At present decreasing of costs and increasing of efficiency are the most priority directions in any industry. Developing in this way, JSC “Ural steel” together with FGUP “CNIIchermet after I.P. Barding” had mastered production of sheet metal product with increased resistivity against atmosphere corrosion made of steel 14ХГНДЦ for construction of bridges. Because of specific chemical composition of the steel, in the process of metal structures running in the open air, a solid strong oxide film is formed on the metal of the structures which prevents further corrosion without painting. For bridge builders elimination of costly operation of painting of span structures will enable to decrease considerably the costs of bridges construction and running. Having many advantages, steel 14ХГНДЦ has some restrictions in applications for steel structures without painting, as follows: - in sea zone according to domestic norms no close than 500 m from coastline; - in case of disorderly conditions of protective film formation and/or application of salt solutions for surface cleaning (as a rule the restrictions refer to traffic area of bridge span). In view of that for JSC “Ural Steel”, as the leading producer of bridge steel in Russia, an actual task erose: to elaborate and create a weatherproof steel, which could not only operate the whole period of a bridge running without additional protection at bridges construction through sea areas or close to coastline, but also withstand severe climate conditions of our country, including areas of High North with temperature lower -50°С. To solve the task together with OJSC “Institute Giprostroymost” and JSC BNIIZhT, a research work was accomplished to elaborate a system of alloying new steel 06ГН3МД with nickel content ~3.0 %, as well as production modes ensuring required corrosion resistance for operation in sea zone. Results of laboratory studies of the new weatherproof steel 06ГН3МД for application in bridge structures for coastal conditions and sea areas presented. Results of mechanical, technological, corrosion as well as fatigue tests of rolling products of the elaborated steel presented. It was established by laboratory studies that the new steel is weatherproofed and ensures lower corrosion losses, higher impact toughness at negative temperatures and plasticity comparing with steels used at present. It was shown that the strength class, technology and modes of factory welding of steel 06ГН3МД meet the requirements to steel span structures of bridges. Base on the results of the studies, the chemical composition of the steel 06ГН3МД was specified, as well as modes of heat treatment, ensuring the required characteristics with significant acceding. It was established that samples of the new steel 06ГН3МД showed considerably higher corrosion resistance - in average by 20% comparing with steel 14ХГНДЦ. At that corrosion resistance tests of welded joints of the new steel showed even higher resistance of the seam comparing with the basic metal, which speaks about quality selection of welding modes and welding materials.
The Corrosion Resistance and Electrochemical Property of Dental Alloys