scholarly journals Mechanical Characterization of Lightweight Foamed Concrete

2018 ◽  
Vol 2018 ◽  
pp. 1-8 ◽  
Author(s):  
Marcin Kozłowski ◽  
Marta Kadela
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
High Strength ◽  
Waste Utilization ◽  
Sound Insulation ◽  
Strongly Correlated ◽  
Freezing And Thawing ◽  
Acoustic Insulation ◽  
Foamed Concrete

Foamed concrete shows excellent physical characteristics such as low self weight, relatively high strength and superb thermal and acoustic insulation properties. It allows for minimal consumption of aggregate, and by replacement of a part of cement by fly ash, it contributes to the waste utilization principles. For many years, the application of foamed concrete has been limited to backfill of retaining walls, insulation of foundations and roof tiles sound insulation. However, during the last few years, foamed concrete has become a promising material for structural purposes. A series of tests was carried out to examine mechanical properties of foamed concrete mixes without fly ash and with fly ash content. In addition, the influence of 25 cycles of freezing and thawing on the compressive strength was investigated. The apparent density of hardened foamed concrete is strongly correlated with the foam content in the mix. An increase of the density of foamed concrete results in a decrease of flexural strength. For the same densities, the compressive strength obtained for mixes containing fly ash is approximately 20% lower in comparison to the specimens without fly ash. Specimens subjected to 25 freeze-thaw cycles show approximately 15% lower compressive strengths compared to the untreated specimens.

Investigation on a New Hydraulic Cementitious Binder Made from Phosphogypsum

2013 ◽  
Vol 864-867 ◽  
pp. 1923-1928
Author(s):  
Yue Xu ◽  
Jian Xi Li ◽  
Li Li Kan
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Active Carbon ◽  
High Strength ◽  
Tricalcium Silicate ◽  
Dicalcium Silicate ◽  
Cementitious Material ◽  
Saturation Ratio ◽  
Tricalcium Aluminate ◽  
Cementitious Binder

A new kind of high strength cementitious material is made from phosphogypsum (PG), active carbon and fly-ash. Through the orthogonal research, it was showed that the calcination temperature, retention time, dosage of active carbon and fly ash on the compressive strength of cementitious binder are the most important. The result also showed that, in the conditions of temperature 1200°C, time retention 30 min, dosage of active carbon 10%, dosage of fly ash 5%, the compressive strength of the cementitious material for 3d and 28d could reach to 46.35MPa and 92.70MPa, the content of sulfur trioxide was 11.60% accordingly. A lot of active mineral materials, such as dicalcium silicate, tricalcium silicate, tricalcium aluminate were formed in the calcination. The C-S-H gel, calcium hydroxide and ettringite were found in 3d and 28d hydrates. It is found that the lime saturation ratio and silica modulus need to be control between 0.40~0.65 and 4~8 in order to produce high strength cementitious material.

Effect of Chopped Basalt Fiber on the Fresh and Hardened Properties of Fly Ash High Strength Concrete

2014 ◽  
Vol 567 ◽  
pp. 381-386 ◽  
Author(s):  
Nasir Shafiq ◽  
Muhd Fadhil Nuruddin ◽  
Ali Elheber Ahmed Elshekh ◽  
Ahmed Fathi Mohamed Salih
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
High Strength Concrete ◽  
Basalt Fiber ◽  
High Strength ◽  
Progressive Increase ◽  
Test Results ◽  
Strength Concrete ◽  
Hardened Properties ◽  
Chopped Basalt Fiber

In order to improve the mechanical properties of high strength concrete, HSC, several studies have been conducted using fly ash, FA. Researchers have made it possible to achieve 100-150MPa high strength concrete. Despite the popularity of this FAHSC, there is a major shortcoming in that it becomes more brittle, resulting in less than 0.1% tensile strain. The main objective of this work was to evaluate the fresh and hardened properties of FAHSC utilizing chopped basalt fiber stands, CBFS, as an internal strengthening addition material. This was achieved through a series of experimental works using a 20% replacement of cement by FA together with various contents of CBFS. Test results of concrete mixes in the fresh state showed no segregation, homogeneousness during the mixing period and workability ranging from 60 to 110 mm. Early and long terms of compressive strength did not show any improvement by using CBFS; in fact, it decreased. This was partially substituted by the effect of FA. Whereas, the split and flexural strengths of FASHC were significantly improved with increasing the content of CBFS as well as the percentage of the split and flexural tensile strength to the compressive strength. Also, test results showed a progressive increase in the areas under the stress-strain curves of the FAHSC strains after the CBFS addition. Therefore, the brittleness and toughness of the FAHSC were enhanced and the pattern of failure moved from brittle failure to ductile collapse using CBFS. It can be considered that the CBFS is a suitable strengthening material to produce ductile FAHSC.

