Effect of the lateral interaction of adsorbed molecules on preexponential factor of the desorption rate constant

1981 ◽  
Vol 111 (1) ◽  
pp. L662-L666 ◽  
Author(s):  
V.P. Zhdanov
Keyword(s):  
Rate Constant ◽  
Preexponential Factor ◽  
Lateral Interaction ◽  
Desorption Rate ◽  
Adsorbed Molecules ◽  
Desorption Rate Constant

Adsorption and Desorption of Contaminant Metals on Si Wafer Surface in SC1 Solution

1995 ◽  
Vol 386 ◽  
Author(s):  
G. Maeda ◽  
I. Takahashi ◽  
H. Kondo ◽  
J. Ryuta ◽  
T. Shingyouji
Keyword(s):  
Metal Concentration ◽  
Rate Constant ◽  
Solution Treatment ◽  
Surface Concentration ◽  
Metal Species ◽  
Wafer Surface ◽  
Solution Treatment Temperature ◽  
Initial Surface ◽  
Desorption Rate ◽  
Desorption Rate Constant

ABSTRACTVariation in the surface concentration of Fe, Ni, Cu and Zn on Si wafers due to treatment in NH4OH/H2aO2/H2O solution called SC1 is investigated. The metal concentration on the wafer surface depends on the initial surface concentration, concentration in the solution, adsorption probability, desorption rate constant and the treatment time. The surface metal concentration behavior is explained by taking into account the effects of these parameters. The variation in the desorption rate constant with the metal species, the concentration in the solution, treatment temperature and mixing ratio of SC1 is discussed.

The lifetime of hydrogen adsorbed on a slightly oxidized nickel surface

1957 ◽  
Vol 240 (1222) ◽  
pp. 423-436 ◽  
Keyword(s):  
Oxide Film ◽  
Mass Spectrometer ◽  
Rate Constant ◽  
Molecular Beam ◽  
Copper Surface ◽  
Solid Surfaces ◽  
Nickel Surface ◽  
Order Process ◽  
Adsorbed Molecules ◽  
First Order

A method for investigating the lifetimes of adsorbed molecules on solid surfaces is described. A molecular beam of hydrogen was projected on to the surface of a spinning nickel disk, and the hydrogen evaporating from the surface at different times after deposition was collected and measured with a mass spectrometer. On a slightly oxidized nickel surface all the hydrogen was adsorbed. The subsequent evaporation was a first-order process with a rate constant of 4·5 x 10 11 exp ( -11·5 kcal/ RT ) S -1 . With a mixed molecular beam of hydrogen and deuterium no exchange was produced by the adsorption, which is considered to be molecular. Attempts to remove the oxide film from the nickel surface gave an un­stable surface on which no clear results were obtained. The lifetime of hydrogen on a copper surface was too short to measure.

MONTE CARLO SIMULATION OF TEMPERATURE-PROGRAMMED DESORPTION CO/Cu(110) AND CO2/Cu(100) SYSTEMS

2004 ◽  
Vol 11 (02) ◽  
pp. 137-143 ◽  
Author(s):  
KH. ZAKERI ◽  
A. DASHTI
Keyword(s):  
Activation Energy ◽  
Monte Carlo Simulation ◽  
Monte Carlo ◽  
Excellent Agreement ◽  
Temperature Programmed Desorption ◽  
High Order ◽  
Kinetics And Mechanism ◽  
Lateral Interaction ◽  
Desorption Rate ◽  
Temperature Programmed

In this investigation, we have studied the kinetics and mechanism of desorption of CO from the Cu (110) surface using a new Monte Carlo simulation and putting emphasis on high order lateral interaction. According to our simulated TPD spectra, for β=10 K/s the maximum desorption rate occurs at Tm=218.6 K. Furthermore, analysis of simulated TPD spectra of CO desorption shows that it is strongly lateral-interactive and results an activation energy of CO desorption from Cu (110) that is Ed=66.6 Kj/mol. These simulated results are compared with other reported results and show excellent agreement. After that we have investigated the kinetics and mechanism of desorption of CO 2 from the Cu (100) surface using a Monte Carlo simulation. According to our simulated TPD spectra, for β=0.5 K/s the maximum desorption rate occurs at Tm=89.7 K. Analysis of simulated TPD spectra of CO 2 desorption shows that it is not strongly lateral-interactive and results in an activation energy of CO desorption from Cu (100) that is Ed=25.2 Kj/mol. Finally, the CO / Cu (110) system is compared with the CO 2/ Cu (100) system.

