Correlation for the maximum oxygen transfer capacity in shake flasks for a wide range of operating conditions and for different culture media

2016 ◽  
Vol 109 ◽  
pp. 228-235 ◽  
Author(s):  
Kristina Meier ◽  
Wolf Klöckner ◽  
Benjamin Bonhage ◽  
Elena Antonov ◽  
Lars Regestein ◽  
...  
Keyword(s):  
Oxygen Transfer ◽  
Culture Media ◽  
Operating Conditions ◽  
Wide Range ◽  
Shake Flasks ◽  
Oxygen Transfer Capacity ◽  
Maximum Oxygen Transfer Capacity

Design and operation of SBR processes for small plants based on simulations

2007 ◽  
Vol 55 (7) ◽  
pp. 163-171 ◽  
Author(s):  
L. Larrea ◽  
J. Albizuri ◽  
I. Irizar ◽  
J.M. Hernández
Keyword(s):  
Experimental Study ◽  
Retention Time ◽  
Oxygen Transfer ◽  
Iterative Process ◽  
Suspended Solids ◽  
Design Procedure ◽  
Operating Conditions ◽  
Solid Retention Time ◽  
Wide Range ◽  
Selection Of

The paper firstly presents an experimental study in a SBR pilot plant operated at 20 °C for nitrogen removal from a very small village wastewater. The plant consisted of only one reactor fed continuously throughout the day and aerated intermittently. Two tests with seven and three intermittences of mixing/aerated phases were conducted and verification of the results by simulations of the activated sludge model (ASM) was also carried out. The experimental results and simulation showed that a wide range of effluent NO3-N can be obtained using different numbers of intermittences and values of the oxygen transfer coefficient (KLa). At the same time, the paper presents a design procedure for SBR processes based on an iterative process of simulations of the ASM model. After the selection of the cycle time, the mixing/aeration pattern, the initial volume, the solid retention time, and the duration of the phases, the simulation is undertaken, resulting in values for the effluent NH4-N and NO3-N, and the suspended solids before settling. Then, the latter parameters are verified to match the effluent and settling requirements. As an application of the design procedure, the effect on design and operation of different SBR configurations and of several operating conditions are analysed in three case studies.

Comparison of Deterministic and Linear Cosine Spatial Filtering of Transmission Electron Micrographs

1972 ◽  
Vol 30 ◽  
pp. 596-597
Author(s):  
David A. Ansley
Keyword(s):  
Spherical Aberration ◽  
Focal Length ◽  
Chromatic Aberration ◽  
Spatial Filter ◽  
Operating Conditions ◽  
Objective Lens ◽  
List Type ◽  
Spatial Filters ◽  
Transmission Electron ◽  
Wide Range

The coherence of the electron flux of a transmission electron microscope (TEM) limits the direct application of deconvolution techniques which have been used successfully on unmanned spacecraft programs. The theory assumes noncoherent illumination. Deconvolution of a TEM micrograph will, therefore, in general produce spurious detail rather than improved resolution.A primary goal of our research is to study the performance of several types of linear spatial filters as a function of specimen contrast, phase, and coherence. We have, therefore, developed a one-dimensional analysis and plotting program to simulate a wide 'range of operating conditions of the TEM, including adjustment of the:(1) Specimen amplitude, phase, and separation(2) Illumination wavelength, half-angle, and tilt(3) Objective lens focal length and aperture width(4) Spherical aberration, defocus, and chromatic aberration focus shift(5) Detector gamma, additive, and multiplicative noise constants(6) Type of spatial filter: linear cosine, linear sine, or deterministic

Structure and properties of compact articles from high-alloyed iron powder with adding of boron nitride

2020 ◽  
pp. 39-48
Author(s):  
B. O. Bolshakov ◽  
◽  
R. F. Galiakbarov ◽  
A. M. Smyslov ◽  
◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Boron Nitride ◽  
Grain Boundary ◽  
Bending Strength ◽  
Physical And Mechanical Properties ◽  
Operating Conditions ◽  
Structure And Properties ◽  
Steam Turbines ◽  
Friction Forces ◽  
Wide Range

The results of the research of structure and properties of a composite compact from 13 Cr – 2 Мо and BN powders depending on the concentration of boron nitride are provided. It is shown that adding boron nitride in an amount of more than 2% by weight of the charge mixture leads to the formation of extended grain boundary porosity and finely dispersed BN layers in the structure, which provides a high level of wearing properties of the material. The effect of boron nitride concentration on physical and mechanical properties is determined. It was found that the introduction of a small amount of BN (up to 2 % by weight) into the compacts leads to an increase in plasticity, bending strength, and toughness by reducing the friction forces between the metal powder particles during pressing and a more complete grain boundary diffusion process during sintering. The formation of a regulated structure-phase composition of powder compacts of 13 Cr – 2 Mо – BN when the content of boron nitride changes in them allows us to provide the specified physical and mechanical properties in a wide range. The obtained results of studies of the physical and mechanical characteristics of the developed material allow us to reasonably choose the necessary composition of the powder compact for sealing structures of the flow part of steam turbines, depending on their operating conditions.

