TYRAMINE, HISTAMINE, AND TRYPTAMINE CONTENT OF CHEESE

1974 ◽  
Vol 37 (7) ◽  
pp. 377-381 ◽  
Author(s):  
M. N. Voigt ◽  
R. R. Eitenmiller ◽  
P. E. Koehler ◽  
M. K. Hamdy

Because of the increasing knowledge of the physiological importance of biologically active amines in man and the importance of the presence of these amines in cheese, this study was done to obtain quantitative information for tyramine, tryptamine, and histamine in cheese available in the United States. The tyramine, histamine, and tryptamine contents of 156 samples of cheese purchased at retail stores were quantitated by thin-layer chromatography and fluorescence measurements of NBD-chloride derivatives of the amines. Tyramine was found in 81 of 85 Cheddar cheese samples examined. Extra-sharp, sharp, and medium Cheddar cheese samples contained average tyramine values of 0.27, 0.21, and 0.24 mg/g, respectively. Average tyramine contents were lower in mild and processed Cheddar (0.09 and 0.11 mg/g, respectively). The highest Cheddar cheese tyramine content was 0.7 mg/g. Tyramine was consistently found in all cheeses except in unripened soft cheese (Cottage). Histamine concentrations varied from nondetectable amounts to 2.6 mg/g in a Sap-Sago cheese sample. Twenty-four Cheddar cheese samples contained histamine with the highest amount being 1.3 mg/g. A domestic Blue cheese contained 2.3 mg/g. Tryptamine was uniformly low or completely absent in the Cheddar cheese samples. The highest tryptamine concentration (1.1 mg/g) was detected in a Blue cheese.

1974 ◽  
Vol 57 (4) ◽  
pp. 852-857
Author(s):  
Robert D Stubblefield ◽  
Gail M Shannon

Abstract An international collaborative study involving 19 collaborators was conducted to test methods for the determination and chemical confirmation of aflatoxin M1 in dairy products. For the quantitative method, collaborators assayed samples of liquid and powdered milk, cheese, and butter containing low levels of M1. Statistical results indicated that sensitivity and precision of this method were comparable to other AOAC methods for aflatoxin M1. Impurities were present in blue cheese extracts that tended to interfere with thin layer chromatography. Analysis of liquid milk samples from different areas revealed that some milk extracts may require column chromatography. For the chemical confirmatory method, collaborators prepared acetate and hemiacetal derivatives of M1 in extracts of liquid milk and colby cheese. A sensitivity limit of 30 ng M1 was apparent for the method, and most collaborators easily identified the derivatives. As a result of this collaboration, both methods have been adopted as official first action methods.


Author(s):  
Dmitry Olegovich Bokov ◽  
Tatyana Yuryevna Kovaleva ◽  
Valentina Alekseevna Ermakova ◽  
Daria Aleksandrovna Trashchenkova ◽  
Ekaterina Anatolievna Dorovskih ◽  
...  

Filipendula ulmaria (L.) Maxim. (Meadowsweet) is known in traditional medicine as anti-inflammatory, wound-healing,astringent and antibacterial remedy. However recent studies show that it also has neurotropic activity. In Russia meadowsweet flowers are used as crude herbal drugs (temporary pharmacopoeial monograph 42-1777-87), also leafs and herb are used in the traditional medicine. Objective of the study was to carry out comparative investigation of composition and content of major biologically active compounds (BAC) in Filipendula ulmaria herb, flowers and leafs by thin-layer chromatography, differential spectrophotometry with aluminum chloride reagent (total flavonoids in terms of rutoside), gravimetry (total extractives, extracted by water), permanganatometric titration (total tannins in terms of tannin). Rutoside, tannin, gallic acid and salicylic acid were identified in Filipendula ulmaria herb, flowers and leafs by TLC. Also we analyzed content of substances extracted by water, flavonoids and tannins. Total extractives, extracted by water in F. ulmaria herb is 13.12±0.10%, in leafs – 13.98±0.37%, in flowers – 18.09±0.17%. Total tannins in F. ulmaria herb is 11.87±0.47%, in leafs – 12.06±0.18%, in flowers – 12.26±0.29%. Total flavonoids in F. ulmaria herb 4.34±0.17%, in leafs – 6.98±0.23%, in flowers – 11.75±0.57%. The obtained data will be used for development of a pharmacopoeial monograph project "Filipendula ulmaria (L.) Maxim., herba" for inclusion in the State Pharmacopoeia of the Russian Federation.


