scholarly journals Fully Differential 4-V Output Range 14.5-ENOB Stepwise Ramp Stimulus Generator for On-Chip Static Linearity Test of ADCs

Author(s):  
Guillaume Renaud ◽  
Mamadou Diallo ◽  
Manuel J. Barragan ◽  
Salvador Mir
Sensors ◽  
2019 ◽  
Vol 19 (17) ◽  
pp. 3673
Author(s):  
Christopher Rogi ◽  
Cesare Buffa ◽  
Niccolo De Milleri ◽  
Richard Gaggl ◽  
Enrique Prefasi

This article focuses on a proposed Switched-Capacitor Dual-Slope based CDC. Special attention is paid to the measurement setup using a real pressure sensor. Performance scaling potential as well as dead zones are pointed out and discussed. In depth knowledge of the physical sensor behavior is key to design an optimal readout circuit. While this is true for high-end applications, low-performance IoT (Internet of Things) sensors aim at moderate resolution with very low power consumption. This article also provides insights into basic MEMS (Micro-Electro-Mechanical-System) physics. Based on that, an ambient air pressure sensor model for SPICE (Simulation-Program-with-Integrated-Circuit-Emphasis) circuit simulators is presented. The converter concept was proven on silicon in a 0.13 μ m process using both a real pressure sensor and an on-chip dummy MEMS bridge. A 3.2-ms measurement results in 13-bit resolution while consuming 35 μ A from a 1.5-V supply occupying 0.148 mm2. A state-of-the-art comparison identifies potential room for improvements towards hybrid solutions, which is proposed in subsequent publications already.


Author(s):  
Guillaume Renaud ◽  
Manuel J. Barragan ◽  
Salvador Mir ◽  
Marc Sabut
Keyword(s):  
On Chip ◽  

Micromachines ◽  
2020 ◽  
Vol 11 (2) ◽  
pp. 119 ◽  
Author(s):  
Yi Zhang ◽  
Jing-Fu Bao ◽  
Xin-Yi Li ◽  
Xin Zhou ◽  
Zhao-Hui Wu ◽  
...  

As one of the core components of MEMS (i.e., micro-electro-mechanical systems), thin-film piezoelectric-on-silicon (TPoS) resonators experienced a blooming development in the past decades due to unique features such as a remarkable capability of integration for attractive applications of system-on-chip integrated timing references. However, the parasitic capacitive feedthrough poses a great challenge to electrical detection of resonance in a microscale silicon-based mechanical resonator. Herein, a fully-differential configuration of a TPoS MEMS resonator based on a novel structural design of dual interdigital electrodes is proposed to eliminate the negative effect of feedthrough. The fundamental principle of feedthrough suppression was comprehensively investigated by using FEA (i.e., finite-element analysis) modeling and electrical measurements of fabricated devices. It was shown that with the help of fully-differential configuration, the key parameter of SBR (i.e., signal-to-background ratio) was significantly enhanced by greatly suppressing the in-phase signal. The S-parameter measurement results further verified the effectiveness of this novel feedthrough suppression strategy, and the insertion loss and SBR of proposed TPoS resonators were improved to 4.27 dB and 42.47 dB, respectively.


Author(s):  
A. J. Gines ◽  
E. Peralias ◽  
G. Leger ◽  
A. Rueda ◽  
G. Renaud ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document