Influence of Coconut Oil Methyl Ester (CME) Mixing Diesel Fuel on the Engine Performance of Diesel Engine

2003 ◽  
Vol 2003.39 (0) ◽  
pp. 199-200
Author(s):  
Kojiro KATADA ◽  
Calos E. ZAPANTA ◽  
Koji YOSHIDA ◽  
Hideo SHOJI
Author(s):  
Ali M. A. Attia ◽  
Ahmed I. El-Seesy ◽  
Hesham M. El-Batsh ◽  
Mohamed S. Shehata

Currently, using biofuels to operate diesel engines gets a great attention to the extent that it could replace the limited conventional fossil fuels. These fuels have a closed life cycle (renewable) and they have a remarkable effect on the global greenhouse phenomena. Moreover, the use of non-edible vegetable oils is considered a good choice after a suitable chemical and/or thermal treatment to convert them into esters. The use of jojoba oil shows a promising alternative fuel for conventional diesel fuel even there were unfavorable effects including power reduction. The wide spread usage of nano additives to improve the combustion quality may be a good solution for these problems. This study represents an experimental investigation to examine the effect of nano additives on diesel engine performance at variable operating conditions of load and speed. In this work, alumina nano-particles are added to a mixture of jojoba methyl ester (biodiesel) and conventional diesel fuel at the most recommended value (20% biodiesel and 80% diesel fuel) with different doses from 10 up to 50 mg/l. The received mixture is homogenized with an ultrasonicator mixer. It is found that, the appropriate nano-additives dose corresponding to optimal engine performance is about 30 mg/l. At this dose, the overall BSFC is reduced by about 6%, engine thermal efficiency is increased up to 7%, and all engine emissions have been reduced (NOx about 70%, CO about 75 %, smoke opacity about 5%, and UHC about 55 %) compared with the corresponding values obtained when only a blended fuel of 20% biodiesel is used.


Author(s):  
Alex Y ◽  
Roji George Roy

Biodiesel has become more attractive recently, because of its environmental benefits and the fact that it is made from renewable resources. Over the past few decades, most of the countries depending on diesel engines for transportation. Some of its valuable advantages like highest thermal efficiency made it very popular. At the same time, the cost of diesel fuel is increasing, due to the depletion of fossil fuels. In this current scenario, we need an alternative fuel instead of diesel fuel. Many of the researchers have successfully placed several works on generating energy from different types of alternative sources including solar and some kind of conversion processes including renewable agricultural products into liquid fuel. One of the biggest challenges for developing countries in relation to energy consumption is to develop and implement technologies that help to improve efficiency of automobile engines, also to reduce the emissions of harmful gases and particulate matters. In order to avoid environmental impacts, emissions are reduced or eliminated by introducing renewable energy resources. The present research chronicles the production and testing of renewable biodiesel fuel derived from virgin coconut oil on a diesel engine, to analyses the engine performance and emission characteristics. In the first phase of work, production of biodiesel fuel from virgin coconut oil using transeterification process with two types of catalysts (homogenous and heterogeneous). The preliminary results shows that, with the addition of homogenous catalyst called Potassium Hydroxide (KOH) with methanol shows much higher activity than that of heterogeneous catalysts, and it shows more similar properties with diesel fuel. The results obtained from the chemical test and physicochemical properties of transesterified biodiesel fuel clearly proves the above-mentioned statement. The chemical tests such as GCMS and FT-IR clearly shows that the biodiesel fuel has sufficient amount of volatile components and functional groups. Then, physicochemical properties include, Fire point, Flashpoint, density, and viscosity were analyzed. Finally, Engine performance and Emission characteristics were analysed to confirm, whether this biodiesel fuel is suitable for diesel engines, without any engine modifications. It was found to be, the transesterified virgin coconut oil biodiesel has similar properties to that of the diesel fuel. From the physiochemical properties and engine performance clearly shows that, coconut oil biodiesel is suitable for diesel engine on blending, at a blending percentage level of 20% with conventional diesel fuel. Since the obtained transesterified biofuel can be used as an alternative fuel for diesel engines. The several journal reports and find outs from experimental investigation clearly depicts that the efficiency of the transesterified biofuel mainly depends upon the amount of catalyst adding and type of catalysts present in the biofuel, whether it is homogenous or heterogeneous catalyst is suitable with methanol. Finally, from the analysis made from biodiesel fuel. Coconut Oil Biodiesel fuel has less emission characteristics than that of the diesel fuels.


Energies ◽  
2019 ◽  
Vol 12 (10) ◽  
pp. 1954 ◽  
Author(s):  
Y.H. Teoh ◽  
K.H. Yu ◽  
H.G. How ◽  
H.-T. Nguyen

In the present study, the effects of adding of bioethanol as a fuel additive to a coconut biodiesel-diesel fuel blend on engine performance, exhaust emissions, and combustion characteristics were studied in a medium-duty, high-pressure common-rail turbocharged four-cylinder diesel engine under different torque conditions. The test fuels used were fossil diesel fuels, B20 (20% biodiesel blend), B20E5 (20% biodiesel + 5% bioethanol blend), and B20E10 (20% biodiesel + 10% bioethanol blend). The experimental results demonstrated that there was an improvement in the brake specific energy consumption (BSEC) and brake thermal efficiency (BTE) of the blends at the expense of brake specific fuel consumption (BSFC) for each bioethanol blend. An increment in nitrogen oxide (NOx) across the entire load range, except at low load conditions, was found with a higher percentage of the bioethanol blend. Also, it was found that simultaneous smoke and carbon monoxide (CO) emission reduction from the baseline levels of petroleum diesel fuel is attainable by utilizing all types of fuel blends. In terms of combustion characteristics, the utilization of bioethanol blended fuels presented a rise in the peak in-cylinder pressure and peak heat release rate (HRR) at a low engine load, especially for the B20E10 blend. Furthermore, the B20E10 showed shorter combustion duration, which reduced by an average of 1.375 °CA compared to the corresponding baseline diesel. This study therefore showed that the B20E10 blend exhibited great improvements in the diesel engine, thus demonstrating that bioethanol is a feasible fuel additive for coconut biodiesel-diesel blends.


2021 ◽  
Vol 13 (14) ◽  
pp. 7688
Author(s):  
Asif Afzal ◽  
Manzoore Elahi M. Soudagar ◽  
Ali Belhocine ◽  
Mohammed Kareemullah ◽  
Nazia Hossain ◽  
...  

In this study, engine performance on thermal factors for different biodiesels has been studied and compared with diesel fuel. Biodiesels were produced from Pongamia pinnata (PP), Calophyllum inophyllum (CI), waste cooking oil (WCO), and acid oil. Depending on their free fatty acid content, they were subjected to the transesterification process to produce biodiesel. The main characterizations of density, calorific range, cloud, pour, flash and fire point followed by the viscosity of obtained biodiesels were conducted and compared with mineral diesel. The characterization results presented benefits near to standard diesel fuel. Then the proposed diesel engine was analyzed using four blends of higher concentrations of B50, B65, B80, and B100 to better substitute fuel for mineral diesel. For each blend, different biodiesels were compared, and the relative best performance of the biodiesel is concluded. This diesel engine was tested in terms of BSFC (brake-specific fuel consumption), BTE (brake thermal efficiency), and EGT (exhaust gas temperature) calculated with the obtained results. The B50 blend of acid oil provided the highest BTE compared to other biodiesels at all loads while B50 blend of WCO provided the lowest BSFC compared to other biodiesels, and B50 blends of all biodiesels provided a minimum % of the increase in EGT compared to diesel.


Sign in / Sign up

Export Citation Format

Share Document