Polycrystalline cubic boron nitride (PcBN) was a high temperature and high pressure composite material with high hardness. With its high wear resistance and good chemical stability, it conforms to the basic characteristics of modern advanced cutting technology of "high efficiency, high precision, high efficiency and green". Currently, it was widely used in the field of ferrous metal cutting tools. Electrical discharge grinding was one of the most effective methods for machining polycrystalline cubic boron nitride cutters. It was especially suitable for machining complex shapes and thin edge cutters. Single pulse electrical discharge grinding is the basis of continuous EDG machining and an effective method to study micro-scale electrical discharge grinding. In this study, the morphology of single pulse discharge corrosion pits and the relationship between discharge parameters and material removal rate, such as the deep-diameter ratio of the corrosion pits, the pulse width and the deep-diameter relationship of the corrosion pits, were studied with the polycrystalline cubic boron nitride composite sheet of 2 micron particle size as the test material and the independently developed single pulse discharge power supply as the device. The experimental results show that the radius and heat affected area of the discharge corrosion pit increase rapidly, then slowly, and finally gradually with the extension of pulse duration. The corrosion depth generally varies gently in the range of 0.2 ~ 0.5 micron, and the pulse duration has no obvious effect on the depth of the discharge corrosion pit. With the extension of pulse duration, the ratio of radius to depth of the corrosion pit changed in the range of 13 ~ 20, and the ratio basically declined.
High efficiency hexagonal boron nitride neutron detectors with 1 cm2 detection areas