This review, the first in a series of minireviews on the passive mechanical properties of skeletal muscles, seeks to summarize what is known about the muscle deformations that allow relaxed muscles to lengthen and shorten. Most obviously, when a muscle lengthens, muscle fascicles elongate, but this is not the only mechanism by which muscles change their length. In pennate muscles, elongation of muscle fascicles is accompanied by changes in pennation and changes in fascicle curvature, both of which may contribute to changes in muscle length. The contributions of these mechanisms to change in muscle length are usually small under passive conditions. In very pennate muscles with long aponeuroses, fascicle shear could contribute substantially to changes in muscle length. Tendons experience moderate axial strains even under passive loads, and, because tendons are often much longer than muscle fibers, even moderate tendon strains may contribute substantially to changes in muscle length. Data obtained with new imaging techniques suggest that muscle fascicle and aponeurosis strains are highly nonuniform, but this is yet to be confirmed. The development, validation, and interpretation of continuum muscle models informed by rigorous measurements of muscle architecture and material properties should provide further insights into the mechanisms that allow relaxed muscles to lengthen and shorten.
Modeling of heat flow using commercial and authorial software on the example of a permanent magnet motor