scholarly journals Long-Span Wooden Structural Floors with Self-Tensioning System: Performance under Asymmetrical Loads

2016 ◽  
Vol 2016 ◽  
pp. 1-11 ◽  
Author(s):  
J. Estévez-Cimadevila ◽  
D. Otero-Chans ◽  
E. Martín-Gutiérrez ◽  
F. Suárez-Riestra

This study analyzes the performance of wooden structural floors equipped with the self-tensioning system patented by the authors, consisting of a force multiplying mechanism connected to a self-tensioning tendon, which is activated automatically when the load is applied to the structural element. The paper describes the system’s difficulties when the structural floor is subjected to asymmetrical loads. The proposed solution consists of anchoring the tendon by an adhesive connection in the central part of the piece yielding a favorable redistribution of the bending moments and an effective performance in terms of deformations. The comparative study focuses onπ-shape cross section pieces with spans of 12 m and 15 m, using sections without prestressing and with initial prestressing and self-tensioning system.

2019 ◽  
Vol 8 (4) ◽  
pp. 80-88
Author(s):  
H. A. Aebischer

Planar spiral coils are used as inductors in radio frequency (RF) microelectronic integrated circuits (IC’s) and as antennas in both  radio frequency identification (RFID) and telemetry systems. They must be designed to a specified inductance. From the literature, approximate analytical formulae for the inductance of such coils with rectangular conductor cross section are known. They yield the direct current (DC) inductance, which is considered as a good approximation for inductors in RF IC’s up to the GHz range. In principle, these formulae can simplify coil design considerably. But a recent comparative study of the most cited formulae revealed that their maximum relative error is often much larger than claimed by the author, and too large to be useful in circuit design. This paper presents a more accurate formula for the DC inductance of square planar spiral coils than was known so far. It is applicable to any design of such coils with up to  windings. Owing to its scalability, this holds irrespectively of the coil size and the inductance range. It lowers the maximum error over the whole domain of definition from so far  down to . This has been tested by the same method used in the comparative study mentioned above, where the precise reference inductances were computed with the help of the free standard software FastHenry2. A comparison to measurements is included. Moreover, the source code of a MATLAB® function to implement the formula is given in the appendix.


1978 ◽  
Vol 12 (3) ◽  
pp. 2-18
Author(s):  
Michael L. Bates

Since Islamic coins characteristically bear no images, they have ample room for inscriptions; a typical coin of the Classical Period bears 50 to 100 words in a total area (obverse plus reverse) of about 10 cm2. Each coin is thus a small document bearing several explicit messages which its makers intended to convey. But inscriptions, like other features of a coin, also carry implicit information unconsciously provided by the makers. Analysis of orthography, grammatical constructions, phraseology, and epigraphical style can illuminate the evolution of the Arabic language and script; the comparative study of titulature brings out changes in the self-image and philosophy of government of rulers; religious inscriptions on coins show what their issuers regarded as fundamental, as opposed to the beliefs attributed to them by hostile or later writers. Such topics must, of course, be studied in the context of the evidence from literature and monumental inscriptions. Coins have the advantage that their evidence is usually firmly dated and placed—and undoubtedly official—although one must beware of the strongly conservative tendency of coin design: inscriptions and designs may reflect traditional practice rather than current attitudes.


Author(s):  
Piyush Kene

The comparative study on analysis of RCC Frame structure supported on a single column and multi-column is done in this project. Cost comparison , Ground space comparison is done between RCC single column and RCC multi column structure .This paper presents structural modelling, stress, bending moment, shear force and displacement, deflection design considerations for a structure and it is analysed using STAAD-Pro. Various steps involved in designing of RCC Frame structure supported on a single column and multi-column by using software are Geometric Modelling, providing material properties and sectional Properties, fixing supports and boundary Conditions, providing loads & load combinations, Special Commands, Analysis Specification , Design Command and Report. The influence of plan geometry has an important role in static analysis. Maximum values of stresses, bending moments, shear forces and displacements and deflection are presented. The acting loads considered in the present analysis were dead load, Live load, floor load, and wind load. The project is to planning & analysis by using software for a multi storied building and single column building of G+3, G+7, G+15 floors. The design is done by taking in to account the requirements and standards recommended by IS code and national building rules.


