBS responses.


Sign in / Sign up

Export Citation Format

Share Document