scholarly journals All Pass Network Based MSO Using OTRA

2015 ◽  
Vol 2015 ◽  
pp. 1-7 ◽  
Author(s):  
Rajeshwari Pandey ◽  
Neeta Pandey ◽  
Romita Mullick ◽  
Sarjana Yadav ◽  
Rashika Anurag
Keyword(s):  
Driving Voltage ◽  
Circuit Performance ◽  
Pspice Simulations ◽  
Sinusoidal Oscillators ◽  
Operational Transresistance Amplifier ◽  
Voltage Output

This paper presents multiphase sinusoidal oscillators (MSOs) using operational transresistance amplifier (OTRA) based all pass networks. Both even and odd phase oscillations of equal amplitudes which are equally spaced in phase can be produced using single all pass section per phase. The proposed MSOs provide voltage output and can readily be used for driving voltage input circuits without increasing component count. The effect of nonideality of OTRA on the circuit performance is also analysed. The functionality of the proposed circuit is verified through PSPICE simulations.

scholarly journals Single OTRA Based Analog Multiplier and Its Applications

2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
Rajeshwari Pandey ◽  
Neeta Pandey ◽  
B. Sriram ◽  
Sajal K. Paul
Keyword(s):  
Close Agreement ◽  
Passive Component ◽  
Analog Multiplier ◽  
Pspice Simulations ◽  
Operational Transresistance Amplifier ◽  
Theoretical Predictions ◽  
Amplitude Modulator ◽  
Simulation Results ◽  
Four Quadrant

This paper presents an analog multiplier using single operational transresistance amplifier (OTRA). The proposed circuit is suitable for integration as it does not use any external passive component. It can be used as a four-quadrant multiplier. Theoretical propositions are verified through PSPICE simulations using 0.5 μm CMOS parameters provided by MOSIS (AGILENT). The simulation results are in close agreement with theoretical predictions. The workability of the proposed multiplier is also tested through two applications, namely, a squarer and an amplitude modulator.

Research on the Pizeoelectric Driving Micro-Flux Valve Power Supply

2011 ◽  
Vol 58-60 ◽  
pp. 727-732
Author(s):  
Hai Chu Chen ◽  
Rui Hua Zhang ◽  
Gen Liang Xiong ◽  
Fa Yun Liang ◽  
Ling Teng Liu
Keyword(s):  
High Voltage ◽  
Power Supply ◽  
Low Voltage ◽  
Piezoelectric Ceramics ◽  
Driving Voltage ◽  
Small Signal ◽  
Precise Control ◽  
Wave Characteristics ◽  
Voltage Output ◽  
Output Characteristics

In order to decrease output micro-flux ripple wave characteristics of the piezoelectric driven micro-flux valve, it carried out research on piezoelectric ceramics driving power supply. In the research, it especially designed the low-voltage and high-voltage stabilizing circuit, small signal amplifying circuit and power amplifying circuit. By applying the power supply, the function signal would be amplified to a high-voltage output to drive the piezoelectric ceramics stack (PZT) to control displacement of the micro-flux valve’s spool, and then realize precise control the micro-flux of the valve. At last, it carried out experimentations on the output characteristics of the power supply, and the experimental results proved the output signal of the power supply have excellent input-output linearity and small ripple wave characteristics, and the high-voltage output ripple wave error is less than 10mV. More over, it used the power supply to drive an 8×8×20mm PZT with capacitance 2.3, and measured the quickly discharging characteristics. The results prove the quickly discharging time is only 10.10ms when the driving voltage is 180V, which means the power supply has excellent quickly discharging characteristics.

scholarly journals New OTRA-Based Generalized Impedance Simulator

2013 ◽  
Vol 2013 ◽  
pp. 1-10 ◽  
Author(s):  
Ashish Gupta ◽  
Raj Senani ◽  
D. R. Bhaskar ◽  
A. K. Singh
Keyword(s):  
Recent Literature ◽  
Sinusoidal Oscillators ◽  
Operational Transresistance Amplifier ◽  
Biquad Filter

Operational transresistance amplifier (OTRA) has attracted considerable attention in the recent literature in several applications such as impedance simulation, universal biquad filter realization, realization of sinusoidal oscillators and multivibrators. However, to the best knowledge of the authors, any OTRA-based generalized impedance simulator circuits have not been reported so far. The purpose of this paper is to present such a circuit.

