Simulation research of wind turbine frequency modulation based on different wind power penetration levels

2019 ◽  
Author(s):  
Xiwang Xu ◽  
Lu Sun ◽  
Ning An ◽  
Fang Li ◽  
Lining Su ◽  
...  
Keyword(s):  
Wind Turbine ◽  
Wind Power ◽  
Frequency Modulation ◽  
Simulation Research

Study on Directly Driven Wind Turbine with Permanent Magnet Synchronous Generators (D-PMSG)

2011 ◽  
Vol 383-390 ◽  
pp. 3528-3534 ◽  
Author(s):  
Zhong Yao Du ◽  
Rong Ju
Keyword(s):  
Wind Turbine ◽  
Wind Power ◽  
Mathematic Model ◽  
Module Structure ◽  
Synchronous Generators ◽  
Simulation Research ◽  
Permanent Magnet Synchronous Generators ◽  
Speed Modulation ◽  
Simulation Results ◽  
Turbine Speed

Recently, the wind power develops rapidly. In this paper, the mathematic model and vector control of D-PMSG are studied. This thesis involves in simulation research of wind turbine, speed modulation, coordinate transformation, SVPWM waves, main loop and the whole system based on module structure under the environment of MATLAB/SIMULINK. The simulation results indicate that PMSM has perfect characteristic and gives practical meanings for the studies of wind power.

scholarly journals Configuration Method and Multi-Functional Strategy for Embedding Energy Storage into Wind Turbine

Energies ◽  
2021 ◽  
Vol 14 (17) ◽  
pp. 5354
Author(s):  
Changqing Chen ◽  
Xinran Li
Keyword(s):  
Energy Storage ◽  
Power Consumption ◽  
Wind Turbine ◽  
Wind Power ◽  
Frequency Modulation ◽  
Synchronous Generator ◽  
Structure Model ◽  
Functional Strategy ◽  
Equal Capacity ◽  
Additional Value

This paper proposes a Configuration method for energy storage (ES), in which the ES inertia of ES is equal to an equal capacity synchronous generator. The purpose is to enhance the frequency modulation capability of double-fed induction generator (DFIG) and wind power consumption. Through the proposed method, the system inertia can remain unchanged after the DFIGs replacing the conventional turbines. During the DFIG rotor speed recovery, the ES releases energy to compensate for sudden changes in active power. On this basis, the DFIG and ES structure model is created, and the ES control strategy is optimized, thereby effectively improving the DFIG frequency modulation capability. Besides, in the non-frequency modulation period, the ES is used to suppress wind power fluctuations, thereby improving system wind power consumption and ES utilization. Simulation results indicate, in the ES-embedded wind turbine structure model, the combination of the ES Configuration method and multi-functional strategy significantly improves the frequency modulation ability and anti-interference performance of a single DFIG. Moreover, the wind power consumption and ES utilization are improved, and the ES achieves additional value.

scholarly journals Research on optimization strategy of grid frequency modulation based on doubly-fed wind turbines

2020 ◽  
Author(s):  
Chao Wang ◽  
Jianyuan Xu ◽  
Liang Wang ◽  
Dan Song
Keyword(s):  
Wind Turbine ◽  
Wind Power ◽  
Wind Turbines ◽  
Frequency Modulation ◽  
Control Strategy ◽  
Large Scale ◽  
Synchronous Generator ◽  
Clean Energy ◽  
Frequency Regulation ◽  
Doubly Fed

Abstract The increasing global energy and environmental problems are encouraging to the development and utilization of renewable and clean energy in various countries. Wind power is one of the major source in large-scale renewable energy applications. However, the frequency regulation becomes a critical issue while the technology is spreading. Research on the frequency modulation (FM) technology of wind turbines and its control strategy for future power grids become significant. The paper proposes a novel coordinated frequency control strategy with the synchronous generator to solve the unmatched state between the output power of the doubly-fed wind turbines (doubly-fed induction generators) and the grid frequency, combined with the frequency response characteristics of the synchronous generator. The FM coordination strategy is formulated by the modulation coefficient from current wind speed and operation mode of each wind turbine. By coordinating the FM output of the doubly-fed wind turbine and the synchronous generator within the allowable range of frequency deviation, it will achieve the dual goal of reducing the frequency regulation pressure of the synchronous generator and indirectly reducing the abandoned wind volume of the wind turbine. The simulation is carried out on the MATLAB/SIMULINK platform. The results show that the presenting variable coefficient frequency modulation strategy could significant smooth the wind power fluctuation, and allow the reserve power of the doubly-fed wind turbine can fully engaged in frequency modulation which will reduces the frequency modulation pressure of the synchronous generator in the system.

