calcium carbonate precipitation
Recently Published Documents


TOTAL DOCUMENTS

488
(FIVE YEARS 198)

H-INDEX

46
(FIVE YEARS 8)

2022 ◽  
Vol 12 (1) ◽  
pp. 1-20
Author(s):  
X. Xu ◽  
H. Guo ◽  
M. Li ◽  
H. Fu

In microbially induced calcium carbonate precipitation (MICP) process, it is the precipitated CaCO3 that cements loose sand particles together to improve their mechanical properties. Seashell nacre composed of CaCO3 is a natural product, which is worth researching for its great hardness, strength, and toughness. However, there is no study connecting this natural nacre mineralization with MICP. Therefore, a precedent herein is established to modify the MICP process via the water-soluble matrix (WSM) extracted from nacre, where WSM contributes to the great mechanical properties of nacre. Correspondingly, this study examines the effects of WSM with different concentrations on urease activity and strength as well as microstructure of bio-cemented sand samples. The experimental results show that a small number of WSM (50mg/L) can improve the average strength of bio-cemented sand samples 1.5 times. This is because 50mg/L WSM can significantly improve the urease activity of bacteria meanwhile increasing the Ca2+ utilization rate. Thus, more CaCO3 crystals are precipitated, and the higher UCS of bio-cemented sand samples is achieved. Moreover, the XRD results indicate that the precipitated CaCO3 is almost calcite, and only a little aragonite is detected when the concentration of WSM increases to 100mg/L. Additionally, the SEM images demonstrate that WSM involvement can affect the shapes and sizes of CaCO3 crystals. Overall, this work is an unprecedented exploration imitating nacre that hopefully paves way for future studies.


2022 ◽  
Vol 8 ◽  
pp. 100061
Author(s):  
Fabiane S. Serpa ◽  
Gabriela M. Silva ◽  
Lucas F.L. Freitas ◽  
Elvio B. Melo Filho ◽  
Jailton F. Nascimento ◽  
...  

Author(s):  
Qianwen Liu ◽  
Brina Montoya

Microbially induced carbonate precipitation (MICP) is a sustainable biological process that catalyzes carbonate mineral precipitation within geomaterials. This study evaluates the performance and mechanisms of the MICP treatment for flocculating the oil sands fine tailings (FT). Column tests showed that the untreated FT did not decant during the 31 days. However, the MICP technique shortened the dewatering process. To elucidate the mechanisms of the MICP-induced flocculation of the FT, the diffuse double layer (DDL) thickness and microstructure of the specimens were evaluated. Three chemical equilibrium scenarios that gradually considered the MICP-biochemical reactions were explored to analyze the change of the DDL thickness. The results showed that increasing of ionic strength by urea hydrolysis decreased the DDL thickness. The fabric observation indicated that the specimens with the most calcium carbonate precipitation had the densest fabric. In summary, the MICP technique densified the fabric of FT via ureolysis process and precipitating minerals.


2022 ◽  
Author(s):  
Zhi-Hao Dong ◽  
Xiaohua Pan ◽  
Chao-Sheng Tang ◽  
Bin Shi

Abstract Rock weathering fractures in nature are complex and fracture healing is an effective strategy for rock weathering mitigation. This study is a first attempt to apply microbially induced calcium carbonate precipitation (MICP) technology in the healing of nature-weathering-like rough fractures (NWLRF). Sandstone was studied as an example due to it is a wide-spread construction, sculpture and monuments material all over the world. In order to achieve a high healing efficiency, a repeated mixture injection strategy was proposed. Based on a series of laboratory MICP injection experiments on four types of NWLRF, we systematically explored the fundamental micro-healing mechanism and the influence of factors including fracture aperture, characteristics of branch fractures, and cementation solution concentration. Experimental results demonstrated that MICP healing with the repeated mixture injection strategy had the ability to efficiently heal the penetrated NWLRF well with length in centimeter-scale and aperture in millimeter-scale, but cannot heal the non-penetrated branch fractures under low injection pressure. The repeated mixture injection strategy furtherly achieved a high apparent fracture healing ratio and a significant reduction of transmissivity. The apparent fracture healing ratios of all main fractures were higher than 80% and the maximum was 99.1%. Fracture transmissivity was reduced by at least three orders of magnitude from about 1×10-4 m2/s to less than 1×10-7 m2/s, and the highest reduction reached to four orders. For the aspect of the effects, larger cementation solution concentration, finer aperture and the existing of penetrated branch fracture were beneficial to improve the healing effect. Moreover, the MICP healing mechanism with high fracture healing ratio and significant reduction of transmissivity on sandstone NWLRF was also analyzed. The research results have important theoretical significance and technical guidance value for the disaster prevention and mitigation of rock weathering.


