Closure to “New Approach for the Computation of the Water Surface Angle in Partially Filled Pipes: Pipes Arranged in Parallel” by Lotfi Zeghadnia and Jean Loup Robert

2020 ◽  
Vol 11 (4) ◽  
pp. 07020002
Author(s):  
Imed Boukhari ◽  
Lotfi Zeghadnia ◽  
Lakhdar Djemili ◽  
Jean loup Robert
Keyword(s):  
Water Surface ◽  
New Approach ◽  
Surface Angle

NEW CONCEPTS IN SPRAYING DISPERSANTS FROM BOATS

1985 ◽  
Vol 1985 (1) ◽  
pp. 3-6
Author(s):  
Tom E. Allen
Keyword(s):  
Water Surface ◽  
High Speed ◽  
Design Parameters ◽  
Stream Velocity ◽  
New Approach ◽  
Air Stream ◽  
New Concepts ◽  
Straight Line ◽  
Coverage Rates ◽  
Wide Swath

ABSTRACT A new approach to applying chemical dispersants from boats has been developed. The equipment has a greater swath width and, thus, greater coverage rates than existing technology. Coverage rates of 2½ square miles per day per boat are likely and four or more square miles per day is possible. The method utilizes high speed fans which create a focused air stream with maximum velocities of 90 miles per hour. Dispersant is injected into and propelled by the air stream. With the air stream acting as a carrier for the dispersant, the spraying of smaller volumes of concentrate dispersant or dilute dispersant over a wide swath width is made possible. The focused air stream and dispersant impacts the water surface in approximately a straight line. The water surface is gently agitated by the air stream and liquid impact. A dispersant fan sprayer has been built and tested statically on land and demonstrated offshore on a supply vessel while spraying water. Design parameters include fan size, air stream velocity, expected swath width, and concentrate (low volume) versus dilute (large volume) spraying.

scholarly journals The effects of three plasma-activated water generation systems on lettuce seed germination

2021 ◽  
Author(s):  
rouzbeh abbaszadeh ◽  
Pegah KHOSRAVİ NİA ◽  
Mahsa Fattahi ◽  
Hamid Ghomi
Keyword(s):  
Water Treatment ◽  
Electrical Discharge ◽  
Water Surface ◽  
Germination Rate ◽  
Lettuce Seed ◽  
New Approach ◽  
Lettuce Seeds ◽  
Mean Germination Time ◽  
Lettuce Seed Germination ◽  
Plasma Activated Water

Irrigation water treatment using plasma technology is a new approach to improve productivity. In this study the generation of plasma-activated water (PAW) as a novel subject in agriculture is investigated. Three water treatment systems were designed and evaluated: 1<sup>st</sup> PAW generation from vapor and injection into the water, 2<sup>nd</sup> PAW generation using electrical discharge on the water surface and 3<sup>rd</sup> PAW generation in the aeration path into the water. The lettuce seeds were irrigated with PAW. The germination rate and mean germination time were measured after 6 days. The seedlings weight and the number of seedlings with a length of more than 3 cm were also recorded after 8 days. The results showed that PAW had a significant effect on the germination rate and length of seedlings. Electrical discharge on the water surface had the best results. Germination rate and the number of seedlings with a length of more than 3 cm increased by 11 and 36% respectively. While injection of plasma-treated air into the water significantly reduced the number of seedlings longer than 3 cm, compared to the control. In conclusion, the PAW application can improve some attributes of lettuce germination depending on the PAW system.  

The O–C diagrams of minor planets − a new approach to modelling the rotation

1999 ◽  
Vol 173 ◽  
pp. 185-188
Author(s):  
Gy. Szabó ◽  
K. Sárneczky ◽  
L.L. Kiss
Keyword(s):  
Error Analysis ◽  
Time Dependence ◽  
Theoretical Work ◽  
Minor Planet ◽  
Minor Planets ◽  
New Approach ◽  
Preliminary Results ◽  
Ccd Observations

AbstractA widely used tool in studying quasi-monoperiodic processes is the O–C diagram. This paper deals with the application of this diagram in minor planet studies. The main difference between our approach and the classical O–C diagram is that we transform the epoch (=time) dependence into the geocentric longitude domain. We outline a rotation modelling using this modified O–C and illustrate the abilities with detailed error analysis. The primary assumption, that the monotonity and the shape of this diagram is (almost) independent of the geometry of the asteroids is discussed and tested. The monotonity enables an unambiguous distinction between the prograde and retrograde rotation, thus the four-fold (or in some cases the two-fold) ambiguities can be avoided. This turned out to be the main advantage of the O–C examination. As an extension to the theoretical work, we present some preliminary results on 1727 Mette based on new CCD observations.

