scholarly journals S-Shaped Canals: A Series of Cases Performed by Four Specialists around the World

2014 ◽  
Vol 2014 ◽  
pp. 1-6 ◽  
Author(s):  
Ricardo Machado ◽  
Antonis Chaniottis ◽  
Jorge Vera ◽  
Carlos Saucedo ◽  
Luiz Pascoal Vansan ◽  
...  

Recognition of anatomical variations is a real challenge for clinicians undertaking therapy regardless of the teeth that are to be treated. The extent of the curvature is one of the most important variables that could lead to instrument fracture. In clinical conditions, two curves can be present in the same root canal trajectory. This type of geometry is denoted as the “S” shape, and it is a challenging condition. This report describes a different clinical and educational scenario where four specialists around the world present different approaches for the treatment of root canals with double curvatures or S-shaped canals. Endodontic therapy is a very nuanced and challenging science and art. The clinical and teaching experience of the authors show different approaches that can be successfully employed to treat challenging teeth having roots with multiple curves. The necessity of precise knowledge of the root canal morphology and its variation is also underlined.

2021 ◽  
Vol 11 (Suppl. 1) ◽  
pp. 279-284
Author(s):  
Emre Bodrumlu ◽  
Esma Dinger

Aim: The aim of this case report is to present a series of anatomical variations and endodontic treatments in four two-canal mandibular premolar teeth and three rooted three-canal maxillary second premolar teeth with root canal treatment indications identified via clinical and radiographic examinations. The success of root canal treatment is achieved with a thoroughly examined root canal morphology that has been accurately determined radiographically and clinically before adequate shaping, irrigation, and hermetic filling procedures. Root canals that are not found or not adequately disinfected can cause root canal treatment failure and complications, such as pain, swelling, or persistent fistula, also known as flare-up, after treatment. Canal variations in the teeth were detected via periapical radiographs during the root canal instrumentation stage. Methodology: The endodontic treatments of four two-canal mandibular premolar teeth and one triple-rooted three-canal maxillary second premolar with root canal treatment indications were described. Conclusion: To achieve full success in root canal treatment, anatomical variations should be examined in detail before and during treatment, and treatment should be completed with appropriate techniques.   How to cite this article: Dinger E, Bodrumlu E. Treatment of anatomic canal variations in premolar teeth: Five case reports. Int Dent Res 2021;11(Suppl.1):279-84. https://doi.org/10.5577/intdentres.2021.vol11.suppl1.41   Linguistic Revision: The English in this manuscript has been checked by at least two professional editors, both native speakers of English.  


2014 ◽  
Vol 142 (9-10) ◽  
pp. 592-596 ◽  
Author(s):  
Igor Stojanac ◽  
Milica Premovic ◽  
Milan Drobac ◽  
Bojana Ramic ◽  
Ljubomir Petrovic

Introduction. Predictable endodontic treatment depends on the dentist?s knowledge about root canal morphology and its possible anatomic variations. The majority of mandibular canines have one root and root canal, but 15% may have two canals and a smaller number may have two distinct roots. The following clinical reports describe endodontic treatment of mandibular canines with two roots and two root canals. Outline of Cases. Four clinical case reports are presented to exemplify anatomical variation in the human mandibular canine. Detailed analysis of the preoperative radiographs and careful examination of the pulp chamber floor detected the presence of two root canal orifices in all canines. Working length was determined with an electronic apex locator and biomechanical preparation was carried out by using engine driven BioRaCe Ni-Ti rotary instruments in a crown-down manner, followed by copious irrigation with 1% sodium hypochlorite. Definitive obturation was performed using cold lateral condensation with gutta-percha cones and Top Seal paste. The treatment outcome was evaluated using postoperative radiographs. Conclusion. Endodontists should be aware of anatomical variations of the treated teeth, and should never presume that canal systems are simple.


2021 ◽  
Vol 9 (10) ◽  
pp. 247-251
Author(s):  
Aviral Verma ◽  
Ritika Singhal ◽  
Nandini Tripathi

Variations in root canal morphology presents a constant challenge for clinicians in their detection and management. Locating and treating these extra canals is important in order to achieve favorable prognosis in endodontic therapy. This review article presents the anatomical variations, frequency of occurrence of aberrant root canal configuration and methods of identification using advanced imaging techniques like CBCT, DOM and loupes.


