Development of LC-MS-ESI-TOF method for quantification of phytates in food using 13C-labelled maize as internal standard

Author(s):  
Kristel Tanilas ◽  
Tiina Kriščiunaite
Keyword(s):  
Author(s):  
Songquan Sun ◽  
Richard D. Leapman

Analyses of ultrathin cryosections are generally performed after freeze-drying because the presence of water renders the specimens highly susceptible to radiation damage. The water content of a subcellular compartment is an important quantity that must be known, for example, to convert the dry weight concentrations of ions to the physiologically more relevant molar concentrations. Water content can be determined indirectly from dark-field mass measurements provided that there is no differential shrinkage between compartments and that there exists a suitable internal standard. The potential advantage of a more direct method for measuring water has led us to explore the use of electron energy loss spectroscopy (EELS) for characterizing biological specimens in their frozen hydrated state.We have obtained preliminary EELS measurements from pure amorphous ice and from cryosectioned frozen protein solutions. The specimens were cryotransfered into a VG-HB501 field-emission STEM equipped with a 666 Gatan parallel-detection spectrometer and analyzed at approximately −160 C.


Author(s):  
R.D. Leapman ◽  
S.Q. Sun ◽  
S-L. Shi ◽  
R.A. Buchanan ◽  
S.B. Andrews

Recent advances in rapid-freezing and cryosectioning techniques coupled with use of the quantitative signals available in the scanning transmission electron microscope (STEM) can provide us with new methods for determining the water distributions of subcellular compartments. The water content is an important physiological quantity that reflects how fluid and electrolytes are regulated in the cell; it is also required to convert dry weight concentrations of ions obtained from x-ray microanalysis into the more relevant molar ionic concentrations. Here we compare the information about water concentrations from both elastic (annular dark-field) and inelastic (electron energy loss) scattering measurements.In order to utilize the elastic signal it is first necessary to increase contrast by removing the water from the cryosection. After dehydration the tissue can be digitally imaged under low-dose conditions, in the same way that STEM mass mapping of macromolecules is performed. The resulting pixel intensities are then converted into dry mass fractions by using an internal standard, e.g., the mean intensity of the whole image may be taken as representative of the bulk water content of the tissue.


2018 ◽  
Vol 84 (12) ◽  
pp. 5-19
Author(s):  
D. N. Bock ◽  
V. A. Labusov

A review of publications regarding detection of non-metallic inclusions in metal alloys using optical emission spectrometry with single-spark spectrum registration is presented. The main advantage of the method - an extremely short time of measurement (~1 min) – makes it useful for the purposes of direct production control. A spark-induced impact on a non-metallic inclusion results in a sharp increase (flashes) in the intensities of spectral lines of the elements that comprise the inclusion because their content in the metal matrix is usually rather small. The intensity distribution of the spectral line of the element obtained from several thousand of single-spark spectra consists of two parts: i) the Gaussian function corresponding to the content of the element in a dissolved form, and ii) an asymmetric additive in the region of high intensity values ??attributed to inclusions. Their quantitative determination is based on the assumption that the intensity of the spectral line in the single-spark spectrum is proportional to the content of the element in the matter ablated by the spark. Thus, according to the calibration dependence constructed using samples with a certified total element content, it is possible not only to determine the proportions of the dissolved and undissolved element, but also the dimensions of the individual inclusions. However, determination of the sizes is limited to a range of 1 – 20 µm. Moreover, only Al-containing inclusions can be determined quantitatively nowadays. Difficulties occur both with elements hardly dissolved in steels (O, Ca, Mg, S), and with the elements which exhibit rather high content in the dissolved form (Si, Mn). It is also still impossible to determine carbides and nitrides in steels using C and N lines. The use of time-resolved spectrometry can reduce the detection limits for inclusions containing Si and, possibly, Mn. The use of the internal standard in determination of the inclusions can also lower the detection limits, but may distort the results. Substitution of photomultipliers by solid-state linear radiation detectors provided development of more reliable internal standard, based on the background value in the vicinity of the spectral line. Verification of the results is difficult in the lack of standard samples of composition of the inclusions. Future studies can expand the range of inclusions to be determined by this method.


Author(s):  
Bo Li ◽  
Jin Wang ◽  
Xinyao Dou ◽  
Xinjie Zhang ◽  
Xianbei Xue ◽  
...  

