Preparation and characterization of distillers’ grain based activated carbon as low cost methylene blue adsorbent: Mass transfer and equilibrium modeling

2018 ◽  
Vol 29 (1) ◽  
pp. 27-35 ◽  
Author(s):  
Hui Wang ◽  
Ruzhen Xie ◽  
Jie Zhang ◽  
Jun Zhao
Keyword(s):  
Mass Transfer ◽  
Methylene Blue ◽  
Activated Carbon ◽  
Low Cost ◽  
Equilibrium Modeling ◽  
Distillers Grain

Characterization of the Corallina Elongata Alga and Study of its Biosorption Properties for Methylene Blue

2019 ◽  
Vol 41 (1) ◽  
pp. 62-62
Author(s):  
Farida Bouremmad Farida Bouremmad ◽  
Abdennour Bouchair Abdennour Bouchair ◽  
Sorour Semsari Parapari Sorour Semsari Parapari ◽  
Shalima Shawuti and Mehmet Ali Gulgun Shalima Shawuti and Mehmet Ali Gulgun
Keyword(s):  
Methylene Blue ◽  
Activated Carbon ◽  
Adsorption Capacity ◽  
Low Cost ◽  
Mediterranean Coast ◽  
Batch Adsorption ◽  
Maximum Adsorption Capacity ◽  
Aquatic Biomass ◽  
Equilibrium Data

Biosorbents can be an alternative to activated carbon. They are derived from agricultural by-products or aquatic biomass. They are low cost and they may have comparable performances to those of activated carbon. The present study focuses on the characterization of the Corallina Elongata (CE) alga and its adsorption performance for Methylene Blue (MB), this alga is found in abundance at the Mediterranean coast of the city of Jijel in eastern Algeria. The dried alga was characterized using various characterization techniques such as DTA, TG, FTIR, XRD, SEM and EDX, which showed that the material consists essentially of a calcite containing magnesium. Batch adsorption studies were carried out and the effect of experimental parameters Such as pH, initial dye concentration, temperature, adsorbent dose and contact time, on the adsorption of MB was studied. The kinetic experimental data were found to conform to the pseudo-second-order model with good correlation and equilibrium data were best fitted to The Langmuir model, with a maximum adsorption capacity of 34.4 mg/g. The adsorption isotherms at various temperatures allowed the determination of certain thermodynamic parameters (ΔG, ΔH and ΔS). Finally, the adsorption results showed a good affinity between CE and MB with a high adsorption capacity.

Preparation and Characterization of Textile Sludge-Based Activated Carbon for Dyes Removal

2016 ◽  
Vol 818 ◽  
pp. 250-253
Author(s):  
Nurul Atiqah Najlaa Yac’cob ◽  
Norzita Ngadi ◽  
Roshanida Abd Rahman
Keyword(s):  
Methylene Blue ◽  
Activated Carbon ◽  
Surface Area ◽  
Low Cost ◽  
Reactive Black 5 ◽  
Adsorbent Dosage ◽  
Percentage Removal ◽  
Textile Sludge ◽  
Dyes Removal

An activated carbon derived from textile sludge was synthesized as an initiative of low cost adsorbent for removal of dyes. The surface area of this activated carbon was determined by Brunauer, Emmett and Teller (BET). From the BET results, it shows a high increment in the BET multi point area for textile sludge-activated carbon as compared to the textile sludge, which is 623.9557 m2/g and 58.9806 m2/g, respectively. The effects of initial adsorbent dosage were studied in the removal of Reactive Black 5 (RB5) and Methylene Blue (MB) dyes. RB5 and MB dyes solutions were used to represent anionic and cationic dyes respectively. It was concluded that the adsorbent dosage was proportional to the dyes removal for both RB5 and MB with percentage removal up to 99%.

scholarly journals Preparation and Characterization of Activated Carbon from Lapsi (Choerospondias axillaris) Seed Stone by Chemical Activation with Potassium Hydroxide

2014 ◽  
Vol 9 (1) ◽  
pp. 79-88 ◽  
Author(s):  
Sahira Joshi ◽  
Bhadra Prasad Pokharel
Keyword(s):  
Methylene Blue ◽  
Activated Carbon ◽  
Potassium Hydroxide ◽  
Low Cost ◽  
Chemical Activation ◽  
Sem Images ◽  
Monolayer Adsorption ◽  
Ft Ir ◽  
Characterization Of Activated Carbon