Nitrogen Removal from Anaerobically-Treated Leachate

1984 ◽  
Vol 19 (1) ◽  
pp. 87-100
Author(s):  
D. Prasad ◽  
J.G. Henry ◽  
P. Elefsiniotis
Keyword(s):  
Nitrogen Removal ◽  
Air Flow ◽  
Operating Conditions ◽  
Air Flow Rate ◽  
Flow Rates ◽  
Anaerobic Filter ◽  
Ph Values ◽  
Wide Range ◽  
Ammonia Desorption ◽  
Effects Of Ph

Abstract Laboratory studies were conducted to demonstrate the effectiveness of diffused aeration for the removal of ammonia from the effluent of an anaerobic filter treating leachate. The effects of pH, temperature and air flow on the process were studied. The coefficient of desorption of ammonia, KD for the anaerobic filter effluent (TKN 75 mg/L with NH3-N 88%) was determined at pH values of 9, 10 and 11, temperatures of 10, 15, 20, 30 and 35°C, and air flow rates of 50, 120, and 190 cm3/sec/L. Results indicated that nitrogen removal from the effluent of anaerobic filters by ammonia desorption was feasible. Removals exceeding 90% were obtained with 8 hours aeration at pH of 10, a temperature of 20°C, and an air flow rate of 190 cm3/sec/L. Ammonia desorption coefficients, KD, determined at other temperatures and air flow rates can be used to predict ammonia removals under a wide range of operating conditions.

scholarly journals Toxin Production in Soybean (Glycine max L.) Plants with Charcoal Rot Disease and by Macrophomina phaseolina, the Fungus that Causes the Disease

Toxins ◽  
2019 ◽  
Vol 11 (11) ◽  
pp. 645 ◽  
Author(s):  
Hamed K. Abbas ◽  
Nacer Bellaloui ◽  
Cesare Accinelli ◽  
James R. Smith ◽  
W. Thomas Shier
Keyword(s):  
Culture Media ◽  
Leaf Disc ◽  
Toxin Production ◽  
Macrophomina Phaseolina ◽  
Economic Losses ◽  
Limit Of Quantification ◽  
Charcoal Rot ◽  
Wide Range ◽  
Soybean Plants ◽  
Rot Disease

Charcoal rot disease, caused by the fungus Macrophomina phaseolina, results in major economic losses in soybean production in southern USA. M. phaseolina has been proposed to use the toxin (-)-botryodiplodin in its root infection mechanism to create a necrotic zone in root tissue through which fungal hyphae can readily enter the plant. The majority (51.4%) of M. phaseolina isolates from plants with charcoal rot disease produced a wide range of (-)-botryodiplodin concentrations in a culture medium (0.14–6.11 µg/mL), 37.8% produced traces below the limit of quantification (0.01 µg/mL), and 10.8% produced no detectable (-)-botryodiplodin. Some culture media with traces or no (-)-botryodiplodin were nevertheless strongly phytotoxic in soybean leaf disc cultures, consistent with the production of another unidentified toxin(s). Widely ranging (-)-botryodiplodin levels (traces to 3.14 µg/g) were also observed in the roots, but not in the aerial parts, of soybean plants naturally infected with charcoal rot disease. This is the first report of (-)-botryodiplodin in plant tissues naturally infected with charcoal rot disease. No phaseolinone was detected in M. phaseolina culture media or naturally infected soybean tissues. These results are consistent with (-)-botryodiplodin playing a role in the pathology of some, but not all, M. phaseolina isolates from soybeans with charcoal rot disease in southern USA.

scholarly journals Applications of Biocatalysts for Sustainable Oxidation of Phenolic Pollutants: A Review

2021 ◽  
Vol 13 (15) ◽  
pp. 8620
Author(s):  
Sanaz Salehi ◽  
Kourosh Abdollahi ◽  
Reza Panahi ◽  
Nejat Rahmanian ◽  
Mozaffar Shakeri ◽  
...  
Keyword(s):  
Phenolic Compounds ◽  
Operating Conditions ◽  
Phenolic Pollutants ◽  
Petroleum Refinery Wastewater ◽  
Start Up ◽  
Low Concentrations ◽  
Effective Removal ◽  
Wide Range ◽  
Loading Effects ◽  
Spent Caustic

Phenol and its derivatives are hazardous, teratogenic and mutagenic, and have gained significant attention in recent years due to their high toxicity even at low concentrations. Phenolic compounds appear in petroleum refinery wastewater from several sources, such as the neutralized spent caustic waste streams, the tank water drain, the desalter effluent and the production unit. Therefore, effective treatments of such wastewaters are crucial. Conventional techniques used to treat these wastewaters pose several drawbacks, such as incomplete or low efficient removal of phenols. Recently, biocatalysts have attracted much attention for the sustainable and effective removal of toxic chemicals like phenols from wastewaters. The advantages of biocatalytic processes over the conventional treatment methods are their ability to operate over a wide range of operating conditions, low consumption of oxidants, simpler process control, and no delays or shock loading effects associated with the start-up/shutdown of the plant. Among different biocatalysts, oxidoreductases (i.e., tyrosinase, laccase and horseradish peroxidase) are known as green catalysts with massive potentialities to sustainably tackle phenolic contaminants of high concerns. Such enzymes mainly catalyze the o-hydroxylation of a broad spectrum of environmentally related contaminants into their corresponding o-diphenols. This review covers the latest advancement regarding the exploitation of these enzymes for sustainable oxidation of phenolic compounds in wastewater, and suggests a way forward.

Sign in / Sign up

Export Citation Format

Share Document