Aim and Objective:: An analytical method for the determination of mobocertinib, an investigational tyrosine kinase inhibitor, was developed and optimized by high-performance liquid chromatography-tandem mass spectrometry (LC-MS/MS) in rat plasma. Materials and Methods:: Plasma samples were pretreated by the protein precipitation method with a methanol solution of osimertinib as the internal standard (IS). Chromatographic separation was performed using an Inertsil ODS-3 column (50 mm × 4.6 mm, I.D. 5 μm) column with the temperature maintained at 40 °C. The mobile phase consisted of water (containing 0.1% formic acid) and methanol in a gradient mode at a flow rate of 0.5 mL/min. Mass spectrometric detection was carried out in the selected reaction monitoring (SRM) mode with positive electrospray ionization, and the mass transitions of mobocertinib and osimertinib were m/z 587.01 → 71.88 and m/z 499.80 → 71.94, respectively. The method was validated in terms of selectivity, linearity, accuracy and precision, extraction recovery and matrix effect, stability and carryover as per the guidelines for bioanalytical method validation (FDA, 2018). The method was applied to the pharmacokinetic study of mobocertinib in rats by oral gavage at the doses of 2, 6, and 18 mg/kg. A total of 216 plasma samples from 18 rats were analyzed. Results:: It showed good linearity over the range of 1-1000 ng/mL (R2 = 0.9957). The intra-batch accuracy was within 94.65-102.59% and the precision was within 5.49-10.46%. The inter-batch accuracy was within 97.08-102.25% with a precision of 7.54-10.13%. The extraction recovery and matrix factor were acceptable for the bioanalysis of mobocertinib. Additionally, mobocertinib was found to be stable under the detected conditions. Mobocertinib showed linear pharmacokinetic characteristics following oral administration to rats at 2.0-18.0 mg/kg. Conclusion:: The developed and validated method was successfully employed in the pharmacokinetic study in rats following oral administration of mobocertinib at the doses of 2, 6, and 18 mg/kg.


2020 ◽  
Vol 17 (2) ◽  
pp. 117-130 ◽  
Author(s):  
Mehdi Kalhor ◽  
Zohre Zarnegar ◽  
Zahra Seyedzade ◽  
Soodabeh Banibairami

Background: SO3H-functionalized zeolite-Y was prepared and used as a catalyst for the synthesis of 2-aryl-N-benzimidazole-4-thiazolidinones and tri-substituted imidazoles at ambient conditions. Objective: The goals of this catalytic method include excellent yields and high purity, inexpensive procedure and ease of product isolation, the use of nontoxic and heterogeneous acid catalyst, shorter reaction times and milder conditions. Materials and Methods: NMR spectra were recorded on Brucker spectrophotometer using Me4Si as internal standard. Mass spectra were recorded on an Agilent Technology 5975C VL MSD with tripe-axis detector. FTIR spectra were obtained with KBr disc on a galaxy series FT-IR 5000 spectrometer. The surface morphology of nanostructures was analyzed by FE-SEM (EVO LS 10, Zeiss, Carl Zeiss, Germany). BET analysis were measured at 196 °C by a Japan Belsorb II system after the samples were vacuum dried at 150°C overnight. Results: The NSZ was characterized by FT-IR, FESEM, EDX, XRF, and BET. The catalytic activity of NSZ was investigated for synthesis of 1,3-tiazolidin-4-ones in H2O/Acetone at room temperature. Moreover, NSZ was used for synthesis of tri-substituted imidazoles at 60 °C via solvent-free condensation. Different kinds of aromatic aldehydes were converted to the corresponding of products with good to excellent yields. Conclusion: Sulfonated zeolite-Y was as an efficient catalyst for the preparation of N-benzimidazole-2-aryl-1,3- thiazolidin-4-ones and 2,4,5-triaryl-1H-imidazoles. High reaction rates, elimination toxic solvent, simple experimental procedure and reusability of the catalyst are the important features of this protocol.


2020 ◽  
Vol 16 (6) ◽  
pp. 752-762
Author(s):  
Vivek Nalawade ◽  
Vaibhav A. Dixit ◽  
Amisha Vora ◽  
Himashu Zade

Background: Food and herbal extracts rich in Quercetin (QRT) are often self-medicated by diabetics and can potentially alter the pharmacokinetics (PK) of Metformin HCl (MET) and Canagliflozin (CNG) leading to food or herb-drug interactions and reduced therapeutic efficacy. However, the impact of these flavonoids on the pharmacokinetic behaviour of MET and CNG is mostly unknown. Methods: A simple one-step protein precipitation method was developed for the determination of MET and CNG from rat plasma. The mobile phase chosen was MeOH 65% and 35% water containing 0.1% formic acid at a flow rate of 1mL/min. Results: The retention time of MET, internal standard (Valsartan) and CNG was 1.83, 6.2 and 8.2 min, respectively. The method was found to be linear in the range of 200 - 8000 ng/mL for CNG and 100 = 4000 ng/ml for MET. Precision and accuracy of the method were below 20% at LLOQ and below 15% for LQC, MQC, and HQC. Conclusion: The method was successfully applied for the determination of PK of MET and CNG by using 100 μL of rat plasma. QRT co-administration affects the PK parameters of MET and CNG. This alteration in PK parameters might be of significant use for clinicians and patients.


Sign in / Sign up

Export Citation Format

Share Document