A Broadband High-speed Programmable Multi-modulus Divider Based on CMOS Process

This paper introduces a design of a high-speed programmable multi-modulus divider (MMD) based on 65nm CMOS process. The design adopts the cascade structure of 7 level 2/3 frequency dividers, and expands the frequency division range by adjusting the number of cascade stages, so as to achieve a continuous frequency division ratio of 16 to 255. Among them, the first level 2/3 frequency divider adopts the D flip-flop design of CML (current mode logic) structure, the second level 2/3 frequency divider adopts the D flip-flop design of E-TSPC (extended true-single-phase-clock) structure. The whole circuit realizes the working frequency range of 13∼18GHz high frequency and large bandwidth. This design has completed layout drawing and parasitic parameter extraction simulation. The simulation results show that the operating frequency range of the circuit can reach 13∼18GHz. When the input signal is 18GHz and the frequency division ratio is 255, the phase noise is about -135dBc/Hz@1kHz. It has the advantages of high frequency, large bandwidth, and low phase noise.

A Reference-Sampling Based Calibration-Free Fractional-N PLL with A PI-Linked Sampling Clock Generator

Sampling-based PLLs have become a new research trend due to the possibility of removing the frequency divider (FDIV) from the feedback path, where the FDIV increases the contribution of in-band noise by the factor of dividing ratio square (N2). Between two possible sampling methods, sub-sampling and reference-sampling, the latter provides a relatively wide locking range, as the slower input reference signal is sampled with the faster VCO output signal. However, removal of FDIV makes the PLL not feasible to implement fractional-N operation based on varying divider ratios through random sequence generators, such as a Delta-Sigma-Modulator (DSM). To address the above design challenges, we propose a reference-sampling-based calibration-free fractional-N PLL (RSFPLL) with a phase-interpolator-linked sampling clock generator (PSCG). The proposed RSFPLL achieves fractional-N operations through phase-interpolator (PI)-based multi-phase generation instead of a typical frequency divider or digital-to-time converter (DTC). In addition, to alleviate the power burden arising from VCO-rated sampling, a flexible mask window generation method has been used that only passes a few sampling clocks near the point of interest. The prototype PLL system is designed with a 65 nm CMOS process with a chip size of 0.42 mm2. It achieves 322 fs rms jitter, −240.7 dB figure-of-merit (FoM), and −44.06 dBc fractional spurs with 8.17 mW power consumption.

A High-Speed Programmable Frequency Divider for a Ka-Band Phase Locked Loop-Type Frequency Synthesizer in 90-nm CMOS

A high-speed programmable frequency divider for a Ka-band phase-locked loop (PLL)-type frequency synthesizer system is presented and fabricated in 90 nm CMOS technology. It consists mainly of a divided-by-8/9 dual-modulus prescaler (DMP) and pulse swallow counters. An active-inductor-based source-coupled logic (SCL) D flip-flop (DFF) and the “OR” gate are used in the DMP in order to promote its locking range and operation frequency. The measured operation frequency range of the improved programmable frequency divider covers from 6 to 20 GHz with a low phase noise of less than −136 dBc/Hz at a 1 MHz offset of output signals, an optimum sensitivity of −27 dBm at 15 GHz, and a low power consumption of 9.1 mW.

Development and Evaluation of a Threshold-Based Motion Cueing Algorithm

In this paper, a motion cueing algorithm (MCA) without a frequency divider is proposed, which aims to reproduce the longitudinal reference acceleration as far as possible via tilt coordination. Using a second-order rate limit, the human perception thresholds can directly be taken into account when parameterizing the MCA. The washout is compensated by tilt coordination and means of feedback from the translational acceleration. The proposed MCA is compared with the classical washout algorithm and the compensation MCA based on selected qualitative metrics and their workspace demand. In addition, a subjective study on the evaluation of the MCA was conducted. The results show that even high washout rates are not noticeable by the test subjects. Overall, the MCA was rated as very good.