2013 ◽  
Vol 14 (2) ◽  
pp. 345-347 ◽  
Author(s):  
Hamid Jafarzadeh ◽  
Amir Maghsoudlou ◽  
Maryam Forghani

ABSTRACT Aim This clinical report presents a rare case of maxillary central incisor with two separate roots. Background Unusual morphology of the roots and root canals may exist in any tooth. Recognition of the dental anatomy and its variations is necessary for successful endodontic therapy. It is well known that maxillary incisors are usually single-rooted teeth. Case report The root canals were instrumented with conventional hand files and Gates Glidden and obturated by using the lateral technique. Recall radiograph after 1 year shows the healing process of the preoperative apical periodontitis. Conclusion and clinical significance Clinicians should be aware of unexpected root canal morphology when performing root canal therapy. The present case demonstrated the importance of accurate preoperative radiograph and adequate access preparation. How to cite this article Maghsoudlou A, Jafarzadeh H, Forghani M. Endodontic Treatment of a Maxillary Central Incisor with Two Roots. J Contemp Dent Pract 2013;14(2):345-347.


2020 ◽  
Vol 16 (12) ◽  
pp. 1033-1036
Author(s):  
Deepa Gurunathan ◽  

It is of interest to compile available information on the root canal morphology of primary maxillary molars from known literature. The literature resources used to collect data include Medline/PubMed, The Cochrane Central Register of Clinical Trials, SIGLE and Science Direct. Data consists of type of population, number of teeth per study, number of root canals, canal length and type of root canal configuration. We used data from a total of 13 studies (951 primary maxillary molars). Maxillary molars (1st and 2nd) are dominant for two roots variant. The first molar the mean root length ranges from 7.9mm – 8.1mm. The second molar ranges from 7.2mm-8.5mm. Type I (explain in a phrase) canal morphology is the common variant in both the molars. Data shows that Root Canal morphology shows variations with the diagnostic aid (example micro CT) used and in different ethnic populations.


2018 ◽  
Vol 56 (210) ◽  
pp. 616-620 ◽  
Author(s):  
Sushmita Shrestha ◽  
Smriti Karki ◽  
Navin Agrawal ◽  
Mannu Vikram ◽  
Vimmi Singh ◽  
...  

  Introduction: Canals can be of different shapes in cross section including round canals, oval canals, long oval canals or ribbon shaped canals. Recesses of nonround canals may not be included in the round preparation created by rotary instruments and thus they remain unprepared. The aim of this study included determination of shape and taper of the apical root canal based on diameter at different levels. Methods: This was a cross sectional study which used convenient sampling technique to determine the sample size. Seventy extracted teeth were sectioned horizontally at one, two and three millimeter from the apex using the diamond disc which was observed under trinocular research microscope for the determination of diameter of root canal under 10x magnification. Results: The most common canal configuration was oval. The taper of the canals was 25% in mesial root and 20% in distal in bucco-lingual orientation and 14% in mesial root and 15% in distal in mesio-distal orientation. Conclusions: The most prevalent canal configuration in this study was non round, however, most of the rotary instruments tend to prepare root canals into round shape making their use questionable. The taper of the root canals was found to be higher in our study than what most of the shaping instruments have to offer. So it would be advisable to consider this fact while selecting instruments and preparing these non-round canals as far as the Nepalese subpopulation is considered.


2015 ◽  
Vol 61 (1) ◽  
pp. 45-48
Author(s):  
Paula Perlea ◽  
◽  
Cristina Nistor ◽  
Alexandru Andrei Iliescu ◽  
Daniel Nistor ◽  
...  

The complex root canal system of maxillary second premolars shows variations among different populations. The aim of this study was to evaluate the root canal morphology of second maxillary premolars in the romanian population. The number of roots, root canals and the root canal configuration were investigated using radiographs in both buccal-oral and mesio-distal incidence. They were categorized using Weine’s classifi cation. Among the 480 teeth, 90.83% had one root and 66.67% one root canal. The frequency of secondary maxillary premolars with two root canals (33.12%) shouldn’t be underestimated. Knowing the variations of the internal root canal morphology of maxillary second premolars in a certain population can lead the clinician to a better approach of the endodontic treatment.