EXPERIMENTAL AND ANALYTICAL STUDIES OF VERTICAL AXIS WIND TURBINES

2018 ◽  
pp. 51-58
Author(s):  
B. P. Khozyainov
Keyword(s):  
Wind Turbine ◽  
Flow Velocity ◽  
Wind Power ◽  
Wind Turbines ◽  
Power Efficiency ◽  
Air Flow ◽  
Geometrical Parameters ◽  
Wind Speeds ◽  
Analytical Studies ◽  
Air Flow Velocity

The article carries out the experimental and analytical studies of three-blade wind power installation and gives the technique for measurements of angular rate of wind turbine rotation depending on the wind speeds, the rotating moment and its power. We have made the comparison of the calculation results according to the formulas offered with the indicators of the wind turbine tests executed in natural conditions. The tests were carried out at wind speeds from 0.709 m/s to 6.427 m/s. The wind power efficiency (WPE) for ideal traditional installation is known to be 0.45. According to the analytical calculations, wind power efficiency of the wind turbine with 3-bladed and 6 wind guide screens at wind speedsfrom 0.709 to 6.427 is equal to 0.317, and in the range of speed from 0.709 to 4.5 m/s – 0.351, but the experimental coefficient is much higher. The analysis of WPE variations shows that the work with the wind guide screens at insignificant average air flow velocity during the set period of time appears to be more effective, than the work without them. If the air flow velocity increases, the wind power efficiency gradually decreases. Such a good fit between experimental data and analytical calculations is confirmed by comparison of F-test design criterion with its tabular values. In the design of wind turbines, it allows determining the wind turbine power, setting the geometrical parameters and mass of all details for their efficient performance.

scholarly journals Impact of the Wind Turbine on the Parameters of the Electricity Supply to an Agricultural Farm

2021 ◽  
Vol 13 (13) ◽  
pp. 7279
Author(s):  
Zbigniew Skibko ◽  
Magdalena Tymińska ◽  
Wacław Romaniuk ◽  
Andrzej Borusiewicz
Keyword(s):  
Power Plant ◽  
Wind Turbine ◽  
Wind Power ◽  
Rural Areas ◽  
Power Plants ◽  
Reactive Power ◽  
Supply Voltage ◽  
Common Source ◽  
Voltage Fluctuations ◽  
The Impact

Wind power plants are an increasingly common source of electricity located in rural areas. As a result of the high variability of wind power, and thus the generated power, these sources should be classified as unstable sources. In this paper, the authors attempted to determine the impact of wind turbine operation on the parameters of electricity supplied to farms located near the source. As a result of the conducted field tests, variability courses of the basic parameters describing the supply voltage were obtained. The influence of power plant variability on the values of voltage, frequency, and voltage distortion factor was determined. To estimate the capacity of the transmission lines, the reactive power produced in the power plant and its effect on the value of the power factor were determined. The conducted research and analysis showed that the wind power plant significantly influences voltage fluctuations in its immediate vicinity (the maximum value registered was close to 2%, while the value required by law was 2.5%). Although all the recorded values are within limits specified by the current regulations (e.g., the THD value is four times lower than the required value), wind turbines may cause incorrect operation of loads connected nearby. This applies mainly to cases where consumers sensitive to voltage fluctuations are installed in the direct vicinity of the power plant.

scholarly journals Research on Zero-Voltage Ride Through Control Strategy of Doubly Fed Wind Turbine

