Kinetics of epoxy resin optical characteristics during ultrasonic processing

2021 ◽  
pp. 002199832110463
Author(s):  
Ekaterina G Kovaleva ◽  
Sergey E Savotchenko
Keyword(s):  
Differential Equation ◽  
Experimental Data ◽  
Optical Properties ◽  
Epoxy Resin ◽  
Processing Time ◽  
Optical Transmission ◽  
Optical Transmittance ◽  
Ultrasonic Processing ◽  
Nonlinear Functions ◽  
Kinetics Of

In this paper, the ultrasonic processing of composite based on epoxy resin ED-20 filled by nanoparticle silicon–containing additives PDMS-5 and HDK during its preparation is studied. Changes in optical transmittance spectra of organosilicon gel (PDMS-5+HDK) and of composite ED-20+L-20+(PDMS-5+HDK) are reported. The observed optical transmission changes were modeled from the experimental results. New phenomenological model describing the kinetics of a change in transmittance with ultrasonic processing time of composite is proposed. The nonlinear differential equation of the process is formulated and solved. The solution of equation applies to description of the experimental data of monitoring of transmittance of composite ED-20+L-20+(PDMS-5+HDK) during ultrasonic processing. The nonlinear functions characterized by three plateaus are proposed to describe the experimental data of monitoring of optical properties of organosilicon gel (PDMS-5+HDK) during ultrasonic processing.

scholarly journals Комплексные исследования кинетики индуцированного фазового перехода в [001], [011] и [111]-ориентированных монокристаллических релаксорных твердых растворах

2018 ◽  
Vol 60 (5) ◽  
pp. 955
Author(s):  
Л.С. Камзина ◽  
Л.А. Кулакова
Keyword(s):  
Phase Transition ◽  
Optical Properties ◽  
Dielectric Properties ◽  
Electric Field ◽  
Solid Solutions ◽  
Room Temperature ◽  
Optical Transmission ◽  
Time Interval ◽  
Small Fields ◽  
Kinetics Of

AbstractThe kinetics of an induced phase transition in single-crystal relaxor solid solutions 33PbIn_1/2Nb_1/2O_3–35PbMg_1/3Nb_2/3O_3–32PbTiO_3 and PbMg_1/3Nb_2/3O_3–29PbTiO_3 under application of an electric field along three directions [001], [011], and [111] at room temperature is studied. Joint measurements of optical transmission at different wavelengths, dielectric properties, and attenuation of sound are carried out. It was found that, even in small fields ( E ~ 2 kV/cm) applied in the [011] and [111] directions, the maximum changes in all three characteristics as well as the coincidence of the time dependences of the optical transmission at different wavelengths of light occur in the same time interval. It is established that, in the same interval of fields along the [001] direction, the anomalies of the optical properties do not coincide in time with the anomalies of the acoustic and dielectric properties. The results obtained are explained by the induction of single-domain and multidomain phases.

A fuzzy neural network approach for modeling the growth kinetics of FeB and Fe2B layers during the boronizing process

2018 ◽  
Vol 106 (6) ◽  
pp. 603 ◽  
Author(s):  
Bendaoud Mebarek ◽  
Mourad Keddam
Keyword(s):  
Neural Network ◽  
Experimental Data ◽  
Fuzzy Neural Network ◽  
Treatment Time ◽  
Calculation Model ◽  
Average Error ◽  
Network Approach ◽  
Neural Network Approach ◽  
Fuzzy Neural ◽  
Kinetics Of

In this paper, we develop a boronizing process simulation model based on fuzzy neural network (FNN) approach for estimating the thickness of the FeB and Fe2B layers. The model represents a synthesis of two artificial intelligence techniques; the fuzzy logic and the neural network. Characteristics of the fuzzy neural network approach for the modelling of boronizing process are presented in this study. In order to validate the results of our calculation model, we have used the learning base of experimental data of the powder-pack boronizing of Fe-15Cr alloy in the temperature range from 800 to 1050 °C and for a treatment time ranging from 0.5 to 12 h. The obtained results show that it is possible to estimate the influence of different process parameters. Comparing the results obtained by the artificial neural network to experimental data, the average error generated from the fuzzy neural network was 3% for the FeB layer and 3.5% for the Fe2B layer. The results obtained from the fuzzy neural network approach are in agreement with the experimental data. Finally, the utilization of fuzzy neural network approach is well adapted for the boronizing kinetics of Fe-15Cr alloy.