2022 ◽  
Vol 9 ◽  
Author(s):  
Jia He ◽  
Xunyu Mao ◽  
Yundong Zhou ◽  
Qiang Tang

Calcium carbonate precipitation and crystallization induced by urease enzyme to solidify soil is known as biocement technology. The uses of waste and cheap materials can make this technology more cost-effective and practical for applications. In this study, calcium ions were obtained by dissolving waste concretes in acidic liquid. Sand columns were treated by enzyme-induced carbonate precipitation (EICP) with either concrete-extracted calcium or reagent calcium for comparison. Compressive strengths, calcium carbonate contents, and microscopic analysis on the treated sand were carried out. It was found that the compressive strength of the former could reach 833 kPa in the dry state and 204 kPa in the wet state after 5 times of EICP treatment, both of which were higher than that of the latter. The calcium carbonate contents could reach 2–3% after 3–5 times of treatment. Based on the scanning electron microscope (SEM) and X-ray diffractometer (XRD) analyses, the crystal type of calcium carbonate produced in sand was calcite. The comparative results showed that the treatment effect using concrete-extracted calcium was similar or better than that using reagent calcium.


2021 ◽  
Vol 12 (1) ◽  
pp. 139
Author(s):  
Yang Zhao ◽  
Qian Wang ◽  
Mengnan Yuan ◽  
Xi Chen ◽  
Zhiyang Xiao ◽  
...  

Microbial-induced calcium carbonate precipitation (MICP) is a new soil remediation technology, which can improve the physical and mechanical properties of soil by transporting bacterial solution and cementation solution to loose soil and precipitating calcium carbonate precipitation between soil particles through microbial mineralization. Based on this technique, the effects of different fine particle content and pore ratio on the physical and chemical properties of silt after reinforcement were studied. The content of calcium carbonate, the ability of silt to fixed bacteria, unconfined compressive strength (UCS), permeability coefficient and microstructure of the samples were determined. The results showed the following: In the process of calcium carbonate precipitation induced by microorganisms, more than 50% bacterial suspension remained on the surface of silt particles and their pores. The higher the bacterial fixation rate of silt, the more CaCO3 was generated during the solidification process. The bacterial fixation rate and CaCO3 content both decreased with the increase in the pore ratio and increased with the increase in the fine particle content. XRD and SEM images show that the calcium carbonate is mainly composed of spherical vaterite and acicular cluster aragonite. There is an obvious correlation between unconfined compressive strength and CaCO3 content of silt. When CaCO3 content accumulates to a certain extent, its strength will be significantly improved. The unconfined compressive strength of silt A with pore ratio of 0.75 and fine particle content of 75% is 2.22 MPa when the single injection amount of cementing fluid is 300 mL. The permeability coefficient of cured silt can be reduced by 1 to 4 orders of magnitude compared with that of untreated silt. In particular, the permeability of MICP-treated silt A is almost impermeable.


Geotechnics ◽  
2021 ◽  
Vol 1 (2) ◽  
pp. 558-572
Author(s):  
Bhaskar C. S. Chittoori ◽  
Tasria Rahman ◽  
Malcolm Burbank

Expansive soils generally recognized as swell-shrink soils have been a problem for civil infrastructure for a long time. Engineers are in search of sustainable stabilization alternatives to counter these problematic soils. Microbial-induced calcium carbonate precipitation (MICP) is a promising biocementation process that can improve the properties of expansive soil through calcium carbonate precipitation. Past research has shown promise for the use of MICP in mitigating swelling distress from expansive soils. In this research, MICP via biostimulation was attempted by mixing enrichment and cementation solutions with soils in an effort to develop a new alternative to shallow chemical stabilization. Three soils with varying clay contents (30%, 40%, and 70%) and plasticity characteristics were selected, and soils were treated by mixing with enrichment solutions followed by cementation solutions. Five different mellowing periods, three different curing periods, and two types of cementation solutions were studied to optimize the method. Treatment effectiveness was evaluated using unconfined compression tests, calcium carbonate tests, and free swell index tests. Results showed that an increase in the mellowing period beyond two days was not beneficial for any of the three soils tested in this research. It was determined that the best improvement was observed at two days of mellowing and seven days of curing.


Sign in / Sign up

Export Citation Format

Share Document