Activated carbon (AC) was prepared from Lapsi seed stone by chemical activation with Potassium hydroxide at 400°C. The AC was characterized by pH, moisture content, Fourier transform-infrared (FTIR) spectroscopy, scanning electron microscopy (SEM), methylene blue (MB) and iodine (I2) number. FT-IR spectra indicated the presence of various oxygen containing functional groups on the surface of AC. SEM images show the highly porous characteristics of AC with full of cavities. The Iodine number of AC revealed that the AC was found to be highly micro-porous. The adsorption of methylene blue by prepared AC was analyzed by the Langmuir and Freundlich adsorption isotherms. The data fitted well to the Langmuir isotherm with monolayer adsorption capacity 158 mg/g. The analysis showed that the AC prepared from Lapsi seed stone activated with potassium hydroxide could be a low-cost adsorbent with favorable surface properties. DOI: http://dx.doi.org/10.3126/jie.v9i1.10673Journal of the Institute of Engineering, Vol. 9, No. 1, pp. 79–88

scholarly journals Removal of Ni (II) from Aqueous Solution by Adsorption onto Activated Carbon Prepared from Lapsi (Choerospondias axillaris) Seed Stone

2014 ◽  
Vol 9 (1) ◽  
pp. 166-174 ◽  
Author(s):  
Rajeshwar M. Shrestha ◽  
Margit Varga ◽  
Imre Varga ◽  
Amar P. Yadav ◽  
Bhadra P. Pokharel ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Activated Carbons ◽  
Low Cost ◽  
Chemical Characterization ◽  
Maximum Adsorption Capacity ◽  
Adsorption Data ◽  
Optimum Ph ◽  
Nickel Adsorption

Activated carbons were prepared from Lapsi seed stone by the treatment with H2SO4 and HNO3 for the removal of Ni (II) ions from aqueous solution. Two activated carbon have been prepared from Lapsi seed stones by treating with conc.H2SO4 and a mixture of H2SO4 and HNO3 in the ratio of 1:1 by weight for removal of Ni(II) ions. Chemical characterization of the resultant activated carbons was studied by Fourier Transform Infrared Spectroscopy and Boehm titration which revealed the presence of oxygen containing surface functional groups like carboxyl, lactones and phenols in the carbons. The optimum pH for nickel adsorption is found to be 5. The adsorption data were better fitted with the Langmuir equations than Freundlich adsorption equation to describe the equilibrium isotherms. The maximum adsorption capacity of Ni (II) on the resultant activated carbons was 28.25.8 mg g-1 with H2SO4 and 69.49 mg g-1 with a mixture of H2SO4 and HNO3. The waste material used in the preparation of the activated carbons is inexpensive and readily available. Hence the carbons prepared from Lapsi seed stones can act as potential low cost adsorbents for the removal of Ni (II) from water. DOI: http://dx.doi.org/10.3126/jie.v9i1.10680Journal of the Institute of Engineering, Vol. 9, No. 1, pp. 166–174

Empirical Equilibrium Study on Rice Husk and Eggshells as Low Cost Bioadsorbent for the Methylene Blue Removal

2014 ◽  
Vol 699 ◽  
pp. 221-226
Author(s):  
Nurul Hanim Razak ◽  
Md. Razali Ayob ◽  
M.A.M. Zainin ◽  
M.Z. Hilwa
Keyword(s):  
Methylene Blue ◽  
Rice Husk ◽  
Low Cost ◽  
Agricultural Waste ◽  
Textile Wastewater ◽  
Blue Dye ◽  
Rice Husks ◽  
Equilibrium Study ◽  
Porosity Characterization

Eggshells and rice husk, two types of notable agricultural waste were used as bioadsorbent to remove Methylene Blue dye (MBD) in aqueous solution. This study was to investigate the performance of these two bioadsorbents in removing MBD. The removal percentage, adsorption capacity, and porosity characterization were examined. The method applied was a physical filtration. UV-VIS Spectrophotometer was used to determine the efficiency of the bioadsorbents in MBD adsorption. The highest removal percentage at the most concentrated MBD were 51% and 98% for eggshells and rice husks respectively. Meanwhile the characterization of rice husks pore size and volume proves that higher adsorptivity towards dye compares to eggshells porosity. It was concluded that the eggshells and rice husks bioadsorbents was successful to treat industrial textile wastewater with rice husks as the most efficient bioadsorbent in removing MBD.

scholarly journals Bioremediation of organic dyes using combination of plants ash