Features of the kinetics of cyclic elastoplastic deformation diagrams at dwells in cycles and superimposition of variable stresses on them

2020 ◽  
Vol 86 (12) ◽  
pp. 46-53
Author(s):  
M. M. Gadenin
Keyword(s):  
Experimental Data ◽  
Elastoplastic Deformation ◽  
Low Cycle Fatigue ◽  
Cycle Fatigue ◽  
Loading Cycle ◽  
Additional Variable ◽  
Dynamic Creep ◽  
Variable Stresses ◽  
Kinetics Of ◽  
Deformation Diagrams

The goal of the study is determination of the regularities of changes in cyclic strains and related deformation diagrams attributed to the existence of time dwells in the loading modes and imposition of additional variable stresses on them. Analysis of the obtained experimental data on the kinetics of cyclic elastoplastic deformation diagrams and their parameters revealed that in contrast to regular cyclic loading (equal in stresses), additional deformations of static and dynamic creep are developed. The results of the studys are especially relevant for assessing the cyclic strength of unique extremely loaded objects of technology, including nuclear power equipment, units of aviation and space systems, etc. The experiments were carried out on the samples of austenitic stainless steel under low-cycle loading and high temperatures of testing. Static and dynamic creep deformations arising under those loading conditions promote an increase in the range of cyclic plastic strain in each loading cycle and also stimulate an increase in the range of elastoplastic strain due to active cyclic deformation. At the same time the existence of dwells on extrema of stresses in cycles without imposition of additional variable stresses on them most strongly affects the growth of plastic strain ranges in cycles. Imposition of additional variable stresses on dwells also results in the development of creep strains, but their growth turns out to be somewhat less than in the presence of dwells without stresses imposed. The diagrams of cyclic deformation obtained in the experiments are approximated by power dependences, their kinetics being described in terms of the number of loading cycles using corresponding temperature-time functions. At the same time, it is shown that increase in the cyclic plastic deformation for cycles with dwells and imposition of additional variable stresses on them decreases low cycle fatigue life compared to regular loading without dwells at the same stress amplitudes, moreover, the higher the values of static and dynamic creep, the greater decrease in low-cycle fatigue life. This conclusion results from experimental data and analysis of conditions of damage accumulation for the considered forms of the loading cycle using the deformation criterion of reaching the limit state leading to fracture.

Effect of ionizing radiation on the kinetics of hydrogenation on the Ni-MgO mixed catalyst

1982 ◽  
Vol 47 (7) ◽  
pp. 1780-1786 ◽  
Author(s):  
Rostislav Kudláček ◽  
Jan Lokoč
Keyword(s):  
Experimental Data ◽  
Activation Energy ◽  
Liquid Phase ◽  
Ionizing Radiation ◽  
Oxide Catalyst ◽  
Absorbed Dose ◽  
Hydrogenation Rate ◽  
Solution Composition ◽  
Mixed Catalyst ◽  
Kinetics Of

The effect of gamma pre-irradiation of the mixed nickel-magnesium oxide catalyst on the kinetics of hydrogenation of maleic acid in the liquid phase has been studied. The changes of the hydrogenation rate are compared with the changes of the adsorbed amount of the acid and with the changes of the solution composition, activation energy, and absorbed dose of the ionizing radiation. From this comparison and from the interpretation of the experimental data it can be deduced that two types of centers can be distinguished on the surface of the catalyst under study, namely the sorption centres for the acid and hydrogen and the reaction centres.

Kinetics of the Crystallization of Potassium Sulfate

1993 ◽  
Vol 58 (8) ◽  
pp. 1848-1854 ◽  
Author(s):  
Miroslav Karel ◽  
Jaroslav Nývlt
Keyword(s):  
Experimental Data ◽  
Crystal Growth ◽  
Growth Rates ◽  
Potassium Sulfate ◽  
Kinetics Of

The kinetics of the crystallization of potassium sulfate has been determined using the MSMPR technique. Values of the nucleation and crystal growth rates evaluated from the experimental data are compared with the corresponding literature data.