scholarly journals Kajian Karakteristik Beton Memadat Sendiri yang Menggunakan Serat Ijuk (Hal. 54-65)

2018 ◽  
Vol 4 (4) ◽  
pp. 54
Author(s):  
Iis Nurjamilah ◽  
Abinhot Sihotang
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Flexural Strength ◽  
Coarse Aggregate ◽  
Fresh Concrete ◽  
High Strength ◽  
Self Compacting Concrete ◽  
Palm Fiber ◽  
Fiber Concrete ◽  
Dilute Mixture

ABSTRAKKajian karakteristik beton memadat sendiri yang menggunakan serat ijuk merupakan sebuah kajian yang dilakukan untuk mengetahui pengaruh penambahan serat ijuk terhadap karakteristik beton memadat sendiri (SCC). Beton memadat sendiri yang menggunakan serat ijuk (PFSCC) didesain memiliki campuran yang encer, bermutu tinggi (= 40 MPa) dan memiliki persentase kekuatan lentur yang lebih baik. PFSCC  didapatkan dari hasil pencampuran antara semen sebanyak 85%, fly ash 15%, superplastizicer 1,5%, serat ijuk 0%, 0,5%; 1%; 1,5%; 2% dan 3% dari berat binder (semen + fly ash), kadar air 190 kg/m3, agregat kasar 552,47 kg/m3 dan pasir 1.063 kg/m3. Semakin banyak persentase penambahan serat ijuk ke dalam campuran berdampak terhadap menurunnya workability beton segar. Penambahan serat ijuk yang paling baik adalah sebanyak 1%, penambahan tersebut dapat meningkatkan kekuatan tekan beton sebesar 13% dan lentur sebesar 1,8%.Kata kunci: beton memadat sendiri (SCC), beton berserat, beton memadat sendiri yang menggunakan serat ijuk (PFSCC), serat ijuk ABSTRACTThe study of characteristics self compacting concrete using palm fibers is a study conducted to determine the effect of adding palm fibers to characteristics of self compacting concrete (SCC). palm fibers self compacting concrete (PFSCC) is designed to have a dilute mixture, high strength (= 40 MPa), and have better precentage flexural strength. PFSCC was obtained from mixing of 85% cement, 15% fly ash, 1.5% superplastizicer, 0%, 0.5%, 1%, 1.5%, 2% and 3% palm fibers from the weight of binder  (cement + fly ash), water content 190 kg/m3, coarse aggregate 552.47 kg/m3 and sand 1,063 kg/m3. The more persentage palm fibers content added to the mixture makes workability of fresh concrete decreases. The best addition of palm fiber is 1%, this addition can increases the compressive strength 13% and flexural strength 1.8%.Keywords: self compacting concrete (SCC), fiber concrete, Palm fiber self compacting concrete (PFSCC), palm fiber

Preparation and Characterization of CCCW/Foamed Concrete Composite

2011 ◽  
Vol 261-263 ◽  
pp. 13-18
Author(s):  
Ke Qing Li ◽  
De Ping Chen ◽  
Shi Li Zhang ◽  
Bao Shun Liu
Keyword(s):  
Thermal Conductivity ◽  
Compressive Strength ◽  
Water Absorption ◽  
Heat Insulation ◽  
High Humidity ◽  
Underground Engineering ◽  
New Approach ◽  
Foamed Concrete ◽  
Insulation Performance

Aimed at improving the waterproofing property of foamed concrete, a heat-insulating and waterproofing composite applied in underground engineering was prepared by using cementitious capillary crystalline waterproofing material and foamed concrete. The properties of foamed concrete and composite such as compressive strength, water absorption and thermal conductivity were tested and contrasted, and the compounding reaction mechanism was analyzed. The results show that, compared with foamed concrete, the water absorption of composite has been significantly reduced while the heat-insulating property of foamed concrete is maintained and the overall waterproofing and heat-insulation performance has been significantly improved. A new approach solving underground heat-harm such as high temperature and high humidity is provided.

