Analysis of Graphene/SiO2/p-Si Schottky Diode by Current–Voltage and Impedance Measurements

2018 ◽  
pp. 583-589
Author(s):  
Pramila Mahala ◽  
Ankita Dixit ◽  
Navneet Gupta
Keyword(s):  
Schottky Diode ◽  
Impedance Measurements ◽  
Current Voltage

The electrical characterization of Ag/PTCDA/PEDOT:PSS/p-Si Schottky diode by current–voltage characteristics

2013 ◽  
Vol 415 ◽  
pp. 77-81 ◽  
Author(s):  
Muhammad Tahir ◽  
Muhammad Hassan Sayyad ◽  
Fazal Wahab ◽  
Dil Nawaz Khan ◽  
Fakhra Aziz
Keyword(s):  
Schottky Diode ◽  
Electrical Characterization ◽  
Current Voltage ◽  
Current Voltage Characteristics

Study on Schottky Diode Characteristics Improving by X-Ray Irradiation

2013 ◽  
Vol 717 ◽  
pp. 113-116
Author(s):  
Sani Klinsanit ◽  
Itsara Srithanachai ◽  
Surada Ueamanapong ◽  
Sunya Khunkhao ◽  
Budsara Nararug ◽  
...  
Keyword(s):  
Leakage Current ◽  
Schottky Diode ◽  
Room Temperature ◽  
The Other ◽  
Low Power Consumption ◽  
Initial Value ◽  
X Ray ◽  
Forward Current ◽  
Current Voltage ◽  
Current Voltage Characteristics

The effect of soft X-ray irradiation to the Schottky diode properties was analyzed in this paper. The built-in voltage, leakage current, and work function of Schottky diode were investigated. The current-voltage characteristics of the Schottky diode are measured at room temperature. After irradiation at 70 keV for 55 seconds the forward current and leakage current are increase slightly. On the other hand, the built-in voltage is decrease from the initial value about 0.12 V. Consequently, this method can cause the Schottky diode has low power consumption. The results show that soft X-ray can improve the characteristics of Schottky diode.

Analysis of current–voltage and capacitance–voltage characteristics of Zr/p-Si Schottky diode with high series resistance

2020 ◽  
Vol 34 (10) ◽  
pp. 2050095
Author(s):  
Durmuş Ali Aldemir
Keyword(s):  
Barrier Height ◽  
Schottky Diode ◽  
Ideality Factor ◽  
Series Resistance ◽  
Zero Bias ◽  
Acceptor Concentration ◽  
Current Voltage ◽  
Capacitance Voltage ◽  
High Series ◽  
Contact Parameters

Zr/p-Si Schottky diode was fabricated by DC magnetic sputtering of Zr on p-Si. Zr rectifying contact gave a zero bias barrier height of 0.73 eV and an ideality factor of 1.33 by current–voltage measurement. The experimental zero bias barrier height was higher than the value predicted by metal-induced gap states (MIGSs) and electronegativity theory. The forward bias current was limited by high series resistance. The series resistance value of 9840 [Formula: see text] was determined from Cheung functions. High value of the series resistance was ascribed to low quality ohmic contact. In addition to Cheung functions, important contact parameters such as barrier height and series resistance were calculated by using modified Norde method. Re-evaluation of modified Norde functions was realized in the direction of the method proposed by Lien et al. [IEEE Trans. Electron Devices 31 (1984) 1502]. From the method, the series resistance and ideality factor values were found to be as 41.49 [Formula: see text] and 2.08, respectively. The capacitance–voltage characteristics of the diode were measured as a function of frequency. For a wide range of applied frequency, the contact parameters calculated from [Formula: see text]–[Formula: see text] curves did not exhibit frequency dependence. The barrier height value of 0.71 eV which was in close agreement with the value of zero bias barrier height was calculated from [Formula: see text]–[Formula: see text] plot at 1 MHz. The values of acceptor concentration obtained from [Formula: see text]–[Formula: see text] curves showed consistency with actual acceptor concentration of p-Si.

PHYSICAL ORIGINS OF 1/f NOISE IN Si δ-DOPED SCHOTTKY DIODES

2014 ◽  
Vol 13 (01) ◽  
pp. 1450003 ◽  
Author(s):  
ALEXEY V. KLYUEV ◽  
EVGENY I. SHMELEV ◽  
ARKADY V. YAKIMOV
Keyword(s):  
Experimental Data ◽  
Schottky Diode ◽  
Series Resistance ◽  
Schottky Diodes ◽  
Voltage Characteristic ◽  
Schottky Junction ◽  
Current Voltage Characteristic ◽  
Impurity Atoms ◽  
Current Voltage

A model of Schottky diode with δ-doping is suggested. The aim is the determination of technological areas of the diode, which are responsible for the 1/f noise. Series resistance of base and contacts, and the possible leakage are taken into account. Equivalent parameters of the diode are defined from the analysis of the current–voltage characteristic. The model of fluctuations in the charge of non-compensated donors in δ-layer of Schottky junction (ΔNs – model) and model of 1/f noise in leakage current are suggested for an explanation of experimental data. Our study show that, in the investigated diodes, in a million atomic impurities, there are about 1–10 special impurity atoms with stochastically modulated ionization energy.

In situ current-voltage characterization of swift heavy ion irradiated Au/n-GaAs Schottky diode at low temperature

2002 ◽  
Vol 157 (4) ◽  
pp. 367-374 ◽  
Author(s):  
R. Singh ◽  
S. K. Arora ◽  
J. P. Singh ◽  
D. Kanjilal
Keyword(s):  
Low Temperature ◽  
Schottky Diode ◽  
Heavy Ion ◽  
Swift Heavy Ion ◽  
Current Voltage
Sign in / Sign up

Export Citation Format

Share Document