2019 ◽  
Vol 7 (2) ◽  
pp. 240-246
Author(s):  
Kaur Harpreet ◽  
Kaur Harpreet ◽  
Vandana Kamboj ◽  
Vandana Kamboj
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Methyl Orange ◽  
Crystal Violet ◽  
Congo Red ◽  
Organic Dyes ◽  
Low Cost ◽  
Sem Image ◽  
Orange Peels

Water is the most crucial thing to mankind and so its contamination by various agencies is posing a threat to the natural balance. So, in the present work, the efficiency of various adsorbents derived from plant waste, to remove different dyes from aqueous solution was evaluated. Parameters for study were contact time, concentration and pH. Various combinations of plant ashes were used for the study. It was found that adsorbent prepared from the combination of orange peels, pomegranate and banana peels ashes, exhibited good adsorption capacity for methylene blue, congo red and crystal violet. All these dyes were completely removed from the aqueous solution while methyl orange was not removed. Congo red was removed completely within 40 min of contact with the adsorbent while methyl orange took 3 hrs to be removed to the extent of 48% only. The adsorption coefficient of congo red was found to be 2.33 while value for methylene blue and crystal violet was 1 and 1.66 respectively. The characterization of adsorbent was done by Scanning Electron Microscopy and IR spectroscopy. SEM image revealed the surface of adsorbent to be made of differential pores. From the results it became evident that the low-cost adsorbent could be used as a replacement for costly traditional methods of removing colorants from water.

scholarly journals Optimisation of durian peel based activated carbon preparation conditions for dye removal

2013 ◽  
Vol 16 (1) ◽  
pp. 22-31
Author(s):  
Phung Thi Kim Le ◽  
Kien Anh Le
Keyword(s):  
Methylene Blue ◽  
Activated Carbon ◽  
Surface Area ◽  
Dye Removal ◽  
Activated Carbons ◽  
Low Cost ◽  
Waste Water Treatment ◽  
Impregnation Ratio ◽  
Carbon Production ◽  
Removal Capacity

Agricultural wastes are considered to be a very important feedstock for activated carbon production as they are renewable sources and low cost materials. This study present the optimize conditions for preparation of durian peel activated carbon (DPAC) for removal of methylene blue (MB) from synthetic effluents. The effects of carbonization temperature (from 673K to 923K) and impregnation ratio (from 0.2 to 1.0) with potassium hydroxide KOH on the yield, surface area and the dye adsorbed capacity of the activated carbons were investigated. The dye removal capacity was evaluated with methylene blue. In comparison with the commercial grade carbons, the activated carbons from durian peel showed considerably higher surface area especially in the suitable temperate and impregnation ratio of activated carbon production. Methylene blue removal capacity appeared to be comparable to commercial products; it shows the potential of durian peel as a biomass source to produce adsorbents for waste water treatment and other application. Optimize condition for preparation of DPAC determined by using response surface methodology was at temperature 760 K and IR 1.0 which resulted the yield (51%), surface area (786 m2/g), and MB removal (172 mg/g).

Characterization of Adsorbents Derived from Palm Fiber Waste and its Potential on Methylene Blue Adsorption

2020 ◽  
Vol 841 ◽  
pp. 273-277
Author(s):  
Ariany Zulkania ◽  
Muhammad Iqbal ◽  
Syamsumarlin
Keyword(s):  
Methylene Blue ◽  
Activated Carbon ◽  
Phosphoric Acid ◽  
Adsorption Capacity ◽  
Adsorption Process ◽  
Methylene Blue Adsorption ◽  
Palm Fiber ◽  
Methylene Blue Removal ◽  
Phosphoric Acid Concentration

In this study, two types of adsorbent including activated carbon and bio-sorbent were produced from Palm fiber wastes (PFW), which were activated by phosphoric acid. The influence of adsorbent type and phosphoric acid concentration on methylene blue adsorption was investigated. The most optimum adsorbent was determined based on adsorption capacity and removal percentage of each adsorbent. The result shows that 9.984 mg/g of adsorption capacity and 99.84% of removal percentage were achieved in 90 minutes’ adsorption, which demonstrates the huge potential of bio-sorbent and was chosen to be the most optimum adsorbent based on methylene blue removal. The characterization of bio-sorbent was then investigated using FTIR and SEM. FTIR result shows that bio-sorbent contains cellulose which affected the adsorption process while SEM result shows the cleaner pores and surface compared to bio-sorbent before activation.

Sign in / Sign up

Export Citation Format

Share Document