scholarly journals Generation of Electricity from Biological Source

Author(s):  
Amey Kulkarni ◽  
Amit Breed

Rapid consumption of renewable energy resources has led to development of an alternative source of energy. Fuel cell technology is a reliable and sustainable source of energy which was developed. Microbial fuel cell is a type which uses active micro-organisms as catalysts for production of electricity. The micro-organisms degrade the organic substrate to release protons and electrons which generate a potential difference across the cell. Our study focused on the generation of electricity from human urine using microbial fuel cell system. Specific bacteria were used as inoculum at anaerobic anode chamber and salt solution was supplied at aerobic cathode. The chambers were connected using salt bridge which would facilitate ion transfer. This made the system cost effective. The potential difference generated was measured using digital multi-meter.




2021 ◽  
Vol 8 (1) ◽  
Author(s):  
Jamile Mohammadi Moradian ◽  
Zhen Fang ◽  
Yang-Chun Yong

AbstractBiomass is one of the most abundant renewable energy resources on the earth, which is also considered as one of the most promising alternatives to traditional fuel energy. In recent years, microbial fuel cell (MFC) which can directly convert the chemical energy from organic compounds into electric energy has been developed. By using MFC, biomass energy could be directly harvested with the form of electricity, the most convenient, wide-spread, and clean energy. Therefore, MFC was considered as another promising way to harness the sustainable energies in biomass and added new dimension to the biomass energy industry. In this review, the pretreatment methods for biomass towards electricity harvesting with MFC, and the microorganisms utilized in biomass-fueled MFC were summarized. Further, strategies for improving the performance of biomass-fueled MFC as well as future perspectives were highlighted.



2017 ◽  
Vol 13 (18) ◽  
pp. 242
Author(s):  
Adegunloye D. V ◽  
Olotu T. M

Generating electricity using microbial fuel cell powered by benthic mud collected from two locations in Akure was carried out. The locations were Riverbed of FUTA and Apatapiti area of Akure. This was achieved by building anode and cathode containers connected together by a salt bridge and an external circuit was made to transfer the electrons from the anode to the cathode. Bacteria and fungi were isolated from the benthic mud for eight days using standard microbiological techniques. Lactobacillus plantarum, Escherichia coli, Bacillus subtilis, Enterobacter aerogenes, Trichoderma sp, Mucor sp and Alterania sp; Lactobacillus plantarum, Escherichia coli, Pseudomonas aeruginosa, Bacillus subtilis, Myrothecium sp and Geotrichum candidum were bacteria and fungi isolated from the benthic mud of Apatapiti area and Riverbed of Futa, Akure respectively. This was used for the generation of electricity using unsterilized mud sample and the control setup was sterilized mud from same source. The set-up was monitored every 24hrous to determine the voltage and current generated. The pH, concentration and temperature were measured. The temperature remains constant throughout the experiment. The set-up were operated at a normal temperature of 27oC and 29oC for Riverbed of FUTA and Apatapiti area of Akure respectively. The peak voltage was between 182.5V and 192.5V and current produced from the main set-up was between 0.3A to 0.53A for Futa river bed while for Apatapiti area of Akure the peak voltage and current were 192.5V and 0.3A respectively. Higher microbial population, current and voltage were observed to be generated in River bed of Futa than Apatapiti area. The difference in the voltage and current and the control set-up shows that anaerobic microorganisms are capable of producing electricity from microbial fuel cell under appropriate conditions.



2015 ◽  
Vol 2015 ◽  
pp. 1-6 ◽  
Author(s):  
Jian-sheng Huang ◽  
Ping Yang ◽  
Chong-ming Li ◽  
Yong Guo ◽  
Bo Lai ◽  
...  

In order to study the effect of nitrite and nitrate on the performance of microbial fuel cell, a system combining an anaerobic fluidized bed (AFB) and a microbial fuel cell (MFC) was employed for high-strength nitrogen-containing synthetic wastewater treatment. Before this study, the AFB-MFC had been used to treat high-strength organic wastewater for about one year in a continuous flow mode. The results showed that when the concentrations of nitrite nitrogen and nitrate nitrogen were increased from 1700 mg/L to 4045 mg/L and 545 mg/L to 1427 mg/L, respectively, the nitrite nitrogen and nitrate nitrogen removal efficiencies were both above 99%; the COD removal efficiency went up from 60.00% to 88.95%; the voltage was about 375 ± 15 mV while the power density was at 70 ± 5 mW/m2. However, when the concentrations of nitrite nitrogen and nitrate nitrogen were above 4045 mg/L and 1427 mg/L, respectively, the removal of nitrite nitrogen, nitrate nitrogen, COD, voltage, and power density were decreased to be 86%, 88%, 77%, 180 mV, and 17 mW/m2 when nitrite nitrogen and nitrate nitrogen were increased to 4265 mg/L and 1661 mg/L. In addition, the composition of biogas generated in the anode chamber was analyzed by a gas chromatograph. Nitrogen gas, methane, and carbon dioxide were obtained. The results indicated that denitrification happened in anode chamber.