Immunoferritin localization of intracellular antigens in positively stained frozen sections

1978 ◽  
Vol 36 (2) ◽  
pp. 168-169
Author(s):  
K. T. Tokuyasu
Keyword(s):  
Surface Tension ◽  
Water Surface ◽  
Thin Layers ◽  
The Other ◽  
Positive Staining ◽  
Frozen Sections ◽  
The Past ◽  
Ultrathin Frozen Sections ◽  
Definition Of

During the past investigations of immunoferritin localization of intracellular antigens in ultrathin frozen sections, we found that the degree of negative staining required to delineate u1trastructural details was often too dense for the recognition of ferritin particles. The quality of positive staining of ultrathin frozen sections, on the other hand, has generally been far inferior to that attainable in conventional plastic embedded sections, particularly in the definition of membranes. As we discussed before, a main cause of this difficulty seemed to be the vulnerability of frozen sections to the damaging effects of air-water surface tension at the time of drying of the sections.Indeed, we found that the quality of positive staining is greatly improved when positively stained frozen sections are protected against the effects of surface tension by embedding them in thin layers of mechanically stable materials at the time of drying (unpublished).

A New Approach to the Demonstration of Oxidase-Localization Using Tannic Acid Or Catechin

1973 ◽  
Vol 31 ◽  
pp. 698-699
Author(s):  
V. Mizuhira ◽  
Y. Futaesaku
Keyword(s):  
Cross Section ◽  
Tannic Acid ◽  
Elastic Fiber ◽  
The Other ◽  
New Approach ◽  
Tissue Block ◽  
Active Reaction ◽  
The Cross

Previously we reported that tannic acid is a very effective fixative for proteins including polypeptides. Especially, in the cross section of microtubules, thirteen submits in A-tubule and eleven in B-tubule could be observed very clearly. An elastic fiber could be demonstrated very clearly, as an electron opaque, homogeneous fiber. However, tannic acid did not penetrate into the deep portion of the tissue-block. So we tried Catechin. This shows almost the same chemical natures as that of proteins, as tannic acid. Moreover, we thought that catechin should have two active-reaction sites, one is phenol,and the other is catechole. Catechole site should react with osmium, to make Os- black. Phenol-site should react with peroxidase existing perhydroxide.

Processing Immunoperoxidase Labeled Cell Monolayers and Cryostat Sesctions For Electron Microscopy

1985 ◽  
Vol 43 ◽  
pp. 714-715
Author(s):  
K. Chien ◽  
R. Van de Velde ◽  
I.P. Shintaku ◽  
A.F. Sassoon
Keyword(s):  
Cell Monolayer ◽  
Cell Types ◽  
Surface Antigens ◽  
Immunoperoxidase Method ◽  
Reaction Step ◽  
Hot Plate ◽  
Air Drying ◽  
New Approach ◽  
Cell Monolayers ◽  
Glass Slides

Immunoelectron microscopy of neoplastic lymphoma cells is valuable for precise localization of surface antigens and identification of cell types. We have developed a new approach in which the immunohistochemical staining can be evaluated prior to embedding for EM and desired area subsequently selected for ultrathin sectioning.A freshly prepared lymphoma cell suspension is spun onto polylysine hydrobromide- coated glass slides by cytocentrifugation and immediately fixed without air drying in polylysine paraformaldehyde (PLP) fixative. After rinsing in PBS, slides are stained by a 3-step immunoperoxidase method. Cell monolayer is then fixed in buffered 3% glutaraldehyde prior to DAB reaction. After the DAB reaction step, wet monolayers can be examined under LM for presence of brown reaction product and selected monolayers then processed by routine methods for EM and embedded with the Chien Re-embedding Mold. After the polymerization, the epoxy blocks are easily separated from the glass slides by heatingon a 100°C hot plate for 20 seconds.

Sign in / Sign up

Export Citation Format

Share Document