2020 ◽  
Vol 5 (443) ◽  
pp. 85-91
Author(s):  
Ibrayev M.K., ◽  
◽  
Takibayeva A.T., ◽  
Fazylov S.D., ◽  
Rakhimberlinova Zh.B., ◽  
...  

This article presents studies on the targeted search for new derivatives of azoles, such as benzthiazole, 3,5-dimethylpyrazole, 1,3,4-oxadiazole-2-thione, 1,3,4-thiadiazole. The possibility of combining in one molecule of the azole ring with other cyclic compounds: the alkaloid cytisine, morpholine, furan and some arenes has been studied. To obtain new compounds, the reactions of bromination, acylation, and interaction with isothiocyanates were studied. Optimal synthesis conditions were studied for all reactions. It was found that the reaction of 4-bromo-3,5-dimethylpyrazole with isothiocyanates, in contrast to the previously written derivatives of anilines, takes a longer time and requires heating the reaction mixture. The combination of a pirasol fragment with halide substituents often results in an enhanced therapeutic effect. The synthesized 2-bromine-N-(6-rodanbenzo[d]thiazole-2-yl)acetamide, due to the alkylbromide group, is an important synth in the synthesis of new benzthiazole derivatives. Its derivatives combine in one molecule the rest of rhodanbenzthiazole with alkaloid cytisine and biogenic amine morpholine and are potentially biologically active compounds, since the molecule structure contains several pharmacophoric fragments: benzthiazole and alkaloid (amine) heterocycles, rhodane and urea groups. The mechanism of formation of 1,3,4-oxadiazole-2-tyons from hydrazides under action on them by carbon disulfide was studied and assumed. It was shown that dithiocarbamates in acidic medium decompose with the release of hydrogen sulfide and the formation of highly reactive isothiocyanate group. Then, intra-molecular cyclization occurs, with the formation of end products - 1,3,4-oxadiazole-2-thions. The structures of the synthesized compounds were studied by 1H and 13C NMR spectroscopy. All synthesized substances are potentially biologically active compounds, since they contain several pharmacophore fragments in their structure.


HortScience ◽  
1998 ◽  
Vol 33 (3) ◽  
pp. 518d-518
Author(s):  
W. Letchamo ◽  
V.S. Krutilina

Echinace from the Asteracea family has been among the top 10 marketed herbs in North America and Europe. So far, only a limited amount of Echinace originate from commercial cultivation. Echinacea purpurea has been commercially cultivated in the United States since the mid 1970s, in Russia since 1935, while in Europe since the 1960s. However, there has been no published information in the English language on methods of cultivation, expected yields, limiting factors, nutrient requirements, and the optimum plant development stage to obtain maximum yield and concentration of the biologically active substances for pharmaceutical and cosmetic processing. The objective of this investigation was, therefore, to study the general distribution of major nutrients and biologically active substances and the relationship between the two groups, and the pattern of the accumulation of cichoric acid, echnacoside, isobutylamides (tetraenes) and essential oil in commercially cultivated Echinacea purpurea. There was a significant variation in the content of essential oil, cichoric acid, and isobutylamides (tetraenes) in different organs and stages of the plant development. Similarly, the difference in the distribution of N, P, K, Ca, Mg, and Fe in different organs and developmental stages is demonstrated. The correlation between the content of the active substances and nutrients is demonstrated, while recommendations for an optimum harvesting stage and date are made.


2019 ◽  
Vol 5 (4) ◽  
pp. 270-277 ◽  
Author(s):  
Vijay Kumar ◽  
Simranjeet Singh ◽  
Ragini Bhadouria ◽  
Ravindra Singh ◽  
Om Prakash

Holoptelea integrifolia Roxb. Planch (HI) has been used to treat various ailments including obesity, osteoarthritis, arthritis, inflammation, anemia, diabetes etc. To review the major phytochemicals and medicinal properties of HI, exhaustive bibliographic research was designed by means of various scientific search engines and databases. Only 12 phytochemicals have been reported including biologically active compounds like betulin, betulinic acid, epifriedlin, octacosanol, Friedlin, Holoptelin-A and Holoptelin-B. Analytical methods including the Thin Layer Chromatography (TLC), High-Performance Thin Layer Chromatography (HPTLC), High-Performance Liquid Chromatography (HPLC) and Liquid Chromatography With Mass Spectral (LC-MS) analysis have been used to analyze the HI. From medicinal potency point of view, these phytochemicals have a wide range of pharmacological activities such as antioxidant, antibacterial, anti-inflammatory, and anti-tumor. In the current review, it has been noticed that the mechanism of action of HI with biomolecules has not been fully explored. Pharmacology and toxicological studies are very few. This seems a huge literature gap to be fulfilled through the detailed in-vivo and in-vitro studies.


