Methane concentrations in the Earth's prebiotic atmosphere

1996 ◽  
Vol 26 (3-5) ◽  
pp. 219-220 ◽  
Author(s):  
James F. Kasting ◽  
Lisa L. Brown
1991 ◽  
Vol 46 (4) ◽  
pp. 351-356
Author(s):  
Bernd M. Rode

Abstract Monte Carlo simulations of a system of 200 water and 24 NaCl molecules at 6 different densities in the range from 0.003 g/cm3 to 0.999 g,/cm3 and T = 125 °C and 225 CC were performed to obtain some insight into cluster formation which should precede and determine the formation of aerosol structures and has possibly played some role in prebiotic atmosphere chemistry. Solute hydration occurs already at very low concentrations mainly in the form of hydrated molecules ("contact ion pairs"). At higher densities larger cluster structures are observed, leading rather continuously to the structure of the supersaturated 7.1 M NaCl solution at the same temperature. Radial distribution functions, coordination numbers and particle interaction energies are discussed with respect to the simulation parameters density and temperature


2015 ◽  
Vol 8 (8) ◽  
pp. 3433-3445 ◽  
Author(s):  
J. R. Worden ◽  
A. J. Turner ◽  
A. Bloom ◽  
S. S. Kulawik ◽  
J. Liu ◽  
...  

Abstract. Evaluating surface fluxes of CH4 using total column data requires models to accurately account for the transport and chemistry of methane in the free troposphere and stratosphere, thus reducing sensitivity to the underlying fluxes. Vertical profiles of methane have increased sensitivity to surface fluxes because lower tropospheric methane is more sensitive to surface fluxes than a total column, and quantifying free-tropospheric CH4 concentrations helps to evaluate the impact of transport and chemistry uncertainties on estimated surface fluxes. Here we demonstrate the potential for estimating lower tropospheric CH4 concentrations through the combination of free-tropospheric methane measurements from the Aura Tropospheric Emission Spectrometer (TES) and XCH4 (dry-mole air fraction of methane) from the Greenhouse gases Observing SATellite – Thermal And Near-infrared for carbon Observation (GOSAT TANSO, herein GOSAT for brevity). The calculated precision of these estimates ranges from 10 to 30 ppb for a monthly average on a 4° × 5° latitude/longitude grid making these data suitable for evaluating lower-tropospheric methane concentrations. Smoothing error is approximately 10 ppb or less. Comparisons between these data and the GEOS-Chem model demonstrate that these lower-tropospheric CH4 estimates can resolve enhanced concentrations over flux regions that are challenging to resolve with total column measurements. We also use the GEOS-Chem model and surface measurements in background regions across a range of latitudes to determine that these lower-tropospheric estimates are biased low by approximately 65 ppb, with an accuracy of approximately 6 ppb (after removal of the bias) and an actual precision of approximately 30 ppb. This 6 ppb accuracy is consistent with the accuracy of TES and GOSAT methane retrievals.


1990 ◽  
Vol 5 (11) ◽  
pp. 2507-2514 ◽  
Author(s):  
A. T. Collins ◽  
M. Kamo ◽  
Y. Sato

Absorption and cathodoluminescence spectra have been recorded for single crystals of diamond and polycrystalline films of diamond, grown by microwave-assisted chemical vapor deposition (CVD) using methane and hydrogen. The investigation has been carried out to see to what extent the properties of CVD diamond are similar to those of conventional diamond, and to what extent they are unique. Studies have been made of the as-grown material, which has not been intentionally doped, and also samples that have been subjected to radiation damage and thermal annealing. The single crystals grown using methane concentrations of 0.5 to 1.0% exhibit bright blue “band A” emission and also intense edge emission, similar to the cathodoluminescence spectra of some natural type IIa diamonds. This implies that the crystals are relatively free from structural and chemical defects, a conclusion which is reinforced by the absence of any zero-phonon lines in the absorption spectra of crystals which have been subjected to radiation damage and annealing at 800 °C. Before radiation damage the spectrum does, however, reveal an absorption which increases progressively to higher energies, and which may be associated with sp2-bonded carbon. The Cathodoluminescence spectra after radiation damage indicate that the crystals contain some isolated nitrogen, and the detection of H3 luminescence, following thermal annealing at 800 °C, demonstrates for the first time that these samples contain small concentrations of nitrogen pairs. All of the polycrystalline films, grown using methane concentrations between 0.3 and 1.5%, have an absorption which increases progressively to higher energies, and which again is attributed to sp2-bonded carbon. This absorption is stronger in the films grown using higher methane concentrations. Films grown at a methane concentration of 0.3% also exhibit bright blue cathodoluminescence, although the edge emission is undetectably weak. The use of higher methane concentrations produces films with evidence in the cathodoluminescence spectra of nitrogen + vacancy and nitrogen + interstitial complexes, as well as optical centers unique to CVD diamond. One particular defect produces an emission and absorption line at 1.681 eV. By implanting conventional diamonds with 29Si ions it has been confirmed that this center involves silicon, and it has been shown that the 1.681 eV luminescence is relatively more intense in implanted diamonds which have a high concentration of isolated nitrogen.


