scholarly journals Energy-efficient solar power plants for autonomous heat supply in Russia

2018 ◽  
Vol 251 ◽  
pp. 03012 ◽  
Author(s):  
Pavel Khavanov ◽  
Anatoly Chulenyov

In the complex of measures for energy saving, partial replacement and reduction of consumption of fossil energy and electricity, water heating solar installations for heating systems have long been in practice for small energy facilities. Solar energy is one of the most dynamically developing directions of use of renewable energy sources, especially the introduction of which are associated with climatic conditions and technical requirements of their application. The territory of Russia is located mainly in the cold climatic zone and in regions with a sharply continental climate in which the operation of water heating solar plants is justified and most rational in seasonal use, in this case, their technical operation is carried out mainly during the non-heating period of the year. In such installations, in a number of cases, it is possible to avoid the need to use “non-freezing” heat carriers, and therefore the thermal schemes of the plants are simpler in design and cheaper, since heat exchangers or bivalent storage tanks can be excluded to transfer heat from the antifreeze to the water of the heating circuit or hot water system.

Author(s):  
Harshkumar Patel ◽  
Yogesh Patel

Now-a-days energy planners are aiming to increase the use of renewable energy sources and nuclear to meet the electricity generation. But till now coal-based power plants are the major source of electricity generation. Disadvantages of coal-based thermal power plants is disposal problem of fly ash and pond ash. It was earlier considered as a total waste and environmental hazard thus its use was limited, but now its useful properties have been known as raw material for various application in construction field. Fly ash from the thermal plants is available in large quantities in fine and coarse form. Fine fly ash is used in construction industry in some amount and coarse fly ash is subsequently disposed over land in slurry forms. In India around 180 MT fly is produced and only around 45% of that is being utilized in different sectors. Balance fly ash is being disposed over land. It needs one acre of land for ash disposal to produce 1MW electricity from coal. Fly ash and pond ash utilization helps to reduce the consumption of natural resources. The fly ash became available in coal based thermal power station in the year 1930 in USA. For its gainful utilization, scientist started research activities and in the year 1937, R.E. Davis and his associates at university of California published research details on use of fly ash in cement concrete. This research had laid foundation for its specification, testing & usages. This study reports the potential use of pond-ash and fly-ash as cement in concrete mixes. In this present study of concrete produced using fly ash, pond ash and OPC 53 grade will be carried. An attempt will be made to investigate characteristics of OPC concrete with combined fly ash and pond ash mixed concrete for Compressive Strength test, Split Tensile Strength test, Flexural Strength test and Durability tests. This paper deals with the review of literature for fly-ash and pond-ash as partial replacement of cement in concrete.


Author(s):  
Александр Григорьевич Комков ◽  
Александр Константинович Сокольский

В статье рассмотрено современное состояние энергоснабжения и перспективы развития альтернативных источников энергии на территории Крайнего Севера. Отмечено, что несмотря на острую потребность во внедрении возобновляемых источников энергии, установленные мощности всех ветряных и солнечных электростанций в регионе не превышают 7-8 МВт. Также в работе рассчитаны технический и экономический потенциал ветровой энергии региона, на основании которых подобрана наиболее эффективная установка. The article discusses the current state of energy supply and the prospects for the development of alternative energy sources in the Far North. It is noted that despite the urgent need for the introduction of renewable energy sources, the installed capacities of all wind and solar power plants in the region do not exceed 7-8 MW. Also, the technical and economic potential of the region’s wind energy was calculated based on which the most efficient installation was selected.


2013 ◽  
Vol 315 ◽  
pp. 783-787
Author(s):  
M.Yaakob Yuhazri ◽  
A.M. Kamarul ◽  
A.H. Rahimah ◽  
Sihombing Haeryip ◽  
S.H. Yahaya

This research is related to thermal efficient water heating system, specifically to improve the water heating system that exists nowadays. The goal of this research is to improve the current water heating system by using solar heat as the energy source to heat the water. The focus is to improve the thermal efficiency by adding different thermal boxes as the absorber bed. By implementing the black body and radiation concept, the air trapped in the box is heated. The trapped air then increases the collisions between the molecules and directly increases the temperature inside the box, higher than the outside environment. Based on a daytime experimental result revealed steel thermal box is better to be used for tropical weather like Malaysia.


