Power Law Lubricant Consistency Variation with Pressure and Mean Temperature Effects in Roller Bearing

Author(s):  
N. Jalatheeswari ◽  
Dhaneshwar Prasad
1998 ◽  
Vol 130 (4) ◽  
pp. 463-471 ◽  
Author(s):  
A. LIAKATAS ◽  
D. ROUSSOPOULOS ◽  
W. J. WHITTINGTON

Temperature effects on cotton yield and fibre properties of three cotton cultivars were determined. Plants were grown in pots maintained in growth rooms at varying day and night temperatures representing seasonally constant or varying (C) or daily varying (V) regimes.Yield and fibre characters responded to variation of daily mean and amplitude of temperature. Mean temperature reduction improved yield components, but fibre length, uniformity, strength and micronaire were increased by high, particularly high day, temperatures. A large daily temperature amplitude produced an intermediate number of flowers and the lowest retention percentage.Fruiting and yield were increased by reduction in temperature down to the threshold mean temperature of 22°C. However, V-regimes with a low minimum temperature acted as a further drop (below 22°C) of temperature and adversely affected these characters. An adverse effect of low minimum temperature combined with a moderate day temperature was observed also on lint percentage and fibre properties.Varietal differences were more pronounced for highly heritable characters such as fibre properties, for which significant interactions between varieties and temperature also occurred. Differences in reproductive development were not sufficient to be of much practical importance.


1973 ◽  
Vol 60 (1) ◽  
pp. 141-159 ◽  
Author(s):  
T. Y. Chu ◽  
R. J. Goldstein

Overall heat transfer and mean temperature distribution measurements have been made of turbulent thermal convection in horizontal water layers heated from below. The Nusselt number is found to be proportional to Ra0·278 in the range 2·76 × 105 < Ra < 1·05 × 108. Eight discrete heat flux transitions are found in this Rayleigh number range. An interferometric method is used to measure the mean temperature distribution for Rayleigh numbers between 3·11 × 105 and 1·86 × 107. Direct visual and photographic observations of the fluctuating interferogram patterns show that the main heat transfer mechanism is the release of thermals from the boundary layers. For relatively low Rayleigh numbers (up to 5 × 105) many of the thermals reach the opposite surface and coalesce to form large masses of relatively warm fluid near the cold surface and masses of cold fluid near the warm surface, resulting in a temperature-gradient reversal. With increasing Rayleigh numbers, fewer and fewer thermals reach the opposite bounding surface and the thermals show persistent horizontal movements near the bounding surfaces. The central region of the layer becomes an isothermal core. The mean temperature distributions for the high Rayleigh number range are found to follow a Z−2 power law over a considerable range, where Z is the distance from the bounding surface. A very limited agreement with the theoretically predicted Z−1 power law is also found.


2012 ◽  
Vol 3 (1) ◽  
pp. 391-416
Author(s):  
S. V. Henriksson ◽  
P. Räisänen ◽  
J. Silen ◽  
H. Järvinen ◽  
A. Laaksonen

Abstract. Using a method of discrete Fourier transform with varying starting point and length of time window and the long time series provided by millennium Earth System Model simulations, we get good fits to power laws between two characteristic oscillatory timescales of the model climate: multidecadal (50–80 yr) and El Nino (3–6 yr) timescales. For global mean temperature, we fit β ~ 0.35 in a relation S(f) ~ f−β in a simulation without external climate forcing and β over 0.7 in a simulation with external forcing included. We also fit a power law with β ~ 8 to the narrow frequency range between El Nino frequencies and the Nyquist frequency. Regional variability in best-fit β is explored and the impact of choosing the frequency range on the result is illustrated. When all resolved frequencies are used, land areas seem to have lower βs than ocean areas on average, but when fits are restricted to frequencies below 1/(6 yr), this difference disappears, while regional differences still remain. Results compare well with measurements both for global mean temperature and for the Central England temperature record.


2004 ◽  
Vol 126 (4) ◽  
pp. 849-857 ◽  
Author(s):  
Jing Shi ◽  
C. Richard Liu

In literature, four models incorporating strain rate and temperature effects are able to generalize material test results of HY-100 steel. This study compares the four models, namely, Litonski-Batra, power law, Johnson-Cook, and Bodner-Partom, in finite element modeling of orthogonal machining of this material. Consistency is found in cutting forces, as well as in stress and temperature patterns in all but the Litonski-Batra model. However, the predicted chip curls are inconsistent among the four models. Furthermore, the predicted residual stresses are substantially sensitive to the selection of material models. The magnitudes, and even the sign of the residual stresses in machined surfaces, vary with different models.


10.14311/364 ◽  
2002 ◽  
Vol 42 (4) ◽  
Author(s):  
M. Červenka ◽  
M. Bednařík ◽  
P. Koníček

This paper deals with problems of nonlinear standing waves in axisymetrically shaped acoustic resonators where a mean temperature is distributed along the axis.


2007 ◽  
Vol 334-335 ◽  
pp. 669-672 ◽  
Author(s):  
Chun Ki Lam ◽  
Alan Kin Tak Lau ◽  
Li Min Zhou

Mechanical properties of nanoclay/epoxy composites (NC) have been studied by various experimental setups in bulk form recently. Creep mechanism of the NC is an important manufacturing criterion for the aircraft industry. In this paper, nanoindentation was employed to investigate the nano-mechanical creep effects on different wt. % of nanoclay contents in epoxy matrix. Creep behaviors of the nanoclay/epoxy composites with different wt. % of nanoclay contents were modeled by the power-law creep equation. Neglecting the temperature effects on creep, the stress exponents of tested composites were estimated.


2017 ◽  
Vol 825 ◽  
pp. 550-572 ◽  
Author(s):  
Chong Shen Ng ◽  
Andrew Ooi ◽  
Detlef Lohse ◽  
Daniel Chung

In thermal convection for very large Rayleigh numbers ($Ra$), the thermal and viscous boundary layers are expected to undergo a transition from a classical state to an ultimate state. In the former state, the boundary-layer thicknesses follow a laminar-like Prandtl–Blasius–Polhausen scaling, whereas in the latter, the boundary layers are turbulent with logarithmic corrections in the sense of Prandtl and von Kármán. Here, we report evidence of this transition via changes in the boundary-layer structure of vertical natural convection (VC), which is a buoyancy-driven flow between differentially heated vertical walls. The numerical dataset spans $Ra$ values from $10^{5}$ to $10^{9}$ and a constant Prandtl number value of $0.709$. For this $Ra$ range, the VC flow has been previously found to exhibit classical state behaviour in a global sense. Yet, with increasing $Ra$, we observe that near-wall higher-shear patches occupy increasingly larger fractions of the wall areas, which suggest that the boundary layers are undergoing a transition from the classical state to the ultimate shear-dominated state. The presence of streaky structures – reminiscent of the near-wall streaks in canonical wall-bounded turbulence – further supports the notion of this transition. Within the higher-shear patches, conditionally averaged statistics yield a logarithmic variation in the local mean temperature profiles, in agreement with the log law of the wall for mean temperature, and an $Ra^{0.37}$ effective power-law scaling of the local Nusselt number. The scaling of the latter is consistent with the logarithmically corrected $1/2$ power-law scaling predicted for ultimate thermal convection for very large $Ra$. Collectively, the results from this study indicate that turbulent and laminar-like boundary layer coexist in VC at moderate to high $Ra$ and this transition from the classical state to the ultimate state manifests as increasingly larger shear-dominated patches, consistent with the findings reported for Rayleigh–Bénard convection and Taylor–Couette flows.


Sign in / Sign up

Export Citation Format

Share Document