Symmetry ◽  
2021 ◽  
Vol 13 (3) ◽  
pp. 497
Author(s):  
Ewa D. Raczyńska

Keto-enol prototropic conversions for carbonyl compounds and phenols have been extensively studied, and many interesting review articles and even books appeared in the last 50 years. Quite a different situation takes place for derivatives of biologically active azulene, for which only scanty information on this phenomenon can be found in the literature. In this work, quantum-chemical studies have been undertaken for symmetrically and unsymmetrically substituted azulenols (constitutional isomers of naphthols). Stabilities of two enol (OH) rotamers and all possible keto (CH) tautomers have been analyzed in the gas phase {DFT(B3LYP)/6-311+G(d,p)} and also in aqueous solution {PCM(water)//DFT(B3LYP)/6-311+G(d,p)}. Contrary to naphthols, for which the keto forms can be neglected, at least one keto isomer (C1H, C2H, and/or C3H) contributes significantly to the tautomeric mixture of each azulenol to a higher degree in vacuo (non-polar environment) than in water (polar amphoteric solvent). The highest amounts of the CH forms have been found for 2- and 5-hydroxyazulenes, and the smallest ones for 1- and 6-hydroxy derivatives. The keto tautomer(s), together with the enol rotamers, can also participate in deprotonation reaction leading to a common anion and influence its acid-base properties. The strongest acidity in vacuo exhibits 6-hydroxyazulene, and the weakest one displays 1-hydroxyazulene, but all azulenols are stronger acids than phenol and naphthols. Bond length alternation in all DFT-optimized structures has been measured using the harmonic oscillator model of electron delocalization (HOMED) index. Generally, the HOMED values decrease for the keto tautomers, particularly for the ring containing the labile proton. Even for the keto tautomers possessing energetic parameters close to those of the enol isomers, the HOMED indices are low. However, some kind of parallelism exists for the keto forms between their relative energies and HOMEDs estimated for the entire molecules.


1982 ◽  
Vol 16 (6) ◽  
pp. 460-463
Author(s):  
A. A. Tsurkan ◽  
Z. F. Gromova ◽  
�. A. Rudzit ◽  
G. N. Neshchadit ◽  
D. A. Kulikova

Author(s):  
Deborah L. Thurston

Abstract A formal methodology is presented which may be used to evaluate design alternatives in the iterative design/redesign process. Deterministic multiattribute utility analysis is used to compare the overall utility or value of alternative designs as a function of the levels of several performance characteristics of a manufactured system. The evaluation function reflects the designers subjective preferences. Sensitivity analysis provides quantitative information as to how a design should be modified in order to increase its utility to the design decision maker. Improvements in one or more areas or performance and tradeoffs between attributes which would increase desirability of a design most may be quantified. A case study of materials selection and design in the automotive industry is presented. The methodology was applied to 6 automotive companies in the United States and Europe, and results are used to illustrate the steps followed in application.


Author(s):  
O.A. Bihdan ◽  
V.V. Parchenko

Current trends in the search for new biologically active compounds among synthetic molecules have arguably proved a priority in studies of the heterocyclic 1,2,4-triazole system. For many years, 1,2,4-triazole derivatives remain the object of close attention of scientists of various scientific fields. The unique properties of 1,2,4-triazole derivatives include high reactivity, which allows different modification of this system, practical absence of toxicity of these derivatives and the presence of a wide range of biological, pharmacological properties, which in the complex provides the prerequisites for the creation of new biologically active compounds, and in the future, active pharmaceutical ingredients (AFI). The aim of our work is to investigate some transformations in a number of derivatives of 5-(thiophen-3-ylmethyl) -4-R1-1,2,4-triazole-3-thiol, to study the physicochemical properties of the new synthesized compounds. A well-known fact remains the successful attempt of many scientists involved in the study of the heterocyclic 1,2,4-triazole system to synthesize potential biologically active compounds. The process of creating new molecules is very painstaking and requires considerable effort. The chemical approaches for the synthesis of the starting compounds required for further transformations are well known and described. Therefore, we used the corresponding N-R1-2 as intermediates for the synthesis of new 5-(thiophen-3-ylmethyl) -4-R1-1,2,4-triazole-3-thiols appropriate ones were used N-R1-2-(2-(thiophen-3-yl) acetyl) hydrazinocarbothioamide.


Sign in / Sign up

Export Citation Format

Share Document