Safety and thermal efficiency performance assessment of solar aided coal-fired power plant based on turbine steam double reheat

Energy ◽  
2021 ◽  
pp. 120277
Author(s):  
Jianlan Li ◽  
Yu Xin ◽  
Bo Hu ◽  
Kuo Zeng ◽  
Zhiyi Wu ◽  
...  
2021 ◽  
Vol 283 ◽  
pp. 116372
Author(s):  
Benjamin Königshofer ◽  
Pavle Boškoski ◽  
Gjorgji Nusev ◽  
Markus Koroschetz ◽  
Martin Hochfellner ◽  
...  

Energies ◽  
2021 ◽  
Vol 14 (10) ◽  
pp. 2950
Author(s):  
Vinod Kumar ◽  
Liqiang Duan

Coal consumption and CO2 emissions are the major concerns of the 21st century. Solar aided (coal-fired) power generation (SAPG) is paid more and more attention globally, due to the lesser coal rate and initial cost than the original coal-fired power plant and CSP technology respectively. In this paper, the off-design dynamic performance simulation model of a solar aided coal-fired power plant is established. A 330 MW subcritical coal-fired power plant is taken as a case study. On a typical day, three various collector area solar fields are integrated into the coal-fired power plant. By introducing the solar heat, the variations of system performances are analyzed at design load, 75% load, and 50% load. Analyzed parameters with the change of DNI include the thermal oil mass flow rate, the mass flow rate of feed water heated by the solar energy, steam extraction mass flow rate, coal consumption, and the plant thermal efficiency. The research results show that, as DNI increases over a day, the coal saving rate will also increase, the maximum coal saving rate reaches up to 5%, and plant thermal efficiency reaches 40%. It is analyzed that the SAPG system gives the best performance at a lower load and a large aperture area.


Author(s):  
Saeed Farokhi

In a modern gas turbine power plant, the axial exhaust diffuser accounts for up to 10% of the generator power. An unshrouded rotor, due to its highly energetic tip clearance flow, improves the pressure recovery characteristic of the exhaust diffuser, while the power production within the blading suffers a loss as a result of the tip leakage flow. In this paper, these conflicting trends are thermodynamically investigated and nondimensional expressions are derived which facilitate the task of a gas turbine system designer. Conservatively, 1% thermal efficiency gain results from elimination of the last rotor tip clearance flow. The corresponding increase in thermal efficiency of a modern gas turbine power plant due to enhanced diffuser pressure recovery is less than one percent.


2019 ◽  
Vol 23 (Suppl. 4) ◽  
pp. 1187-1197 ◽  
Author(s):  
Marek Jaszczur ◽  
Michal Dudek ◽  
Zygmunt Kolenda

One of the most advanced and most effective technology for electricity generation nowadays based on a gas turbine combined cycle. This technology uses natural gas, synthesis gas from the coal gasification or crude oil processing products as the energy carriers but at the same time, gas turbine combined cycle emits SO2, NOx, and CO2 to the environment. In this paper, a thermodynamic analysis of environmentally friendly, high temperature gas nuclear reactor system coupled with gas turbine combined cycle technology has been investigated. The analysed system is one of the most advanced concepts and allows us to produce electricity with the higher thermal efficiency than could be offered by any currently existing nuclear power plant technology. The results show that it is possible to achieve thermal efficiency higher than 50% what is not only more than could be produced by any modern nuclear plant but it is also more than could be offered by traditional (coal or lignite) power plant.


2020 ◽  
Author(s):  
J. Fajardo ◽  
D. Barreto ◽  
T. Castro ◽  
I. Baldiris

Abstract It is known that high temperatures adversely affect the performance of gas turbines, but the effect of the combination of atmospheric conditions (temperature and relative humidity -RH-) on the operation of this type of system is unknown. In this work the effects of atmospheric conditions on the energy and exergy indicators of a power plant with gas turbine were studied. The indicators studied were the mass flow, the specific work consumed by the compressor, specific work produced by the turbine, the combustion gas temperature, the NO concentration, the net output power, the thermal efficiency, the heat rate, the specific consumption of fuel, the destruction of exergy and exergy efficiency. Among the results, it is noted that for each degree celsius that reduces the temperature of the air at the compressor inlet at constant relative humidity on average, the mass flow of dry air increases by 0.27 kg/s, the specific work consumed by the compressors decreases by 0.45%, the output power increases by 1.17% and the thermal efficiency increases by 0.8%, the exergy destruction increases by 0.72% and the exergy efficiency increases by 0.81%. In addition, humidity changes relative to high temperatures are detected more significantly than at low temperatures. The power plant studied is installed in Cartagena, Colombia and since it is not operating in the design environmental conditions (15 °C and 60% relative humidity) it experiences a loss of output power of 6140 kW and a drop in thermal efficiency of 5.12 %. These results allow considering the implementation of air cooling technologies at the compressor inlet to compensate for the loss of power at atmospheric air conditions.


Author(s):  
H. Jericha ◽  
E. Go¨ttlich

The gas turbine system GRAZ CYCLE has been thoroughly studied in terms of thermodynamics and turbomachinery layout. What is to be presented here is a prototype design for an industrial size plant, suited for NG-fuel and coal and heavy fuel oil gasification products, capable to retain the CO2 from combustion and at the same time able to achieve maximum thermal efficiency. The authors hope for an international cooperation to make such a plant available within a few years.


2019 ◽  
Vol 143 ◽  
pp. 1318-1330 ◽  
Author(s):  
Nordine Sahouane ◽  
Rachid Dabou ◽  
Abderrezzaq Ziane ◽  
Ammar Neçaibia ◽  
Ahmed Bouraiou ◽  
...  

2005 ◽  
Vol 128 (3) ◽  
pp. 293-301 ◽  
Author(s):  
M. Eck ◽  
R. Buck ◽  
M. Wittmann

The dual receiver concept presented in this paper improves the adaptation of the central receiver to the steam cycle in a solar thermal power plant. By combination of an open volumetric air heater and a tubular evaporator the dual receiver concept profits from the advantages of these two concepts while their characteristic problems are avoided. The water is evaporated directly in the tubular steam generator; preheating and superheating are done in heat exchangers by using the hot air from the volumetric receiver. This paper presents a concept study that extends previous work on the 10MWel level (Buck et al., 2004, “Dual Receiver Concept for Solar Towers,” Proc. 12th Solar PACES Int. Symposium, Oct. 6–8, Oaxaca, Mexico) to a level of 100MWel, which is the expected power range of future plants. The results confirm the benefits of the new concept, resulting from higher thermal efficiency of the receiver and lower parasitic power consumption. The annual mean efficiency is increased from 13% to 16%. Advantageous are also the reduced thermal loads in the receiver components.


Sign in / Sign up

Export Citation Format

Share Document