Predicting Analog Circuit Performance Based on Importance of Uncertainties

2010 ◽  
Vol E93-C (6) ◽  
pp. 893-904
Author(s):  
Jin SUN ◽  
Kiran POTLURI ◽  
Janet M. WANG
Keyword(s):  
Analog Circuit ◽  
Circuit Performance

Analysis of AC-DC Converter Circuit Performance with Difference Piezoelectric Transducer Array Connection

2020 ◽  
Vol 12 (7) ◽  
Author(s):  
Nik Ahmad Zainal Abidin ◽  
◽  
Norkharziana Mohd Nayan ◽  
Azuwa Ali ◽  
N. A. Azli ◽  
...  
Keyword(s):  
Piezoelectric Transducer ◽  
Simulation Analysis ◽  
Piezoelectric Sensor ◽  
Transducer Array ◽  
Circuit Performance ◽  
Array Configuration ◽  
Full Wave ◽  
Bridge Rectifier ◽  
In Series ◽  
Parallel Voltage

This research presents a simulation analysis for the AC-DC converter circuit with a different configurations of the array connection of the piezoelectric sensor. The selection of AC-DC converter circuits is full wave bridge rectifier (FWBR), parallel SSHI (P-SSHI) and parallel voltage multiplier (PVM) with array configuration variation in series (S), parallel (P), series-parallel (SP) and parallel-series (PS). The system optimizes with different load configurations ranging from 10 kΩ to 1 MΩ. The best configuration of AC-DC converter with an appropriate array piezoelectric connection producing the optimum output of harvested power is presented. According to the simulation results, the harvested power produced by using P-SSHI converter connected with 3 parallel piezoelectric transducer array was 85.9% higher than for PVM and 15.88% higher than FWBR.

An Overview of 300 mm SOI Starting Wafer Quality and Its Yield Detractors

2005 ◽  
Author(s):  
Pei Y. Tsai ◽  
Junedong Lee ◽  
Paul Ronsheim ◽  
Lindsay Burns ◽  
Richard Murphy ◽  
...  
Keyword(s):  
Integrated Circuits ◽  
Device Fabrication ◽  
Sampling Plan ◽  
Silicon On Insulator ◽  
Manufacturing Processes ◽  
Circuit Performance ◽  
Characterization Techniques ◽  
Wafer Manufacturing

Abstract A stringent sampling plan is developed to monitor and improve the quality of 300mm SOI (silicon on insulator) starting wafers procured from the suppliers. The ultimate goal is to obtain the defect free wafers for device fabrication and increase yield and circuit performance of the semiconductor integrated circuits. This paper presents various characterization techniques for QC monitor and examples of the typical defects attributed to wafer manufacturing processes.

CDBA based current instrumentation amplifier

2016 ◽  
Vol 4 ◽  
pp. 11 ◽  
Author(s):  
Priyanka Gupta ◽  
Kunal Gupta ◽  
Neeta Pandey ◽  
Rajeshwari Pandey
Keyword(s):  
Current Mode ◽  
Instrumentation Amplifier ◽  
Pspice Simulations ◽  
Differential Gain ◽  
Novel Method ◽  
Current Difference ◽  
A Current

This paper presents a novel method to realize a current mode instrumentation amplifier (CMIA) through CDBA (Current difference Buffered Amplifier). It employs two CDBAs and two resistors to obtain desired functionality. Further, it does not require any resistor matching. The gain can be set according to the resistor values. It offers high differential gain and a bandwidth, which is independent of gain. The working of the circuit is verified through PSPICE simulations using CFOA IC based CDBA realization.

Erratum: Circuit performance of low temperature CMOS polysilicon TFT operational amplifiers

1993 ◽  
Vol 29 (8) ◽  
pp. 726
Author(s):  
H.-G. Yang ◽  
P. Migliorato ◽  
C. Reita ◽  
S. Fluxman
Keyword(s):  
Low Temperature ◽  
Operational Amplifiers ◽  
Circuit Performance ◽  
Polysilicon Tft

Sensitivity-based CMOS VLSI circuit performance optimisation

1995 ◽  
Vol 31 (22) ◽  
pp. 1918-1919
Author(s):  
P.J. Mather ◽  
P. Hallam ◽  
M. Brouwer
Keyword(s):  
Vlsi Circuit ◽  
Circuit Performance ◽  
Cmos Vlsi
Sign in / Sign up

Export Citation Format

Share Document