Control of Plasma Etch Profiles with Plasma Sheath Electric Field and RF Power Density

1982 ◽  
Vol 129 (11) ◽  
pp. 2541-2547 ◽  
Author(s):  
C. B. Zarowin ◽  
R. S. Horwath
2010 ◽  
Vol 24 (08) ◽  
pp. 937-942 ◽  
Author(s):  
K. OZGA ◽  
J. EBOTHÉ ◽  
H. NGUYEN CONG ◽  
D. MARTEL ◽  
W. GRUHN ◽  
...  

In the present paper, we study the influence of simultaneous polarized optical treatment (10 ns Nd: YAG lasers with wavelengths 1064 nm and 532 nm with power density 0.6 GW/cm2) together with electrostatic dc electric field (up to 8 kV/cm) on self-assembled multi-layer film samples. The second-order optical susceptibility (SOS) achieves the maximal values after one minute simultaneous dc electrical-optical treatment. Further treatment will not enhance the values and even leads to the decrease of SOS. The independent measurement of the local temperature shows that local heating does not exceed 10.1 K.


2019 ◽  
Vol 40 (2) ◽  
pp. 279-282 ◽  
Author(s):  
Shoichiro Imanishi ◽  
Kiyotaka Horikawa ◽  
Nobutaka Oi ◽  
Satoshi Okubo ◽  
Taisuke Kageura ◽  
...  

1989 ◽  
Vol 165 ◽  
Author(s):  
J. D. Chapple-Sokol ◽  
E. Tiemey ◽  
J. Batey

AbstractSilicon dioxide films deposited from the PECVD reaction of silane and nitrous oxide in the presence of helium were studied to determine the effects of RF power on the deposition process. Increased RF power density yielded oxides which were structurally and chemically more homogeneous. The combination of elevated power density with increased silane concentration resulted in the deposition of films of high electrical and physical integrity at high deposition rates.


2007 ◽  
Vol 1035 ◽  
Author(s):  
Shahrukh Khan ◽  
Abbas jamshidi-Roudbari ◽  
Miltiadis Hatalis

AbstractThis work emphasizes room temperature deposition and fabrication of top-gated staggered structure ZnO-TFTs and integration of ZnO-TFT based simple logic circuits. We synthesized ZnO thin films by RF sputtering in an Ar/Oxygen ambience with no intentional heating of the substrates. The electrical, optical and structural properties of the ZnO thin films can be well-controlled by altering process parameters such as RF power density and relative Oxygen partial pressure. Typical deposition was carried out at a chamber pressure of 15 mTorr, Ar/Oxygen flow rates of 15 sccm/1 sccm and RF power density of 3W/cm2. The resistivity of the as-deposited films was between 104-106 Ù-cm with high optical transparency (>80%) in the visible spectrum and minimal surface roughness as detected by high-resolution AFM imaging. Gated van der Pauw and Kelvin-bridge structures were lithographically patterned to asses ZnO channel resistance. In the completed devices, a dual-stack (Ta2O5/SiO2) dielectric layer was effective in suppressing gate-leakage current below 10 pA and enabled depletion-mode ZnO-TFT operation exhibiting hard saturation. A Ti/Au metallization scheme was adopted to provide good ohmic contact to ZnO. TFTs retained well-behaved transfer characteristics down to a channel length of 4 ìm with on/off drain current ratio exceeding 105, threshold voltage between -15 V to -5 V and inverse sub-threshold slope of around 1.75 V/decade.


1989 ◽  
Vol 164 ◽  
Author(s):  
Ratnabali Berjee ◽  
A. K. Bandyopadhyay ◽  
S. N. Sharma ◽  
A. K. Patabyal ◽  
A.K. Barua

AbstractResults on characterisation of undoped, μc-Si:H films prepared by rf magnetron sputtering technique are presented. Highly conducting films (10−3 Δ−cm−1) were obtained at fairly low rf power density (l.2W/cm2). Critical parameters for obtaining microcrystalline phase were identified. The effect of humid ambient on film properties was looked into.


Sign in / Sign up

Export Citation Format

Share Document