Author(s):  
Baba Dzhabrailovich Babaev ◽  
Vladimir Panchenko ◽  
Valeriy Vladimirovich Kharchenko

The main objective of the work is to develop principles for the formation of the optimal composition of the energy complex from all the given power plants based on renewable energy sources for an autonomous consumer, taking into account the variable energy loads of the consumer, changing climatic conditions and the possibility of using local fuel and energy resources. As a result of solving this optimization problem, in addition to the optimal configuration of the power complex, it is also necessary to solve the problem of optimizing the joint operation of different types of power plants from the selected optimal configuration, that is, it is necessary to determine the optimal modes of operation of power plants and the optimal share of their participation in providing consumers at every moment in time. A numerical method for analyzing and optimizing the parameters and operating mode of the energy complex with the most accurate consideration of the schedule of changes in consumer load and software that automates the solution of this optimization problem are also presented.


A completed study of a solar hot water heating system installed in a school showed an annual average efficiency of 15%, the low efficiency largely caused by the unfavourable pattern of use in schools. Field studies, in 80 existing and 12 new houses, of a simple domestic hot water system have been initiated to ascertain the influence of the occupants on the actual performance of solar collector systems. The development of testing methods of solar collectors and solar water heating systems is being undertaken in close collaboration with the B.S.I. and the E.E.C. Solar space heating is being investigated in two experimental low energy house laboratories, one using conventional solar collectors with interseasonal heat storage and the other a heat pump with an air solar collector. Studies of the cost-effectiveness of solar collector applications to buildings in the U.K. show that they are far less cost-effective than other means of conserving energy in buildings.


2019 ◽  
Vol 124 ◽  
pp. 01040 ◽  
Author(s):  
D. T. Nguen ◽  
D. N. Pham ◽  
G. R. Mingaleeva ◽  
O. V. Afanaseva ◽  
P. Zunino

The growing demand for energy and fossil fuels creates increased number of difficulties, while renewable energy sources are still rarely used worldwide, particularly in Vietnam. In this article hybrid thermal power plants based on gas turbine plants are discussed, the increased efficiency of which is achieved by air heating after the compressor in solar air heaters. The basic design equations and the results of evaluating the efficiency and fuel consumption are presented for two thermal power plants of 4.6 MW and 11.8 MW. The dependence of the results on the intensity of solar extraction for the climatic conditions of the Ninh Thuan province of the Republic of Vietnam is discussed.


2018 ◽  
Vol 5 ◽  
pp. 56-65
Author(s):  
Alexander Foldi ◽  
Duy Khang Simba Nguyen ◽  
Yeong Cherng Yap

The desire to increase the efficiency of existing renewable energy sources has been thoroughly researched over the past years. This meta study aimed to investigate existing methods used by previous researchers to increase the Specific Heat Capacity of Molten Salt used for Concentrated Solar Power Plants. Investigations into nanoparticles were explored because of the effect of particle size and concentration can potentially increase the specific heat capacity of the molten salt. Numerous nanoparticles have shown to improve the thermal properties such as Silica (SiO2), Alumina (Al2O3), Titania (TiO2). Our summation was that the addition of nanoparticles into Molten Salts shows an increase in desired thermal properties of the Molten Salts. An efficiency increase of up to 28% was noted in the SHC (Cp) of the Molten Salts when Nanoparticles of 60nm were introduced.


2016 ◽  
Vol 19 ◽  
pp. 124-131
Author(s):  
Beate Naser ◽  
Franziska Schäfer ◽  
Jörg Franke

By increasing the share of renewable energy sources, the volatility of available energy is rising. More and more fluctuating power generation by solar power plants and wind turbines has to be integrated into the power grid. Demand side management (DSM) represents one possible solution to achieve this goal by including energy production and energy consumption simultaneously. In this paper, we especially focus on the field of electric energy in smart homes. Considering the implementation of different DSM devices, an ontology-based approach can serve as a conceptual foundation for a necessary knowledge base. We propose an advanced energy ontology for smart homes, integrating important aspects for a successful DSM. We describe how power producers, storages and consumers are represented in our ontology. Finally, we show the scenario-based utilization of our approach.


2014 ◽  
Vol 1020 ◽  
pp. 518-523
Author(s):  
Martin Kovac ◽  
Katarina Knizova

The subject of the paper is to calculate the energy performance of building in proposed variants. The differences in the variants are in the using of conventional and renewable sources for heating and domestic hot water system. Target of the second part of paper is to know, how much money we need to invest into the proposed variants for heating and domestic hot water systems and how much money will by the user paying for operating costs. The conclusion of the paper describes the payback periods of proposed variants.


Sign in / Sign up

Export Citation Format

Share Document