EFFECT OF GRAIN SIZE AND ACTIVATION TIME OF ZEOLITE TO ADSORPTION AND DESORPTION OF NH4OH AND KCL AS MODEL OF FERTILIZER-ZEOLITE MIX

Konversi ◽  
2018 ◽  
Vol 6 (2) ◽  
pp. 21 ◽  
Author(s):  
Muhammad Prasanto Bimantio
Keyword(s):  
Grain Size ◽  
Rate Constant ◽  
Adsorption Process ◽  
Activation Time ◽  
Desorption Process ◽  
Adsorption And Desorption ◽  
Catalyst Carrier ◽  
Three Samples ◽  
Research Procedure ◽  
Desorption Rate Constant

Abstract - Zeolites can be used as adsorbent, ion exchange, catalyst, or catalyst carrier. Application of fertilizer use in the zeolite also be one of the interesting topic. Zeolites in a mixture of fertilizer can use to control the release of nutrients. The purpose of this research is to study the effect of grain size and time of the activation of zeolite to adsorption and desorption of NH4OH and KCl as modeling of ZA and KCl fertilizer, to obtain the value of adsorption rate constant (ka) and desorption rate constant (kd). This research procedure include: the process of adsorption by adding zeolite with various size and time of activation into a sealed beaker glass and let the adsorption process occurs for 24 hours. After 24 hours, the solution was filtered, the zeolite then put in 100 ml of aquadest into a sealed beaker glass and let the desorption process happened for another 24 hours. Three samples with the largest difference solution concentrations looked for the value of the ka and kd. Zeolite configuration with the largest ka is trialed with fertilizer and compared with the value of ka obtained from modeling. The result for NH4OH adsorbate, -50+60 mesh 2 hours configuration zeolite give the largest ka. For KCl adsorbate, -30+40 mesh 4 hours configuration zeolite give the largest ka. The value between modeling and trials with fertilizers are not much different. Keywords: zeolite, ZA fertilizer, KCl fertilizer, mathematical modelling.

scholarly journals Determining Preexponential Factor in Model-Free Kinetic Methods: How and Why?

Molecules ◽  
2021 ◽  
Vol 26 (11) ◽  
pp. 3077
Author(s):  
Sergey Vyazovkin
Keyword(s):  
Activation Energy ◽  
Kinetic Analysis ◽  
Rate Constant ◽  
Condensed Phase ◽  
Compensation Effect ◽  
Preexponential Factor ◽  
Isoconversional Methods ◽  
Activation Entropy ◽  
Model Free ◽  
Kinetics Of

The kinetics of thermally stimulated processes in the condensed phase is commonly analyzed by model-free techniques such as isoconversional methods. Oftentimes, this type of analysis is unjustifiably limited to probing the activation energy alone, whereas the preexponential factor remains unexplored. This article calls attention to the importance of determining the preexponential factor as an integral part of model-free kinetic analysis. The use of the compensation effect provides an efficient way of evaluating the preexponential factor for both single- and multi-step kinetics. Many effects observed experimentally as the reaction temperature shifts usually involve changes in both activation energy and preexponential factor and, thus, are better understood by combining both parameters into the rate constant. A technique for establishing the temperature dependence of the rate constant by utilizing the isoconversional values of the activation energy and preexponential factor is explained. It is stressed that that the experimental effects that involve changes in the preexponential factor can be traced to the activation entropy changes that may help in obtaining deeper insights into the process kinetics. The arguments are illustrated by experimental examples.

scholarly journals Study on the Size-Dependent Oxidation Reaction Kinetics of Nanosized Zinc Sulfide

2014 ◽  
Vol 2014 ◽  
pp. 1-8 ◽  
Author(s):  
Qing-Shan Fu ◽  
Yong-Qiang Xue ◽  
Zi-Xiang Cui ◽  
Ming-Fang Wang
Keyword(s):  
Activation Energy ◽  
Particle Size ◽  
Surface Energy ◽  
Apparent Activation Energy ◽  
Zinc Sulfide ◽  
Rate Constant ◽  
Oxidation Reaction ◽  
Reaction Order ◽  
Preexponential Factor ◽  
Surface Entropy

Numerous oxidation problems of nanoparticles are often involved during the preparation and application of nanomaterials. The oxidation rate of nanomaterials is much faster than bulk materials due to nanoeffect. Nanosized zinc sulfide (nano-ZnS) and oxygen were chosen as a reaction system. The influence regularities were discussed and the influence essence was elucidated theoretically. The results indicate that the particle size can remarkably influence the oxidation reaction kinetics. The rate constant and the reaction order increase, while the apparent activation energy and the preexponential factor decrease with the decreasing particle size. Furthermore, the logarithm of rate constant, the apparent activation energy and the logarithm of preexponential factor are linearly related to the reciprocal of particle diameter, respectively. The essence is that the rate constant is influenced by the combined effect of molar surface energy and molar surface entropy, the reaction order by the molar surface area, the apparent activation energy, by the molar surface energy, and the preexponential factor by the molar surface entropy. The influence regularities and essence can provide theoretical guidance to solve the oxidation problems involved in the process of preparation and application of nanomaterials.

Sign in / Sign up

Export Citation Format

Share Document