Energies ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 2287
Author(s):  
Kaina Qin ◽  
Shanshan Wang ◽  
Zhongjian Kang
Keyword(s):  
Wind Turbine ◽  
Wind Power ◽  
Control Strategy ◽  
Large Scale ◽  
Sliding Mode ◽  
Stable Operation ◽  
Wide Range ◽  
Dc Bus ◽  
Doubly Fed ◽  
Zero Voltage

With the rapid increase in the proportion of the installed wind power capacity in the total grid capacity, the state has put forward higher and higher requirements for wind power integration into the grid, among which the most difficult requirement is the zero-voltage ride through (ZVRT) capability of the wind turbine. When the voltage drops deeply, a series of transient processes, such as serious overvoltage, overcurrent, or speed rise, will occur in the motor, which will seriously endanger the safe operation of the wind turbine itself and its control system, and cause large-scale off-grid accident of wind generator. Therefore, it is of great significance to improve the uninterrupted operation ability of the wind turbine. Doubly fed induction generator (DFIG) can achieve the best wind energy tracking control in a wide range of wind speed and has the advantage of flexible power regulation. It is widely used at present, but it is sensitive to the grid voltage. In the current study, the DFIG is taken as the research object. The transient process of the DFIG during a fault is analyzed in detail. The mechanism of the rotor overcurrent and DC bus overvoltage of the DFIG during fault is studied. Additionally, the simulation model is built in DIgSILENT. The active crowbar hardware protection circuit is put into the rotor side of the wind turbine, and the extended state observer and terminal sliding mode control are added to the grid side converter control. Through the cooperative control technology, the rotor overcurrent and DC bus overvoltage can be suppressed to realize the zero-voltage ride-through of the doubly fed wind turbine, and ensure the safe and stable operation of the wind farm. Finally, the simulation results are presented to verify the theoretical analysis and the proposed control strategy.

Comparative Exploration of Mini Vertical Axis Breeze-Driven Generator

2014 ◽  
Vol 670-671 ◽  
pp. 964-967
Author(s):  
Shu Hua Bai ◽  
Hai Dong Yang
Keyword(s):  
Natural Gas ◽  
Wind Turbine ◽  
Wind Power ◽  
North Africa ◽  
Large Scale ◽  
Solar Power ◽  
Vertical Axis ◽  
Green Energy ◽  
Energy Crisis ◽  
Fossil Energy

Nowadays, energy crisis is becoming increasingly serious. Coal, petroleum, natural gas and other fossil energy tend to be exhausted due to the crazy exploration. In recent decades, several long lasting local wars broke out in large scale in Mideast and North Africa because of the fighting for the limited petroleum. The reusable green energy in our life like enormous wind power, solar power, etc is to become the essential energy. This article is to conduct a comparative exploration of mini wind turbine, with the purpose of finding a good way to effectively deal with the energy crisis.

Hub height optimisation of commercial WTGs based on accurate wind resource analysis

2021 ◽  
pp. 0309524X2110227
Author(s):  
Kyle O Roberts ◽  
Nawaz Mahomed
Keyword(s):  
Power Generation ◽  
Wind Turbine ◽  
Wind Power ◽  
Capacity Factor ◽  
Resource Analysis ◽  
Wind Speeds ◽  
Unique Maximum ◽  
Wind Measurements ◽  
Generation Capacity ◽  
Wind Resource

Wind turbine selection and optimal hub height positioning are crucial elements of wind power projects. However, in higher class wind speeds especially, over-exposure of wind turbines can lead to a reduction in power generation capacity. In this study, wind measurements from a met mast were validated according to specifications issued by IRENA and NREL. As a first step, it is shown that commercial WTGs from a database may be matched to the wind class and turbulence intensity. Secondly, a wind turbine selection algorithm, based on maximisation of capacity factor, was implemented across the range of WTGs. The selected WTGs were further exposed to an iterative algorithm using pointwise air density and wind shear coefficients. It is shown that a unique maximum capacity factor, and hence wind power generation, exists for a wind turbine, premised on its eventual over-exposure to the wind resource above a certain hub height.

Sign in / Sign up

Export Citation Format

Share Document