RSBO ◽  
2020 ◽  
Vol 17 (1) ◽  
pp. 12-20
Author(s):  
Flares Baratto-Filho ◽  
Nathaly Dias Morais ◽  
Kauhanna Vianna de Oliveira ◽  
Flávia Sens Fagundes Tomazinho ◽  
Carla Castiglia Gonzaga ◽  
...  

The aim of this study was to analyze the root canal anatomy variations of permanent mandibular molars using three different cone-beam computed tomography (CBCT) protocols. Material and methods: Thirty-five freshly extracted first and second mandibular molars were collected and subjected to three CBCT protocols: i-CAT Classic (ICC); i-CAT Next Generation (ICN), and PreXion 3D (PXD). Images were evaluated by two previously calibrated and experienced endodontists. The morphological root canal configurations were classified according to Vertucci. Data were analyzed for frequency, and the binomial and Kappa tests were then performed (α = 0.05). Results: ICC and ICN were able to diagnose a higher percentage of anatomical variations in the mesial roots. In this same root, Vertucci’s type V was the most prevalent, and in distal was the type I. In comparisons of CBCT techniques for agreement, significant differences in the mesial root canals were found in the following: ICC versus (vs) ICN; ICC vs PXD; and ICN vs PXD (p <0.001). However, there were no statistical differences in the distal root canals (p >0.05). The level of agreement in mesial roots was poor or absent, while in distal was moderate.


2021 ◽  
Vol 7 (2) ◽  
pp. 61-66
Author(s):  
Vasavi Santosh ◽  
Rhea Reji John ◽  
Mandavi Waghmare ◽  
Reema Manoj

The purpose of this study was to determine the variations in the number of canals and its morphology in permanent mandibular first molars using cone-beam computed tomography (CBCT) in a subset of Indian population. A total of 350 CBCT scans were collected and evaluated in all three orthogonal planes to determine the number of root canals and study their anatomic variations using Vertucci’s classification.: The total number of roots and root canals, the root canal configuration, the incidence, and the correlations between left- and right-side occurrences and between males and females were analysed. Statistically significant differences were evaluated using the chi-square test with SPSS 16.0 for Windows (SPSS, Chicago, IL), with significance set at p &#60; 0.05.: The results of this study showed that predominantly, two thirds of the subjects had type VI mesial canal configuration and two-thirds had type I distal canal configuration. Also there was significant variance in the canal anatomy across gender and age of the subjects.: CBCT is a clinically useful tool in understanding the variations in root canal morphology, which guides in the assessment of the canal morphology aiding in successful root canal treatment.


2014 ◽  
Vol 15 (3) ◽  
pp. 367-371 ◽  
Author(s):  
Gurudutt Nayak ◽  
Surya Dahiya ◽  
Inderpreet Singh ◽  
Faiz Hasan Mohammad

ABSTRACT Aim The aim of this clinical article is to describe the unusual anatomy that was detected in a maxillary first molar during routine endodontic treatment. Background Variation in root and root canal morphology especially in multirooted teeth presents a constant challenge for a clinician in their detection and management. The literature is replete with cases that have extra canal or root but cases with fused root and fewer numbers of canals are sparse. Case description This case report describes the endodontic management of one such unusual case of maxillary first molar presenting with a single fused buccal and a palatal root. The confirmatory diagnosis of this morphologic aberration was done with the help of spiral computerized tomography, which revealed that the contralateral tooth also had a similar morphology. Conclusion Dental practitioners should always be aware of the fact that abnormalities need not be in form of extra roots or root canals; anomalies can also be in form of fewer number of roots or root canals. Clinical significance A thorough knowledge of the complexities and variations of the root canal system would help in avoiding some of the common iatrogenic access opening errors like perforations and excessive tooth removal caused during the search for the missing or extracanal. How to cite this article Nayak G, Dahiya S, Singh I, Mohammad FH. Endodontic Management of an Unusual Maxillary First Molar with a Single Buccal Root. J Contemp Dent Pract 2014;15(3):367-371.


Sign in / Sign up

Export Citation Format

Share Document