Transport and retention of bacteria through a filtration system consisting of sands and geotextiles

2021 ◽  
Vol 208 ◽  
pp. 112114
Author(s):  
Hongjuan Bai ◽  
Junhang Chen ◽  
Weiqiang Gao ◽  
Beibei Yang ◽  
Yufeng Yan ◽  
...  
Keyword(s):  
Filtration System

Low-pressure membrane filtration with unconventional coagulation regimes

2005 ◽  
Vol 5 (5) ◽  
pp. 1-8 ◽  
Author(s):  
K.Y. Choi ◽  
B.A. Dempsey
Keyword(s):  
Activated Carbon ◽  
Membrane Filtration ◽  
Membrane Surface ◽  
Cross Flow ◽  
Chemical Cleaning ◽  
Sand Filters ◽  
Charge Neutralization ◽  
Floc Size ◽  
Filtration System ◽  
Pre Treatment

The objective of the research was to evaluate in-line coagulation to improve performance during ultrafiltration (UF). In-line coagulation means use of coagulants without removal of coagulated solids prior to UF. Performance was evaluated by removal of contaminants (water quality) and by resistance to filtration and recovery of flux after hydraulic or chemical cleaning (water production). We hypothesized that coagulation conditions inappropriate for conventional treatment, in particular under-dosing conditions that produce particles that neither settle nor are removed in rapid sand filters, would be effective for in-line coagulation prior to UF. A variety of pre-treatment processes for UF have been investigated including coagulation, powdered activated carbon (PAC) or granular activated carbon (GAC), adsorption on iron oxides or other pre-formed settleable solid phases, or ozonation. Coagulation pre-treatment is often used for removal of fouling substances prior to NF or RO. It has been reported that effective conventional coagulation conditions produced larger particles and this reduced fouling during membrane filtration by reducing adsorption in membrane pores, increasing cake porosity, and increasing transport of foulants away from the membrane surface. However, aggregates produced under sweep floc conditions were more compressible than for charge neutralization conditions, resulting in compaction when the membrane filtration system was pressurized. It was known that the coagulated suspension under either charge-neutralization or sweep floc condition showed similar steady-state flux under the cross-flow microfiltration mode. Another report on the concept of critical floc size suggested that flocs need to reach a certain critical size before MF, otherwise membranes can be irreversibly clogged by the coagulant solids. The authors were motivated to study the effect of various coagulation conditions on the performance of a membrane filtration system.

Carbon–titanium dioxide (C/TiO2) nanofiber composites for chemical oxidation of emerging organic contaminants in reactive filtration applications

2021 ◽  
Vol 8 (3) ◽  
pp. 711-722
Author(s):  
Katherine E. Greenstein ◽  
Matthew R. Nagorzanski ◽  
Bailey Kelsay ◽  
Edgard M. Verdugo ◽  
Nosang V. Myung ◽  
...  
Keyword(s):  
Titanium Dioxide ◽  
Water Treatment ◽  
Organic Contaminants ◽  
Membrane Filtration ◽  
Titanium Dioxide Nanoparticles ◽  
Chemical Oxidation ◽  
Tio2 Nanofiber ◽  
System P ◽  
Filtration System ◽  
Emerging Organic Contaminants

Electrospun carbon nanofibers with integrated titanium dioxide nanoparticles are used for water treatment in a photoactive membrane filtration system.

scholarly journals Effects of the Filtration on the Biotic Fraction of Extra Virgin Olive Oil

Foods ◽  
2021 ◽  
Vol 10 (8) ◽  
pp. 1677
Author(s):  
Biagi Angelo Zullo ◽  
Giulia Venditti ◽  
Gino Ciafardini
Keyword(s):  
Olive Oil ◽  
Virgin Olive Oil ◽  
Extra Virgin Olive Oil ◽  
Filter Press ◽  
Filtration Process ◽  
Virgin Olive Oils ◽  
Olive Oils ◽  
Filtration System ◽  
Cellulose Filter ◽  
Initial Contamination