2015 ◽  
Vol 8 (10) ◽  
pp. 11171-11207
Author(s):  
E. M. Buzan ◽  
C. A. Beale ◽  
C. D. Boone ◽  
P. F. Bernath

Abstract. This paper presents an analysis of observations of methane and its two major isotopologues, CH3D and 13CH4 from the Atmospheric Chemistry Experiment (ACE) satellite between 2004 and 2013. Additionally, atmospheric methane chemistry is modeled using the Whole Atmospheric Community Climate Model (WACCM). ACE retrievals of methane extend from 6 km for all isotopologues to 75 km for 12CH4, 35 km for CH3D, and 50 km for 13CH4. While total methane concentrations retrieved from ACE agree well with the model, values of δD–CH4 and δ13C–CH4 show a bias toward higher δ compared to the model and balloon-based measurements. Calibrating δD and δ13C from ACE using WACCM in the troposphere gives improved agreement in δD in the stratosphere with the balloon measurements, but values of δ13C still disagree. A model analysis of methane's atmospheric sinks is also performed.


2017 ◽  
Vol 4 (1) ◽  
pp. 83-86
Author(s):  
V. Mazánková ◽  
L. Töröková ◽  
D. Trunec ◽  
F. Krčma ◽  
S. Matejčík ◽  
...  

The exploration of planetary atmosphere is being advanced by the exciting results of the Cassin-Huygens mission to Titan. The complex chemistry revealed in such atmospheres leading to the synthesis of bigger molecules is providing new insights into our understanding of how life on Earth developed. This work extends our previous investigation of nitrogen-methane (N<sub>2</sub>-CH<sub>4</sub>) atmospheric glow discharge for simulation chemical processes in prebiotic atmospheres. In presented experiments 2 % of water vapor were addet to nitrogen-methane gas mixture. Exhaust products of discharge in this gas mixture were in-situ analysed by Fourier Transform Infra Red spectroscopy (FTIR). The major products identified in spectra were: hydrogen cyanide, acetylene and acetonitrile.


2020 ◽  
Author(s):  
Laura Stecher ◽  
Franziska Winterstein ◽  
Martin Dameris ◽  
Patrick Jöckel ◽  
Michael Ponater ◽  
...  

Sensors ◽  
2021 ◽  
Vol 21 (22) ◽  
pp. 7456
Author(s):  
Leonardo Furst ◽  
Manuel Feliciano ◽  
Laercio Frare ◽  
Getúlio Igrejas

Methane is a major greenhouse gas and a precursor of tropospheric ozone, and most of its sources are linked to anthropogenic activities. The sources of methane are well known and its monitoring generally involves the use of expensive gas analyzers with high operating costs. Many studies have investigated the use of low-cost gas sensors as an alternative for measuring methane concentrations; however, it is still an area that needs further development to ensure reliable measurements. In this work a low-cost platform for measuring methane within a low concentration range was developed and used in two distinct environments to continuously assess and improve its performance. The methane sensor was the Figaro TGS2600, a metal oxide semiconductor (MOS) based on tin dioxide (SnO2). In a first stage, the monitoring platform was applied in a small ruminant barn after undergoing a multi-point calibration. In a second stage, the system was used in a wastewater treatment plant together with a multi-gas analyzer (Gasera One Pulse). The calibration of low-cost sensor was based on the relation of the readings of the two devices. Temperature and relative humidity were also measured to perform corrections to minimize the effects of these variables on the sensor signal and an active ventilation system was used to improve the performance of the sensor. The system proved to be able to measure low methane concentrations following reliable spatial and temporal patterns in both places. A very similar behavior between both measuring systems was also well noticeable at WWTP. In general, the low-cost system presented good performance under several environmental conditions, showing itself to be a good alternative, at least as a screening monitoring system.


Sign in / Sign up

Export Citation Format

Share Document