2014 ◽  
Vol 26 (5) ◽  
pp. 1473-1477 ◽  
Author(s):  
Jianping Cheng ◽  
Shaohua Chen ◽  
Zhiguo Tang ◽  
Ting Cheng ◽  
Jiaquan Wang


2020 ◽  
Vol 310 ◽  
pp. 123420 ◽  
Author(s):  
Khaled Elmaadawy ◽  
Jingping Hu ◽  
Shengxia Guo ◽  
Huijie Hou ◽  
Jikun Xu ◽  
...  


2013 ◽  
Vol 777 ◽  
pp. 92-95
Author(s):  
Wei Ping Liu ◽  
Xia Fei Yin

A continuous flow double chamber microbial fuel cell (MFC) for wastewater treatment was constructed. Anaerobic activated sludge was used as bacterial source and simulated organic wastewater was used as substrate. Effluent of anode chamber was used directly as influent of the cathode chamber. The aerobic microorganisms could degrade organic matters further. The electricity production and organic wastewater treatment of the MFC were studied. The results show that the wastewater chemical oxygen demand (COD) of the total removal rate was 74.1%~77.45%, the anode chamber in which the removal rate of COD is 32.2%~35.3%, and COD removal efficiency of aerobic biological treatment in the cathode chamber was 60.2%~66.7%. The continuous flow system could improve the removal rate further. The maximum current density of MFC was 1.56 mAm-2, the maximum output power was 24.336 mWm-2.



2010 ◽  
Vol 113-116 ◽  
pp. 286-290 ◽  
Author(s):  
Guang Zhao ◽  
Li Wei ◽  
Fang Ma ◽  
Hong Chua ◽  
Zhe Wang

The microbial fuel cell (MFC) constructed by a modified Continuous Stirred Tank Reactor (CSTR) which was used as acidification-phase of two-phase anaerobic digestion system. The experiment was operated as batch mode at mesophilic condition (35°C) to evaluate continue voltage output using cattle dung as substrate in hydrolysis-acidification process. The results illustrated that electricity generation increased noticeably to 300mV after 3 days operation, reached 430mV after 20 days and stabilized electricity generation from 420mV to 470mV in the following 70 days. The pH decreased from 7.15 to 6.65 after 15 days operation and maintained stability from 6.4 to 6.8. The main components of VFA in anode chamber were acetic, propionic and butiric acids. The dominating VFA was acetic acid that predominated untile day 50 and the maximum propionic acid concentration was 15% of total VFA.



2019 ◽  
Vol 92 (1) ◽  
pp. 60-72 ◽  
Author(s):  
Sofia Babanova ◽  
Jason Jones ◽  
Sujal Phadke ◽  
Mengqian Lu ◽  
Carlo Angulo ◽  
...  


Energies ◽  
2020 ◽  
Vol 13 (9) ◽  
pp. 2231 ◽  
Author(s):  
Hongjun Ni ◽  
Kaixuan Wang ◽  
Shuaishuai Lv ◽  
Xingxing Wang ◽  
Lu Zhuo ◽  
...  

The variation of substrate concentration in anode chamber directly affects the power generation efficiency and decontamination performance of microbial fuel cell (MFC). In this study, three concentrations of swine wastewater with 800 mg/L, 1600 mg/L and 2500 mg/L were selected as substrates, and the performance of MFC and response characteristics of anode microbial community were investigated. The results show that the concentration of a selected substrate is positively correlated with the output voltage of MFC and chemical oxygen demand (COD) removal rate. The microbial community diversity in the anode chamber and the performance of battery can be significantly affected when concentration changes in different ways, which helps to selectively cultivate the adaptable dominant bacteria to enhance the stability and decontamination performance of MFC. The community structure of anodic biofilm is mainly composed of Proteobacteria, Bacteroidetes, Firmicutes, Chloroflexi and Spirochaetae. These findings are meaningful to improve the treatment effects of swine wastewater and can help to find out the mechanism of varying concentration that influences the production of microorganisms in MFC.



Sign in / Sign up

Export Citation Format

Share Document