Resistance Against Cavitation Erosion of 14 Chromium Steels

1970 ◽  
Vol 92 (2) ◽  
pp. 220-226 ◽  
Author(s):  
J. W. Tichler ◽  
J. B. van den Elsen ◽  
A. W. J. de Gee

For 14 chromium steels of different composition and structure, cavitation-erosion damage has been studied and interpreted in terms of structure and strength properties. The use of chambered cylindrical specimens ensured a uniform attack from the very beginning of the erosion process and, thus, highly reproducible wear values. As could be expected on the basis of existing evidence, the duration of the incubation period is a function of the initial condition of the surface, as determined by the finishing process. The reciprocal rate of volume loss, occurring during the first steady-state period (which is characterized by a uniform attack of the surface, without formation of deep craters) (Rc), turned out to be a linear function of the “true” tensile strength, measured at maximum load. It does not depend on grain size, structure and elongation properties of the material. On the other hand, the tendency toward the formation of craters in the surface and the ratio Rc/R∼, in which R∼ is the reciprocal rate of volume loss, during the second, and final, steady-state period, are shown to be exclusively determined by structural parameters.

Author(s):  
Matylda Tankiewicz

Abstract In the paper the results of laboratory investigations of structure of layered soil are presented. They focus on varved clay that is a soil composed of two alternately arranged varves with different texture and mechanical properties. An effect of such structure is an anisotropy of the material. Due to varying conditions during its formation process the soil exhibits some irregularities in composition and structure. Due to that modelling of mechanical behavior, like strength, may not provide satisfactory results. Main purpose of the examinations is an investigation of internal structure of layered soil – varved clay – in relation to its strength anisotropy and evaluation of the suitability of the use of two different techniques to assess the soil structure. Investigated material have been taken from area near city of Bełchatów in central Poland. The examinations included investigation of particle size distribution of soil and its components, identification of lamination with use of scanning electron microscope (SEM) and computed microtomography technique (μCT). First, the texture of each varve and varved clay as a composite have been estimated. Next, the investigation of surface perpendicular to the lamination have been carried out with SEM. Pictures of varves with different magnifications are presented. Also the varves arrangement and details of layers contact area are shown. Finally, investigation of internal structure of the soil have been performed by using microtomograph. The outcome is a series of radiographic images and reconstructed 3D model of tested soil. Presented results show complexity of the structure of varved clay that affect the mechanical behavior. Determination of the structure with use of presented techniques may be helpful in examination of strength properties and proper modeling of such soil.


1998 ◽  
Vol 120 (2) ◽  
pp. 405-409 ◽  
Author(s):  
P. Monmousseau ◽  
M. Fillon ◽  
J. Freˆne

Nowadays, tilting-pad journal bearings are submitted to more and more severe operating conditions. The aim of this work is to study the thermal and mechanical behavior of the bearing during the transient period from an initial steady state to a final steady state (periodic). In order to study the behavior of this kind of bearing under dynamic loading (Fdyn) due to a blade loss, a nonlinear analysis, including local thermal effects, realistic boundary conditions, and bearing solid deformations (TEHD analysis) is realized. After a comparison between theoretical results obtained with four models (ISO, ADI, THD, and TEHD) and experimental data under steady-state operating conditions (static load Ws), the evolution of the main characteristics for three different cases of the dynamic load (Fdyn/Ws < 1, Fdyn/Ws = 1 and Fdyn//Ws > 1) is discussed. The influence of the transient period on the minimum film thickness, the maximum pressure, the maximum temperature, and the shaft orbit is presented. The final steady state is obtained a long time after the appearance of a dynamic load.


2018 ◽  
Vol 26 (2(128)) ◽  
pp. 79-86 ◽  
Author(s):  
Pengbi Liu ◽  
Hong Shao ◽  
Nanliang Chen ◽  
Nanliang Cheng ◽  
Jinhua Jiang ◽  
...  