Filtration is a widely used process in the production of extra virgin olive oil. We studied the influence of filtration performed with cotton filters and cellulose filter press on the biotic components of the oily mass containing probiotic traits in two freshly produced monocultivar extra virgin olive oils. The concentration of bacteria was reduced from 100% to 28%, while that of fungi was reduced from 100% to 44% after filtration, according to the filtration system and the initial contamination of the original monocultivar extra virgin olive oil. Compared with the control, the yeast content in the oil samples filtered with cotton filters was reduced from 37% to 11% depending on the cultivar. In the oil filtered with cellulose filter press, the yeast content reduced from 42% to 16%. The viable yeast that passed through the oily mass during the filtration process with cellulose filter press, unlike all the other samples, were unable to survive in the oil after a month of storage. The possible health benefits of compounds from both the biotic and abiotic fraction of the oil, compared to the control, were significantly low when filtered with the cellulose filter press.

scholarly journals Effect of Pre-Oxidation on Coagulation/Ceramic Membrane Treatment of Yangtze River Water

Membranes ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 369
Author(s):  
Shengji Xia ◽  
Xinran Zhang ◽  
Yuanchen Zhao ◽  
Fibor J. Tan ◽  
Pan Li ◽  
...  
Keyword(s):  
Water Treatment ◽  
Membrane Fouling ◽  
Membrane Filtration ◽  
Ceramic Membrane ◽  
Membrane Separation ◽  
Membrane System ◽  
Coagulation System ◽  
Fouling Control ◽  
Filtration System ◽  
Membrane Treatment

The membrane separation process is being widely used in water treatment. It is very important to control membrane fouling in the process of water treatment. This study was conducted to evaluate the efficiency of a pre-oxidation-coagulation flat ceramic membrane filtration process using different oxidant types and dosages in water treatment and membrane fouling control. The results showed that under suitable concentration conditions, the effect on membrane fouling control of a NaClO pre-oxidation combined with a coagulation/ceramic membrane system was better than that of an O3 system. The oxidation process changed the structure of pollutants, reduced the pollution load and enhanced the coagulation process in a pre-oxidation-coagulation system as well. The influence of the oxidant on the filtration system was related to its oxidizability and other characteristics. NaClO and O3 performed more efficiently than KMnO4. NaClO was more conducive to the removal of DOC, and O3 was more conducive to the removal of UV254.

scholarly journals Inflight Transmission of COVID-19 Based on Experimental Aerosol Dispersion Data

2021 ◽  
Author(s):  
Zhaozhi Wang ◽  
Edwin R Galea ◽  
Angus Grandison ◽  
John Ewer ◽  
Fuchen Jia
Keyword(s):  
High Efficiency ◽  
Face Mask ◽  
Generation Rate ◽  
Aviation Industry ◽  
Filtration System ◽  
Dispersion Data ◽  
Low Probability ◽  
Meal Service ◽  
Low Efficiency ◽  
Aerosol Dispersion

Abstract Background An issue of concern to the travelling public is the possibility of in-flight transmission of COVID-19 during long- and short-haul flights. The aviation industry maintains that the probability of contracting the illness is small based on reported cases, modelling and data from aerosol dispersion experiments conducted on-board aircraft. Methods Using experimentally derived aerosol dispersion data for a B777–200 aircraft and a modified version of the Wells-Riley equation we estimate inflight infection probability for a range of scenarios involving quanta generation rate and face mask efficiency. Quanta generation rates were selected based on COVID-19 events reported in the literature while mask efficiency was determined from the aerosol dispersion experiments. Results The MID-AFT cabin exhibits the highest infection probability. The calculated maximum individual infection probability (without masks) for a 2-hour flight in this section varies from 4.5% for the ‘Mild Scenario’ to 60.2% for the ‘Severe Scenario’ although the corresponding average infection probability varies from 0.1% to 2.5%. For a 12-hour flight, the corresponding maximum individual infection probability varies from 24.1% to 99.6% and the average infection probability varies from 0.8% to 10.8%. If all passengers wear face masks throughout the 12-hour flight, the average infection probability can be reduced by approximately 73%/32% for high/low efficiency masks. If face masks are worn by all passengers except during a one-hour meal service, the average infection probability is increased by 59%/8% compared to the situation where the mask is not removed. Conclusions This analysis has demonstrated that while there is a significant reduction in aerosol concentration due to the nature of the cabin ventilation and filtration system, this does not necessarily mean that there is a low probability or risk of in-flight infection. However, mask wearing, particularly high-efficiency ones, significantly reduces this risk.

Sign in / Sign up

Export Citation Format

Share Document