Diffusion model for deposition of epitaxial GaAs layers prepared by the MOCVD method

1991 ◽  
Vol 56 (10) ◽  
pp. 2020-2029
Author(s):  
Jindřich Leitner ◽  
Petr Voňka ◽  
Josef Stejskal ◽  
Přemysl Klíma ◽  
Rudolf Hladina
Keyword(s):  
Experimental Data ◽  
Growth Rate ◽  
Kinetic Model ◽  
Gas Phase ◽  
Substrate Surface ◽  
Deposition Process ◽  
Hydrogen Atmosphere ◽  
Epitaxial Gaas ◽  
Kinetics Of ◽  
Good Agreement

The authors proposed and treated quantitatively a kinetic model for deposition of epitaxial GaAs layers prepared by reaction of trimethylgallium with arsine in hydrogen atmosphere. The transport of gallium to the surface of the substrate is considered as the controlling process. The influence of the rate of chemical reactions in the gas phase and on the substrate surface on the kinetics of the deposition process is neglected. The calculated dependence of the growth rate of the layers on the conditions of the deposition is in a good agreement with experimental data in the temperature range from 600 to 800°C.

Kinetic analysis of mechanism of intestinal Na+-dependent sugar transport

1985 ◽  
Vol 248 (5) ◽  
pp. C498-C509 ◽  
Author(s):  
D. Restrepo ◽  
G. A. Kimmich
Keyword(s):  
Experimental Data ◽  
Steady State ◽  
Sugar Transport ◽  
Enzyme Kinetic ◽  
Steady State Distribution ◽  
State Distribution ◽  
Least Squares Fit ◽  
Coupling Stoichiometry ◽  
Rate Limiting ◽  
Kinetics Of

Zero-trans kinetics of Na+-sugar cotransport were investigated. Sugar influx was measured at various sodium and sugar concentrations in K+-loaded cells treated with rotenone and valinomycin. Sugar influx follows Michaelis-Menten kinetics as a function of sugar concentration but not as a function of Na+ concentration. Nine models with 1:1 or 2:1 sodium:sugar stoichiometry were considered. The flux equations for these models were solved assuming steady-state distribution of carrier forms and that translocation across the membrane is rate limiting. Classical enzyme kinetic methods and a least-squares fit of flux equations to the experimental data were used to assess the fit of the different models. Four models can be discarded on this basis. Of the remaining models, we discard two on the basis of the trans sodium dependence and the coupling stoichiometry [G. A. Kimmich and J. Randles, Am. J. Physiol. 247 (Cell Physiol. 16): C74-C82, 1984]. The remaining models are terter ordered mechanisms with sodium debinding first at the trans side. If transfer across the membrane is rate limiting, the binding order can be determined to be sodium:sugar:sodium.

scholarly journals UV-A Treatment of ZrO2 Thin Films Fabricated by Environmental Friendlier Water-Based Solution Processing: Structural and Optical Studies

Coatings ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 821
Author(s):  
Aneeqa Bashir ◽  
Mehwish Farooq ◽  
Abdul Malik ◽  
Shahzad Naseem ◽  
Arshad Saleem Bhatti
Keyword(s):  
Optical Properties ◽  
Low Cost ◽  
Annealed Film ◽  
Optical Transmittance ◽  
Amorphous Structure ◽  
Solution Processing ◽  
Vis Spectroscopy ◽  
Water Based ◽  
Free Films ◽  
Quartz Substrates

An environmentally friendlier solution processing has been introduced to fabricate zirconium oxide (ZrO2) films on quartz substrates, using spin coating of simple water-based solution. The films cured with UV-A = 330 nm for different times (40, 80, 120 min) were investigated for structural and optical properties and compared with thermally annealed film (at 350 °C). XRD and Raman spectroscopy showed amorphous structure in all the samples with no significant phase transformation with UV-A exposure. AFM microscopy showed smooth and crack free films with surface roughness ≤2 nm that reduced with UV-A exposure. Ultraviolet-visible (UV–Vis) spectroscopy demonstrated optical transmittance ≥88% and energy band gap variations as 4.52–4.70 eV. Optical constants were found from spectroscopic ellipsometry (SE). The refractive index (n) values, measured at 470 nm increased from 1.73 to 2.74 as the UV-A exposure prolonged indicating densification and decreasing porosity of the films. The extinction coefficient k decreased from 0.32 to 0.19 indicating reduced optical losses in the films under the UV-A exposure. The photoluminescence (PL) spectra exhibited more pronounced UV emissions which grew intense with UV-A exposure thereby improving the film quality. It is concluded that UV-A irradiation can significantly enhance the optical properties of ZrO2 films with minimal changes induced in the structure as compared to thermally treated film. Moreover, the present work indicates that water-based solution processing has the potential to produce high-quality ZrO2 films for low cost and environmental friendlier technologies. The work also highlights the use of UV-A radiations as an alternate to high temperature thermal annealing for improved quality.

Sign in / Sign up

Export Citation Format

Share Document