This paper studied the relationship between the textile structure of warp knitted hernia repair meshes and their physico-mechanical properties to solve the problem of hernia patch application evaluation and clear the mechanism of hernia patch structure-performance for clinical application. Six different prototypes of large pore meshes were fabricated, including four kinds of meshes with different pore shapes: H (hexagonal), D (diamond), R (round) and P (pentagonal); and two kinds of meshes with inlays: HL (hexagonal with inlays) and DL (diamond with inlays), using the same medical grade polypropylene monofilament. All meshes were designed with the same walewise density and coursewise density. Then the influence of other structural parameters on the physico-mechanical properties of the meshes was analysed. The physico-mechanical properties of these meshes tested meet the requirements of hernia repair, except mesh DL, whose tear resistance strength (12.93 ± 2.44 N in the transverse direction) was not enough. Mesh R and P demonstrated less anisotropy, and they exhibited similar physico-mechanical properties. These four kinds of meshes without inlays demonstrated similar ball burst strength properties, but mesh HL and DL exhibited better ball burst strength than the others. All in all, uniform structures are expected to result in less anisotropy, and meshes with inlays, to some extent, possess higher mechanical properties. And the ratio of open loop number to closed loop number in a repetition of weave of fabric has marked effect on the physico-mechanical properties. Thus we can meet the demands of specific patients and particular repair sites by designing various meshes with appropriate textile structures.


CORROSION ◽  
1993 ◽  
Vol 49 (11) ◽  
pp. 910-920 ◽  
Author(s):  
J. G. Auret ◽  
O. F. R. A. Damm ◽  
G. J. Wright ◽  
F. P. A. Robinson

Abstract A vibratory-type cavitation test rig was constructed to study the effect of polarizing currents applied to a cavitating body. The generation of gas by electrolysis reduced mechanical damage suffered by a cavitating body because of bubble collapse cushioning. However, the net effect on overall damage depended on several factors, including the intensity of mechanical attack, corrosion rate, and surface geometrical effects. A cathodic current was shown to always decrease of the total volume loss rate, but the volume loss rate sometimes was increased and sometimes was reduced in the anodic current range.


Sensors ◽  
2019 ◽  
Vol 19 (15) ◽  
pp. 3413 ◽  
Author(s):  
Pengcheng Zhao ◽  
Jingang Wang ◽  
Qian Wang ◽  
Qianbo Xiao ◽  
Ruiqiang Zhang ◽  
...  

Accurate measurement of overvoltage in power grids is of great significance to study the characteristics of overvoltage and design of insulation coordination. Based on the research of D-dot voltage sensor, we designed a Dual-Differential D-dot overvoltage sensor. In order to quantify the structural parameters of the sensor, improve the performance and measurement accuracy of the sensor. The Field-Circuit Coupling method was proposed to be used in the parameter design of D-dot overvoltage sensor. The joint simulation of space electromagnetic field model and equivalent circuit model of the Dual-Differential D-dot overvoltage sensor was established with the finite element simulation software Ansoft Maxwell and circuit simulation software Simplorer. Finally, the actual sensor was manufactured. A test platform was built to verify the steady-state and transient performance of the sensor. The results show that the Dual-Differential D-dot sensor has excellent steady-state and transient performance, the error of phase and amplitude are small, and the sensor can achieve the non-contact measurement of power transmission line. Simultaneously, the rationality of the Field-Circuit Coupling method was further verified.


2012 ◽  
Vol 232 ◽  
pp. 521-526
Author(s):  
Hui Wang ◽  
Zhuo Xu ◽  
Fan Long Meng

Based on the theoretical analysis on working principle and motion of the electro-hydraulic proportional variable piston pump, it created and simulated the model in the AMESIM software. The influences of main structural parameters of variable pump on system output dynamic characteristics were revealed after simulating analysis results of pressure control characteristics. And the steady state output of system pressure is proportional to the input voltage of amplifier. The overshoot decreases with the increasing of input voltage, and the response get faster. The damping aperture of proportional reversing valve and core diameter of control plunger have a greater influence on the dynamic response of system.


1994 ◽  
Vol 259 ◽  
pp. 107-124 ◽  
Author(s):  
P. G. Daniels ◽  
P. Wang

The temporal evolution of thermally driven flow in a shallow laterally heated cavity is studied for the nonlinear regime where the Rayleigh number R based on cavity height is of the same order of magnitude as the aspect ratio L (length/height). The horizontal surfaces of the cavity are assumed to be thermally insulating. For a certain class of initial conditions the evolution is found to occur over two non-dimensional timescales, of order one and of order L2. Analytical solutions for the motion throughout most of the cavity are found for each of these timescales and numerical solutions are obtained for the nonlinear time-dependent motion in end regions near each lateral wall. This provides a complete picture of the evolution of the steady-state flow in the cavity for cases where instability in the form of multicellular convection does not occur. The final steady state evolves on a dimensional timescale proportional to l2/κ, where l is the length of the cavity, κ is the thermal diffusivity of the fluid and the constant of proportionality depends on the ratio R/L.