scholarly journals Strength Characteristics of High Strength Concrete (HSC) with and without Coarse Aggregate

2019 ◽  
Vol 9 (2) ◽  
pp. 4701-4704
Keyword(s):  
Mechanical Properties ◽  
Compressive Strength ◽  
Fly Ash ◽  
Flexural Strength ◽  
Silica Fume ◽  
High Strength Concrete ◽  
Mechanical Characteristics ◽  
Coarse Aggregate ◽  
High Strength ◽  
Set Up

This paper aimed to investigate the mechanical characteristics of HSC of M60 concrete adding 25% of fly ash to cement and sand and percentage variations of silica fumes 0%,5% and 10% to cement with varying sizes of 10mm,6mm,2mm and powder of granite aggregate with w/c of 0.32. Specimens are tested for compressive strength using 10cm X 10cmX10cm cubes for 7,14,28 days flexural strength was determined by using 10cmX10cmX50cm beam specimens at 28 days and 15cm diameter and 30cm height cylinder specimens at 28 days using super plasticizers of conplast 430 as a water reducing agent. In this paper the experimental set up is made to study the mechanical properties of HSC with and without coarse aggregate with varying sizes as 10mm, 6mm, 2mm and powder. Similarly, the effect of silica fume on HSC by varying its percentages as 0%, 5% and 10% in the mix studied. For all mixes 25% extra fly ash has been added for cement and sand.

COMPRESSIVE STRENGTH OF FRACTAL-TEXTURED FOAMED CONCRETE

Fractals ◽  
2019 ◽  
Vol 27 (01) ◽  
pp. 1940003 ◽  
Author(s):  
Y. CHEN ◽  
Y. F. XU
Keyword(s):  
Compressive Strength ◽  
Fractal Dimension ◽  
Porous Structure ◽  
Fractal Theory ◽  
Scaling Law ◽  
Weight Ratio ◽  
High Strength ◽  
Labor Cost ◽  
Fractal Model ◽  
Foamed Concrete

Foamed concrete possesses characteristics such as high strength-to-weight ratio and low density, and widely used to reduce dead loads on the structure and foundation, contributes to energy conservation, and lowers the labor cost during construction. In this paper, the objective is to propose prediction relation for the compressive strength of foamed concrete by fractal theory. A theoretical relation was derived for the compressive strength relating to porosity based on the fractal model for foamed concrete. The proposed relation stands out compared to empirical model since it employs easily measurable parameter, the fractal dimension of porous structure in foamed concrete. The fractal dimension of porous structure can be calculated from the scaling law of the compressive strength of foamed concrete. The fractal model for porous structure serves as a simple and effective tool for predicting the compressive strength of foamed concrete because of its ease in application. The prediction relation of the compressive strength developed in this paper is found to match well with the measured strength.

Study on Properties of Foam Concrete Based on Fractal Theory

2011 ◽  
Vol 194-196 ◽  
pp. 1916-1919 ◽  
Author(s):  
Wen Ling Tian ◽  
Jiang Bo Yang ◽  
Xiao Yan Zhao
Keyword(s):  
Fractal Dimension ◽  
Fly Ash ◽  
Thermal Insulation ◽  
Fractal Theory ◽  
High Strength ◽  
Sound Insulation ◽  
Foam Concrete ◽  
Insulation Property ◽  
Foaming Agent ◽  
Thermal Insulation Property

Foam concrete is provided with light weight, thermal insulation, sound insulation and fire resistance, good seismic performance and other characteristics. To improve properties of foam concrete microstructure is studied with the help of fractal theory, fractal dimension related to mechanical properties and thermal performance of foam concrete is calculated by MATLAB language program. The results indicate that the microstructure of foam concrete showed significant fractal character, the fractal dimension is between 1.3 and 2.0. Apparent density, 28d compressive strength, and thermal conductivity decreases with the increase of fly ash and foaming agent content, fractal dimension increased. Formulas of fractal dimension and the fly ash, foaming agent content were established. Foam concrete with low density, high strength, and good thermal insulation property will be prepared conducted by the formulas.

Sign in / Sign up

Export Citation Format

Share Document