scholarly journals Impact of deposition conditions on nanostructured anisotropic silica thin films in multilayer interference coatings

2021 ◽  
pp. 150167
Author(s):  
Lina Grineviciute ◽  
Holger Badorreck ◽  
Lars Jensen ◽  
Detlev Ristau ◽  
Marco Jupé ◽  
...  
Materials ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 724
Author(s):  
Tong Li ◽  
Masaya Ichimura

Magnesium hydroxide (Mg(OH)2) thin films were deposited by the drop-dry deposition (DDD) method using an aqueous solution containing Mg(NO3)2 and NaOH. DDD was performed by dropping the solution on a substrate, heating-drying, and rinsing in water. Effects of different deposition conditions on the surface morphology and optical properties of Mg(OH)2 thin films were researched. Films with a thickness of 1−2 μm were successfully deposited, and the Raman peaks of Mg(OH)2 were observed for them. Their transmittance in the visible range was 95% or more, and the bandgap was about 5.8 eV. It was found that the thin films have resistivity of the order of 105 Ωcm. Thus, the transparent and semiconducting Mg(OH)2 thin films were successfully prepared by DDD.


2012 ◽  
Vol 5 (1) ◽  
pp. 015007 ◽  
Author(s):  
D E Mihaiescu ◽  
R Cristescu ◽  
G Dorcioman ◽  
C E Popescu ◽  
C Nita ◽  
...  
Keyword(s):  

1994 ◽  
Vol 361 ◽  
Author(s):  
V.A. Alyoshin ◽  
E.V. Sviridov ◽  
V.I.M. Hukhortov ◽  
I.H. Zakharchenko ◽  
V.P. Dudkevich

ABSTRACTSurface and cross-section relief evolution of ferroelectric epitaxial (Ba,Sr)TiO3 films rf-sputtered on (001) HgO crystal cle-avage surface versus the oxygen worKing gas pressure P and subst-rate temperature T were studied. Specific features of both three-dimensional and two-dimensional epitaxy mechanisms corresponding to various deposition conditions were revealed. Difference between low and high P-T-value 3D epitaxy was established. The deposition of films with mirror-smooth surfaces and perfect interfaces is shown to be possible.


2005 ◽  
Vol 17 (8) ◽  
pp. 1035-1039 ◽  
Author(s):  
H. Fukumoto ◽  
S. Nagano ◽  
N. Kawatsuki ◽  
T. Seki

1995 ◽  
Vol 411 ◽  
Author(s):  
J. R. Kokan ◽  
R. A. Gerhardt

ABSTRACTImpedance Spectroscopy is being used to study the humidity sensitivity of porous silica thin films. The films are processed via a colloidal sol-gel method which leaves some remnant potassium and sodium. Previous work on bulk porous silica samples processed by the same method showed that the dielectric properties and ac conductivity were very sensitive to changes in humidity. The aim of this work was to determine if the same dependencies could be found in the thin films. The capacitance, dielectric loss, and ac conductivity of the films were measured in a controlled environment chamber from 20–80% RH for frequencies ranging from 10Hz–10MHz. In addition to characterizing films with varying amounts of residual alkali ions obtained through leaching, we have also measured films that were surface doped with controlled amounts of KCl, LiCl, or NaCl. Relative humidity dependencies in the films are not as dramatic as in the bulk samples. The reasons for this behavior are not yet clear, but may be associated with the porosity, thickness, and surface area of the films.


Sign in / Sign up

Export Citation Format

Share Document