Blood ◽  
2015 ◽  
Vol 126 (23) ◽  
pp. 546-546 ◽  
Author(s):  
Odianosen Eigbire-Molen ◽  
Deepika S. Darbari ◽  
Maria R. Ponisio ◽  
Mikhail V. Milchenko ◽  
Mark J. Rodeghier ◽  
...  

Abstract Introduction: Neurological injury is a common complication of sickle cell anemia (SCA). SCA is the most common cause of stroke in children between 1-14 years of age, while silent cerebral infarct is the most common neurologic injury in this population. Young children are particularly vulnerable to the adverse impact of strokes, and are at risk of cognitive and developmental deficits; thus, we sought to examine brain volume changes in children with SCA. The Silent Cerebral Infarct Transfusion (SIT) Trial was a multicenter trial designed to determine the efficacy of blood transfusion therapy for prevention of recurrent silent cerebral infarcts in participants with SCA. This intervention trial followed 196 children with SCA aged 5-14 years randomized to receive blood transfusion therapy or observation for 36 months (DeBaun et al. N Engl J Med. 2014;371(8):699-710). As a planned secondary analysis, we used the SIT Trial brain imaging archive to determine longitudinal brain volume change in children with SCA. We performed a multivariable analysis using demographic and clinical variables to identify predictors of brain volume change. Methods SIT participants: The current study used a subset of the registered participants (n=169) in the SIT Trial with brain MRIs at study entry and exit, demographic and clinical information. Estimation of brain volume and percent brain volume change: Baseline brain volume and longitudinal percent brain volume change (PBVC) were derived from T1-weighted structural MRIs using the automated image analysis programs SIENAX and SIENA, respectively, from the FMRIB Software Library (FSL) (www.fmrib.ox.ac.uk/fsl). For each participant, PBVC was calculated between entry and exit brain MR scans, a mean time of 41 ± 6 months. A negative PBVC indicates a decrease in brain volume and a positive PBVC indicates an increase in brain volume. All analyses were performed blinded to the participant's identity. Statistical Analysis: A multivariable linear regression analysis was used to determine predictors of PBVC. The model included the following potential covariates : demographic variables (age, gender), laboratory measures (baseline oxygen saturation, steady state hemoglobin, steady state WBC, systolic blood pressure, % Hemoglobin F, steady state reticulocytes), clinical measures (acute chest syndrome and painful crisis rates), and regular transfusions provided as part of the trial. Results: Of the 169 SIT participants, 96 were male and 73 were female, including 80 participants in the observation group and 89 in the transfusion group. Median normalized brain volume was 1,237.6 cm3 at the study entry and 1,194.7 cm3 at exit. Baseline brain volume in males was different from females (1,290.6 cm3 vs. 1,166.6 cm3; p<0.001). Comparing total brain volumes from entry to exit, the mean percent brain volume change was -2.7% (median, -2.4%; SD, 2.75). Percent brain volume change in males was not different from females (-2.6% vs. -2.8%; p=0.75). In the multivariable analysis of demographic, clinical, and pain measures, age was the only significant predictor of PBVC (p<0.001) (Figure 1). Conclusion: Using longitudinal MRI images from the SIT Trial, we demonstrate progressive brain volume loss in children, with SCA with a mean percent brain volume change of -2.7% in the SIT Trial cohort. In comparison, brain volumes of children without SCA have been reported to remain stable in this age group (Cereb Cortex. 2012; 22 (1):1-12). We conclude that loss of brain volume begins early in children with SCA. Further investigations into the etiology of brain volume loss in children with SCA, and measures to better understand and reduce or prevent brain volume loss in SCA are needed. References 1. Controlled trial of transfusions for silent cerebral infarcts in sickle cell anemia. DeBaun MR, Gordon M, McKinstry RC, et al. N Engl J Med. 2014;371(8):699-710. 2. Total and regional brain volumes in a population-based normative sample from 4 to 18 years: the NIH MRI Study of Normal Brain Development. Cereb Cortex. 2012;22(1):1-12. Figure 1. Age at randomization versus percent change in brain volume in 169 participants randomly allocated to receive blood transfusion therapy or observation for median of 36 months. Figure 1. Age at randomization versus percent change in brain volume in 169 participants randomly allocated to receive blood transfusion therapy or observation for median of 36 months. Disclosures No relevant conflicts of interest to declare.


Sign in / Sign up

Export Citation Format

Share Document