2003 ◽  
Vol 7 (3) ◽  
pp. 312-331
Author(s):  
Kathleen Comerford

AbstractThis article explores several dioceses in Tuscany—Arezzo, Fiesole, Lucca, Montepulciano, Siena, and Volterra—in light of the foundation of diocesan seminaries, to determine if a new corps of priests was produced and if that corps instituted major changes. Historians refer to post-Tridentine attempts to strengthen the faith and power of groups and institutions by such processes as education as the parallel trends of confessionalism and confessionalization. Since these dioceses represent different economic, educational, and demographic levels of development, the comparative study of quantitative and qualitative measures in these regions addresses the impact of educational changes in the parish clergy in a significant cross-section of late-sixteenth and seventeenth-century Tuscany. Even in dioceses which were wealthy and which supported seminaries, the institutions had little influence, and therefore the slow and spotty improvements in the parishes and dioceses did not result in the confessionalization of the region, although limited confessionalism did occur.


Author(s):  
Policy Studies on Culture & CMNS (CPCC)

A CPCC public lecture on the topic of "From Immolation to Preservation: The Self and Identity Politics Since the Arab Uprisings" will be hosted on January 22, 2015 from 5-7pm in room HC1600 (SFU Vancouver). The event is sponsored by FCAT's Centre For Policy Studies on Culture and Communities, SFU Institute for Humanities; SFU International Studies; SFU Centre for the Comparative Study of Muslim Societies and Cultures; and SFU's Vancity Office of Community Engagement. Please see the attached PDF for further details.


Manuskripta ◽  
2020 ◽  
Vol 10 (1) ◽  
pp. 67
Author(s):  
Novarina Novarina

Abstract: This research is a comparative literary study that uses Malay and Javanese versions of Mahabarata text sources. The research objects used were the text edition of Pandhawa Gubah (PG) by Sudibjo Z. Hadisutjipto and the text of Cheritera Pandawa Lima (CPL) by Khalid Hussain. The research method used is descriptive-analysis method. In the comparative study used a comparative literary theory proposed by Endraswara (2011). The results of the text comparison reveal the similarities and differences in the image of Bima figures in the Javanese and Malay versions. The equation as a whole is that both texts contain the same heroic storyline and heroic character, Bima. In addition, Indian influence is still evident in the two texts seen from the nuances of Hinduism that exist in both texts. While the difference is seen in the events that accompany Bima's struggle in achieving his victory. Based on these similarities and differences, it can be seen that the authors attempt to represent the concept of metaphysical interactions vertically and horizontally expressed through PG text. --- Abstrak: Penelitian ini adalah satu kajian sastra bandingan yang menggunakan sumber teks Mahabarata versi Melayu dan Jawa. Objek penelitian yang digunakan adalah edisi teks Pandhawa Gubah (PG) karya Sudibjo Z. Hadisutjipto dan teks Cheritera Pandawa Lima (CPL) karya Khalid Hussain. Metode penelitian yang digunakan adalah metode deskriptif-analisis. Dalam telaah perbandingan digunakan teori sastra bandingan yang dikemukakan Endraswara (2011). Hasil perbandingan teks mengungkapkan adanya persamaan dan perbedaan citra tokoh Bima dalam versi Jawa maupun versi Melayu. Persamaan secara keseluruhan adalah kedua teks tersebut mengandung alur cerita kepahlawanan dan tokoh pahlawan yang sama yaitu Bima. Selain itu, pengaruh India masih tampak dalam kedua teks tersebut dilihat dari nuansa Hinduisme yang ada dalam kedua teks. Sementara perbedaannya tampak pada peristiwa-peristiwa yang menyertai perjuangan Bima dalam mencapai kemenangannya. Berdasarkan persamaan dan perbedaan tersebut tampak adanya upaya penulis untuk merepresentasikan konsep interaksi metafisik secara vertikal dan horizontal yang diungkapkan melalui teks PG.


Sign in / Sign up

Export Citation Format

Share Document